arXiv:1811.06036 · Physical Review Applied

Realization of Directional Amplification in a Microwave Optomechanical Device

Laure Mercier de Lépinay, Erno Damskägg, Caspar F. Ockeloen-Korppi, Mika A. Sillanpää

Published Mar 12, 2019• 80 citations

Abstract

Directional amplification is essential in superconducting quantum information experiments, to measure small signals without disturbing potentially fragile sources. While several classes of amplifiers provide directionality and good noise figures, they generally have low levels of saturation. Optomechanical amplifiers would not suffer from this limitation. This work demonstrates a microwave directional amplifier, based on the directional interference effect between two optomechanical amplifiers. The study reveals this amplifier's robustness to typical nonidealities, and allows the formulation of guidelines for designing multimode optomechanical devices for applied or fundamental physics.

DOI: 10.1103/physrevapplied.11.034027

Related papers

Directional amplifier in an optomechanical system with optical gain

Cheng Jiang, Lijia Song, Yong Li

Directional amplifiers are crucial nonreciprocal devices in both classical and quantum information processing. Here we propose a scheme for realizing a directional amplifier between optical and microwave fields based on an optomechanical system with optical gain, where an active optical cavity and two passive microwave cavities are coupled to a common mechanical resonator via radiation pressure. The two passive cavities are coupled via hopping interaction to facilitate the directional amplification between the active and passive cavities. We obtain the condition of achieving optical directional amplification and find that the direction of amplification can be controlled by the phase differences between the effective optomechanical couplings. The effects of the gain rate of the active cavity and the effective coupling strengths on the maximum gain of the amplifier are discussed. We show that the noise added to this amplifier can be greatly suppressed in the large cooperativity limit.

arXiv:1805.08098Physical Review AMay 11, 201870 citations

Low-Noise Amplification and Frequency Conversion with a Multiport Microwave Optomechanical Device

Caspar F. Ockeloen-Korppi, Erno Damskägg, J.-M. Pirkkalainen +3 more

High-gain amplifiers of electromagnetic signals operating near the quantum limit are crucial for quantum information systems and ultrasensitive quantum measurements.However, the existing techniques have a limited gain-bandwidth product and only operate with weak input signals.Here, we demonstrate a two-port optomechanical scheme for amplification and routing of microwave signals, a system that simultaneously performs high-gain amplification and frequency conversion in the quantum regime.Our amplifier, implemented in a two-cavity microwave optomechanical device, shows 41 dB of gain and has a high dynamic range, handling input signals up to 10 13 photons per second, 3 orders of magnitude more than corresponding Josephson parametric amplifiers.We show that although the active medium, the mechanical resonator, is at a high temperature far from the quantum limit, only 4.6 quanta of noise is added to the input signal.Our method can be readily applied to a wide variety of optomechanical systems, including hybrid optical-microwave systems, creating a universal hub for signals at the quantum level.

arXiv:1602.05779Physical Review XOct 28, 201666 citations

Josephson Directional Amplifier for Quantum Measurement of Superconducting Circuits

Baleegh Abdo, Katrina Sliwa, Shyam Shankar +4 more

We realize a microwave quantum-limited amplifier that is directional and can therefore function without the front circulator needed in many quantum measurements. The amplification takes place in only one direction between the input and output ports. Directionality is achieved by multipump parametric amplification combined with wave interference. We have verified the device noise performances by using it to read out a superconducting qubit and observed quantum jumps. With an improved version of this device, the qubit and preamplifer could be integrated on the same chip.

arXiv:1311.5345Physical Review LettersApr 22, 2014105 citations

Quantum-limited directional amplifier based on a triple-cavity optomechanical system

Cheng Jiang, Baowei Ji, Yuanshun Cui +3 more

We theoretically propose a scheme for realizing a quantum-limited directional amplifier in a triple-cavity optomechanical system, where one microwave cavity and two optical cavities are, respectively, coupled to a common mechanical resonator. Moreover, the two optical cavities are coupled directly to facilitate the directional amplification between microwave and optical photons. We find that directional amplification between the three cavity modes is achieved with two gain process and one conversion process, and the direction of amplification can be modulated by controlling the phase difference between the field-enhanced optomechanical coupling strengths. Furthermore, with increasing the optomechanical cooperativity, both gain and bandwidth of the directional amplifier can be enhanced, and the noise added to the amplifier can be suppressed to approach the standard quantum limit on the phase-preserving linear amplifier.

