Traveling wave parametric amplifier with Josephson junctions using minimal resonator phase matching
T. White, J. Mutus, I.-C. Hoi, R. Barends, B. Campbell, Yu Chen, Z. Chen, B. Chiaro, A. Dunsworth, Evan R. Jeffrey, J. Kelly, A. Megrant, Charles Neill, P. J. J. O’Malley, P. Roushan, D. Sank, A. Vainsencher, J. Wenner, Saptarshi Chaudhuri, J. Gao, John M. Martinis
Josephson parametric amplifiers have become a critical tool in superconducting device physics due to their high gain and quantum-limited noise. Traveling wave parametric amplifiers (TWPAs) promise similar noise performance, while allowing for significant increases in both bandwidth and dynamic range. We present a TWPA device based on an LC-ladder transmission line of Josephson junctions and parallel plate capacitors using low-loss amorphous silicon dielectric. Crucially, we have inserted λ/4 resonators at regular intervals along the transmission line in order to maintain the phase matching condition between pump, signal, and idler and increase gain. We achieve an average gain of 12 dB across a 4 GHz span, along with an average saturation power of −92 dBm with noise approaching the quantum limit.
Josephson parametric amplifiers have become a critical tool in superconducting device physics due to their high gain and quantum-limited noise. Traveling wave parametric amplifiers (TWPAs) promise similar noise performance, while allowing for significant increases in both bandwidth and dynamic range. We present a TWPA device based on an LC-ladder transmission line of Josephson junctions and parallel plate capacitors using low-loss amorphous silicon dielectric. Crucially, we have inserted λ/4 resonators at regular intervals along the transmission line in order to maintain the phase matching condition between pump, signal, and idler and increase gain. We achieve an average gain of 12 dB across a 4 GHz span, along with an average saturation power of −92 dBm with noise approaching the quantum limit.
We propose a technique to overcome phase mismatch in Josephson-junction traveling wave parametric amplifiers in order to achieve high gain over a broad bandwidth. Using "resonant phase matching," we design a compact superconducting device consisting of a transmission line with subwavelength resonant inclusions that simultaneously achieves a gain of 20 dB, an instantaneous bandwidth of 3 GHz, and a saturation power of -98 dBm. Such an amplifier is well suited to cryogenic broadband microwave measurements such as the multiplexed readout of quantum coherent circuits based on superconducting, semiconducting, or nanomechanical elements, as well as traditional astronomical detectors.
Superconducting traveling-wave parametric amplifiers (TWPA) have emerged as highly versatile devices, offering broadband amplification with quantum-limited noise performance. They hold significant potential for addressing the readout bottleneck in prototype quantum computers, enabling scalability. Key challenges with this technology include achieving sufficient gain with minimal gain ripple while maintaining low noise performance. Efficient phase matching between a weak signal and a strong pump over the entire length of the TWPA is critical to overcoming these challenges. We present an experimental demonstration of the inverse Kerr phase matching technique in a TWPA, first proposed in Ref. Phys. Rev. Appl. 4, 024014. This method addresses several limitations of conventional dispersion engineering approaches of phase matching in the four-wave mixing parametric process in TWPAs. Most notably the existence of an unusable region of gain near the pump frequency which typically corresponds to the region of most optimal phase matching and maximum gain. The inverse Kerr phase matching approach, allows for greater frequency separation between the region of optimal gain and pump, \textit{in situ} tunability of the pump, minimal gain ripple, and a compact footprint which reduces losses. A TWPA employing the inverse Kerr phase matching technique experimentally demonstrated 20 dB of gain over a 3 GHz instantaneous bandwidth, with a tunable bandwidth of 8 GHz, minimal gain ripple, and near quantum-limited noise performance, with 1.5 photons of added noise.
