We propose a setup for universal and electrically controlled quantum information processing with hole spins in Ge/Si core/shell nanowire quantum dots (NW QDs). Single-qubit gates can be driven through electric-dipole-induced spin resonance, with spin-flip times shorter than 100 ps. Long-distance qubit-qubit coupling can be mediated by the cavity electric field of a superconducting transmission line resonator, where we show that operation times below 20 ns seem feasible for the entangling $\sqrt{i\text{SWAP}}$ gate. The absence of Dresselhaus spin-orbit interaction (SOI) and the presence of an unusually strong Rashba-type SOI enable precise control over the transverse qubit coupling via an externally applied, perpendicular electric field. The latter serves as an on-off switch for quantum gates and also provides control over the $g$ factor, so single- and two-qubit gates can be operated independently. Remarkably, we find that idle qubits are insensitive to charge noise and phonons, and we discuss strategies for enhancing noise-limited gate fidelities.
We propose a setup for universal and electrically controlled quantum information processing with hole spins in Ge/Si core/shell nanowire quantum dots (NW QDs). Single-qubit gates can be driven through electric-dipole-induced spin resonance, with spin-flip times shorter than 100 ps. Long-distance qubit-qubit coupling can be mediated by the cavity electric field of a superconducting transmission line resonator, where we show that operation times below 20 ns seem feasible for the entangling iSWAP gate. The absence of Dresselhaus spin-orbit interaction (SOI) and the presence of an unusually strong Rashba-type SOI enable precise control over the transverse qubit coupling via an externally applied, perpendicular electric field. The latter serves as an on-off switch for quantum gates and also provides control over the g factor, so single- and two-qubit gates can be operated independently. Remarkably, we find that idle qubits are insensitive to charge noise and phonons, and we discuss strategies for enhancing noise-limited gate fidelities.
A controllable and coherent light-matter interface is an essential element for a scalable quantum information processor. Strong coupling to an on-chip cavity has been accomplished in various electron quantum dot systems, but rarely explored in the hole systems. Here we demonstrate a hybrid architecture comprising a microwave transmission line resonator controllably coupled to a hole charge qubit formed in a Ge/Si core/shell nanowire (NW), which is a natural one-dimensional hole gas with a strong spin–orbit interaction (SOI) and lack of nuclear spin scattering, potentially enabling fast spin manipulation by electric manners and long coherence times. The charge qubit is established in a double quantum dot defined by local electrical gates. Qubit transition energy can be independently tuned by the electrochemical potential difference and the tunnel coupling between the adjacent dots, opening transverse (σ x ) and longitudinal (σ z ) degrees of freedom for qubit operation and interaction. As the qubit energy is swept across the photon level, the coupling with resonator is thus switched on and off, as detected by resonator transmission spectroscopy. The observed resonance dynamics is replicated by a complete quantum numerical simulation considering an efficient charge dipole-photon coupling with a strength up to 2π × 55 MHz, yielding an estimation of the spin-resonator coupling rate through SOI to be about 10 MHz. The results inspire the future researches on the coherent hole-photon interaction in Ge/Si nanowires.
Spin qubits in semiconductor quantum dots constitute one of the leading platforms for quantum information processing, combining long coherence times, high-fidelity gate operations, and compatibility with semiconductor industry technologies. In particular, holes confined in planar Ge/SiGe heterostructures have recently emerged as promising qubit candidates owing to their low effective mass, high mobility, low percolation density, absence of valley states, and strong spin-orbit interaction, which enables fast all-electrical spin control. At the same time, spin-orbit interaction also gives rise to a highly anisotropic and electrically tunable gyromagnetic response. Understanding and controlling this response is therefore essential for high-fidelity single- and multi-qubit operations. The realization of scalable quantum processors also requires efficient qubit readout and long-range connectivity. Circuit quantum electrodynamics (cQED), based on the coupling between artificial atoms and microwave photons confined in superconducting resonators, provides a natural framework to address these challenges. However, the implementation of hybrid semiconductor-superconductor devices in planar Ge has so far been hindered by large microwave losses originating from the heterostructure. In this thesis, we demonstrate, for the first time in planar Ge, strong coupling between a hole charge qubit in a double quantum dot and a high-impedance microwave resonator, reaching a cooperativity of C â 100. In addition, we leverage the frequency tunability of the resonator to perform detailed spectroscopy of a multi-level energy spectrum of low-lying states arising from strong Coulomb-correlation effects. To further improve the quality of the hole-photon interface, we investigate the source of microwave losses in different Ge/SiGe heterostructures, identifying defects at the lattice-mismatched Si/Ge interface as the dominant source of resonator losses in reverse-graded heterostructures. To mitigate this limitation, a deep tapered-etching approach is introduced, enabling the fabrication of superconducting resonators directly on etched heterostructures. This method yields internal quality factors exceeding Qint > 10 000 for high-impedance Josephson junction array resonators and Qint > 100 000 for 50 â Nb resonators. Finally, this thesis explores the spin properties of multi-hole quantum dots beyond the conventional single-orbital picture. By reconstructing and electrically tuning the g tensors of holes confined in different orbital states, we show that confinement can substantially modify both their magnitude and orientation. These results open new opportunities for engineering qubit properties through orbital occupation. Furthermore, highly coherent singlet-triplet oscillations are demonstrated in the seven-hole regime, yielding a quality factor of approximately 330 at in-plane magnetic fields as low as 2.5 mT. Together, these results establish a foundation for high-fidelity hole-spin-qubit operation based on g-tensor engineering and for the integration of planar Ge quantum dots with superconducting quantum circuits.
