Quantum measurements can be expressed in a thermodynamic context. Here, they are broken down into a series of distinct steps and the consequent energetic changes --- work and heat --- are investigated. When the assumption is made that the measurement outcome must be stable over time, the heat fluctuations from a quantum measurement are shown to be necessarily classical.
Quantum measurements can be expressed in a thermodynamic context. Here, they are broken down into a series of distinct steps and the consequent energetic changes --- work and heat --- are investigated. When the assumption is made that the measurement outcome must be stable over time, the heat fluctuations from a quantum measurement are shown to be necessarily classical.
Quantum measurement is ultimately a physical process, resulting from an interaction between the measured system and a measurement apparatus. Considering the physical process of measurement within a thermodynamic context naturally raises the following question: how can the work and heat resulting from the measurement process be interpreted? In the present manuscript, we model the measurement process for an arbitrary discrete observable as a measurement scheme. Here, the system to be measured is first unitarily coupled with a measurement apparatus, and subsequently the apparatus is measured by a pointer observable, thus producing a definite measurement outcome. The work can therefore be interpreted as the change in internal energy of the compound of system-plus-apparatus due to the unitary coupling. By the first law of thermodynamics, the heat is the subsequent change in internal energy of this compound due to the measurement of the pointer observable. However, in order for the apparatus to serve as a stable record for the measurement outcomes, the pointer observable must commute with the Hamiltonian, and its implementation must be repeatable. Given these minimal requirements, we show that the heat will necessarily be a classically fluctuating quantity.
Quantum measurement of a system can change its mean energy, as well as entropy. A selective measurement (classical or quantum) can be used as a "Maxwell's demon" to power a single-temperature heat engine, by decreasing the entropy. Quantum mechanically, so can a non-selective measurement, despite increasing the entropy of a thermal state. The maximal amount of work extractable following the measurement is given by the change in free energy: Wmax(non−)sel.=ΔEmeas−TBathΔSmeas(non−)sel.. This follows from the "generalized 2nd law for nonequilibrium initial state" [Hasegawa et. al, PLA (2010)], of which an elementary reduction to the standard law is given here. It is shown that Wmaxsel.−Wmaxnon−sel. equals the work required to reset the memory of the measuring device, and that no such resetting is needed in the non-selective case. Consequently, a single-bath engine powered by either kind of measurement works at a net loss of TBathΔSmeasnon−sel per cycle. By replacing the measurement by a reversible "premeasurement" and allowing a work source to couple to the system and memory, the cycle can be made completely reversible.
Abstract This article sets up a new formalism to investigate stochastic thermodynamics in the quantum regime, where stochasticity and irreversibility primarily come from quantum measurement. In the absence of any bath, we define a purely quantum component to heat exchange, that corresponds to energy fluctuations caused by quantum measurement. Energetic and entropic signatures of measurement-induced irreversibility are then explored for canonical experiments of quantum optics, and the energetic cost of counter-acting decoherence is studied on a simple state-stabilizing protocol. By placing quantum measurement in a central position, our formalism contributes to bridge a gap between experimental quantum optics and quantum thermodynamics, and opens new paths to characterize the energetic features of quantum processing.
Quantum measurements are known to affect the state of the measured system. Such a measurement backaction is due to the interaction of the quantum system with the measuring device. When the measured observable and the system's Hamiltonian do not commute, the backaction can lead to a mean energy change of the system. This energy change has been dubbed "quantum heat" and, in association with feedback processes and/or the interaction with thermal bath(s), proves to be a genuinely quantum resource to fuel new kinds quantum engines. We propose such a measurement powered engine exploiting the non-commutativity of local and non-local operations on a bipartite quantum system.We then investigate the origin of the quantum heat. Even if one cannot model the full dynamics of a measurement due to the collapse of the wavefunction, the energetic aspects can still be investigated by modeling the so-called pre-measurement. During this step, the system interacts and gets correlated with a quantum system which can be viewed as a small part of the measuring apparatus and called the quantum meter. Ideally, at the end of this process, the system's reduced state will be fully decohered in the measurement basis, thus corresponding to the averaged collapsed output states given by the measurement postulate. We find that the quantum heat received by the measured system corresponds to the energy necessary to turn off the coupling between the meter and the system. Using generalized definitions of heat and work, we moreover characterize the work and heat nature of these energy exchanges.Tracing the source of this energy one step further, we propose an autonomous description of a measurement. This is done by considering a flying qubit measured by the quantum field of the cavity it crosses. The interaction being position dependent, the kinetic degree of freedom is providing the required energy to switch on and off the interaction between the qubit and the meter field. A full quantum treatment allows us to evaluate the impact of the finite spatial and momentum extension of the qubit wavepacket. Since the kinetic degree of freedom can be affected by the interaction, it does not simply generate a time dependent Hamiltonian for the other degrees of freedom. We find the correction to this ideal dynamic and analyse its consequences on the nature of the energy fluxes. %spread/extension/broadnessTaking the opposite point of view, we compare the measurement cost of a qubit by a field propagating in a waveguide, depending on the initial state of the field. In the context of a circuit quantum electrodynamics setup, we find that thermal and coherent fields induce the same backaction on the qubit given the same energy constraints.The results presented and discussed in this thesis contribute to unravel the mysterious effects and mechanisms due to quantum measurements. Notably, they give an outlook to further analyse quantum measurement-based engines and to understand the energetic resource that measurements cost and constitute at the same time.
Quantum heat engines are devices comprised of one or more quantum systems operating cyclically between two heat reservoirs to produce work.Although the laws of quantum mechanics rule these engines, this does not imply that these machines function in a quantum fashion, or exhibit a quantum advantage.Indeed, quantum heat engines have shown a remarkable similarity with classical models, thus raising the question of what is "quantum" in quantum thermodynamics.With the help of the P-representability concept, an expression called classicality function is introduced -allowing us to quantify the degree of non-classicality of a bosonic system.As an illustration, we consider a quantum heat engine consisting of a single bosonic mode as a working substance coupled to a cold thermal and hot squeezed thermal bath.For two specific protocols, i.e., a quantum Otto and a generalized cycle, we show that the non-classicality is a resource that can be used to perform thermodynamical tasks more efficiently.Furthermore, we present a theoretical framework to study how quantum features, such as entanglement or coherence, affect the classical formulations of thermodynamic axioms.
This Colloquium is a fast journey through the build-up of key thermodynamical concepts, i.e. work, heat and irreversibility -- and how they relate to information. Born at the time of industrial revolution to optimize the exploitation of thermal resources, these concepts have been adapted to small systems where thermal fluctuations are predominant. Extending the framework to quantum fluctuations is a great challenge of quantum thermodynamics, that opens exciting research lines e.g. measurement fueled engines or thermodynamics of driven-dissipative systems. On a more applied side, it provides the tools to optimize the energetic consumption of future quantum computers.