Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1308.4891 · Applied Physics Letters

Compacted tunable split-ring resonators

A. Vidiborskiy, V. P. Koshelets, L. V. Filippenko, S. V. Shitov, Alexey Vladimirovich Ustinov

Published Oct 14, 2013• 6 citations
arXivHTMLPDF

Abstract

We propose tunable superconducting split-ring resonators (SRRs) employing nonlinear Josephson inductance. A fraction of SRR is replaced by Nb-AlOx-Nb Josephson tunnel junctions connected in parallel and forming a superconducting quantum interference device, whose inductance is sensitive to the external dc magnetic field. Due to the lumped nature of the Josephson inductance, the SRR can be made very compact, and its resonance frequency can be tuned by applying magnetic field. We present the model, results of extensive electromagnetic-simulation and experimental data for the SRR weakly coupled to a transmission line within frequency range of 11–13 GHz.

DOI
10.1063/1.4826255

Related papers

Low-loss tunable metamaterials using superconducting thin-film circuits with Josephson junctions

S. Butz, P. Jung, Alexey Vladimirovich Ustinov

We report on experiments with superconducting Josephson metamaterials. In such a material, conventional split ring resonators are replaced by superconducting loops that are interrupted by Josephson junctions, so called rf-SQUIDs. Like the split ring resonators, they can be seen as LCresonators that couple to the magnetic component of the incoming wave. The advantage of superconducting thin-film metamaterials is that due to the tunable intrinsic inductance of the Josephson junction, the resonance frequency of the rf-SQUID can be changed by applying an external dc magnetic field. We present experimental results that show the tunability of the resonance frequency of these devices.

•Jan 1, 2012•0 citations

Tunable superconducting transmissionline resonator for qubit coupling

Martin Sandberg

In this licentiate thesis design, fabrication, and measurements of tunable superconducting microwave transmission line resonators are described. The resonators are of quarter wavelength type were the tuning is achieved by changing one of the boundary conditions of the resonator through a tunable impedance. As tunable impedance the Josephson inductance in form of SQUIDs is used. The Josephson inductance can then be tuned by applying a magnetic field to the SQUID loop. A tuning range of 750 MHz for a 5 GHz resonator is achieved, and as a figure of merit it can be tuned over 200 line widths. The purpose of the tunable resonators is to use them for dynamic coupling of superconducting quantum bits, this requires that the resonators can be tuned fast on the timescale of the resonator-qubit coupling. To measure tuning speeds faster then the ring up time of the resonators a method that measures the leakage of energy out of a detuned resonator was developed. With this method a frequency shift of the energy stored in the resonator can be measured. A detuning of 330 MHz in less than 10 ns is demonstrated for a 4.5 GHz resonator with a quality factor of 10$^4$. Working in the few photon limit indicates that the devices can be used to change the frequency of individual photons, this is however still to be demonstrated. As a part of this work the dressed states of a superconducting charge qubit was also studied.

•Jan 1, 2008•0 citations

Realization and Modeling of Metamaterials Made of rf Superconducting Quantum-Interference Devices

Melissa Trepanier, Daimeng Zhang, Oleg A. Mukhanov +1 more

We have prepared meta-atoms based on radio-frequency superconducting quantum-interference devices (rf SQUIDs) and examined their tunability with dc magnetic field, rf current, and temperature. rf SQUIDs are superconducting split-ring resonators in which the usual capacitance is supplemented with a Josephson junction, which introduces strong nonlinearity in the rf properties. We find excellent agreement between the data and a model that regards the Josephson junction as the resistively and capacitively shunted junction. A magnetic field tunability of 80 THz=G at 12 GHz is observed, a total tunability of 56% is achieved, and a unique electromagnetically induced transparency feature at intermediate excitation powers is demonstrated for the first time. An rf SQUID metamaterial is shown to have qualitatively the same behavior as a single rf SQUID with regard to dc flux and temperature tuning.

