Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1707.04725 · Physical Review A

Multiparameter estimation along quantum trajectories with sequential Monte Carlo methods

Jason F. Ralph, Simon R. Maskell, Kurt A. Jacobs

Published Nov 2, 2017• 24 citations
arXivHTMLPDF

Abstract

This paper proposes an efficient method for the simultaneous estimation of the state of a quantum system and the classical parameters that govern its evolution. This hybrid approach benefits from efficient numerical methods for the integration of stochastic master equations for the quantum system, and efficient parameter estimation methods from classical signal processing. The classical techniques use sequential Monte Carlo (SMC) methods, which aim to optimize the selection of points within the parameter space, conditioned by the measurement data obtained. We illustrate these methods using a specific example, an SMC sampler applied to a nonlinear system, the Duffing oscillator, where the evolution of the quantum state of the oscillator and three Hamiltonian parameters are estimated simultaneously.

DOI
10.1103/physreva.96.052306

Related papers

Time-dependent multiparameter estimation for quantum experiments via online-offline sequential Monte-Carlo method

Chattamas Manoworakul, Jason F. Ralph, Nattaphong Wonglakhon +1 more

While typical online estimation methods can estimate the multiparameter dynamics of many systems, they may not be sufficient for a system with highly noisy measurement and rapid detection rate. In this paper, we create a hybrid estimation method by augmenting the sequential Monte Carlo (SMC) sampler, an online estimation method with an offline technique known as the time-batch estimation technique. By continuously monitoring the system, we may divide signals into batches and average them into an averaged trajectory. The system dynamics is then evolved with batch-averaged Kraus maps, for which we derive a highly efficient approximation. To facilitate the adoption of our algorithm, we present a modular derivation of the SMC methods and showcase our algorithm as an explicit example. We then implement our algorithm on the measurement signals obtained from superconducting-qubit experiments under two types of measurement setting: a fluorescence measurement and a dispersive $z$-measurement. The algorithm's hyperparameter values are chosen from independent numerical simulation, while the accuracy of our estimation is validated by a signal reconstruction method. Our results show that, for the fluorescence case, our algorithm can estimate the system's parameters better than the standard calibration method, and, for the dispersive case, our estimation is capable of finding an unexpected jump in parameter values that the standard calibration method could not find.

quant-pharXiv:2607.02987•Jul 6, 2026•0 citations

Classical Tracking for Quantum Trajectories

Jason F. Ralph, Simon R. Maskell, Michael J. Ransom +1 more

Quantum state estimation, based on the numerical integration of stochastic master equations (SMEs), provides estimates for the evolution of quantum systems subject to continuous weak measurements. The approach is similar to classical state estimation methods in that the ‘quantum trajectories’ produced by solving the SME are conditioned on continuous classical measurement signals. In this paper, we explore the use of classical state estimation for a candidate quantum system, one based on an experimentally realisable system: a material object undergoing continuous feedback cooling in an optical trap. In particular, we demonstrate that classical tracking methods based on particle filters can be used to track quantum states, and are particularly useful for higher temperature regimes where quantum state estimation becomes computationally demanding.

arXiv:2202.00276•International Conference on Information Fusion (FUSION)•Nov 1, 2021•2 citations

Parameter estimation from measurements along quantum trajectories

Pierre Six, Philippe Campagne-Ibarcq, Landry Bretheau +2 more

The dynamics of many open quantum systems are described by stochastic master equations. In the discrete-time case, we recall the structure of the derived quantum filter governing the evolution of the density operator conditioned to the measurement outcomes. We then describe the structure of the corresponding particle quantum filters for estimating constant parameter and we prove their stability. In the continuous-time (diffusive) case, we propose a new formulation of these particle quantum filters. The interest of this new formulation is first to prove stability, and also to provide an efficient algorithm preserving, for any discretization step-size, positivity of the quantum states and parameter classical probabilities. This algorithm is tested on experimental data to estimate the detection efficiency for a superconducting qubit whose fluorescence field is measured using a heterodyne detector.

arXiv:1503.06149•IEEE Conference on Decision and Control (CDC)•Dec 1, 2015•26 citations

Monte Carlo sampling from the quantum state space. II

Yi-Lin Seah, Jiangwei Shang, Hui Khoon Ng +2 more

High-quality random samples of quantum states are needed for a variety of tasks in quantum information and quantum computation. Searching the high-dimensional quantum state space for a global maximum of an objective function with many local maxima or evaluating an integral over a region in the quantum state space are but two exemplary applications of many. These tasks can only be performed reliably and efficiently with Monte Carlo methods, which involve good samplings of the parameter space in accordance with the relevant target distribution. We show how the Markov-chain Monte Carlo method known as Hamiltonian Monte Carlo, or hybrid Monte Carlo, can be adapted to this context. It is applicable when an efficient parameterization of the state space is available. The resulting random walk is entirely inside the physical parameter space, and the Hamiltonian dynamics enable us to take big steps, thereby avoiding strong correlations between successive sample points while enjoying a high acceptance rate. We use examples of single and double qubit measurements for illustration.

