Abstract Here, we optimized ultrathin films of granular NbN on SiO 2 and of amorphous α W 5 Si 3 . We showed that hybrid superconducting nanowire single-photon detectors (SNSPDs) made of 2 nm thick α W 5 Si 3 films over 2 nm thick NbN films exhibit advantageous coexistence of timing (<5 ns reset time and 52 ps timing jitter) and efficiency (>96% quantum efficiency) performance. We discuss the governing mechanism of this hybridization via the proximity effect. Our results demonstrate saturated SNSPDs performance at 1550 nm optical wavelength and suggest that such hybridization can significantly expand the range of available superconducting properties, impacting other nano-superconducting technologies. Lastly, this hybridization may be used to tune properties, such as the amorphous character of superconducting films.
Abstract Here, we optimized ultrathin films of granular NbN on SiO 2 and of amorphous α W 5 Si 3 . We showed that hybrid superconducting nanowire single-photon detectors (SNSPDs) made of 2 nm thick α W 5 Si 3 films over 2 nm thick NbN films exhibit advantageous coexistence of timing (<5 ns reset time and 52 ps timing jitter) and efficiency (>96% quantum efficiency) performance. We discuss the governing mechanism of this hybridization via the proximity effect. Our results demonstrate saturated SNSPDs performance at 1550 nm optical wavelength and suggest that such hybridization can significantly expand the range of available superconducting properties, impacting other nano-superconducting technologies. Lastly, this hybridization may be used to tune properties, such as the amorphous character of superconducting films.
Superconducting nanowire single photon detectors (SNSPDs) based on Si substrates have demonstrated excellent performance, such as high efficiency, low dark count rate, short reset time and low timing jitter. But due to the lattice mismatch between NbN and Si substrate, the performance of film is limited. To this end, Nb5N6layer is fabricated as the buffer layer between the NbN film and Si substrate, and that will reduce the mismatch and optimize superconducting properties of NbN films. The 6nm-thick film with a 65 nm-thick buffer layer shows the zero resistance critical temperature (Tc0) of 13.27 K, which is 5 K higher than that without buffer. Based on the NbN film on the buffered substrate, we fabricated SNSPD devices demonstrate critical current (IC) of 65 μA which is 5 ~ 6 times higher to the detectors without buffer. Besides, the experiment results prove that the buffer layer reduces the kinetic inductance, which fasten the recovery of nanowire.
In this Letter, we characterized superconducting nanowire single-photon detectors (SNSPDs) based on amorphous tungsten germanide (W0.8Ge0.2) superconducting films, which exhibit superconducting properties comparable to those of amorphous WSi. The nanowire width ranges from 60 to 90 nm, with a fixed filling factor of 30%. All fabricated devices exhibit saturated intrinsic detection efficiency for infrared photons with wavelengths up to 2 μm, indicating that WGe is a promising candidate for SNSPDs designed for mid- and far-infrared photon detection. The timing jitter of these detectors, measured with a room-temperature amplifier, ranges from 127 to 234.5 ps. Further improvements can be achieved through device geometry optimization or the implementation of cryogenic amplifiers.
Superconducting nanowire single photon detectors stand today as the best technology, due to their near-unity detection efficiency, low dark count rates, and low timing jitter. In this work, we demonstrate the improvement of the superconducting properties of NbN thin films on 8” silicon-on-insulator wafers by using an ultra-thin (10-15 nm) sputtered AlN buffer layer. The higher crystalline quality of NbN, leads to an increase of the superconducting critical temperature up to 10 K for 9-nm-thick NbN films. The material was validated for single photon detection using a fiber-coupled vertical SNSPD with half-cavity architecture. This results opens the way for the development of CMOS compatible waveguide-integrated detectors. The implementation of such guided devices is a keystone for the development of a fully integrated quantum photonics platform able to generate, manipulate and detect a large number of photonic qubits for secure communications and quantum computing applications.