We develop a concept of traveling-wave Josephson parametric amplifier based on a ladder-type superconducting transmission line containing serial array of one-junctions SQUIDs. The circuit operates in a three-wave mixing mode and exploits both quadratic and cubic (Kerr) nonlinearities in the current-phase relation of the SQUIDs controlled by external magnetic flux. These two types of nonlinearities allow efficient three-wave mixing and perfect phase matching, respectively. The transmission line exhibits a power gain with exponential dependence on its length (number of cells N) in the widest frequency range, 0≲fs,fi≲fp, where fs, fi and fp are the signal, idler and pump frequencies, respectively, obeying relation fs+fi=fp. Estimation of the amplifier characteristics with typical experimental parameters, number of cells N = 700, length of 28 mm and pump frequency of 12.5 GHz yields a flat (-3 dB) gain of about 20 dB in the bandwidth from 3.35 GHz to 9.15 GHz and a saturation power of -90 dBm.
Recent progress in physics has increased the necessity for ultra-low noise amplifiers capable of operating at the quantum limit performance. These amplifiers are essential to enhance astronomical detection, dark-matter search, and qubit readout in quantum computing, among other applications. Superconducting Josephson junction Travelling Wave Parametric Amplifiers (JTWPAs) operated in the microwave range, have demonstrated high gain over several gigahertz (GHz) bandwidth, with quantum-limited noise performance and minimal heat dissipation. These excellent properties make JTWPAs an ideal solution for ultra-low noise amplification. This thesis delves into the design, fabrication and characterisation of JTWPAs operated in the microwave (1-16 GHz) and the W-band (70-115GHz) regimes. A generalised coupled-mode equations (CME) framework describing JTWPAs based on Josephson junctions and DC superconducting quantum interference devices (SQUIDs) is introduced. This framework can be combined with electromagnetic (EM) simulation softwares to model the JTWPAs, facilitating their design. It is therefore used to model two microwave JTWPA designs, using parallel plate capacitors (PPCs) and interdigitated capacitors (IDCs). The fabrication and characterisation of both designs are presented, and possible fabrication and design issues are carefully discussed. Despite these issues, we observed broadband gain in the JTWPA with PPCs, achieving > 20 dB gain at several frequency points, and a measured P1dB = −95.8dBm when operated at 17.3 dB. The RF properties of a 500-junction Josephson array are also presented in this manuscript. The device creates a Fabry-Perot cavity, leading to non-travelling wave parametric effects, such as narrow-band gain. We also observed indications of efficient phase-sensitive amplification. The thesis is concluded with the first — to the best of our knowledge — experimental attempt to extend the operational frequency of a JTWPA to the W-band. The novel design, fabrication techniques and characterisation of the W-band JTWPA are discussed in detail in this manuscript, leading to promising results suggesting that JTWPA could operate at high frequencies.
High gain and large bandwidth of traveling-wave parametric amplifier exploiting the nonlinearity of Josephson Junctions can be achieved by fulfilling the so-called phase-matching condition. This condition is usually addressed by placing resonant structures along the waveguide or by periodic modulations of its parameters, creating gaps in the waveguide’s dispersion. Here, we propose to employ the Josephson junctions, which constitute the centerline of the amplifier, as resonant elements for phase matching. By numerical simulations in JoSIM (and WRspice) software, we show that Josephson plasma oscillations can be utilized to create wave vector mismatch sufficient for phase matching as well as to prevent the conversion of the pump energy to higher harmonics. The proposed traveling wave parametric amplifier design has a gain of 15 dB and a 3 GHz bandwidth, which is comparable to the state-of-the-art TWPAs.
Traveling-wave parametric amplifiers (TWPAs) have become an essential tool for the readout of quantum circuits and the search for dark matter. We report on the implementation of an rf-superconducting quantum interference device (SQUID)-based Josephson TWPA with an average saturation power of −84 dBm while providing an average power gain of 20 dB from 3.5 to 8.5 GHz. This wide bandwidth is enabled by reducing the curvature of the dispersion in the signal band while suppressing detrimental mixing processes. With 2393 rf-SQUIDs, our device has a comparable number of nonlinear elements but achieves ten times higher saturation power than previously reported devices. This shows that using rf-SQUIDs results in a more favorable trade-off between device length and saturation power. Harnessing wideband characterization techniques, we determine the TWPA’s excess noise above the quantum limit to be 0.8 to 1.5 photons. In addition, we validate the signal-to-noise ratio improvement as a practical measure for tuning the TWPA to minimize the total system noise and demonstrate that its optimum does not coincide with the highest gain.