arXiv:1407.7806•New Journal of Physics•Apr 13, 2015•36 citations

Optimal noisy sequential multiparameter quantum sensing

Andrew Tanggara, Lorcán O Conlon, Alexey V. Gorshkov +1 more

The most general strategy for estimating parameters of a quantum channel is to probe the channel many times sequentially with the help of coherent ancillary systems. However, finding the strategy that minimizes the mean-squared error (MSE) is a notoriously hard problem, requiring optimization over the initial probe state, intermediate evolutions, final measurement, and classical postprocessing. In this work, we study how the minimum attainable MSE can be bounded from below in this setting. We propose a lower bound for the MSE of any physically implementable sequential sensing strategy that applies to estimating parameters of any physical quantum evolution, including quantum channels probed over multiple time steps under temporally correlated noise and general temporally correlated quantum processes. We show that this lower bound can be formulated as a semidefinite program (SDP). Our bound generalizes the Nagaoka-Hayashi lower bound (that applies to parameter estimation tasks with separable measurements) to the regime where the quantum channel can be accessed sequentially multiple times. For regular finite-dimensional single-parameter sequential estimation tasks admitting an optimal strategy, we show that our SDP bound is tight and provide a procedure to obtain a locally optimal strategy from the SDP optimizer. Using our optimization bound, we compute the MSE lower bound and derive new protocols for several other physically motivated problems including error-corrected quantum sensing under an unknown correlated noise model, multiparameter estimation, and estimation with qudit systems.

quant-pharXiv:2609.30398•Sep 28, 2026•0 citations

Feedback stabilization of multi-qubit Hamiltonian parameters enabled by single-shot measurement-based sequential Monte Carlo

Hyeongyu Jang, Jaemin Park, Younguk Song +6 more

Fast measurement, signal processing, and accurate estimation of Hamiltonian parameters are essential for feedback control in quantum-classical interface circuitry. However, existing frequentist and Bayesian inference methods typically require a large number of measurements to achieve the accuracy needed to mitigate qubit decoherence. Consequently, feedback control of semiconductor qubits has largely been limited to single-qubit frequency stabilization, whereas two-qubit parameter stabilization remains experimentally unexplored. Here, we demonstrate a real-time feedback framework based on sequential Monte Carlo estimation using one bit of data from a single-shot measurement. Using a four-qubit semiconductor quantum dot device, we rapidly estimate individual qubit frequencies, yielding an approximately twofold increase in coherence time compared with a conventional Bayesian strategy. Moreover, sequential two-qubit parameter estimation using two bits of data enables stabilization of qubit-qubit coupling, allowing both quasi-static frequency drift and exchange-interaction noise to be estimated and suppressed. By shortening the time required for precise parameter estimation, these results demonstrate the importance of the synergistic development of classical and quantum electronics for building robust and scalable quantum technologies in fluctuating environments.

