Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2008.11397 · Physical Review A

Optical-lattice-based Cs active clock with a continual superradiant lasing signal

Duo Pan, Bindiya Arora, Yanmei Yu, B. K. Sahoo, Jingbiao Chen

Published Oct 21, 2020• 20 citations
arXivHTMLPDF

Abstract

We demonstrate the state-of-the-art technique of an active clock to provide a continuous superradiant lasing signal using an ensemble of trapped Cs atoms in an optical lattice. A magic wavelength of the proposed $|7{S}_{1/2};F=4,{M}_{F}=0\ensuremath{\rangle}\ensuremath{\rightarrow}|6{P}_{3/2};F=3,{M}_{F}=0\ensuremath{\rangle}$ clock transition in Cs atoms is identified at 1181 nm for constructing the optical lattice. Pertinent optical lines are also found for pumping and repumping atoms from their ground states. A fractional uncertainty about ${10}^{\ensuremath{-}15}$ in the clock frequency has been predicted by carrying out rigorous calculations of several atomic properties. The bad-cavity operational mode of the active clock is anticipated to improve remarkably its short-term stability by suppressing intrinsic thermal fluctuations. Thus, a composite clock system with better short-term and long-term stabilities can be built by combining the proposed active clock with another high-accuracy passive optical clock.

DOI
10.1103/physreva.102.041101

Related papers

Magic Wavelengths for Optical-Lattice Based Cs and Rb Active Clocks

Sukhjit Singh Sehra, Jyoti, Bindiya Arora +2 more

Active clocks could provide better stabilities during initial stages of measurements over passive clocks, in which stabilities become saturated only after long-term measurements. This unique feature of an active clock has led to search for suitable candidates to construct such clocks. The other challenging task of an atomic clock is to reduce its possible systematics. A major part of the optical lattice atomic clocks based on neutral atoms are reduced by trapping atoms at the magic wavelengths of the optical lattice lasers. Keeping this in mind, we find the magic wavelengths between all possible hyperfine levels of the transitions in Rb and Cs atoms that were earlier considered to be suitable for making optical active clocks. To validate the results, we give the static dipole polarizabilities of Rb and Cs atoms using the electric dipole transition amplitudes that are used to evaluate the dynamic dipole polarizabilities and compare them with the available literature values.

Atoms•Nov 10, 2020•4 citations

Research progress on active optical clocks

Jingbiao Chen, Wei Zhang

Active optical clocks, a new class of optical atomic clocks, work through stimulated emission lasing, a unique mechanism that is distinct from laser absorption spectroscopy of conventional optical clocks. With coherent weak optical feedback from a Fabry-Perot resonator operating in the bad-cavity regime, active optical clocks sustain a lasing oscillation at an atomic transition frequency. They are used directly as quantum optical frequency standards with expected stability better by about two orders of magnitude than that of the best clocks. This review starts with a simplified account of historical developments and the limitations of critical techniques in optical atomic clocks. After an introduction of the basic mechanism underlying active optical clocks, we discuss the most recent experimental results for several configurations and experimental set-ups of active optical clocks. These include those based on a 2-level atomic beam and 3-level laser-cooled trapped-atom system, those based on a 4-level atom scheme, and the Faraday active optical clock. Moreover, following the successful lasing and preliminary results on a Faraday active optical frequency standard with Faraday atomic filter using thermal Cs cell, we describe an experimental scheme of a Faraday active optical clock with a Faraday atomic filter using magic-lattice-trapped Sr atoms at the 689-nm transition, and Faraday optical clocks operating in the good-cavity regime. We conclude with a comprehensive comparison of the different active optical clocks, prospects for active Faraday optical clocks, and potential applications of active optical clocks.

Chinese Science Bulletin (Chinese Version)•Jul 1, 2015•4 citations

High-Accuracy Microwave Atomic Clock via Magic Optical Lattice

Xiaoji Zhou, Xuzong Chen, Jingbiao Chen

A microwave atomic clock scheme based on Rb and Cs atoms trapped in optical lattice with magic wavelength for clock transition is proposed. The ac Stark shift of clock transition due to trapping laser can be canceled at some specific laser wavelengths. Comparing with in fountain clock, the cavity related shifts, the collision shift, and the Doppler effect are eliminated or suppressed dramatically in atomic clock when the magic optical lattice is exploited. By carefully analyzing various sources of clock uncertainty, we conclude that a microwave atomic clock with an accuracy of better than $2\times10^{-17}$ is feasible, which is of the same accuracy as the expected best optical atomic clock.

