We characterize control of a qutrit implemented in the lowest three energy levels of a capacitively shunted flux-biased superconducting circuit.Randomized benchmarking over the qutrit Clifford group yields an average fidelity of 98.89 ± 0.05%.For a selected subset of the Clifford group, we perform quantum process tomography and observe the behavior of repeated gate sequences.Each qutrit gate is generated using only two-state rotations via a method applicable to any unitary.We find that errors are due primarily to decoherence and have a significant contribution from level shifts.This work demonstrates high-fidelity qutrit control and outlines avenues for future work on the optimal control of superconducting qudits.
We characterize control of a qutrit implemented in the lowest three energy levels of a capacitively shunted flux-biased superconducting circuit.Randomized benchmarking over the qutrit Clifford group yields an average fidelity of 98.89 ± 0.05%.For a selected subset of the Clifford group, we perform quantum process tomography and observe the behavior of repeated gate sequences.Each qutrit gate is generated using only two-state rotations via a method applicable to any unitary.We find that errors are due primarily to decoherence and have a significant contribution from level shifts.This work demonstrates high-fidelity qutrit control and outlines avenues for future work on the optimal control of superconducting qudits.
Superconducting devices have emerged as leading candidates for building practical quantum computers, owing to their scalability, designability, and ease of control. Development of superconducting devices has been accompanied by increases in coherence times from nanoseconds to tens of microseconds, and a multitude of new types of superconducting qubits. In turn, these improvements in coherence, and study of superconducting qubits has produced models for these devices accurate and trustworthy enough to enable design decisions to be determined prior to device fabrication. Recent work by the superconducting quantum devices (SQD) group has produced a variant of the capacitively-shunted flux qubit that features fast control over the lowest three levels, allowing the device to be used as a qutrit. This thesis presents a model and characterization results for this device. \n \nThis thesis also presents experimental results characterizing control fidelity for a qutrit using randomized benchmarking (RB). Quantum process tomography and application of repeated gate sequences are also used to support the randomized benchmarking results. The method of synthesizing the gates in the qutrit Clifford group can decompose any gate into two-state rotations. The fidelity of 99.0 +/- 0.2% obtained by randomized benchmarking establishes the device as a useful qutrit, and outlines interesting directions in using higher levels to improve qubit-based quantum computers, and in using higher levels to pack more states into fewer devices in quantum computers. Analysis of experimental results indicates errors are dominated by ac-Stark and Bloch-Siegert shifts during qutrit control. \n \nThis thesis then presents two new devices meant to study the impact of changing design parameters on the suitability of flux qubits for multilevel control. The first device test individual qubits, with the goal of further improving the coherence time, and improving qutrit control. The second device couples two devices together, so that two-qubit gates can be studied. The available design parameters and their impact on qubit properties are discussed, and design variations are selected for the single and two-qubit devices. The result is a set of devices ready for manufacture and experimental characterization.
We have implemented a Walsh-Hadamard gate, which performs a quantum Fourier transform, in a superconducting qutrit. The qutrit is encoded in the lowest three energy levels of a capacitively shunted flux device, operated at the optimal flux-symmetry point. We use an efficient decomposition of the Walsh-Hadamard gate into two unitaries, generated by off-diagonal and diagonal Hamiltonians, respectively. The gate implementation utilizes simultaneous driving of all three transitions between the three pairs of energy levels of the qutrit, one of which is implemented with a two-photon process. The gate has a duration of 35 ns and an average fidelity over a representative set of states, including preparation and tomography errors, of 99.2%, characterized with quantum-state tomography. Compensation of ac-Stark and Bloch-Siegert shifts is essential for reaching high gate fidelities.
