We present a theoretical and experimental investigation of the emission characteristics and the flux of photon pairs generated by spontaneous parametric downconversion in quasi-phase matched bulk crystals for the use in quantum communication sources. We show that, by careful design, one can attain well defined modes close to the fundamental mode of optical fibers and obtain high coupling efficiencies also for bulk crystals, these being more easily aligned than crystal waveguides. We distinguish between singles coupling, ${\ensuremath{\gamma}}_{\mathrm{s}}$ and ${\ensuremath{\gamma}}_{\mathrm{i}}$, conditional coincidence, ${\ensuremath{\mu}}_{\mathrm{i}\ensuremath{\mid}\mathrm{s}}$, and pair coupling, ${\ensuremath{\gamma}}_{\mathrm{c}}$, and show how each of these parameters can be maximized by varying the focusing of the pump mode and the fiber-matched modes using standard optical elements. Specifically we analyze a periodically poled KTP-crystal pumped by a
532nm laser creating photon pairs at
810nm and
1550nm. Numerical calculations lead to coupling efficiencies above 93% at optimal focusing, which is found by the geometrical relation
L∕zR to be $\ensuremath{\approx}1$ to 2 for the pump mode and $\ensuremath{\approx}2$ to 3 for the fiber-modes, where
L is the crystal length and
zR is the Rayleigh-range of the mode-profile. These results are independent on
L. By showing that the single-mode bandwidth decreases $\ensuremath{\propto}1∕L$, we can therefore design the source to produce and couple narrow bandwidth photon pairs well into the fibers. Smaller bandwidth means both less chromatic dispersion for long propagation distances in fibers, and that telecom Bragg gratings can be utilized to compensate for broadened photon packets---a vital problem for time-multiplexed qubits. Longer crystals also yield an increase in fiber photon flux $\ensuremath{\propto}\sqrt{L}$, and so, assuming correct focusing, we can only see advantages using long crystals.
Photon-based quantum information schemes have increased the need for light sources that produce individual photons, with many such schemes relying on optical parametric down-conversion (PDC). Practical realizations of this technology require that the PDC light be collected into a single spatial mode defined by an optical fibre. We present two possible models to describe single-mode fibres coupling with PDC light fields in a non-collinear configuration, that lead to two different results. These approaches include factors such as crystal length and walk-off, non-collinear phase-matching and transverse pump field distribution. We propose an experimental test to distinguish between the two. The goal is to help clarify open issues, such as how to extend the theory beyond the simplest experimental arrangements and, more importantly, to suggest ways to improve the collection efficiency.
The efforts of this research have been directed towards improving both the heralding efficiency and heralding rates of a high performance fiber-coupled single photon source based on an ultrafast pulsed beam-like Type-II parametric down conversion (PDC) source. Entangled photons generated from PDC are inherently broadband (many frequencies) and exit the nonlinear crystal at varying angles (different directions). This makes coupling the photons into single-mode fibers, a desirable feature for quantum computing, difficult. In response to these difficulties we have explored applying multi-layered thin film broadband anti-reflection coatings onto the ends of single-mode fibers using the technique of RF Planar Magnetron Sputtering in an effort to increase the coupling efficiency of the beam-like down converted photons. In addition, we have explored theoretically the broadband nature of novel phase matching geometries to increase heralding rates and minimize photon losses. With the ability to tailor coupling fibers to various down conversion sources we hope to increase both the heralding efficiency and heralding rate to levels needed for a broad range of future experiments.
Spatially entangled photon pairs (biphotons) generated by spontaneous parametric down-conversion offer unique opportunities for quantum imaging, but image-plane biphoton correlations are difficult to observe with camera-based detectors. Previous camera-based biphoton imaging experiments have relied on photon-counting detection, which necessitates operation deep in the photon-sparse regime and requires extremely low dark rates.
Here, we demonstrate the detection of spatial biphoton joint probability distributions in both the image plane and the pupil plane (also termed "near-field plane" and "far-field plane" respectively) using a conventional scientific CMOS camera operated in linear mode. We work at mesoscopic intensity levels, corresponding to a photon flux approximately four orders of magnitude higher than typical photon-counting approaches. From the measured image- and pupil plane correlations, we observe position and momentum correlations consistent with an EPR-type entanglement witness.
A tailored correlation analysis suited for image plane imaging suppresses detector artifacts and intensity fluctuations, enabling acquisition with significantly fewer frames. Our results demonstrate that spatially entangled-light imaging can be performed efficiently with standard imaging hardware, extending quantum imaging techniques beyond the photon-counting regime.
Entangled photon pairs play a crucial role in emerging quantum technologies, acting as tamper-proof padlocks in secure quantum communication, ultra-precise probes in quantum metrology and high-fidelity information carriers in photonic quantum computing. Amongst the many technological possibilities for generating photon pairs, sources based on spontaneous parametric down-conversion (SPDC) in second-order nonlinear crystals are still the workhorse tool in quantum optics laboratories, and more recently even in long-distance quantum communication with satellites. SPDC is a widely used method to create entangled photon pairs. The number of photon pairs that can be detected in a particular choice of collection modes, typically being optical single-mode fibers, depends critically on the spatial characteristics of the multi-mode SPDC emission as well as the particular beam waist of the collection modes. While several studies have already addressed the issue of optimal fiber coupling of SPDC photons in theory and experiment, the results of these studies arrive at different conclusions. Here, we present the results of a comprehensive experimental study on the optimal collection of photon pairs into single-mode optical fibers. Our approach is based on quasi-phase-matched type II SPDC from a periodically poled KTiOPO4 (ppKTP) crystal. We discuss the influence of pump and collection focal parameters on the spectral brightness and heralding efficiency, as well as practical issues of alignment tolerances into an optical single mode fiber. Further, Using two-photon interference (Hong-Ou-Mandel interference), we assess the spectral bandwidth of the photon pairs for variable crystal lengths. The results are in good agreement with our theoretical model, thus providing the recipe of building ultra bright and stable entangled photon sources.
In the process of spontaneous parametric down-conversion, photons from a pump field are converted to signal and idler photon pairs in a nonlinear crystal. The reversed process, or up-conversion of these pairs back to single photons in a second crystal, is also possible. Here, we present experimental measurements of the up-conversion rate with a controlled time delay introduced between the signal and idler photons. As a function of delay, this rate presents a full width at half maximum of 27.9 fs under our experimental conditions, and we further demonstrate that group delay dispersion of the photon pairs broadens this width. These observations are in close agreement with our calculations, thus demonstrating an ultrafast, nonclassical correlation between the signal and idler waves.