arXiv:physics/0512244•Dec 25, 2005•3 citations

A superradiant clock laser on a magic wavelength optical lattice

Thomas Maier, Sebastian Kraemer, Laurin Ostermann +1 more

An ideal superradiant laser on an optical clock transition of noninteracting cold atoms is predicted to exhibit an extreme frequency stability and accuracy far below mHz-linewidth. In any concrete setup sufficiently many atoms have to be confined and pumped within a finite cavity mode volume. Using a magic wavelength lattice minimizes light shifts and allows for almost uniform coupling to the cavity mode. Nevertheless, the atoms are subject to dipole-dipole interaction and collective spontaneous decay which compromises the ultimate frequency stability. In the high density limit the Dicke superradiant linewidth enhancement will broaden the laser line and nearest neighbor couplings will induce shifts and fluctuations of the laser frequency. We estimate the magnitude and scaling of these effects by direct numerical simulations of few atom systems for different geometries and densities. For Strontium in a regularly filled magic wavelength configuration atomic interactions induce small laser frequency shifts only and collective spontaneous emission weakly broadens the laser. These interactions generally enhance the laser sensitivity to cavity length fluctuations but for optimally chosen operating conditions can lead to an improved synchronization of the atomic dipoles.

arXiv:1402.4356•Optics Express•May 27, 2014•62 citations

Advances in active optical clocks: Past decade developments and future outlook

Chen Wang, Shougang Zhang, Jingbiao Chen +1 more

Atomic clocks can be broadly classified into passive and active types according to their mode of operation. In the microwave domain, active hydrogen masers provide excellent short-term stability and are widely used as flywheel oscillators in timekeeping systems along with the cesium fountain standards. In the optical domain, passive optical clocks have achieved unprecedented accuracy and stability, but at the cost of large and complex infrastructures associated with ultrastable cavities and the preparation of atoms in optical lattices or ion traps. By contrast, active optical clocks generate coherent clock light directly from an atomic transition in the bad-cavity regime, where cavity pulling is strongly suppressed, thereby reducing sensitivity to cavity fluctuations and potentially simplifying optical clock architectures. Over the past decade, active optical clocks have developed from a conceptual proposal into a rapidly advancing field that includes pulsed superradiant systems based on cold atoms and continuous-wave bad-cavity systems based on thermal atomic vapors. This review summarizes recent progress in active optical clocks and discusses future directions of the field.

Quantum Review Letters•Jan 1, 2026•0 citations

Characterisation and feasibility study for superradiant lasing in 40Ca atoms

Anahit L. Gogyan, Georgy A. Kazakov, Marcin Bober +1 more

Superradiant active clocks operating on narrow linewidth clock transitions are predicted to achieve precision orders of magnitude higher than any currently existing optical atomic clocks. We introduce a theory of superradiant lasing and implement it for the example of 40Ca atoms. The presented model, however, is valid for any two- or three-level system in an optical lattice. We perform a feasibility analysis and suggest a set of parameters for the experimental fulfillment of superradiant lasing in Ca. Moreover, we present an overview of different magic wavelengths for the 4s2 1S0 ↔ 4s4p 3P1 (m J = 0) transition in Ca for different polarizations and a robustness analysis of these magic conditions. We also report the magic-zero wavelengths for the 4s4p 3P1, m J = 0 state.

