Flux-tunable heat sink for quantum electric circuits
Matti Partanen, Kuan Yen Tan, Shumpei Masuda, Joonas Govenius, Russell E. Lake, Máté Jenei, Leif Grönberg, Juha Hassel, Slawomir Simbierowicz, Visa Vesterinen, Jani Tuorila, Tapio Ala-Nissilä, Mikko Möttönen
Abstract Superconducting microwave circuits show great potential for practical quantum technological applications such as quantum information processing. However, fast and on-demand initialization of the quantum degrees of freedom in these devices remains a challenge. Here, we experimentally implement a tunable heat sink that is potentially suitable for the initialization of superconducting qubits. Our device consists of two coupled resonators. The first resonator has a high quality factor and a fixed frequency whereas the second resonator is designed to have a low quality factor and a tunable resonance frequency. We engineer the low quality factor using an on-chip resistor and the frequency tunability using a superconducting quantum interference device. When the two resonators are in resonance, the photons in the high-quality resonator can be efficiently dissipated. We show that the corresponding loaded quality factor can be tuned from above 105 down to a few thousand at 10 GHz in good quantitative agreement with our theoretical model.
Abstract Superconducting microwave circuits show great potential for practical quantum technological applications such as quantum information processing. However, fast and on-demand initialization of the quantum degrees of freedom in these devices remains a challenge. Here, we experimentally implement a tunable heat sink that is potentially suitable for the initialization of superconducting qubits. Our device consists of two coupled resonators. The first resonator has a high quality factor and a fixed frequency whereas the second resonator is designed to have a low quality factor and a tunable resonance frequency. We engineer the low quality factor using an on-chip resistor and the frequency tunability using a superconducting quantum interference device. When the two resonators are in resonance, the photons in the high-quality resonator can be efficiently dissipated. We show that the corresponding loaded quality factor can be tuned from above 105 down to a few thousand at 10 GHz in good quantitative agreement with our theoretical model.
Abstract Here we consider a tunable superconducting cavity that can be used either as a tunable coupler to a qubit inside the cavity or as a tunable low noise, low temperature, RF filter. Our design consists of an array of radio-frequency superconducting quantum interference devices (rf SQUIDs) inside a superconducting cavity. This forms a tunable metamaterial structure which couples to the cavity through its magnetic plasma frequency. By tuning the resonant frequency of the metamaterial through an applied magnetic flux, one can tune the cavity mode profile. This allows us to detune the cavity initially centered at 5.593 GHz by over 200 MHz. The maximum quality factor approaches that of the empty cavity, which is 4.5 × 106. The metamaterial electromagnetic response is controlled via a low-frequency or dc magnetic flux bias, and we present a control line architecture that is capable of applying sufficient magnetic flux bias with minimal parasitic coupling. Together this design allows for an in-situ tunable cavity which enables low-temperature quantum control applications.
This thesis presents circuit quantum electrodynamic (cQED) experiments done with artificial atoms coupled to a high quality factor superconducting microwave resonator. This work discusses the theoretical framework, design, fabrication, implementation and characterization of a multi-qubit system using superconducting persistent current qubits, often referred as flux qubits. \n \nWe developed a new type of cryogenic aid for fast turnaround microwave experiments. The minimum turnaround time to perform microwave experiments in dilution refrigerators is typically a few days, as required by cooling down and warming up the entire refrigerator. The cryogenic microwave payload and wiring needed for each qubit and resonator add a significant heat load to \nthe system which typically only has a few µW s of cooling power at millikelvin temperatures. We present a new experimental approach we developed in which a suitable sample holder is attached to a cold-insertable probe and brought in contact with transmission lines permanently mounted inside the cryostat. The total turnaround time is reduced to 8 hours if the target temperature is 80 mK. This new measurement method increased our ability to successfully identify good devices with fast design-characterization iterations, while allowing months-long measurements at 30 mK. \n \nOur device architecture uses several qubits, each of which is controlled via on-chip fast flux bias lines. Readout of the qubit’s quantum state is performed by homodyne detection of the resonator field at large driving power. We observe long coherence times at the optimal bias point of the flux qubits and present decoherence measurements around this optimal point, where the \nflux qubits couple mostly to magnetic flux noise. Dynamical decoupling techniques employing fast microwave pulses are used to protect the qubit’s coherence and allow calculating the magnetic flux noise power spectral density of the qubit’s environment. Photon-mediated interaction between distant qubits in the resonator allows the implementation of a two-qubit controlled-NOT gate \nusing the selective darkening technique. \n \nThis multi-qubit superconducting design is an interesting platform to study the decoherence properties of flux qubits, the properties of strong interaction of electromagnetic radiation with macroscopic quantum systems. These results demonstrate the potential of cQED as a platform for fundamental investigations of decoherence and quantum dynamics of flux qubits.
