We address potential deviations of radiation field from the bosonic behavior and employ local quantum estimation theory to evaluate the ultimate bounds to precision in the estimation of these deviations using quantum-limited measurements on optical signals. We consider different classes of boson deformations and found that intensity measurement on coherent or thermal states would be suitable for their detection making, at least in principle, tests of boson deformation feasible with current quantum optical technology. On the other hand, we found that the quantum signal-to-noise ratio (QSNR) is vanishing with the deformation itself for all the considered classes of deformations and probe signals, thus making any estimation procedure of photon deformation inherently inefficient. A partial way out is provided by the polynomial dependence of the QSNR on the average number of photons, which suggests that, in principle, it would be possible to detect deformation by intensity measurements on high-energy thermal states.
We address potential deviations of radiation field from the bosonic behavior and employ local quantum estimation theory to evaluate the ultimate bounds to precision in the estimation of these deviations using quantum-limited measurements on optical signals. We consider different classes of boson deformations and found that intensity measurement on coherent or thermal states would be suitable for their detection making, at least in principle, tests of boson deformation feasible with current quantum optical technology. On the other hand, we found that the quantum signal-to-noise ratio (QSNR) is vanishing with the deformation itself for all the considered classes of deformations and probe signals, thus making any estimation procedure of photon deformation inherently inefficient. A partial way out is provided by the polynomial dependence of the QSNR on the average number of photons, which suggests that, in principle, it would be possible to detect deformation by intensity measurements on high-energy thermal states.
Optical techniques are widely used in many areas of science and technology to make accurate measurements and diagnostics, from microscopy, spectroscopy, chemical analysis, to gravitational wave detection and ranging. There are many reasons for this: light allows us to extract information in a remote and non-destructive way, it carries information in a massively parallel way, and perhaps more importantly, optical measurements can reach very high precision and sensitivity levels. It is therefore important to know what is the ultimate limit of sensitivity that can be possibly achieved in the estimation of a physical parameter p that is encoded in a light beam of fixed mean photon number N. This limit is imposed by the unavoidable quantum fluctuations of light and depends on the quantum state of light that conveys the information about p. When the light is in a coherent state, this limit is called ‘standard quantum limit’ and scales as 1/N1/2.
In this thesis we make progress towards applications of quantum estimation theory to new physical systems. We first consider two commonly visited problems in quantum metrology: source optimisation and source localisation. For the first, we focus on estimating the distances, d, between neighbouring light sources along an array, which undergoes stretching deformations. We evaluate how changing the nature of the sources impacts the estimation precision of d by using the quantum Fisher information (QFI) as a figure of merit. By comparing this quantity for arrays of single photon emitters, coherent, thermal, and entangled sources, we find that the classical coherent and thermal states outperform the single photon emitters. This would be favourable since generating classical states is less resource-expensive to create. However, a quantum enhancement is observed when entanglement is employed. In agreement with separate work, the optimal state is that which entangles the eigenstates corresponding to the maximum and minimum difference eigenvalues of the generator. We demonstrate that not all entangled states can reproduce similar precision enhancements. This insight is reminiscent of previous studies, where entanglement was concluded as a necessary but insufficient resource for quantum metrology.
Next, we address the source localisation problem to detect any deformations applied to a grid of sources. Improving this detection depends on our ability to engineer grids that maximise the sensitivity of the QFI matrix. Hence, we derive the generators of local translations of unitary evolutions that describe any general grid deformation, and show that our result is a multi-parameter extension of other results in the literature. We obtain a general result for the quantum Fisher information matrix (QFIM) through these generators for any grid deformation and explore specific spatial maps, including composite stretches, shears, and rotations. Since the QFI matrix depends only on the properties of the probe state and the configuration of the emitters, we explore how we can modify both to enhance our estimation sensitivity to determine the applied grid deformation. Physically motivated, we find the best arrangement of sources that enhances the sensitivity of detection for a set number of sources.
