Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1705.05345 · Applied Physics Letters

Frequency-multiplexed bias and readout of a 16-pixel superconducting nanowire single-photon detector array

S. Doerner, A. Kuzmin, S. Wünsch, Ilya Charaev, F. Boes, T. Zwick, M. Siegel

Published Jul 17, 2017• 88 citations
arXivHTMLPDF

Abstract

We demonstrate a 16-pixel array of microwave-current driven superconducting nanowire single-photon detectors with an integrated and scalable frequency-division multiplexing architecture, which reduces the required number of bias and readout lines to a single microwave feed line. The electrical behavior of the photon-sensitive nanowires, embedded in a resonant circuit, as well as the optical performance and timing jitter of the single detectors is discussed. Besides the single pixel measurements, we also demonstrate the operation of a 16-pixel array with a temporal, spatial, and photon-number resolution.

DOI
10.1063/1.4993779

Related papers

Demonstration of Microwave Multiplexed Readout of DC-Biased Superconducting Nanowire Detectors

A. K. Sinclair, E. Schroeder, Di Zhu +5 more

Superconducting nanowires are widely used as sensitive single photon detectors with wide spectral coverage and high timing resolution. We describe a demonstration of an array of dc-biased superconducting nanowire single photon detectors read out with a microwave multiplexing circuit. In this design, each individual nanowire is part of a resonant LC circuit where the inductance is dominated by the kinetic inductance of the nanowire. The circuit also contains two parallel plate capacitors, one of them is in parallel with the inductor and the other is coupled to a microwave transmission line that carries the signals to a cryogenic low-noise amplifier. All of the nanowires are connected via resistors to a single dc bias line that enables the nanowires to be current biased close to their critical current. When a photon hits a nanowire, it creates a normal hotspot that produces a voltage pulse across the LC circuit. This pulse rings down at the resonant frequency of the LC circuit over a time period that is fixed by the quality factor. We present measurements of an array of these devices and an evaluation of their performance in terms of frequency and time response.

arXiv:1905.06880•IEEE Transactions on Applied Superconductivity•Mar 8, 2019•26 citations

Operation of Superconducting Nanowire Single-Photon Detectors Embedded in Lumped-Element Resonant Circuits

Steffen Doerner, Artem A. Kuzmin, S. Wünsch +2 more

We propose a new operation principle for superconducting nanowire single-photon detectors (SNSPDs) enabling an efficient frequency-division multiplexing of the bias and readout signals of a large multipixel detector array. The SNSPD is part of a resonant circuit, and the microwave signal inside the device is used to bias the detector close to the critical state. Hence, an n×m pixel SNSPD array requires only two coaxial cables from room temperature to the detector ambient temperature of 4.2 K. We show the microwave characterization and single-photon response of such devices and compare the detector efficiencies with conventional dc-biased SNSPDs. Furthermore, we demonstrate the feasibility of array applications with the new operation mode in a two-pixel proof-of-principle device.

IEEE Transactions on Applied Superconductivity•Feb 5, 2016•19 citations

Demonstration of Microwave Multiplexed Readout of DC-Biased Superconducting Nanowire Detectors

Sinclair, AK, Schroeder, E, Di Zhu +5 more

© 2002-2011 IEEE. Superconducting nanowires are widely used as sensitive single photon detectors with wide spectral coverage and high timing resolution. We describe a demonstration of an array of dc-biased superconducting nanowire single photon detectors read out with a microwave multiplexing circuit. In this design, each individual nanowire is part of a resonant LC circuit where the inductance is dominated by the kinetic inductance of the nanowire. The circuit also contains two parallel plate capacitors, one of them is in parallel with the inductor and the other is coupled to a microwave transmission line that carries the signals to a cryogenic low-noise amplifier. All of the nanowires are connected via resistors to a single dc bias line that enables the nanowires to be current biased close to their critical current. When a photon hits a nanowire, it creates a normal hotspot that produces a voltage pulse across the LC circuit. This pulse rings down at the resonant frequency of the LC circuit over a time period that is fixed by the quality factor. We present measurements of an array of these devices and an evaluation of their performance in terms of frequency and time response.

•Jan 1, 2019•14 citations

Operation of Multipixel Radio-Frequency Superconducting Nanowire Single-Photon Detector Arrays

Steffen Doerner, Artem Kuzmin, S. Wünsch +2 more

The concept of the radio-frequency superconducting nanowire single-photon detector (RF-SNSPD) allows frequency-division multiplexing of the bias and readout lines of several SNSPDs. Using this method, a multi-pixel array can be operated by only one feed line. Consequently, the system complexity as well as the heat load is significantly reduced. To allocate many pixels into a small bandwidth the quality factor of each device is crucial. In this paper, we present an improved RF-SNSPD design. This new design enables a simple tuning of the quality factor as well as the resonant frequency. With a two-pixel device we have demonstrated the operation without crosstalk between the detectors and showed the time, spatial, and photon number resolution. Thereby a single pixel requires only a bandwidth of 14 MHz.