•Jan 1, 2013•52 citations

A tunable coupler for superconducting microwave resonators using a nonlinear kinetic inductance transmission line

Clint Bockstiegel, Yiwen Wang, Michael R. Vissers +4 more

We present a tunable coupler scheme that allows us to tune the coupling strength between a feedline and a superconducting resonator in situ over a wide range. In this scheme, we shunt the feedline with a 50-Ω lumped-element nonlinear transmission line made from a 20 nm NbTiN film. By injecting a DC current, the nonlinear kinetic inductance changes and the effective impedance shunting the resonator periodically varies from a short to an open, which tunes the coupling strength and coupling quality factor Qc. We have demonstrated Qc tuning over a factor of 40, between Qc∼5.5×104 and Qc∼2.3×106, for a 4.5 GHz resonator by applying a DC current less than 3.3 mA. Our tunable coupler scheme is easy to implement and may find broad applications in superconducting detector and quantum computing/information experiments.

Applied Physics Letters•May 30, 2016•25 citations

Design and experimental study of superconducting left-handed transmission lines with tunable dispersion

Е. А. Овчинникова, S. Butz, P. Jung +5 more

We study the microwave properties of a superconducting tunable coplanar waveguide (CPW). Pairs of Josephson junctions are forming superconducting quantum interference devices (SQUIDs), which shunt the central conductor of the CPW. The Josephson inductance of the SQUIDs is varied in the range of 0.08–0.5 nH by applying a dc magnetic field. The central conductor of the CPW contains Josephson junctions connected in series that provide extra inductances; the magnetic field controlling the SQUIDs is weak enough not to influence the inductance of the chain of the single junctions. The circuit is designed to have left- and right-handed transmission properties separated by a variable rejection band; the band edges can be tuned by the magnetic field. We present transmission measurements on CPWs based on up to 120 Nb–AlO x –Nb Josephson junctions. At zero magnetic field, we observed no rejection band in the frequency range of 8–11 GHz. When applying the magnetic field, a rejection band between 7 GHz and 9 GHz appears. The experimental data are compared with numerical simulations.

arXiv:1309.7557•Superconductor Science and Technology•Oct 7, 2013•16 citations

qConnect: Increasing Qubit Connectivity in Quantum Computing Fabric Using Active Transmission Lines

Sasan Razmkhah, Pascal Febvre, Massoud Pedram

We present a novel approach for tunable superconductor microwave transmission lines and resonators that can be integrated on-chip using standard Al or Nb-based fabrication processes. By leveraging the nonlinear inductance of a Josephson junction, the impedance and, consequently, the resonance frequency of the lines can be adjusted via a small DC signal. This signal is inductively coupled to a superconducting quantum interference device loop, with the circuit designed to remain open at microwave frequencies, effectively preventing energy leakage. The simplicity and tunability of this design make it adaptable to various applications. In this work, we demonstrate the multiplexing capability of such design for use in dynamic connections between control circuits and qubits, as well as dynamic routing in quantum circuits.

