We demonstrate a method for broadband tunable continuous frequency electric field measurement based on the DC Stark effect in Rydberg atoms. In our experiment, we place a pair of parallel electrode plates inside the atomic vapor cell, utilizing the DC Stark effect to induce splitting and shifting of the Rydberg energy levels, thereby altering the resonance frequency of the Stark subpeaks. By employing the 52D5/2 Rydberg state, we achieve electric field measurements in the frequency range of 5.083–14.470 GHz. At an EDC of 3.45 V/cm and a resonant microwave frequency of 14.470 GHz, using heterodyne technology, the microwave electric field sensitivity is 538.89 μV/cm/√Hz, with a linear dynamic range of 23 dB. In comparison, a Rydberg heterodyne receiver with an EDC of 0 V/cm and a resonant microwave frequency of 5.083 GHz has a sensitivity of 5.43 μV/cm/√Hz and a linear dynamic range of 51 dB. This work will promote the study of atomic microwave receivers in continuous microwave frequency measurement.
We demonstrate the measurement of super low-frequency electric field using Rydberg atoms in an atomic vapor cell with inside parallel electrodes, thus overcoming the low-frequency electric-field-screening effect at frequencies below a few kHz. Rydberg electromagnetically induced transparency (EIT) spectra involving 52 D 5/2 state is employed to measure the signal electric field. An auxiliary DC field is applied to improve the sensitivity. A DC Stark map is demonstrated, where the utilized 52 D 5/2 exhibits m j = 1/2, 3/2, 5/2 Stark shifts and splittings. The m j = 1/2 state is employed to detect the signal field because of its larger polarizability than that of m j = 3/2, 5/2. Also, we show that the strength of the spectrum is dependent on the angle between the laser polarizations and the electric field. With optimization of the applied DC field to shift the m j = 1/2 Rydberg energy level to a high sensitivity region and the laser polarizations to obtain the maximum m j = 1/2 signal, we achieve the detection of the signal electric field with a frequency of 100 Hz down to 214.8 µ V/cm with a sensitivity of 67.9 µ V cm −1 Hz −1/2 , and the linear dynamic range is over 37 dB. Our work extends the measurement frequency of Rydberg sensors to super low frequency with high sensitivity, which has the advantages of high sensitivity and miniaturization for receiving super low frequency.
We demonstrate laser induced DC electric fields in an all-glass vapor cell without bulk or thin film electrodes. The spatial field distribution is mapped by Rydberg electromagnetically induced transparency (EIT) spectroscopy. The fields are generated by a photoelectric effect and allow DC electric field tuning of up to 0.8 V/cm within the Rydberg EIT probe region. We explain the measured with a boundary-value electrostatic model. This work may inspire new approaches for DC electric field control in designing miniaturized atomic vapor cell devices. Limitations and other charge effects are also discussed.
Research of hot atomic vapor systems has a long history. Recently, much-improved technologies, such as lasers, microwaves and digital/analog control systems, have led to exciting progress in this reviving field. Due to its cryogenic-free and vacuum-free deployment potential, room-temperature and quantum-enabled sensing devices using gaseous atoms have become a popular research topic, and engineering such devices has received considerable attention. Proof-of-principle experiments have been performed demonstrating new ideas such as quantum-enhanced motion sensors, next-generation magnetometers, Rydberg enabled microwave sensors, etc. This thesis focuses on my work related to electromagnetic-field sensing using Rydberg atoms in vapor cells, where Rydberg atoms are excited and detected by electromagnetically induced transparency (EIT) spectroscopy. I first investigate the detection of strong magnetic fields (
sim 1~T) in the Paschen-Back regime. The diamagnetic (quadratic) response of the Rydberg levels makes the atoms sensitive to small fluctuations in field strength on a large background. By implementing an isotope-mixed cell, we demonstrate that accurate measurement, within a relative uncertainty of
pm0.12%. Many Rydberg-enabled radio frequency and microwave sensing applications require a capability of zeroing or intentional tuning of small DC electric fields inside the vapor cell. For this purpose, I explore an in-situ DC electric-field sensing and tuning method without using any bulk or thin film electrodes. I find that the photoelectric effect on the vapor cell walls (with invisible, atomic Rb aggregate layers covering the surfaces) can generate tuning fields up to 0.8~V/cm, with an inhomogeneity of about 2%. The spatial distribution of these fields can be directly monitored by quadratic Stark shifts of the Rydberg atoms. This work may inspire new approaches for DC-field control in miniaturized, metal-free atomic vapor-cell devices. Like many other quantum measurements on hot gaseous samples, short interaction time and other technical decoherence processes are the major factors which limit the precision and, in certain cases, the accuracy of the metrological results. In order to study these effects in the context of EIT, I performed an EIT experiment using a