Ternary quantum processors offer significant potential computational advantages over conventional qubit technologies, leveraging the encoding and processing of quantum information in qutrits (three-level systems). To evaluate and compare the performance of such emerging quantum hardware it is essential to have robust benchmarking methods suitable for a higher-dimensional Hilbert space. We demonstrate extensions of industry standard randomized benchmarking (RB) protocols, developed and used extensively for qubits, suitable for ternary quantum logic. Using a superconducting five-qutrit processor, we find an average single-qutrit process infidelity of 3.8×10^{-3}. Through interleaved RB, we characterize a few relevant gates, and employ simultaneous RB to fully characterize crosstalk errors. Finally, we apply cycle benchmarking to a two-qutrit CSUM gate and obtain a two-qutrit process fidelity of 0.85. Our results present and demonstrate RB-based tools to characterize the performance of a qutrit processor, and a general approach to diagnose control errors in future qudit hardware.
Typical quantum gate tomography protocols struggle with a self-consistency problem: the gate operation cannot be reconstructed without knowledge of the initial state and final measurement, but such knowledge cannot be obtained without well-characterized gates. A recently proposed technique, known as randomized benchmarking tomography (RBT), sidesteps this self-consistency problem by designing experiments to be insensitive to preparation and measurement imperfections. We implement this proposal in a superconducting qubit system, using a number of experimental improvements including implementing each of the elements of the Clifford group in single 'atomic' pulses and custom control hardware to enable large overhead protocols. We show a robust reconstruction of several single-qubit quantum gates, including a unitary outside the Clifford group. We demonstrate that RBT yields physical gate reconstructions that are consistent with fidelities obtained by RB.
We implement a complete randomized benchmarking protocol on a system of two superconducting qubits. The protocol consists of randomizing over gates in the Clifford group, which experimentally are generated via an improved two-qubit cross-resonance gate implementation and single-qubit unitaries. From this we extract an optimal average error per Clifford operation of 0.0936. We also perform an interleaved experiment, alternating our optimal two-qubit gate with random two-qubit Clifford gates, to obtain a two-qubit gate error of 0.0653. We compare these values with a two-qubit gate error of $\ensuremath{\sim}0.12$ obtained from quantum process tomography, which is likely limited by state preparation and measurement errors.
Superconducting devices as quantum bits (qubits) are one of the most promising candidates for implementing a practical quantum computer. Over the last decade, quantum coherence times of superconducting qubits have been continuously improved. Operating qubits in noise insensitive points, eliminating the participation of the lossy materials, and better isolation from environment increased the decoherence times from nanoseconds to tens of microseconds. One recent approach on the qubit design is to shunt the Josephson junctions with large capacitors to reduce the sensitivity to noise and to redistribute the stored electromagnetic energy in a well-engineered area. This approach was first applied on charge qubits and later adopted to other types of superconducting qubits. \n \nIn this thesis, we present the design and the characterization of a three-Josephson junction superconducting circuit with three large shunt capacitors. We present experiments on decoherence in the circuit used as a qubit. The qubit relaxation time T₁ is reaching as high as 47 μs and the spin-echo dephasing time T₂ = 9.4 μs. In addition, we present spectroscopy experiments and decoherence characterization in the qutrit subspace formed by the lowest three energy levels. The spectroscopy data is in excellent agreement with the complete circuit model based on the system capacitance matrix. At the flux symmetry point, the circuit has a large anharmonicity, defined as the difference between the 1-2 and 0-1 transition frequencies, approaching 2π × 3.7 GHz, which is enabling fast single qubit operations. We performed randomized benchmarking with the qubit gates with a duration of 1.62 ns and an average gate fidelity of 99.9%. \n \nMoreover, we present experiments with multi-level control in qutrit subspace, formed by the lowest three energy levels. We demonstrate a single step experimental implementation of a generalized Walsh-Hadamard gate. We use a decomposition of the quantum gate into two unitary operations, one implemented by an off-diagonal Hamiltonian and the other implemented by a diagonal Hamiltonian. The off-diagonal Hamiltonian is obtained by the simultaneous driving of the transitions between levels 0-1, 1-2, and 0-2, with the latter being a two-photon process. The diagonal Hamiltonian is effectively implemented by appropriately shifting the phases of adjacent pulses. The gate is characterized using tomography process and the average fidelity exceeds 90%, in good agreement with numerical simulations that take into account the multi-level structure of the system.