Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:2003.04625 · Physical Review Applied

Superconducting Detector That Counts Microwave Photons Up to Two

Andrii M. Sokolov, Frank K. Wilhelm

Published Dec 22, 2020• 10 citations
arXivHTMLPDF

Abstract

We propose a detector of microwave photons that can distinguish the vacuum state, one-photon state, and the states with two or more photons. Its operation is based on the two-photon transition in a biased Josephson junction and detection occurs when it switches from a superconducting to a normal state. We model the detector theoretically. The detector performs with more than 90% success probability in several microseconds. The working frequency can be set at the design stage in the range from about 1 to 20 GHz.

DOI
10.1103/physrevapplied.14.064063

Related papers

Stepping Closer to Pulsed Single Microwave Photon Detectors for Axions Search

Alessandro D’Elia, A. Rettaroli, S. Tocci +23 more

Axions detection requires the ultimate sensitivity down to the single-photon limit. In the microwave region, this corresponds to energies in the yJ range. This extreme sensitivity has to be combined with an extremely low dark-count rate since the probability of axions conversion into microwave photons is supposed to be very low. To face this complicated task, we followed two promising approaches that both rely on the use of superconducting devices based on the Josephson effect. The first one is to use a single Josephson junction (JJ) as a switching detector (i.e., exploiting the superconducting to normal state transition in the presence of microwave photons). We designed a device composed of a coplanar waveguide terminated on a current-biased JJ. We tested its efficiency to pulsed (pulse duration 10 ns) microwave signals since this configuration is closer to an actual axions search experiment. We show how our device is able to reach detection capability of the order of ten photons with the frequency of 8 GHz. The second approach is based on an intrinsically quantum device formed by two resonators coupled only via a superconducting qubit network. This approach relies on quantum nondemolition measurements of the resonator photons. We show that by injecting radiofrequency power into the resonator, the frequency position of the resonant drop in the transmission coefficient (S21) can be modulated up to 4 MHz. We anticipate that, once optimized, both the devices have the potential to reach single-photon sensitivity.

arXiv:2302.07556•IEEE Transactions on Applied Superconductivity•Nov 4, 2022•16 citations

Approaching microwave photon sensitivity with Al Josephson junctions

A. L. Pankratov, Anna V. Gordeeva, L. S. Revin +3 more

Here, we experimentally test the applicability of an aluminium Josephson junction of a few micrometers size as a single photon counter in the microwave frequency range. We have measured the switching from the superconducting to the resistive state through the absorption of 10 GHz photons. The dependence of the switching probability on the signal power suggests that the switching is initiated by the simultaneous absorption of three and more photons, with a dark count time above 0.01 s.

Beilstein Journal of Nanotechnology•Jul 4, 2022•21 citations

Microwave Photon Counter Based on Josephson Junctions

Yung‐Fu Chen, David J. Hover, S. Sendelbach +5 more

We describe a microwave photon counter based on the current-biased Josephson junction. The junction is tuned to absorb single microwave photons from the incident field, after which it tunnels into a classically observable voltage state. Using two such detectors, we have performed a microwave version of the Hanbury Brown-Twiss experiment at 4 GHz and demonstrated a clear signature of photon bunching for a thermal source. The design is readily scalable to tens of parallelized junctions, a configuration that would allow number-resolved counting of microwave photons.

arXiv:1011.4329•Physical Review Letters•Nov 14, 2011•245 citations

A microwave photon detector

E. V. Il’ichev

The possibility of the implementation of a single-photon detector in the microwave range has been discussed. It has been shown that, for these purposes, it is possible to use an unshunted Josephson junction, which is switched from the superconducting state into a finite-voltage state at the presence of an external signal. The sensitivity of this detector is determined by the distribution of switchings in the absence of an external signal. It has been demonstrated that there is a Josephson junction with a noise temperature below 60 mK at a nominal external temperature of 10 mK. A specific detector intended for the measurement of external microwave signals has been proposed, designed, and fabricated. The first experimental results have been presented.

Physics of the Solid State•Nov 1, 2016•3 citations

Nonlocal Superconducting Single-Photon Detector

Federico Paolucci

We present and theoretically analyze the performance of a nonlocal superconducting single-photon detector. The device operates due to the energy-to-phase conversion mechanism, where the energy of the absorbed single photon is transformed in a variation of the superconducting phase. Within this scope, the detector is designed in the form of a double-loop superconductor--normal-metal--superconductor ($S$-$N$-$S$) Josephson interferometer, where the detection occurs in a long $S$-$N$-$S$ junction and the readout is operated by a short $S$-$N$-$S$ junction. The variation of the superconducting phase across the readout junction is measured by recording the quasiparticle current flowing through a tunnel-coupled superconducting probe. By exploiting realistic geometry and materials, the detector is able to reveal single photons of frequency down to 10 GHz when operated at 10 mK. Furthermore, the device provides a value of the signal-to-noise ratio of up ${10}^{4}$ in the range from 10 GHz to 10 THz by selection of the magnetic flux and the bias voltage. This device will hopefully find direct application as a single-photon detector in both basic science and quantum technology, while the energy-to-phase conversion mechanism could be the basis of nonlocal readout and memory architectures for superconducting qubits.

