Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1801.09612 · Review of Scientific Instruments

Note: A 3D-printed alkali metal dispenser

Eric B. Norrgard, D. S. Barker, J. A. Fedchak, N. Klimov, Julia K. Scherschligt, Stephen Eckel

Published May 1, 2018• 17 citations
arXivHTMLPDF

Abstract

We demonstrate and characterize a source of Li atoms made from direct metal laser sintered titanium. The source’s outgassing rate is measured to be 5(2) × 10−7 Pa L s−1 at a temperature T = 330 °C, which optimizes the number of atoms loaded into a magneto-optical trap. The source loads ≈107 7Li atoms in the trap in ≈1 s. The loaded source weighs 700 mg and is suitable for a number of deployable sensors based on cold atoms.

DOI
10.1063/1.5023906

Related papers

A 3D-printed alkali metal dispenser

Eric B. Norrgard, Daniel S. Barker, James A. Fedchak +3 more

We demonstrate and characterize a source of Li atoms made from direct metal laser sintered titanium. The source's outgassing rate is measured to be $5 \,(2)\cdot 10^{-7}$\,$\rm{Pa}~ \rm{L}~ \rm{s}^{-1}$ at a temperature $T=330\,^\circ$C, which optimizes the number of atoms loaded into a magneto-optical trap. The source loads $\approx 10^7$ $^7$Li atoms in the trap in $\approx 1$\,s. The loaded source weighs 700\,mg and is suitable for a number of deployable sensors based on cold atoms.

Review of Scientific Instruments•May 1, 2018•0 citations

Direct loading of Yb atoms into a 3D magneto-optical trap from a dispenser atomic source

Junia Nomura, Tomohiko Momma, Yuki Kojima +4 more

The realization of cold atoms using a compact and low-power-consumption experimental setup is indispensable for cold atom experiments, including optical clocks and quantum simulations. We demonstrate the direct loading of Yb atoms into a 3D magneto-optical trap (MOT) from a dispenser atomic source without using a Zeeman slower. The power consumption of the dispenser was ∼3 W. Spectroscopy of the atomic beam from the dispenser on the 6s2 1S0–6s6p 1P1 Yb transition at 399 nm shows that the flux of the atomic beam reaches 1.4 × 1013 s−1 cm−2. We can load up to 4.1 × 107 atoms into the MOT with slowing and trapping laser powers of 20.3 and 35.0 mW, respectively. The realized cold atom system is reliable and can be adapted for experiments on alkaline earth and other alkaline earth-like atoms.

AIP Advances•Feb 1, 2023•6 citations

Fast loading of a magneto-optical trap from a pulsed thermal source

József Fortágh, Alexander Grossmann, Theodor W. Hänsch +1 more

We report an efficient method to load atoms into a magneto-optical trap. A resistively heated alkali metal dispenser, which is mounted close to the trapping region, serves as a compact, pulsed source for Rb atoms. The atoms are captured by the magneto-optical trap within less than 3 s at a loading rate of more than 107 atoms per second. The lifetime of the trapped atoms exceeds the filling time by about 30 s.

Journal of Applied Physics•Dec 15, 1998•72 citations

Collimated, single-pass atom source from a pulsed alkali metal dispenser for laser-cooling experiments

Kevin L. Moore, Thomas Purdy, Kater W. Murch +3 more

We have developed an improved scheme for loading atoms into a magneto-optical trap (MOT) from a directed rubidium alkali metal dispenser in <10−10Torr ultrahigh vacuum conditions. A current-driven dispenser was surrounded with a cold absorbing “shroud” held at ⩽0°C, pumping rubidium atoms not directed into the MOT. This nearly eliminates background atoms and reduces the detrimental rise in pressure normally associated with these devices. The system can be well-described as a current-controlled, rapidly switched, two-temperature thermal beam, and was used to load a MOT with 3×108atoms.

arXiv:physics/0409011•Review of Scientific Instruments•Jan 7, 2005•22 citations

Simultaneous trapping of sodium and lithium in a magneto-optical trap

Volker Wippel, Christopher Binder, W. Huber +1 more

A two element magneto-optical trap (MOT) in standard configuration for Na and 7Li or 6Li is used to cool and trap Na and one Li isotope simultaneously or separately. The metal background vapor out of which the atoms are trapped comes from dispensers. The two atom clouds can be slightly shifted what makes it easy to overlap them. The number and density of the clouds were determined and the temperature measured roughly. The mutual influence of the clouds was investigated and turned out to be smaller than the noise. Preliminary experiments working towards the production of heteronuclear cold molecules by photoassociation were performed, showing the well known production of Na2 long- range molecules. Additionally, the photoionization cross- section was determined by ionizing cold atoms in the excited state by UV-laser light. The results are in reasonable agreement with data obtained elsewhere using synchrotron radiation.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Apr 9, 2001•0 citations

