Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1612.02043 · Scientific Reports

Photon pair generation in hydrogenated amorphous silicon microring resonators

Elizabeth Hemsley, Damien Bonneau, Jason S. Pelc, Raymond G. Beausoleil, Jeremy L. O’Brien, Mark G. Thompson

Published Dec 20, 2016• 16 citations
arXivHTMLPDF

Abstract

Abstract We generate photon pairs in a-Si:H microrings using a CW pump, and find the Kerr coefficient of a-Si:H to be 3.73 ± 0.25 × 10−17m2/W. By measuring the Q factor with coupled power we find that the loss in the a-Si:H micro-rings scales linearly with power, and therefore cannot originate from two photon absorption. Theoretically comparing a-Si:H and c-Si micro-ring pair sources, we show that the high Kerr coefficient of this sample of a-Si:H is best utilized for microrings with Q factors below 103, but that for higher Q factor devices the photon pair rate is greatly suppressed due to the first order loss.

DOI
10.1038/srep38908

Related papers

Photon Pair Generation in an Amorphous Silicon Micro-ring Resonator

Elizabeth Hemsley, Damien Bonneau, Gary F. Sinclair +12 more

The high Kerr coefficient of amorphous silicon makes it a promising material for generating photons on chip via spontaneous four wave mixing (SFWM), for applications in quantum photonics. Previous work shows high photon generation rates in a-Si waveguides, [1], and here we expand this study to investigate micro-ring resonator photon sources, which have a small footprint and can produce photons with high spectral purity, ideal for quantum interference. We compare SFWM generation rates in an a-Si micro-ring resonator to a straight waveguide, in both continuous wave and pulsed pump regimes.

European Quantum Electronics Conference (EQEC)•Jun 21, 2015•0 citations

The impact of nonlinear losses in the silicon micro-ring cavities on CW pumping correlated photon pair generation

Yuan Guo, Wei Zhang, Ning Lv +3 more

In this paper, 1.5 μm correlated photon pairs are generated under continuous wave (CW) pumping in a silicon micro-ring cavity with a Q factor of 8.1 × 10(4). The ratio of coincidences to accidental coincidences (CAR) is up to 200 under a coincidence time bin width of 5 ns. The experiment result of single side photon count shows that the generation rate does not increase as the square of the pump level due to the nonlinear losses in the cavity which reduce the Q factor and impact the field enhancement effect in the cavity under high pump level. Theoretical analysis shows that the photon pair generation rate in the cavity is proportional to the seventh power of the Q factor, which agrees well with the experiment result. It provides a way to analyze the performance of CW pumping correlated photon pair generation in silicon micro-ring cavities under high pump levels.

Optics Express•Jan 30, 2014•35 citations

Photon pair generation from compact silicon microring resonators using microwatt-level pump powers

Marc Savanier, Ranjeet Kumar, Shayan Mookherjea

Microring resonators made from silicon are becoming a popular microscale device format for generating photon pairs at telecommunications wavelengths at room temperature. In compact devices with a footprint less than 5 × 10(-4) mm2, we demonstrate pair generation using only a few microwatts of average pump power. We discuss the role played by important parameters such as the loss, group-velocity dispersion and the ring-waveguide coupling coefficient in finding the optimum operating point for silicon microring pair generation. Silicon photonics can be fabricated using deep ultraviolet lithography wafer-scale fabrication processes, which is scalable and cost-effective. Such small devices and low pump power requirements, and the side-coupled waveguide geometry which uses an integrated waveguide, could be beneficial for future scaled-up architectures where many pair-generation devices are required on the same chip.

