Quantum optical coherence: From linear to nonlinear interferometers
Kai-Hong Luo, Matteo Santandrea, Michael Stefszky, Jan Sperling, Marcello Massaro, Alessandro Ferreri, Polina R. Sharapova, Harald Herrmann, Christine Silberhorn
Interferometers provide a highly sensitive means to investigate and exploit the coherence properties of light in metrology applications. However, interferometers come in various forms and exploit different properties of the optical states within. In this paper, we introduce a classification scheme that characterizes any interferometer based on the number of involved nonlinear elements by studying their influence on single-photon and photon-pair states. Several examples of specific interferometers from these more general classes are discussed, and the theory describing the expected first-order and second-order coherence measurements for single-photon and single-photon-pair input states is summarized and compared. These theoretical predictions are then tested in an innovative experimental setup that is easily able to switch between implementing an interferometer consisting of only one or two nonlinear elements. The resulting singles and coincidence rates are measured in both configurations and the results are seen to fit well with the presented theory. The measured results of coherence are tied back to the presented classification scheme, revealing that our experimental design can be useful in gaining insight into the properties of the various interferometeric setups containing different degrees of nonlinearity.
Interferometers provide a highly sensitive means to investigate and exploit the coherence properties of light in metrology applications. However, interferometers come in various forms and exploit different properties of the optical states within. In this paper, we introduce a classification scheme that characterizes any interferometer based on the number of involved nonlinear elements by studying their influence on single-photon and photon-pair states. Several examples of specific interferometers from these more general classes are discussed, and the theory describing the expected first-order and second-order coherence measurements for single-photon and single-photon-pair input states is summarized and compared. These theoretical predictions are then tested in an innovative experimental setup that is easily able to switch between implementing an interferometer consisting of only one or two nonlinear elements. The resulting singles and coincidence rates are measured in both configurations and the results are seen to fit well with the presented theory. The measured results of coherence are tied back to the presented classification scheme, revealing that our experimental design can be useful in gaining insight into the properties of the various interferometeric setups containing different degrees of nonlinearity.
Phase estimation has a wide range of applications. Over the years, several strategies have been studied to improve precision in phase estimation. These strategies include using exotic quantum states to quantum detection schemes. This dissertation summarizes my effort in improving the precision of phase estimation with a linear and nonlinear interferometer. Chapter 1 introduces quantum optics and quantum metrology. I introduce all relevant quantum states of light used. We also look into tools and terminologies of quantum metrology such as Fisher information, shot-noise limit, Heisenberg limit, etc., along with examples of phase estimation with a Mach-Zehnder interferometer. In Chapter 2, I discuss multiple phase estimation using a multimode interferometer. Building upon previous work, our scheme consists of a multimode interferometer with single-photon inputs. By using a quantum Fisher information analysis, we show that our scheme gives a constant improvement over other schemes. We also show that our scheme with photon-number-resolving detection approaches the quantum Cram\'er-Rao bound. Moreover, we also consider the probabilistic nature of photon emission at the input, and we study its effect on phase sensitivity. I discuss phase estimation with SU(1,1) interferometer in Chapter 3. We look at phase sensitivity in this interferometer with different input states. Namely, we consider two different phase estimation scheme, one using thermal and squeezed states, and others using coherent and displaced squeezed states with parity and on-off as a detection scheme. We also look into the effect of photon loss inside the interferometer. In Chapter 4, we revisit phase estimation in SU(1,1) interferometer from the perspective of quantum Fisher information. I discuss in detail a longstanding confusion regarding the use of quantum Fisher information in SU(1,1) interferometer. We show that phase averaging or quantum Fisher information matrix method is needed in general for calculating the phase sensitivity which resolves inconsistencies reported in previously published articles.
The standard quantum limit (SQL) describes the best precision that can be achieved for phase measurements using a classical interferometer. For such an interferometer, this limit is given by1/NwhereNis the total number of photons launched into the interferometer. The SQL can be circumvented through the utilisation of quantum states combined with advanced low-loss detection schemes. Such overcoming of the SQL has been demonstrated, for example, by replacing the unused vacuum input port of the linear interferometer with a non-classical state [1], and by exploiting nonlinear SU (1,1) interferometers in the high-gain regime [2]. However, the impact of the experimental losses on the ability of nonlinear interferometers to beat the SQL is often neglected, particularly in the low-gain regime. In this work, we close this gap by studying the performance of lossy SU (1,1) interferometers in the single-photon pair regime, with particular attention to the different amount of information contained in the measurement of single counts and of coincidences at the output of the interferometer.