IEEE Transactions on Applied Superconductivity•Jan 27, 2025•1 citation
We propose tunable superconducting split-ring resonators (SRRs) employing nonlinear Josephson inductance. A fraction of SRR is replaced by Nb-AlOx-Nb Josephson tunnel junctions connected in parallel and forming a superconducting quantum interference device, whose inductance is sensitive to the external dc magnetic field. Due to the lumped nature of the Josephson inductance, the SRR can be made very compact, and its resonance frequency can be tuned by applying magnetic field. We present the model, results of extensive electromagnetic-simulation and experimental data for the SRR weakly coupled to a transmission line within frequency range of 11–13 GHz.
We report on experiments with superconducting Josephson metamaterials. In such a material, conventional split ring resonators are replaced by superconducting loops that are interrupted by Josephson junctions, so called rf-SQUIDs. Like the split ring resonators, they can be seen as LCresonators that couple to the magnetic component of the incoming wave. The advantage of superconducting thin-film metamaterials is that due to the tunable intrinsic inductance of the Josephson junction, the resonance frequency of the rf-SQUID can be changed by applying an external dc magnetic field. We present experimental results that show the tunability of the resonance frequency of these devices.
In this licentiate thesis design, fabrication, and measurements of tunable superconducting microwave transmission line resonators are described. The resonators are of quarter wavelength type were the tuning is achieved by changing one of the boundary conditions of the resonator through a tunable impedance. As tunable impedance the Josephson inductance in form of SQUIDs is used. The Josephson inductance can then be tuned by applying a magnetic field to the SQUID loop. A tuning range of 750 MHz for a 5 GHz resonator is achieved, and as a figure of merit it can be tuned over 200 line widths. The purpose of the tunable resonators is to use them for dynamic coupling of superconducting quantum bits, this requires that the resonators can be tuned fast on the timescale of the resonator-qubit coupling. To measure tuning speeds faster then the ring up time of the resonators a method that measures the leakage of energy out of a detuned resonator was developed. With this method a frequency shift of the energy stored in the resonator can be measured. A detuning of 330 MHz in less than 10 ns is demonstrated for a 4.5 GHz resonator with a quality factor of 104^44. Working in the few photon limit indicates that the devices can be used to change the frequency of individual photons, this is however still to be demonstrated. As a part of this work the dressed states of a superconducting charge qubit was also studied.
We have prepared meta-atoms based on radio-frequency superconducting quantum-interference devices (rf SQUIDs) and examined their tunability with dc magnetic field, rf current, and temperature. rf SQUIDs are superconducting split-ring resonators in which the usual capacitance is supplemented with a Josephson junction, which introduces strong nonlinearity in the rf properties. We find excellent agreement between the data and a model that regards the Josephson junction as the resistively and capacitively shunted junction. A magnetic field tunability of 80 THz=G at 12 GHz is observed, a total tunability of 56% is achieved, and a unique electromagnetically induced transparency feature at intermediate excitation powers is demonstrated for the first time. An rf SQUID metamaterial is shown to have qualitatively the same behavior as a single rf SQUID with regard to dc flux and temperature tuning.
We present a tunable coupler scheme that allows us to tune the coupling strength between a feedline and a superconducting resonator in situ over a wide range. In this scheme, we shunt the feedline with a 50-Ω lumped-element nonlinear transmission line made from a 20 nm NbTiN film. By injecting a DC current, the nonlinear kinetic inductance changes and the effective impedance shunting the resonator periodically varies from a short to an open, which tunes the coupling strength and coupling quality factor Qc. We have demonstrated Qc tuning over a factor of 40, between Qc∼5.5×104 and Qc∼2.3×106, for a 4.5 GHz resonator by applying a DC current less than 3.3 mA. Our tunable coupler scheme is easy to implement and may find broad applications in superconducting detector and quantum computing/information experiments.
We study the microwave properties of a superconducting tunable coplanar waveguide (CPW). Pairs of Josephson junctions are forming superconducting quantum interference devices (SQUIDs), which shunt the central conductor of the CPW. The Josephson inductance of the SQUIDs is varied in the range of 0.08–0.5 nH by applying a dc magnetic field. The central conductor of the CPW contains Josephson junctions connected in series that provide extra inductances; the magnetic field controlling the SQUIDs is weak enough not to influence the inductance of the chain of the single junctions. The circuit is designed to have left- and right-handed transmission properties separated by a variable rejection band; the band edges can be tuned by the magnetic field. We present transmission measurements on CPWs based on up to 120 Nb–AlO x –Nb Josephson junctions. At zero magnetic field, we observed no rejection band in the frequency range of 8–11 GHz. When applying the magnetic field, a rejection band between 7 GHz and 9 GHz appears. The experimental data are compared with numerical simulations.
We present a novel approach for tunable superconductor microwave transmission lines and resonators that can be integrated on-chip using standard Al or Nb-based fabrication processes. By leveraging the nonlinear inductance of a Josephson junction, the impedance and, consequently, the resonance frequency of the lines can be adjusted via a small DC signal. This signal is inductively coupled to a superconducting quantum interference device loop, with the circuit designed to remain open at microwave frequencies, effectively preventing energy leakage. The simplicity and tunability of this design make it adaptable to various applications. In this work, we demonstrate the multiplexing capability of such design for use in dynamic connections between control circuits and qubits, as well as dynamic routing in quantum circuits.