arXiv:1511.03359•Optics Express•Feb 9, 2016•74 citations

Development of a High Performance Resonant Photon-Pair Source in Silicon

Jeffrey A. Steidle

One of the key building blocks of quantum photonic systems is a source of indistinguishable photons. Silicon ring resonators can be used as photon pair sources by taking advantage of silicon's large third order nonlinearity with a process known as spontaneous four wave mixing. These sources are capable of producing pairs of indistinguishable photons but typically suffer from an effective 50% loss. By slightly decoupling the input waveguide from the ring, the desired photons generated in the ring can be directed to the drop port. Thus, the ratio between the coincidences from the drop port and the total number of coincidences from all ports (coincidence efficiency) can be significantly increased, with the trade-off being that the pump is less efficiently coupled into the ring. This asymmetric coupling scheme was used to demonstrate a dual-bus microring source with a coincidence efficiency of ~96%. Unfortunately, the penalty to pump power was quite large, with a required ~10x increase in the pump power to maintain the same pair generation rate.\nTo further improve upon this result, a microring source was designed with multipoint evanescent couplers to induce a strong spectral dependence in the coupling coefficients. This coupler design can be used on both sides of the ring resonator so that resonances supported by one of the couplers are suppressed by the other. This is the ideal configuration for a ring-based photon-pair source as it can only support the pump photons at the input side while only allowing the generated photons to leave through the output side. Asymmetric coupling was also used in this configuration but in a different way than in the previous source. In this case, the input side of the ring was configured to be critically coupled for maximal resonance enhancement while the output side was configured to be over coupled to minimize photon-pair loss within the ring. This device design was used to demonstrate a photon-pair source with coincidence efficiencies of 0.9981+-6.425x10^-4 and 0.9979+-1.665x10^-3 for degenerate and non-degenerate pump configuration respectively.\nIn addition to the source development, work was done to move some of the pump rejection filtering onto the photonic chip. While the fabricated device only exhibited an extinction of 50 dB, the root cause of the limited extinction was explored and a new filter design was proposed to overcome these limitations. With the combination of the microring source with its greatly improved efficiency and the movement toward reducing the required off-chip filtering, this work represents a significant advancement in the scalability of integrated quantum photonic systems which can enable high performance quantum computing and communication systems.

•Jan 1, 2019•0 citations

Prospects for photon-pair generation using silicon microring resonators with two photon absorption and free carrier absorption

Chaoxuan Ma, Shayan Mookherjea

Silicon microring resonators are being recently used for high-brightness and efficient photon-pair generation at telecommunication wavelengths. Here, based on detailed theoretical and numerical modeling, we study the impact on pair generation of increasing the optical pump power, which generally causes nonlinear impairments such as free-carrier and two-photon absorption in silicon micro-resonators. Contrary to expectation, the pair generation properties of such devices may seem to be preserved at increasing pump powers, although not better than at a moderate pump power. These results suggest that silicon microrings can be used for pair generation over a wide range of pump powers, which may benefit applications in remotely pumped architectures, where the pump level might not be known a priori.

OSA Continuum•Apr 13, 2020•15 citations

Generation rate scaling: the quality factor optimization of microring resonators for photon-pair sources

Kai Guo, Xiaodong Shi, Xiaolin Wang +4 more

To achieve photon-pair generation scaling, we optimize the quality factor of microring resonators for efficient continuous-wave-pumped spontaneous four-wave mixing. Numerical studies indicate that a high intrinsic quality factor makes high pair rate and pair brightness possible, in which the maximums take place under overcoupling and critical-coupling conditions, respectively. We fabricate six all-pass-type microring resonator samples on a silicon-on-insulator chip involving gap width as the only degree of freedom. The signal count rate, pair brightness, and coincidence rate of all the samples are characterized, which are then compared with the modified simulations by taking the detector saturation and nonlinear loss into account. Being experimentally validated for the first time to the best of our knowledge, this work explicitly demonstrates that reducing the round-trip loss in a ring cavity and designing the corresponding optimized gap width are more effective to generate high-rate or high-brightness photon pairs than the conventional strategy of simply increasing the quality factor. (C) 2018 Chinese Laser Press