Optics ExpressJun 1, 201816 citations

Optomechanical Microwave Amplification without Mechanical Amplification

Martijn A. Cohen, Daniel Bothner, Yaroslav M. Blanter +1 more

High-gain and low-noise signal amplification is a valuable tool in various cryogenic microwave experiments. A microwave optomechanical device, in which a vibrating capacitor modulates the frequency of a microwave cavity, is one technique that is able to amplify microwave signals with high gain and large dynamical range. Such optomechanical amplifiers typically rely on strong backaction of microwave photons on the mechanical mode achieved in the sideband-resolved limit of optomechanics. Here, we observe microwave amplification in an optomechanical cavity in the extremely unresolved sideband limit. A large gain is observed for any detuning of the single pump tone within the cavity linewidth, a clear indication that the amplification is not induced by dynamical backaction. By being able to amplify for any detuning of the pump signal, the amplification center frequency can be tuned over the entire range of the broad cavity linewidth. Additionally, by providing microwave amplification without mechanical amplification, we predict that by using this scheme it is possible to achieve near-quantum-limited microwave amplification despite a large thermal occupation of the mechanical mode.

arXiv:1812.05459Physical Review AppliedJan 16, 202010 citations

Multimode microwave circuit optomechanics as a platform to study coupled quantum harmonic oscillators

Nathan Bernier

Harmonic oscillators might be one of the most fundamental entities described by physics. Yet they stay relevant in recent research. The topological properties associated with exceptional points that can occur when two modes interact have generated much interest in recent years. Harmonic oscillators are also at the heart of new quantum technological applications: the long lifetime of high-Q resonators make them advantageous as quantum memories, and they are employed for narrowband processing of quantum signals, as in Josephson parametric amplifiers. The goal of this thesis is to explore different fundamental regimes of two coupled harmonic oscillators using cavity optomechanics as the experimen- tal platform. With consistent progress in attaining ever increasing Q factors, mechanical and electromagnetic resonators realize near-ideal harmonic oscillators. By parametrically modulating the nonlinear optomechanical interaction between them, an effective linear coupling is achieved, which is tunable in strength and in the relative frequencies of the two modes. Thus cavity optomechanics provides a framework with excellent control over system parameters for the study of two coupled harmonic modes. The specific optomechanical implementation employed are superconducting circuits with the vibrating top plate of a capacitor as the mechanical element. Multimode optomechanical circuits are realized, with two microwave modes interacting with one or two mechanical oscillators. The supplementary modes serve either as intermediaries in the relation of the two modes of interest, or as auxiliaries used to control a parameter of the system. Three main experimental results are achieved. First, an auxiliary microwave mode allows the engineering of the effective dissipation rate of a mechanical oscillator. The latter then acts as a reservoir for the main microwave mode with which it interacts. The microwave mode susceptibility can be tuned, resulting in an instability akin to that of a maser and in resonant amplification of incoming microwave signals with an added noise close to the quantum minimum. Second, we study the conditions for a nonreciprocal interaction between two microwave modes, when the information flows in one direction but not in the other. The two modes interact through two mechanical oscillators, leading to frequency conversion between the two cavities. Dissipation in the mechanical modes is essential to the scheme in two ways: it provides a reciprocal phase necessary for the interference and eliminates the unwanted signals. Third, level attraction between a microwave and a mechanical mode is demonstrated, where the eigenfrequencies of the system are drawn closer as the result of interaction, rather distancing themselves as in the more usual case of level repulsion. The phenomenon is theoretically connected to exceptional points, and a general classification of the possible regimes of interaction between two harmonic modes is exposed, including level repulsion and attraction as special cases.

Jan 1, 20195 citations