Superconducting nanowire single photon detectors (SNSPD) offer excellent performance for infrared single photon detection, combining high efficiency, low timing jitter, low dark count rates and high photon counting rates. Promising application areas for SNSPDs include quantum key distribution, space-to-ground communications and single photon remote sensing [1]. SNSPDs are typically made with ultrathin niobium nitride (NbN) films with thickness 4 nm and a superconducting transition temperature above 9 K. NbN offers high performance in the near infrared but their sensitivity drops at wavelengths beyond 2 um. There is growing interest in potential photon counting applications in the mid infrared domain (for example remote sensing of greenhouse gases in the atmosphere [2]). One way to overcome the wavelength limit in NbN SNSPDs is to use films with a lower superconducting energy gap [3]. Here we report on the study of SNSPDs fabricated with thin films of titanium nitride (TiN). We compare TiN films deposited by atomic layer deposition (ALD) and by magnetron sputtering. The TiN films range in thickness from 5 to 60 nm, with superconducting transition temperatures from ~1 K to 3.5 K. We have analyzed the films via transmission electron microscopy and variable angle spectroscopic ellipsometry. We characterize TiN SNSPDs performance from near to mid-infrared at wavelengths (1-4 um) with fast optical parametric oscillator (OPO) source. We compare the performance of TiN SNSPDs to devices based on other lower gap materials: MoSi, NbTiN, WSi. [1] Natarajan et al Superconductor Science and Technology 25 063001 (2012) [2] Abshire et al Laser Applications to Chemical, Security and Environmental Analysis, (Optical Society of America, 2008) paper LMA4 [3] Verma et al Applied Physics Letters 105 022602 (2014)
Superconducting nanowire single photon detectors (SNSPDs) promise to combine near-unity quantum efficiency with >100 megacounts per second rates, picosecond timing jitter, and sensitivity ranging from x-ray to mid-infrared wavelengths. However, this promise is not yet fulfilled, as superior performance in all metrics is yet to be combined into one device. The highest single-pixel detection efficiency and the widest bias windows for saturated quantum efficiency have been achieved in SNSPDs based on amorphous materials, while the lowest timing jitter and highest counting rates were demonstrated in devices made from polycrystalline materials. Broadly speaking, the amorphous superconductors that have been used to make SNSPDs have higher resistivities and lower critical temperature (Tc) values than typical polycrystalline materials. Here, we demonstrate a method of preparing niobium nitride (NbN) that has lower-than-typical superconducting transition temperature and higher-than-typical resistivity. As we will show, NbN deposited onto unheated SiO2 has a low Tc and high resistivity but is too rough for fabricating unconstricted nanowires, and Tc is too low to yield SNSPDs that can operate well at liquid helium temperatures. By adding a 50 W RF bias to the substrate holder during sputtering, the Tc of the unheated NbN films was increased by up to 73%, and the roughness was substantially reduced. After optimizing the deposition for nitrogen flow rates, we obtained 5 nm thick NbN films with a Tc of 7.8 K and a resistivity of 253 μΩ cm. We used this bias sputtered room temperature NbN to fabricate SNSPDs. Measurements were performed at 2.5 K using 1550 nm light. Photon count rates appeared to saturate at bias currents approaching the critical current, indicating that the device's quantum efficiency was approaching unity. We measured a single-ended timing jitter of 38 ps. The optical coupling to these devices was not optimized; however, integration with front-side optical structures to improve absorption should be straightforward. This material preparation was further used to fabricate nanocryotrons and a large-area imager device, reported elsewhere. The simplicity of the preparation and promising device performance should enable future high-performance devices.
Superconducting nanowire single-photon detectors (SNSPDs) are the leading technology for low noise, high efficiency infrared single-photon detection. The basic SNSPD consists of a nanowire patterned in an ultrathin superconducting thin film, which is cooled below its critical temperature and biased close to its critical current. The absorption of a single-photon creates a resistive region, triggering a fast output voltage pulse which can be readily amplified and registered. The excellent performance of SNSPDs at near-infrared and telecommunications wavelengths has led to their adoption in important applications such as quantum secure communications, single-photon spectroscopy and single-photon LIDAR. A clear challenge for the SNSPD community is to extend the spectral range of SNSPDs into the mid infrared, and to improve material uniformity to enable the realization of large area arrays for multimode or free space coupling. The aim of this work is to evaluate potential materials for next generation mid-infrared SNSPD arrays. In this work, thin films of polycrystalline NbN and amorphous MoSi have been optimized to test the uniformity of a multipixel array configuration composed of 8 nanowire meander structures covering 10 um x 10 um area, 100 nm width and 50% filling factor. The 8-pixels SNSPD arrays have been patterned on 8 nm thickness NbN grown on high resistivity silicon (HR Si) substrate at room temperature and at 800 °C exhibiting respectively 4.4 K and 7.3 K as mean critical temperature across the pixels. The 8- pixels SNSPD array patterned on 8 nm thickness MoSi cooling the HR Si substrate to -180 °C has exhibited a mean critical temperature of 3.2 K across the pixels. Optical properties have been measured by an attenuated 1550 nm laser diode source delivered by single mode optical fibre at a controlled distance from the chip in order to broadly illuminate the array. The optical properties have been studied only for the 8 nm thickness NbN SNSPD array grown at room temperature has demonstrated uniform optical properties across pixels exhibiting similar saturation of the internal efficiency over a large bias, similar dark count rate and similar timing jitter (about 137 ps) across pixels. In the single photon regime at 1550 nm, pixels 4 and 6 of the 8 nm thickness NbN SNSPD array exhibit 28.4% and 4.7% pixel detection efficiency as measured at the bias current 95% of their respective critical current at 2.2 K.