This thesis fathoms the possibilities and limitations of measurements in quantum optics. After a short introduction to the general aspects of measurements in quantum mechanics, it presents three examples of a measurement process in concrete applications to quantum optics. For one, while operators describing quantities of interest might have a simple theoretical form, it is often hard to actually implement a measurement of their expectation values experimentally. This situation is encountered in the first part which is devoted to the measurement of quantum statistical properties of a light beam. In contrast to classical optics, these statistics are not fully determined by first- and second-order correlations. Instead, higher-order correlations, usually described by non-Hermitian operators, are necessary to characterize the quantum state completely. A particular example is the N-photon Fock state, for which only a measurement of the Nth-order correlations allows for a full characterization. Here, we present a new method how to measure an important class of Nth-order correlations for arbitrary N in a single spatial mode with two polarizations with limited experimental resources. The second part is again centered around the realization of specific measurement operators for photon correlation measurements. However, in contrast to the previous chapter, these measurements are not an end in their own, but are designed to create specific quantum states as a consequence of the measurement process: A suitable measurement of photons emitted by a number of atoms allows to transfer the atoms into long-lived entangled states. We find that with this method it is possible to entangle two remote atomic qubits to an arbitrary and well-defined degree. Furthermore, we show how to generate two families of quantum states in an arbitrary number of remote atomic qubits: one family consists of all -- symmetric and non-symmetric -- total angular momentum eigenstates in N remote qubits, the other is a family of cluster states. It is also systematically investigated whether the technique of quantum state engineering by projective measurements allows for the creation of any arbitrary state. We find explicit solutions for the case of two and three qubits, while it is shown that no solution exist for N > 6. We conclude the section by proving that with some changes in the setup, this measurement-based quantum state engineering technique allows to create the same states among the scattered photons themselves rather than among the emitting atoms. The last part is devoted to the amount of information one is able to gain about a given system when performing a measurement. The corresponding limits of information are investigated at the example of the duality that arises in a two-way interferometer between the visibility of the interference pattern and the knowledge about the path of the interfering object. We show that there exist correlations between the phase difference the interfering object acquires on its way through the interferometer and the amount of which-way information retrievable from certain observables of the which-way detector. In this way, the which-way information becomes a phase-dependent quantity. In particular, we find that for certain values of the phase shift, the amount of extractable which-way information can be larger than allowed by phase-independent measurement. This property is put to use to find the optimal observable for the which-way detector readout in dependence on the phase of the interfering object. Following this strategy, we are able to gain more which-way information than previously thought possible.
The interference of entangled photon pairs permits the study of the fundamental properties of quantum mechanics. The process is also finding practical applications in optical imaging. The Michelson interferometer provides an elegant means for characterizing the degree of two-photon entanglement, but the technique has not yet been described and analyzed in detail. Here we provide a full description of the interference of collinear down-converted photons in a Michelson interferometer. We explain the basic elements that characterize the interference pattern and complement the theory with experimental measurements. The two-photon Michelson interferometer can be used in quantum optical coherence tomography for dispersion-free imaging and localization.
We investigate how the temporal coherence interference properties of light in a Michelson-Morley interferometer (MMI), using only a single-photon detector, can be understood in a quantum-optics framework in a straightforward and pedagogical manner. For this purpose we make use of elementary quantum field theory and Glaubers theory for photon detection in order to calculate the expected interference pattern in the MMI. If a thermal reference source is used in the MMI local oscillator port in combination with a thermal source in the signal port, the interference pattern revealed by such an intensity measurement shows a distinctive dependence on the differences in the temperature of the two sources. The MMI can therefore be used in order to perform temperature measurements. A related method was actually used to carry out high precision measurements of the cosmic micro-wave background radiation on board of the COBE satellite. The theoretical framework allows us to consider any initial quantum state. The interference of single photons as a tool to determine the angular peak-frequency of a one-photon pulse interfering with a single-photon reference pulse is, e.g., considered. A similar consideration for coherent laser pulses leads to a different response in the detector. The MMI experimental setup is therefore in a sense an example of an optical device where one can exhibit the difference between classical and quantum-mechanical light using only intensity measurements.
The temporal coherence interference properties of light as revealed by single detector intensity measurements in a Michelson-Morley interferometer (MMI) is often described in terms of classical optics. We show, in a pedagogical manner, how such features of light also can be understood in terms of a more general quantum-optics framework. If a thermal reference source is used in the MMI local oscillator port in combination with a thermal source in the signal port, the interference pattern revealed by single detector intensity measurements shows a distinctive dependence on the differences in the temperature of the two sources. A related method has actually been used to perform high-precision measurements of the cosmic microwave background radiation. The general quantum-optics framework allows us to consider any initialquantum state. As an example, we consider the interference of single photons as a tool to determine the peak angular-frequency of a single-photon pulse interfering with a single-photon reference pulse. A similar consideration for laser pulses, in terms of coherent states, leads to a different response in the detector. The MMI experimental setup is therefore an example of an optical device where one, in terms of intensity measurements, can exhibit the difference between classical and quantum-mechanical light.