arXiv:2303.13928•Physical Review Applied•Jul 5, 2023•5 citations

Stroboscopic detection of itinerant microwave photons

Hanna Zeller, Lukas Danner, Max Hofheinz +3 more

We present a novel scheme to detect itinerant microwave radiation at the single photon level. Using existing Josephson-photonics devices, where two microwave cavities are coupled by a dc-voltage biased superconducting junction, we theoretically show how to implement a stroboscopically repeated, near-projective measurement of a photon impinging on one of the cavities. Optimizing rate, duration, and strength of the measurement by flux control of the junction and developing a threshold protocol to detect the photon from a homodyne measurement of the radiation output of the other cavity, we achieve highly efficient detection with low dark counts. By cascading the detector with a preamplifier, where a similar two-cavity Josephson-photonics device acts as a photon multiplier, we can further improve the device to reach a detection efficiency of $88.5 \%$ with a dark count rate of $\sim10^{-4} γ_a$, set by the resonance width $γ_a$ of the absorbing cavity. These results for a multiplication factor of two suggest that near-unity efficiencies may be reached for higher multiplication factors.

quant-pharXiv:2603.16522•Physical Review Research•Mar 18, 2026•0 citations
We propose a detector of microwave photons that can distinguish the vacuum state, one-photon state, and the states with two or more photons. Its operation is based on the two-photon transition in a biased Josephson junction and detection occurs when it switches from a superconducting to a normal state. We model the detector theoretically. The detector performs with more than 90% success probability in several microseconds. The working frequency can be set at the design stage in the range from about 1 to 20 GHz.
Axions detection requires the ultimate sensitivity down to the single-photon limit. In the microwave region, this corresponds to energies in the yJ range. This extreme sensitivity has to be combined with an extremely low dark-count rate since the probability of axions conversion into microwave photons is supposed to be very low. To face this complicated task, we followed two promising approaches that both rely on the use of superconducting devices based on the Josephson effect. The first one is to use a single Josephson junction (JJ) as a switching detector (i.e., exploiting the superconducting to normal state transition in the presence of microwave photons). We designed a device composed of a coplanar waveguide terminated on a current-biased JJ. We tested its efficiency to pulsed (pulse duration 10 ns) microwave signals since this configuration is closer to an actual axions search experiment. We show how our device is able to reach detection capability of the order of ten photons with the frequency of 8 GHz. The second approach is based on an intrinsically quantum device formed by two resonators coupled only via a superconducting qubit network. This approach relies on quantum nondemolition measurements of the resonator photons. We show that by injecting radiofrequency power into the resonator, the frequency position of the resonant drop in the transmission coefficient (S21) can be modulated up to 4 MHz. We anticipate that, once optimized, both the devices have the potential to reach single-photon sensitivity.
We describe a microwave photon counter based on the current-biased Josephson junction. The junction is tuned to absorb single microwave photons from the incident field, after which it tunnels into a classically observable voltage state. Using two such detectors, we have performed a microwave version of the Hanbury Brown-Twiss experiment at 4 GHz and demonstrated a clear signature of photon bunching for a thermal source. The design is readily scalable to tens of parallelized junctions, a configuration that would allow number-resolved counting of microwave photons.
The possibility of the implementation of a single-photon detector in the microwave range has been discussed. It has been shown that, for these purposes, it is possible to use an unshunted Josephson junction, which is switched from the superconducting state into a finite-voltage state at the presence of an external signal. The sensitivity of this detector is determined by the distribution of switchings in the absence of an external signal. It has been demonstrated that there is a Josephson junction with a noise temperature below 60 mK at a nominal external temperature of 10 mK. A specific detector intended for the measurement of external microwave signals has been proposed, designed, and fabricated. The first experimental results have been presented.
We present and theoretically analyze the performance of a nonlocal superconducting single-photon detector. The device operates due to the energy-to-phase conversion mechanism, where the energy of the absorbed single photon is transformed in a variation of the superconducting phase. Within this scope, the detector is designed in the form of a double-loop superconductor--normal-metal--superconductor (SSS-NNN-SSS) Josephson interferometer, where the detection occurs in a long SSS-NNN-SSS junction and the readout is operated by a short SSS-NNN-SSS junction. The variation of the superconducting phase across the readout junction is measured by recording the quasiparticle current flowing through a tunnel-coupled superconducting probe. By exploiting realistic geometry and materials, the detector is able to reveal single photons of frequency down to 10 GHz when operated at 10 mK. Furthermore, the device provides a value of the signal-to-noise ratio of up 104{10}^{4}104 in the range from 10 GHz to 10 THz by selection of the magnetic flux and the bias voltage. This device will hopefully find direct application as a single-photon detector in both basic science and quantum technology, while the energy-to-phase conversion mechanism could be the basis of nonlocal readout and memory architectures for superconducting qubits.
We present a novel scheme to detect itinerant microwave radiation at the single photon level. Using existing Josephson-photonics devices, where two microwave cavities are coupled by a dc-voltage biased superconducting junction, we theoretically show how to implement a stroboscopically repeated, near-projective measurement of a photon impinging on one of the cavities. Optimizing rate, duration, and strength of the measurement by flux control of the junction and developing a threshold protocol to detect the photon from a homodyne measurement of the radiation output of the other cavity, we achieve highly efficient detection with low dark counts. By cascading the detector with a preamplifier, where a similar two-cavity Josephson-photonics device acts as a photon multiplier, we can further improve the device to reach a detection efficiency of 88.5%88.5 \%88.5% with a dark count rate of ∼10−4γa\sim10^{-4} γ_a∼10−4γa​, set by the resonance width γaγ_aγa​ of the absorbing cavity. These results for a multiplication factor of two suggest that near-unity efficiencies may be reached for higher multiplication factors.