Finally, we consider the optimal estimation of a complex squeezing operation in phase space. The use of squeezed light as a quantum resource is ubiquitous in quantum optics, and a complete characterisation of a complex squeezing operation is pivotal for fundamental reasons. This is a true multi-parameter quantum estimation problem of incompatible observables. Specifically, we find that the symmetric logarithmic derivates (SLDs) for amplitude and directional squeezing do not commute. This prohibits simultaneous optimal estimates of both parameters, even in the asymptotic limit. As a result, we focus on finding separable optimal estimates. The Cramer-Rao bound is determined to provide a theoretical benchmark on the bi-variate estimation precision for general single mode Gaussian probes. Using this and the SLDs, we present a practical experimental implementation that can realise the individual fundamental precision bounds.
Several quantities of interest in quantum information, including entanglement and purity, are nonlinear functions of the density matrix and cannot, even in principle, correspond to proper quantum observables. Any method aimed to determine the value of these quantities should resort to indirect measurements and thus corresponds to a parameter estimation problem whose solution, i.e the determination of the most precise estimator, unavoidably involves an optimization procedure. We review local quantum estimation theory and present explicit formulas for the symmetric logarithmic derivative and the quantum Fisher information of relevant families of quantum states. Estimability of a parameter is defined in terms of the quantum signal-to-noise ratio and the number of measurements needed to achieve a given relative error. The connections between the optmization procedure and the geometry of quantum statistical models are discussed. Our analysis allows to quantify quantum noise in the measurements of non observable quantities and provides a tools for the characterization of signals and devices in quantum technology. 1.
Several quantities of interest in quantum information, including entanglement and purity, are nonlinear functions of the density matrix and cannot, even in principle, correspond to proper quantum observables. Any method aimed to determine the value of these quantities should resort to indirect measurements and thus corresponds to a parameter estimation problem whose solution, i.e the determination of the most precise estimator, unavoidably involves an optimization procedure. We review local quantum estimation theory and present explicit formulas for the symmetric logarithmic derivative and the quantum Fisher information of relevant families of quantum states. Estimability of a parameter is defined in terms of the quantum signal-to-noise ratio and the number of measurements needed to achieve a given relative error. The connections between the optmization procedure and the geometry of quantum statistical models are discussed. Our analysis allows to quantify quantum noise in the measurements of non observable quantities and provides a tools for the characterization of signals and devices in quantum technology.
Squeezed light has lower quantum noise in amplitude or phase than the quantum noise limit (QNL) of classical light. This enables enhancing sensitivity -- quantified by the signal-to-noise ratio (SNR) -- to beyond the QNL in optical techniques such as spectroscopy, gravitational wave detection, magnetometry and imaging. Precision -- the variance of repeated estimates -- has also been enhanced beyond the QNL using squeezed vacuum to estimate optical phase and transmission. However, demonstrations have been limited to femtowatts of probe power. Here we demonstrate simultaneous precision and sensitivity beyond the QNL for estimating modulated transmission using a squeezed amplitude probe of 0.2 mW average (25 W peak) power. This corresponds to 8 orders of magnitude above the power limitations of previous sub-QNL precision measurements. Our theory and experiment show precision enhancement scales with the amount of squeezing and increases with the resolution bandwidth of detection. We conclude that quantum enhanced precision in estimating a modulated transmission increases when observing dynamics at ∼ kHz and above. This opens the way to performing measurements that compete with the optical powers of current classical techniques, but have superior precision and sensitivity beyond the classical limit.
Quantum enhancements of precision in metrology can be compromised by system imperfections. These may be mitigated by appropriate optimization of the input state to render it robust, at the expense of making the state difficult to prepare. In this paper, we identify the major sources of imperfection of an optical sensor: input state preparation inefficiency, sensor losses, and detector inefficiency. The second of these has received much attention; we show that it is the least damaging to surpassing the standard quantum limit in a optical interferometric sensor. Further, we show that photonic states that can be prepared in the laboratory using feasible resources allow a measurement strategy using photon-number-resolving detectors that not only attain the Heisenberg limit for phase estimation in the absence of losses, but also deliver close to the maximum possible precision in realistic scenarios including losses and inefficiencies. In particular, we give bounds for the tradeoff between the three sources of imperfection that will allow true quantum-enhanced optical metrology