Photonics Research•May 22, 2018•33 citations
Abstract We generate photon pairs in a-Si:H microrings using a CW pump, and find the Kerr coefficient of a-Si:H to be 3.73 ± 0.25 × 10−17m2/W. By measuring the Q factor with coupled power we find that the loss in the a-Si:H micro-rings scales linearly with power, and therefore cannot originate from two photon absorption. Theoretically comparing a-Si:H and c-Si micro-ring pair sources, we show that the high Kerr coefficient of this sample of a-Si:H is best utilized for microrings with Q factors below 103, but that for higher Q factor devices the photon pair rate is greatly suppressed due to the first order loss.
The high Kerr coefficient of amorphous silicon makes it a promising material for generating photons on chip via spontaneous four wave mixing (SFWM), for applications in quantum photonics. Previous work shows high photon generation rates in a-Si waveguides, [1], and here we expand this study to investigate micro-ring resonator photon sources, which have a small footprint and can produce photons with high spectral purity, ideal for quantum interference. We compare SFWM generation rates in an a-Si micro-ring resonator to a straight waveguide, in both continuous wave and pulsed pump regimes.
In this paper, 1.5 μm correlated photon pairs are generated under continuous wave (CW) pumping in a silicon micro-ring cavity with a Q factor of 8.1 × 10(4). The ratio of coincidences to accidental coincidences (CAR) is up to 200 under a coincidence time bin width of 5 ns. The experiment result of single side photon count shows that the generation rate does not increase as the square of the pump level due to the nonlinear losses in the cavity which reduce the Q factor and impact the field enhancement effect in the cavity under high pump level. Theoretical analysis shows that the photon pair generation rate in the cavity is proportional to the seventh power of the Q factor, which agrees well with the experiment result. It provides a way to analyze the performance of CW pumping correlated photon pair generation in silicon micro-ring cavities under high pump levels.
Microring resonators made from silicon are becoming a popular microscale device format for generating photon pairs at telecommunications wavelengths at room temperature. In compact devices with a footprint less than 5 × 10(-4) mm2, we demonstrate pair generation using only a few microwatts of average pump power. We discuss the role played by important parameters such as the loss, group-velocity dispersion and the ring-waveguide coupling coefficient in finding the optimum operating point for silicon microring pair generation. Silicon photonics can be fabricated using deep ultraviolet lithography wafer-scale fabrication processes, which is scalable and cost-effective. Such small devices and low pump power requirements, and the side-coupled waveguide geometry which uses an integrated waveguide, could be beneficial for future scaled-up architectures where many pair-generation devices are required on the same chip.
One of the key building blocks of quantum photonic systems is a source of indistinguishable photons. Silicon ring resonators can be used as photon pair sources by taking advantage of silicon's large third order nonlinearity with a process known as spontaneous four wave mixing. These sources are capable of producing pairs of indistinguishable photons but typically suffer from an effective 50% loss. By slightly decoupling the input waveguide from the ring, the desired photons generated in the ring can be directed to the drop port. Thus, the ratio between the coincidences from the drop port and the total number of coincidences from all ports (coincidence efficiency) can be significantly increased, with the trade-off being that the pump is less efficiently coupled into the ring. This asymmetric coupling scheme was used to demonstrate a dual-bus microring source with a coincidence efficiency of ~96%. Unfortunately, the penalty to pump power was quite large, with a required ~10x increase in the pump power to maintain the same pair generation rate.\nTo further improve upon this result, a microring source was designed with multipoint evanescent couplers to induce a strong spectral dependence in the coupling coefficients. This coupler design can be used on both sides of the ring resonator so that resonances supported by one of the couplers are suppressed by the other. This is the ideal configuration for a ring-based photon-pair source as it can only support the pump photons at the input side while only allowing the generated photons to leave through the output side. Asymmetric coupling was also used in this configuration but in a different way than in the previous source. In this case, the input side of the ring was configured to be critically coupled for maximal resonance enhancement while the output side was configured to be over coupled to minimize photon-pair loss within the ring. This device design was used to demonstrate a photon-pair source with coincidence efficiencies of 0.9981+-6.425x10^-4 and 0.9979+-1.665x10^-3 for degenerate and non-degenerate pump configuration respectively.\nIn addition to the source development, work was done to move some of the pump rejection filtering onto the photonic chip. While the fabricated device only exhibited an extinction of 50 dB, the root cause of the limited extinction was explored and a new filter design was proposed to overcome these limitations. With the combination of the microring source with its greatly improved efficiency and the movement toward reducing the required off-chip filtering, this work represents a significant advancement in the scalability of integrated quantum photonic systems which can enable high performance quantum computing and communication systems.
Silicon microring resonators are being recently used for high-brightness and efficient photon-pair generation at telecommunication wavelengths. Here, based on detailed theoretical and numerical modeling, we study the impact on pair generation of increasing the optical pump power, which generally causes nonlinear impairments such as free-carrier and two-photon absorption in silicon micro-resonators. Contrary to expectation, the pair generation properties of such devices may seem to be preserved at increasing pump powers, although not better than at a moderate pump power. These results suggest that silicon microrings can be used for pair generation over a wide range of pump powers, which may benefit applications in remotely pumped architectures, where the pump level might not be known a priori.
To achieve photon-pair generation scaling, we optimize the quality factor of microring resonators for efficient continuous-wave-pumped spontaneous four-wave mixing. Numerical studies indicate that a high intrinsic quality factor makes high pair rate and pair brightness possible, in which the maximums take place under overcoupling and critical-coupling conditions, respectively. We fabricate six all-pass-type microring resonator samples on a silicon-on-insulator chip involving gap width as the only degree of freedom. The signal count rate, pair brightness, and coincidence rate of all the samples are characterized, which are then compared with the modified simulations by taking the detector saturation and nonlinear loss into account. Being experimentally validated for the first time to the best of our knowledge, this work explicitly demonstrates that reducing the round-trip loss in a ring cavity and designing the corresponding optimized gap width are more effective to generate high-rate or high-brightness photon pairs than the conventional strategy of simply increasing the quality factor. (C) 2018 Chinese Laser Press