Lambda-type quantum system consisting of the hyperfine ground states and the first excited electronic state of the Rb atoms contained in a buffer-gas-free thermal vapor cell without anti-relaxation coating. Technical line-broadening effects due to inhomogeneity of stray magnetic fields, laser frequency jitter, transverse beam intensity distribution, interaction time distribution, and atom-wall/impurity gas collisions are studied. Experimental results and numerical simulations are compared. These results provide crucial information and quantitative insights for vapor cell sensor design. The development of compact and multi-functional spectroscopy vapor cells is widely considered to be a critical engineering step towards manufacturing field-deployable sensors for real life applications. My R&D efforts towards fabrication of glass spectroscopy cells with integrated, highly-conductive silicon components are presented in the last part of my thesis. I explored various technical challenges and successfully developed a proof-of-principle prototype from scratch. The device allows the application of electric fields inside the cell for particle trapping and for tuning Rydberg transitions. Further, the highly-conductive silicon components enable microwave polarization filtering for microwave sensing applications, plasma-physics studies, etc. Preliminary experimental/technical data and simulations are presented. In summary, in my thesis I report on a comprehensive study of several spectroscopic and field sensing applications of Rydberg and ground-state atoms in vapor cells, as well as forays into novel methods to engineer vapor cells with embedded electrodes.
Significant progress has been made in atom-based measurements of length, time, gravity and electromagnetic fields in recently years. Rydberg atom-based microwave electric field measurement, using electromagnetically induced transparency (EIT) in room temperature alkali-metal vapors, has been extensively investigated and aroused the broad interest. This approach may establish a new standard for the measurements of microwave (MW) and radio frequency (RF) electric fields.In this review, we describe the work on a new method of measuring electric fields based on quantum interference by using either cesium or rubidium atoms contained in a dielectric vapor cell. Rydberg atoms with principal quantum number n >>1 have large direct current (DC) polarizabilities and microwave transition dipole moments, thereby making them extremely sensitive to external electric fields. Using the Rydberg three-level EIT to detect the level splitting and shift that is induced by the external field, we can realize a rapid and robust self-calibration method of measuring the electric field in a frequency range from 0.01 GHz to 1000 GHz. For the MW electric field (frequency range > 1 GHz), the MW field causes the Rydberg states to split, known as an Autler-Townes splitting (A-T) effect when the applied microwave can resonate with adjacent Rydberg states. The MW coupled A-T splitting is proportional to the applied electric field strength, from which the field strength is measured. Using the EIT window, a high sensitivity of 3 μV·cm-1·Hz-1/2 and small electric field of 1 μV/cm are expected to be achieved with a modest setup, and the limitations of the sensitivity are also addressed in the review. For the RF field at frequency mj EIT lines, and avoided crossings formed with the fine-structure levels of equal mj and different J's, which is used to calibrate and measure the RF field amplitude. On the other hand, the dependence of the EIT-line strength on the RF field polarization provides a fast and robust polarization measurement of RF fields based on matching experimental data with a theoretical simulation. The measurements of minimum strengths and sensitivity of RF fields based on Rydberg atoms are one order magnitude below the values obtained by traditional antenna methods. The atom-based field measurement paves the way for determining fields through calibration-free, invariable atomic properties and miniaturization. We also propose its various potential applications in the future.
Quantum computing and quantum simulation with ultracold neutral atoms require Rydberg excitation of individual atoms in atomic arrays. Rydberg states are extremely sensitive to external electric fields, therefore precise three-dimensional control of the electric field is essential. We performed a spectroscopic study of three-photon Rydberg excitation of a single Rb atom in an optical dipole trap in the presence of an external DC electric field. The field was generated by eight electrodes deposited on the inner surfaces of an ultrahigh-vacuum glass cell. The used three-photon scheme of laser excitation of Rydberg \textit{nP} states allows the Stark shift and the splitting of the resonances to be observed simultaneously, which simplifies calibration of the electric field. In addition, in the commonly used two-photon Rydberg excitation schemes, the light shifts can complicate accurate determination of the DC Stark shift, particularly when the external electric field is scanned across different spatial directions, and different Stark components are excited. These shifts are absent in the three-photon excitation scheme used in our experiment. We demonstrated the ability to independently tune the electric field along all three spatial directions and to compensate for stray electric fields. The measured three-photon spectra exhibit Stark shifts and splittings of the three-photon resonance that are in good agreement with theoretical calculations. These results are also of interest for Rydberg electrometry.