In this licentiate thesis design, fabrication, and measurements of tunable superconducting microwave transmission line resonators are described. The resonators are of quarter wavelength type were the tuning is achieved by changing one of the boundary conditions of the resonator through a tunable impedance. As tunable impedance the Josephson inductance in form of SQUIDs is used. The Josephson inductance can then be tuned by applying a magnetic field to the SQUID loop. A tuning range of 750 MHz for a 5 GHz resonator is achieved, and as a figure of merit it can be tuned over 200 line widths. The purpose of the tunable resonators is to use them for dynamic coupling of superconducting quantum bits, this requires that the resonators can be tuned fast on the timescale of the resonator-qubit coupling. To measure tuning speeds faster then the ring up time of the resonators a method that measures the leakage of energy out of a detuned resonator was developed. With this method a frequency shift of the energy stored in the resonator can be measured. A detuning of 330 MHz in less than 10 ns is demonstrated for a 4.5 GHz resonator with a quality factor of 104. Working in the few photon limit indicates that the devices can be used to change the frequency of individual photons, this is however still to be demonstrated. As a part of this work the dressed states of a superconducting charge qubit was also studied.
The emerging quantum technological applications call for fast and accurate initialization of the corresponding devices to low-entropy quantum states. To this end, we theoretically study a recently demonstrated quantum-circuit refrigerator in the case of nonlinear quantum electric circuits such as superconducting qubits. The maximum refrigeration rate of transmon and flux qubits is observed to be roughly an order of magnitude higher than that of usual linear resonators, increasing flexibility in the design. We find that for typical experimental parameters, the refrigerator is suitable for resetting different qubit types to fidelities above 99.99% in a few or a few tens of nanoseconds depending on the scenario. Thus the refrigerator appears to be a promising tool for quantum technology and for detailed studies of open quantum systems.
We introduce a setup which realises a tunable engineered environment for experiments in circuit quantum electrodynamics. We illustrate this concept with the specific example of a quantum bit, qubit, in a high-quality-factor cavity which is capacitively coupled to another cavity including a resistor. The temperature of the resistor, which acts as the dissipative environment, can be controlled in a well defined manner in order to provide a hot or cold environment for the qubit, as desired. Furthermore, introducing superconducting quantum interference devices (SQUIDs) into the cavity containing the resistor, provides control of the coupling strength between this artificial environment and the qubit. We demonstrate that our scheme allows us to couple strongly to the environment enabling rapid initialization of the system, and by subsequent tuning of the magnetic flux of the SQUIDs we may greatly reduce the resistor-qubit coupling, allowing the qubit to evolve unhindered.
Hybrid quantum systems play an essential role in efforts towards the advancements of quantum information technology and quantum sensing by bridging distinct technological platforms. In particular, hybrid systems comprising superconducting microwave circuits are being pursued intensely in light of existing achievements in superconducting qubits and precise quantum control in microwave circuits. Their realization relies on the design of superconducting resonators capable of coupling to an oscillatory mode of a second quantum system, facilitating the probing and manipulation of one via the other. In order to accommodate the coupled system, its particular constraints and requirements must be respected, which may be quite extreme from the perspective of established superconducting circuit design and operation. Overcoming this challenge has proved to be a substantial obstacle for the attainment of strongly coupled hybrid systems, despite spectacular advances in superconducting microwave circuits individually. In this work, we examine two approaches tackling this issue for different hybrid quantum systems, focusing on the optimization and characterization of the superconducting circuits. The first device aims at a superconductor-atom hybrid system through the coupling to Rydberg-Rydberg transitions in ultra-cold Rb-87 atoms trapped near the superconducting chip. Using simulations in conjunction with theoretical considerations, we demonstrate a comprehensive geometry parameter optimization procedure for maximum coupling rate. Presenting an experimental implementation of the resulting circuit, we validate its suitability for use under the intended operation conditions, including the option of tuning the electronic transition frequencies using a dc voltage. Secondly, we investigate a device designed for applications in large magnetic in-plane fields used to mediate coupling to integrated micromechanical oscillators; more specifically it is a flux-tunable SQUID resonator comprising Josephson nano-constrictions as nonlinear inductive components. Performing a thorough characterization of its frequency and Kerr anharmonicity tuning behavior at fields up to several hundred mT, we discover a pronounced asymmetry in its flux response at large fields. We show this asymmetry to be caused by the nano-constrictions turning into Josephson diodes, develop an intuitive macroscopic model for its field-induced emergence and reconstruct the diode current-phase relation from the flux tuning data. Several figures of merit informing the suitability of the SQUID resonators for optomechanical systems as well as other applications are improved by the diode effect, highlighting the potential of Josephson diodes in superconducting microwave circuits. Our results provide a promising stepping stone for the advancement of hybrid systems involving superconducting microwave circuits, putting new and exciting operation and coupling regimes within reach.