arXiv:1612.02228•IEEE Transactions on Applied Superconductivity•Dec 9, 2016•8 citations

A near-infrared 64-pixel superconducting nanowire single photon detector array with integrated multiplexed readout

Michael S. Allman, Varun Boehm Verma, Martin J. Stevens +9 more

We demonstrate a 64-pixel free-space-coupled array of superconducting nanowire single photon detectors optimized for high detection efficiency in the near-infrared range. An integrated, readily scalable, multiplexed readout scheme is employed to reduce the number of readout lines to 16. The cryogenic, optical, and electronic packaging to read out the array, as well as characterization measurements are discussed.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•May 6, 2015•5 citations

A near-infrared 64-pixel superconducting nanowire single photon detector array with integrated multiplexed readout

Michael S. Allman, Varun Boehm Verma, Martin J. Stevens +9 more

We demonstrate a 64-pixel free-space-coupled array of superconducting nanowire single photon detectors optimized for high detection efficiency in the near-infrared range. An integrated, readily scalable, multiplexed readout scheme is employed to reduce the number of readout lines to 16. The cryogenic, optical, and electronic packaging to read out the array as well as characterization measurements are discussed.

arXiv:1504.02812•Applied Physics Letters•May 11, 2015•140 citations
We demonstrate a 16-pixel array of microwave-current driven superconducting nanowire single-photon detectors with an integrated and scalable frequency-division multiplexing architecture, which reduces the required number of bias and readout lines to a single microwave feed line. The electrical behavior of the photon-sensitive nanowires, embedded in a resonant circuit, as well as the optical performance and timing jitter of the single detectors is discussed. Besides the single pixel measurements, we also demonstrate the operation of a 16-pixel array with a temporal, spatial, and photon-number resolution.
Superconducting nanowires are widely used as sensitive single photon detectors with wide spectral coverage and high timing resolution. We describe a demonstration of an array of dc-biased superconducting nanowire single photon detectors read out with a microwave multiplexing circuit. In this design, each individual nanowire is part of a resonant LC circuit where the inductance is dominated by the kinetic inductance of the nanowire. The circuit also contains two parallel plate capacitors, one of them is in parallel with the inductor and the other is coupled to a microwave transmission line that carries the signals to a cryogenic low-noise amplifier. All of the nanowires are connected via resistors to a single dc bias line that enables the nanowires to be current biased close to their critical current. When a photon hits a nanowire, it creates a normal hotspot that produces a voltage pulse across the LC circuit. This pulse rings down at the resonant frequency of the LC circuit over a time period that is fixed by the quality factor. We present measurements of an array of these devices and an evaluation of their performance in terms of frequency and time response.
We propose a new operation principle for superconducting nanowire single-photon detectors (SNSPDs) enabling an efficient frequency-division multiplexing of the bias and readout signals of a large multipixel detector array. The SNSPD is part of a resonant circuit, and the microwave signal inside the device is used to bias the detector close to the critical state. Hence, an n×m pixel SNSPD array requires only two coaxial cables from room temperature to the detector ambient temperature of 4.2 K. We show the microwave characterization and single-photon response of such devices and compare the detector efficiencies with conventional dc-biased SNSPDs. Furthermore, we demonstrate the feasibility of array applications with the new operation mode in a two-pixel proof-of-principle device.
© 2002-2011 IEEE. Superconducting nanowires are widely used as sensitive single photon detectors with wide spectral coverage and high timing resolution. We describe a demonstration of an array of dc-biased superconducting nanowire single photon detectors read out with a microwave multiplexing circuit. In this design, each individual nanowire is part of a resonant LC circuit where the inductance is dominated by the kinetic inductance of the nanowire. The circuit also contains two parallel plate capacitors, one of them is in parallel with the inductor and the other is coupled to a microwave transmission line that carries the signals to a cryogenic low-noise amplifier. All of the nanowires are connected via resistors to a single dc bias line that enables the nanowires to be current biased close to their critical current. When a photon hits a nanowire, it creates a normal hotspot that produces a voltage pulse across the LC circuit. This pulse rings down at the resonant frequency of the LC circuit over a time period that is fixed by the quality factor. We present measurements of an array of these devices and an evaluation of their performance in terms of frequency and time response.
The concept of the radio-frequency superconducting nanowire single-photon detector (RF-SNSPD) allows frequency-division multiplexing of the bias and readout lines of several SNSPDs. Using this method, a multi-pixel array can be operated by only one feed line. Consequently, the system complexity as well as the heat load is significantly reduced. To allocate many pixels into a small bandwidth the quality factor of each device is crucial. In this paper, we present an improved RF-SNSPD design. This new design enables a simple tuning of the quality factor as well as the resonant frequency. With a two-pixel device we have demonstrated the operation without crosstalk between the detectors and showed the time, spatial, and photon number resolution. Thereby a single pixel requires only a bandwidth of 14 MHz.