Simultaneous trapping of sodium and lithium in a magneto-optical trap

Volker Wippel, Christopher Binder, W. Huber +1 more

A two element magneto-optical trap (MOT) in standard configuration for Na and 7Li or 6Li is used to cool and trap Na and one Li isotope simultaneously or separately. The metal background vapor out of which the atoms are trapped comes from dispensers. The two atom clouds can be slightly shifted what makes it easy to overlap them. The number and density of the clouds were determined and the temperature measured roughly. The mutual influence of the clouds was investigated and turned out to be smaller than the noise. Preliminary experiments working towards the production of heteronuclear cold molecules by photoassociation were performed, showing the well known production of Na2 long- range molecules. Additionally, the photoionization cross- section was determined by ionizing cold atoms in the excited state by UV-laser light. The results are in reasonable agreement with data obtained elsewhere using synchrotron radiation.© (2001) COPYRIGHT SPIE--The International Society for Optical Engineering. Downloading of the abstract is permitted for personal use only.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Jan 1, 2001•0 citations
We demonstrate and characterize a source of Li atoms made from direct metal laser sintered titanium. The source’s outgassing rate is measured to be 5(2) × 10−7 Pa L s−1 at a temperature T = 330 °C, which optimizes the number of atoms loaded into a magneto-optical trap. The source loads ≈107 7Li atoms in the trap in ≈1 s. The loaded source weighs 700 mg and is suitable for a number of deployable sensors based on cold atoms.
We demonstrate and characterize a source of Li atoms made from direct metal laser sintered titanium. The source's outgassing rate is measured to be 5 (2)⋅10−75 \,(2)\cdot 10^{-7}5(2)⋅10−7\,Pa L s−1\rm{Pa}~ \rm{L}~ \rm{s}^{-1}Pa L s−1 at a temperature T=330 ∘T=330\,^\circT=330∘C, which optimizes the number of atoms loaded into a magneto-optical trap. The source loads ≈107\approx 10^7≈107 7^77Li atoms in the trap in ≈1\approx 1≈1\,s. The loaded source weighs 700\,mg and is suitable for a number of deployable sensors based on cold atoms.
The realization of cold atoms using a compact and low-power-consumption experimental setup is indispensable for cold atom experiments, including optical clocks and quantum simulations. We demonstrate the direct loading of Yb atoms into a 3D magneto-optical trap (MOT) from a dispenser atomic source without using a Zeeman slower. The power consumption of the dispenser was ∼3 W. Spectroscopy of the atomic beam from the dispenser on the 6s2 1S0–6s6p 1P1 Yb transition at 399 nm shows that the flux of the atomic beam reaches 1.4 × 1013 s−1 cm−2. We can load up to 4.1 × 107 atoms into the MOT with slowing and trapping laser powers of 20.3 and 35.0 mW, respectively. The realized cold atom system is reliable and can be adapted for experiments on alkaline earth and other alkaline earth-like atoms.
We have developed an improved scheme for loading atoms into a magneto-optical trap (MOT) from a directed rubidium alkali metal dispenser in <10−10Torr ultrahigh vacuum conditions. A current-driven dispenser was surrounded with a cold absorbing “shroud” held at ⩽0°C, pumping rubidium atoms not directed into the MOT. This nearly eliminates background atoms and reduces the detrimental rise in pressure normally associated with these devices. The system can be well-described as a current-controlled, rapidly switched, two-temperature thermal beam, and was used to load a MOT with 3×108atoms.
A two element magneto-optical trap (MOT) in standard configuration for Na and 7Li or 6Li is used to cool and trap Na and one Li isotope simultaneously or separately. The metal background vapor out of which the atoms are trapped comes from dispensers. The two atom clouds can be slightly shifted what makes it easy to overlap them. The number and density of the clouds were determined and the temperature measured roughly. The mutual influence of the clouds was investigated and turned out to be smaller than the noise. Preliminary experiments working towards the production of heteronuclear cold molecules by photoassociation were performed, showing the well known production of Na2 long- range molecules. Additionally, the photoionization cross- section was determined by ionizing cold atoms in the excited state by UV-laser light. The results are in reasonable agreement with data obtained elsewhere using synchrotron radiation.
A two element magneto-optical trap (MOT) in standard configuration for Na and 7Li or 6Li is used to cool and trap Na and one Li isotope simultaneously or separately. The metal background vapor out of which the atoms are trapped comes from dispensers. The two atom clouds can be slightly shifted what makes it easy to overlap them. The number and density of the clouds were determined and the temperature measured roughly. The mutual influence of the clouds was investigated and turned out to be smaller than the noise. Preliminary experiments working towards the production of heteronuclear cold molecules by photoassociation were performed, showing the well known production of Na2 long- range molecules. Additionally, the photoionization cross- section was determined by ionizing cold atoms in the excited state by UV-laser light. The results are in reasonable agreement with data obtained elsewhere using synchrotron radiation.© (2001) COPYRIGHT SPIE--The International Society for Optical Engineering. Downloading of the abstract is permitted for personal use only.