Cryogenic buffer-gas beams are a promising method for producing bright sources of cold molecular radicals for cold-collision and chemical-reaction experiments. In order to use these beams in studies of reactions with controlled collision energies or in trapping experiments, one needs a method of controlling the forward velocity of the beam. A Stark decelerator can be an effective tool for controlling the mean speed of molecules produced by supersonic jets, but efficient deceleration of buffer-gas beams presents new challenges due to longer pulse lengths. Traveling-wave decelerators are uniquely suited to meet these challenges because of their ability to confine molecules in three dimensions during deceleration and their versatility afforded by the analog control of the electrodes. We have created ground-state $\mathrm{CH}(X{\phantom{\rule{0.16em}{0ex}}}^{2}\ensuremath{\Pi})$ radicals in a cryogenic buffer-gas cell with the potential to produce a cold molecular beam of ${10}^{11}$ molecules/pulse. We present a general protocol for Stark deceleration of beams with a large position and velocity spread for use with a traveling-wave decelerator. Our method involves confining molecules transversely with a hexapole for an optimized distance before deceleration. This rotates the phase-space distribution of the molecular packet so that the packet is matched to the time-varying phase-space acceptance of the decelerator. We demonstrate with simulations and an analytic one-dimensional model that this method can decelerate a significant fraction of the molecules in successive wells of a traveling-wave decelerator to produce energy-tuned beams for cold and controlled-molecule experiments.
Cryogenic buffer-gas beams are a promising method for producing bright sources of cold molecular radicals for cold-collision and chemical-reaction experiments. In order to use these beams in studies of reactions with controlled collision energies or in trapping experiments, one needs a method of controlling the forward velocity of the beam. A Stark decelerator can be an effective tool for controlling the mean speed of molecules produced by supersonic jets, but efficient deceleration of buffer-gas beams presents new challenges due to longer pulse lengths. Traveling-wave decelerators are uniquely suited to meet these challenges because of their ability to confine molecules in three dimensions during deceleration and their versatility afforded by the analog control of the electrodes. We have created ground-state CH(X2\ensuremathΠ) radicals in a cryogenic buffer-gas cell with the potential to produce a cold molecular beam of 1011 molecules/pulse. We present a general protocol for Stark deceleration of beams with a large position and velocity spread for use with a traveling-wave decelerator. Our method involves confining molecules transversely with a hexapole for an optimized distance before deceleration. This rotates the phase-space distribution of the molecular packet so that the packet is matched to the time-varying phase-space acceptance of the decelerator. We demonstrate with simulations and an analytic one-dimensional model that this method can decelerate a significant fraction of the molecules in successive wells of a traveling-wave decelerator to produce energy-tuned beams for cold and controlled-molecule experiments.
The growing field of cold molecule physics has demonstrated many methods of quantum control for precision measurement and molecular interaction studies. One particular method is Stark deceleration, which uses electric field gradients to produce packets of slow polar molecules. Since Stark deceleration does not increase phase-space density, the efficiency of the deceleration process is critical in determining the final cold molecule density. This dissertation describes three different Stark deceleration techniques. The first type of deceleration is pulsed-pin deceleration. We use this technique to produce slow OH molecules that can be trapped for cold collision studies. A two photon state-selective detection system, which includes a 118 nm photon, is used to determine the density distribution of OH in the trap. We explore the advantages and limitations to creating 118 nm light. The second and third types of Stark deceleration are pulsed-ring and traveling-wave methods of running a ring-geometry decelerator. Ring-geometry decelerators present improved deceleration efficiencies due to the cylindrical symmetry of the electrodes and true three-dimensional confinement. The pulsed-ring mode of the ring decelerator uses commercial high-voltage switches to apply discrete pulses to the ring electrodes. The continuous operation mode of the ring decelerator uses varying sine-wave voltages to create a traveling Stark potential well and has proven to be incredibly challenging due to the analog high voltage requirements of the system. In order to bring ND3 seeded in krypton (∼415 m/s) down to rest in the laboratory, sine wave voltages with amplitudes up to ±10 kV, currents up to 500 mA, and a bandwidth of 30 kHz down to DC are required. We describe a high-voltage amplifier that can be used for traveling-wave deceleration. The traveling-wave Stark deceleration mode is then compared to the pulsed-ring Stark deceleration mode and cases where one mode is superior to another are discussed.
Abstract Stark deceleration is a technique that uses time-varying inhomogeneous electric fields to decelerate polar molecules for various molecular beam and trapping experiments. New ring-geometry Stark decelerators with continuously varying voltages offer a method to produce a more intense source of molecules than in the more typically used crossed-pin geometry Stark decelerators. However, this new technique, traveling-wave Stark deceleration, is more experimentally challenging due to the electronic requirements. A third method, pulsed-ring Stark deceleration, uses ring-geometry electrodes with high-voltage pulses to decelerate molecules. The discrete voltages make it easier to implement, and it is more efficient in certain situations due to an increased longitudinal potential gradient. Here, we present an experimental realization of a ring-geometry Stark decelerator using both continuously varying and discrete voltages. Using the pulsed-ring method, we demonstrate a newly accessible low-velocity regime for moderate peak voltages on ring electrodes. This opens up the opportunity to efficiently decelerate various molecular species using a medium length decelerator. A comparison of experimental and simulated results between traveling-wave and pulsed-ring Stark deceleration is presented along with a simple model for determining when each mode is more efficient.