Spin qubits in gate-defined semiconductor quantum dots are a promising platform for realising a scalable quantum computer. This platform encodes quantum information into the intrinsic angular momentum (spin) of individual electrons or holes. In particular, hole spins in quantum dots enable the possibility of all-electrical spin control due to their intrinsic spin-orbit coupling. One important criterion of a quantum computer is the ability to reliably read out the state of the qubit. This is done by mapping spin information to the charge degree of freedom, combined with a method for charge detection. Charge detection can be facilitated by coupling a resonator directly to the quantum dot gate or to a charge sensor and measuring the resonator's phase or amplitude response. In this thesis, we describe a set of experiments relating to the implementation of hole spin qubit readout with superconducting resonators. First, we study gate-based charge sensing in a Si fin field-effect transistor (finFET) device using a superconducting NbN nanowire resonator. We find that the resonator amplifies capacitive crosstalk when electrical control pulses are applied to gate electrodes in this device. This occurs whenever a spectral component of qubit control pulses overlaps with the resonance frequency, which we show may occur for both baseband and radio-frequency (RF) drive signals. We quantify this crosstalk in a transport-based method, and attribute its source to the capacitance between the bondpads of neighbouring gate electrodes. In a second experiment, we use an RF charge sensor with the same nanowire technology to read out hole spin qubits formed in the quantum well of a Ge/SiGe heterostructure. A screening layer approach is used to facilitate RF matching due to large RF dissipation found in the heterostructure. We implement a double-latched readout scheme in this system to reduce errors arising from both spin and charge decay during readout. The spin-to-charge conversion process and its dependence on magnetic field orientation is studied. Spin and charge decay processes arising after spin-to-charge conversion are mitigated by choosing an optimal working point for the field orientation, field amplitude and readout pulse times. By doing so, we achieve an average single-shot state-preparation-and-measurement fidelity of 97%, primarily bounded by imperfect state preparation and limited signal-to-noise ratio. Finally, we study coplanar waveguide resonators fabricated from NbN. We investigate the feasibility of integrating this type of resonator onto the same chip as the Si finFET quantum dots. We then develop a novel resonator readout technique by the interference of two microwave sidebands. We demonstrate the insensitivity of this technique to common-mode phase and amplitude noise both theoretically and experimentally. This technique is then used to study resonator noise arising from two-level system defects. These results highlight both the practical constraints and the potential for achieving high readout fidelities using resonator-based hole spin qubit readout. This work establishes a blueprint for mitigating resonator-induced crosstalk and enabling high-fidelity readout in lossy materials by incorporating a screening layer.
Abstract Spin qubits in semiconductor quantum dots offer a gate-tunable platform for quantum information processing. While two-qubit interactions are typically realized through exchange coupling between neighboring spins, coupling spin qubits to photons via hybrid spin-circuit QED (cQED) devices enables long-range interactions and integration with other cQED platforms. Here, we investigate hole spin–photon coupling in compact single quantum dot setups. By incorporating ubiquitous strain inhomogeneities to our theory, we identify three main spin–photon coupling channels: a vector-potential-spin–orbit geometric mechanism–dominant for vertical magnetic fields–, an inhomogeneous Rashba term generalizing previous spin–orbit field models, and strain-induced g -tensor terms–most relevant for in-plane fields. Comparing Si, unstrained (relaxed) Ge, and biaxially strained Ge wells, we find that Si and unstrained Ge provide optimal coupling strengths (tens of MHz) thanks to their reduced heavy-hole, light-hole splitting. We demonstrate efficient switching of the spin–photon coupling while preserving sweet spot conditions by operating with an in-plane magnetic field. Finally, we evaluate quantum state transfer and two-qubit gate protocols, achieving ≳ 99 % fidelity for state transfer and > 90 % for two-qubit gates with realistic coherence times, establishing single-dot hole spins as a viable platform for compact spin-cQED architectures and highlighting unstrained Ge as a promising candidate for spin–photon interactions.
Micromagnet-free operation of electron spin qubits in Si/Si1−xGex vertical double quantum dots
We study a vertical double quantum dot (DQD) in a Si/Si1−xGex/Si double-well heterostructure for full electrical control of electron Loss-DiVincenzo (LD) spin qubits, using realistic device modeling and numerical simulations. Due to the emerging spin-orbit interaction in the DQD, as well as strain from the gate electrodes, small (percentage range) but finite g tensor variations emerge. In addition, we find a large valley splitting, on the order of Ev∼250μeV. As a result, multiple avenues for fast electrical single qubit rotations emerge. An ac electric field gives rise to electric dipole spin resonance (EDSR), while electron spin resonance (ESR) in the presence of an ac magnetic field can be electrically controlled by local gates due to varying g factors in DQDs. We also show that shuttling between neighboring dots, in vertical and horizontal direction, results in ultrafast single qubit gates of less than a nanosecond. Remarkably, this DQD architecture completely eliminates the need for micromagnets, significantly facilitating the scalability of LD spin qubits in semiconductor foundries.
We study theoretically electron spins in nanowire quantum dots placed inside a transmission line resonator. Because of the spin-orbit interaction, the spins couple to the electric component of the resonator electromagnetic field and enable coherent manipulation, storage, and readout of quantum information in an all-electrical fashion. Coupling between distant quantum-dot spins, in one and the same or different nanowires, can be efficiently performed via the resonator mode either in real time or through virtual processes. For the latter case, we derive an effective spin-entangling interaction and suggest means to turn it on and off. We consider both transverse and longitudinal types of nanowire quantum dots and compare their manipulation time scales against the spin relaxation times. For this, we evaluate the rates for spin relaxation induced by the nanowire vibrations (phonons) and show that, as a result of phonon confinement in the nanowire, this rate is a strongly varying function of the spin operation frequency and thus can be drastically reduced compared to lateral quantum dots in GaAs. Our scheme is a step forward to the formation of hybrid structures where qubits of different nature can be integrated in a single device.