quant-pharXiv:2607.26480•Jul 30, 2026•0 citations
This paper proposes an efficient method for the simultaneous estimation of the state of a quantum system and the classical parameters that govern its evolution. This hybrid approach benefits from efficient numerical methods for the integration of stochastic master equations for the quantum system, and efficient parameter estimation methods from classical signal processing. The classical techniques use sequential Monte Carlo (SMC) methods, which aim to optimize the selection of points within the parameter space, conditioned by the measurement data obtained. We illustrate these methods using a specific example, an SMC sampler applied to a nonlinear system, the Duffing oscillator, where the evolution of the quantum state of the oscillator and three Hamiltonian parameters are estimated simultaneously.
While typical online estimation methods can estimate the multiparameter dynamics of many systems, they may not be sufficient for a system with highly noisy measurement and rapid detection rate. In this paper, we create a hybrid estimation method by augmenting the sequential Monte Carlo (SMC) sampler, an online estimation method with an offline technique known as the time-batch estimation technique. By continuously monitoring the system, we may divide signals into batches and average them into an averaged trajectory. The system dynamics is then evolved with batch-averaged Kraus maps, for which we derive a highly efficient approximation. To facilitate the adoption of our algorithm, we present a modular derivation of the SMC methods and showcase our algorithm as an explicit example. We then implement our algorithm on the measurement signals obtained from superconducting-qubit experiments under two types of measurement setting: a fluorescence measurement and a dispersive zzz-measurement. The algorithm's hyperparameter values are chosen from independent numerical simulation, while the accuracy of our estimation is validated by a signal reconstruction method. Our results show that, for the fluorescence case, our algorithm can estimate the system's parameters better than the standard calibration method, and, for the dispersive case, our estimation is capable of finding an unexpected jump in parameter values that the standard calibration method could not find.
Quantum state estimation, based on the numerical integration of stochastic master equations (SMEs), provides estimates for the evolution of quantum systems subject to continuous weak measurements. The approach is similar to classical state estimation methods in that the ‘quantum trajectories’ produced by solving the SME are conditioned on continuous classical measurement signals. In this paper, we explore the use of classical state estimation for a candidate quantum system, one based on an experimentally realisable system: a material object undergoing continuous feedback cooling in an optical trap. In particular, we demonstrate that classical tracking methods based on particle filters can be used to track quantum states, and are particularly useful for higher temperature regimes where quantum state estimation becomes computationally demanding.
The dynamics of many open quantum systems are described by stochastic master equations. In the discrete-time case, we recall the structure of the derived quantum filter governing the evolution of the density operator conditioned to the measurement outcomes. We then describe the structure of the corresponding particle quantum filters for estimating constant parameter and we prove their stability. In the continuous-time (diffusive) case, we propose a new formulation of these particle quantum filters. The interest of this new formulation is first to prove stability, and also to provide an efficient algorithm preserving, for any discretization step-size, positivity of the quantum states and parameter classical probabilities. This algorithm is tested on experimental data to estimate the detection efficiency for a superconducting qubit whose fluorescence field is measured using a heterodyne detector.
High-quality random samples of quantum states are needed for a variety of tasks in quantum information and quantum computation. Searching the high-dimensional quantum state space for a global maximum of an objective function with many local maxima or evaluating an integral over a region in the quantum state space are but two exemplary applications of many. These tasks can only be performed reliably and efficiently with Monte Carlo methods, which involve good samplings of the parameter space in accordance with the relevant target distribution. We show how the Markov-chain Monte Carlo method known as Hamiltonian Monte Carlo, or hybrid Monte Carlo, can be adapted to this context. It is applicable when an efficient parameterization of the state space is available. The resulting random walk is entirely inside the physical parameter space, and the Hamiltonian dynamics enable us to take big steps, thereby avoiding strong correlations between successive sample points while enjoying a high acceptance rate. We use examples of single and double qubit measurements for illustration.
The most general strategy for estimating parameters of a quantum channel is to probe the channel many times sequentially with the help of coherent ancillary systems. However, finding the strategy that minimizes the mean-squared error (MSE) is a notoriously hard problem, requiring optimization over the initial probe state, intermediate evolutions, final measurement, and classical postprocessing. In this work, we study how the minimum attainable MSE can be bounded from below in this setting. We propose a lower bound for the MSE of any physically implementable sequential sensing strategy that applies to estimating parameters of any physical quantum evolution, including quantum channels probed over multiple time steps under temporally correlated noise and general temporally correlated quantum processes. We show that this lower bound can be formulated as a semidefinite program (SDP). Our bound generalizes the Nagaoka-Hayashi lower bound (that applies to parameter estimation tasks with separable measurements) to the regime where the quantum channel can be accessed sequentially multiple times. For regular finite-dimensional single-parameter sequential estimation tasks admitting an optimal strategy, we show that our SDP bound is tight and provide a procedure to obtain a locally optimal strategy from the SDP optimizer. Using our optimization bound, we compute the MSE lower bound and derive new protocols for several other physically motivated problems including error-corrected quantum sensing under an unknown correlated noise model, multiparameter estimation, and estimation with qudit systems.
Fast measurement, signal processing, and accurate estimation of Hamiltonian parameters are essential for feedback control in quantum-classical interface circuitry. However, existing frequentist and Bayesian inference methods typically require a large number of measurements to achieve the accuracy needed to mitigate qubit decoherence. Consequently, feedback control of semiconductor qubits has largely been limited to single-qubit frequency stabilization, whereas two-qubit parameter stabilization remains experimentally unexplored. Here, we demonstrate a real-time feedback framework based on sequential Monte Carlo estimation using one bit of data from a single-shot measurement. Using a four-qubit semiconductor quantum dot device, we rapidly estimate individual qubit frequencies, yielding an approximately twofold increase in coherence time compared with a conventional Bayesian strategy. Moreover, sequential two-qubit parameter estimation using two bits of data enables stabilization of qubit-qubit coupling, allowing both quasi-static frequency drift and exchange-interaction noise to be estimated and suppressed. By shortening the time required for precise parameter estimation, these results demonstrate the importance of the synergistic development of classical and quantum electronics for building robust and scalable quantum technologies in fluctuating environments.