Optics Express•Feb 8, 2020•17 citations
We demonstrate the state-of-the-art technique of an active clock to provide a continuous superradiant lasing signal using an ensemble of trapped Cs atoms in an optical lattice. A magic wavelength of the proposed ∣7S1/2;F=4,MF=0\ensuremath⟩\ensuremath→∣6P3/2;F=3,MF=0\ensuremath⟩|7{S}_{1/2};F=4,{M}_{F}=0\ensuremath{\rangle}\ensuremath{\rightarrow}|6{P}_{3/2};F=3,{M}_{F}=0\ensuremath{\rangle}∣7S1/2​;F=4,MF​=0\ensuremath⟩\ensuremath→∣6P3/2​;F=3,MF​=0\ensuremath⟩ clock transition in Cs atoms is identified at 1181 nm for constructing the optical lattice. Pertinent optical lines are also found for pumping and repumping atoms from their ground states. A fractional uncertainty about 10\ensuremath−15{10}^{\ensuremath{-}15}10\ensuremath−15 in the clock frequency has been predicted by carrying out rigorous calculations of several atomic properties. The bad-cavity operational mode of the active clock is anticipated to improve remarkably its short-term stability by suppressing intrinsic thermal fluctuations. Thus, a composite clock system with better short-term and long-term stabilities can be built by combining the proposed active clock with another high-accuracy passive optical clock.
Active clocks could provide better stabilities during initial stages of measurements over passive clocks, in which stabilities become saturated only after long-term measurements. This unique feature of an active clock has led to search for suitable candidates to construct such clocks. The other challenging task of an atomic clock is to reduce its possible systematics. A major part of the optical lattice atomic clocks based on neutral atoms are reduced by trapping atoms at the magic wavelengths of the optical lattice lasers. Keeping this in mind, we find the magic wavelengths between all possible hyperfine levels of the transitions in Rb and Cs atoms that were earlier considered to be suitable for making optical active clocks. To validate the results, we give the static dipole polarizabilities of Rb and Cs atoms using the electric dipole transition amplitudes that are used to evaluate the dynamic dipole polarizabilities and compare them with the available literature values.
Active optical clocks, a new class of optical atomic clocks, work through stimulated emission lasing, a unique mechanism that is distinct from laser absorption spectroscopy of conventional optical clocks. With coherent weak optical feedback from a Fabry-Perot resonator operating in the bad-cavity regime, active optical clocks sustain a lasing oscillation at an atomic transition frequency. They are used directly as quantum optical frequency standards with expected stability better by about two orders of magnitude than that of the best clocks. This review starts with a simplified account of historical developments and the limitations of critical techniques in optical atomic clocks. After an introduction of the basic mechanism underlying active optical clocks, we discuss the most recent experimental results for several configurations and experimental set-ups of active optical clocks. These include those based on a 2-level atomic beam and 3-level laser-cooled trapped-atom system, those based on a 4-level atom scheme, and the Faraday active optical clock. Moreover, following the successful lasing and preliminary results on a Faraday active optical frequency standard with Faraday atomic filter using thermal Cs cell, we describe an experimental scheme of a Faraday active optical clock with a Faraday atomic filter using magic-lattice-trapped Sr atoms at the 689-nm transition, and Faraday optical clocks operating in the good-cavity regime. We conclude with a comprehensive comparison of the different active optical clocks, prospects for active Faraday optical clocks, and potential applications of active optical clocks.
A microwave atomic clock scheme based on Rb and Cs atoms trapped in optical lattice with magic wavelength for clock transition is proposed. The ac Stark shift of clock transition due to trapping laser can be canceled at some specific laser wavelengths. Comparing with in fountain clock, the cavity related shifts, the collision shift, and the Doppler effect are eliminated or suppressed dramatically in atomic clock when the magic optical lattice is exploited. By carefully analyzing various sources of clock uncertainty, we conclude that a microwave atomic clock with an accuracy of better than 2×10−172\times10^{-17}2×10−17 is feasible, which is of the same accuracy as the expected best optical atomic clock.
An ideal superradiant laser on an optical clock transition of noninteracting cold atoms is predicted to exhibit an extreme frequency stability and accuracy far below mHz-linewidth. In any concrete setup sufficiently many atoms have to be confined and pumped within a finite cavity mode volume. Using a magic wavelength lattice minimizes light shifts and allows for almost uniform coupling to the cavity mode. Nevertheless, the atoms are subject to dipole-dipole interaction and collective spontaneous decay which compromises the ultimate frequency stability. In the high density limit the Dicke superradiant linewidth enhancement will broaden the laser line and nearest neighbor couplings will induce shifts and fluctuations of the laser frequency. We estimate the magnitude and scaling of these effects by direct numerical simulations of few atom systems for different geometries and densities. For Strontium in a regularly filled magic wavelength configuration atomic interactions induce small laser frequency shifts only and collective spontaneous emission weakly broadens the laser. These interactions generally enhance the laser sensitivity to cavity length fluctuations but for optimally chosen operating conditions can lead to an improved synchronization of the atomic dipoles.
Atomic clocks can be broadly classified into passive and active types according to their mode of operation. In the microwave domain, active hydrogen masers provide excellent short-term stability and are widely used as flywheel oscillators in timekeeping systems along with the cesium fountain standards. In the optical domain, passive optical clocks have achieved unprecedented accuracy and stability, but at the cost of large and complex infrastructures associated with ultrastable cavities and the preparation of atoms in optical lattices or ion traps. By contrast, active optical clocks generate coherent clock light directly from an atomic transition in the bad-cavity regime, where cavity pulling is strongly suppressed, thereby reducing sensitivity to cavity fluctuations and potentially simplifying optical clock architectures. Over the past decade, active optical clocks have developed from a conceptual proposal into a rapidly advancing field that includes pulsed superradiant systems based on cold atoms and continuous-wave bad-cavity systems based on thermal atomic vapors. This review summarizes recent progress in active optical clocks and discusses future directions of the field.
Superradiant active clocks operating on narrow linewidth clock transitions are predicted to achieve precision orders of magnitude higher than any currently existing optical atomic clocks. We introduce a theory of superradiant lasing and implement it for the example of 40Ca atoms. The presented model, however, is valid for any two- or three-level system in an optical lattice. We perform a feasibility analysis and suggest a set of parameters for the experimental fulfillment of superradiant lasing in Ca. Moreover, we present an overview of different magic wavelengths for the 4s2 1S0 ↔ 4s4p 3P1 (m J = 0) transition in Ca for different polarizations and a robustness analysis of these magic conditions. We also report the magic-zero wavelengths for the 4s4p 3P1, m J = 0 state.