Producing high densities of molecules is a fundamental challenge for low-temperature, ion-molecule reaction studies. Traveling-wave Stark decelerators promise to deliver high density beams of cold, polar molecules but require non-trivial control of high-voltage potentials. We have overcome this experimental challenge and demonstrate continuous deceleration of ND3 from 385 to 10 m/s, while driving the decelerator electrodes with a 10 kV amplitude sinewave. In addition, we test an alternative slowing scheme, which increases the time delay between decelerated packets of ND3 and non-decelerated molecules, allowing for better energy resolution of subsequent reaction studies. We characterize this source of neutral, polar molecules suitable for energy-resolved reaction studies with trapped ions at cold translational temperatures. We also propose a combined apparatus consisting of the traveling-wave decelerator and a linear ion trap with a time-of-flight mass spectrometer and discuss to what extent it may achieve cold, energy-resolved, ion-neutral reactions.
With the Stark deceleration technique, packets of molecules with a tunable velocity, a narrow velocity spread, and a high state purity can be produced. These tamed molecular beams find applications in high resolution spectroscopy, cold molecule trapping, and controlled scattering experiments. The quality and purity of the packets of molecules emerging from the decelerator critically depend on the specifications of the decelerator, but also on the characteristics of the molecular beam pulse with which the decelerator is loaded. We consider three frequently used molecular beam sources, and discuss their suitability for molecular beam deceleration experiments, in particular with the application in crossed beam scattering in mind. The performance of two valves in particular, the Nijmegen Pulsed Valve and the Jordan Valve, is illustrated by decelerating ND 3 molecules in a 2.6 meter-long Stark decelerator. We describe a protocol to characterize the valve, and to optimally load the pulse of molecules into the decelerator. We characterize the valves regarding opening time duration, optimal valve-to-skimmer distance, mean velocity, velocity spread, state purity, and relative intensity.
We report on the electrostatic trapping of neutral SrF molecules. The molecules are captured from a cryogenic buffer-gas beam source into the moving traps of a 4.5-m-long traveling-wave Stark decelerator. The SrF molecules in X^{2}Σ^{+}(v=0,N=1) state are brought to rest as the velocity of the moving traps is gradually reduced from 190 m/s to zero. The molecules are held for up to 50 ms in multiple electric traps of the decelerator. The trapped packets have a volume (FWHM) of 1 mm^{3} and a velocity spread of 5(1) m/s, which corresponds to a temperature of 60(20) mK. Our result demonstrates a factor 3 increase in the molecular mass that has been Stark decelerated and trapped. Heavy molecules (mass>100 amu) offer a highly increased sensitivity to probe physics beyond the standard model. This work significantly extends the species of neutral molecules of which slow beams can be created for collision studies, precision measurement, and trapping experiments.
Research of cold and ultracold molecules is currently a burgeoning field in experimental and theoretical physics. New experimental techniques, involving an increasingly large set of molecule types under high levels of control, are currently opening up new avenues of research with a vast array of potential applications. From understanding the role of quantum mechanics in molecular scattering and cold chemistry, to testing the fundamental symmetries of nature and realizing quantum computing with dipolar molecular qubits, experiments are accessing regimes not dreamed of even a few years ago. Theoretical interest and computing capabilities are also at an all time high, spurred on by the possibility of creating ultracold dipolar gases as tunable realizations of strongly interacting quantum Hamiltonians, creating exotic phases of matter, and the investigation of controlling molecular interactions with applied electromagnetic fields.\nLess than a decade ago, cold molecule experiments had seemingly reached a technological plateau, being capable of creating moderate densities of 106-107 molecules/cm3 at temperatures of 10-100 mK. With many applications requiring colder temperatures and higher densities, the field was ripe for new advances. Today, via a plethora of methods such as direct molecular laser cooling, electro-optical cooling, magneto- and photo-association, and new molecular beam deceleration techniques, the field is just beginning to have the tools capable of producing truly interesting systems for study.\nThis work will discuss a couple of major steps taken in the direction of achieving scientific goals using cold molecules. The first experimental advancement discussed will be the development of a co-trap environment for studying interactions and collisions between ultracold atoms and Stark decelerated cold polar molecules. In this experiment, rubidium atoms are trapped using magnetic fields, and ammonia atoms are decelerated and trapped using electric fields. The two traps are spatially overlapped in order to investigate inter-species interactions. The co-trap environment provides exceedingly long interaction times, many orders of magnitude longer than typical beam-based interaction studies. As a result, it provides extremely high sensitivity to weak interaction mechanisms. The second experimental advancement discussed will be the development and construction of a new style of Stark decelerator, capable of producing much larger densities of cold molecules. This apparatus has the potential to expand the realm of possible experiments with chemically interesting species, and provide an unprecedented amount of control over molecular beams and traps. The gains haven't come easily though, as a new class of custom high-voltage amplifiers have needed to be developed. This part of the experiment alone took approximately two years of consistent effort to bring to fruition. After many years of development, this experiment is poised to come online, finally fulfilling its potential.