Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1306.0164 · Scientific Reports

Waveguide integrated low noise NbTiN nanowire single-photon detectors with milli-Hz dark count rate

Carsten Schuck, Wolfram H. P. Pernice, Hong X. Tang

Published May 29, 2013• 148 citations
arXivHTMLPDF

Abstract

Superconducting nanowire single-photon detectors are an ideal match for integrated quantum photonic circuits due to their high detection efficiency for telecom wavelength photons. Quantum optical technology also requires single-photon detection with low dark count rate and high timing accuracy. Here we present very low noise superconducting nanowire single-photon detectors based on NbTiN thin films patterned directly on top of Si3N4 waveguides. We systematically investigate a large variety of detector designs and characterize their detection noise performance. Milli-Hz dark count rates are demonstrated over the entire operating range of the nanowire detectors which also feature low timing jitter. The ultra-low dark count rate, in combination with the high detection efficiency inherent to our travelling wave detector geometry, gives rise to a measured noise equivalent power at the 10(-20) W/Hz(1/2) level.

DOI
10.1038/srep01893

Related papers

Waveguide integrated superconducting single-photon detectors with high internal quantum efficiency at telecom wavelengths

Oliver Kahl, Simone Ferrari, Vadim V. Kovalyuk +3 more

Superconducting nanowire single-photon detectors (SNSPDs) provide high efficiency for detecting individual photons while keeping dark counts and timing jitter minimal. Besides superior detection performance over a broad optical bandwidth, compatibility with an integrated optical platform is a crucial requirement for applications in emerging quantum photonic technologies. Here we present SNSPDs embedded in nanophotonic integrated circuits which achieve internal quantum efficiencies close to unity at 1550 nm wavelength. This allows for the SNSPDs to be operated at bias currents far below the critical current where unwanted dark count events reach milli-Hz levels while on-chip detection efficiencies above 70% are maintained. The measured dark count rates correspond to noise-equivalent powers in the 10(-19) W/Hz(-1/2) range and the timing jitter is as low as 35 ps. Our detectors are fully scalable and interface directly with waveguide-based optical platforms.

Scientific Reports•Jun 10, 2015•111 citations

Amorphous superconducting nanowire single-photon detectors integrated with nanophotonic waveguides

M. Häußler, M. Yu. Mikhaı̆lov, Martin A. Wolff +1 more

Future applications in integrated quantum photonics will require large numbers of efficient, fast, and low-noise single-photon counters. Superconducting nanowire single-photon detectors made from amorphous material systems are best suited to meet these demands, but the integration with nanophotonic circuits has remained a challenge. Here, we show how amorphous molybdenum silicide (MoSi) nanowires are integrated with nanophotonic silicon nitride waveguides in traveling wave geometry. We found a saturated on-chip detection efficiency of (73 ± 10) % for telecom wavelength photons and the sub-10 Hz dark count rate at a temperature of 2.1 K, which allows for operation in robust, compact, and economic cryogenic systems. Applications requiring fast counting will benefit from the sub-5 ns recovery times of our devices that we combine with 135 ps timing accuracy. Achieving this performance with waveguide-integrated amorphous superconductors is an important step toward enabling high yield fabrication of competitive single-photon detectors on a large variety of nanophotonic material systems.

APL Photonics•Jul 1, 2020•24 citations

Broadband waveguide-integrated superconducting single-photon detectors with high system detection efficiency

Martin A. Wolff, Fabian Beutel, Jonas Schütte +4 more

Fast and efficient detection of single photons with high timing accuracy is a crucial requirement in most quantum optics experiments and enables novel sensing and imaging solutions. Superconducting nanowire single-photon detectors (SNSPD) achieve technology-leading performance in terms of detection efficiency, dark count rate, timing jitter, and detector dead times. However, conventional SNSPDs with high system detection efficiency typically rely on resonant enhancement of the absorption efficiency, thus only achieving attractive detector benchmarks over narrow spectral windows. Waveguide-integrated SNSPDs allow for leveraging the wideband material absorption in superconducting nanowires by absorbing light in a traveling-wave geometry but have been limited to low system detection efficiencies due to interface losses when coupling to optical fibers. Here, we show how high system detection efficiencies of 22%–73% are realized over a broad wavelength range from 532 nm to 1640 nm in a single waveguide-integrated SNSPD device. We accomplish efficient coupling between optical fibers and waveguide-integrated nanowire detectors by employing a 3D interface, produced in direct laser writing, that relies on total internal reflection for achieving a broad transmission bandwidth. We further find low timing jitter of 25.7 ps and detector decay times of 9.8 ns, allowing for single-photon counting with high repetition rates up to 100 MHz. Our work paves the way for an efficient single-photon detector solution that combines the spectral requirements of an extremely wide range of quantum optics experiments in a single device. The coupling approach and SNSPD-integration with nanophotonic circuits are further well-suited for realizing large-scale detector arrays.

Applied Physics Letters•Apr 12, 2021•43 citations

Single-photon detectors combining high efficiency, high detection rates, and ultra-high timing resolution

Iman Esmaeil Zadeh, Johannes W. N. Los, Ronan Gourgues +5 more

Single-photon detection with high efficiency, high time resolution, low dark counts, and high photon detection rates is crucial for a wide range of optical measurements. Although efficient detectors have been reported before, combining all performance parameters in a single device remains a challenge. Here, we show a broadband NbTiN superconducting nanowire detector with an efficiency exceeding 92%, over 150 MHz photon detection rate, and a dark count rate below 130 Hz operated in a Gifford-McMahon cryostat. Furthermore, with careful optimization of the detector design and readout electronics, we reach an ultra-low system timing jitter of 14.80 ps (13.95 ps decoupled) while maintaining high detection efficiencies (>75%).

arXiv:1611.02726•APL Photonics•Nov 1, 2017•181 citations

NbTiN superconducting nanowire detectors for visible and telecom wavelengths single photon counting on Si3N4 photonic circuits

Carsten Schuck, Wolfram H. P. Pernice, Hong X. Tang

We demonstrate niobium titanium nitride superconducting nanowires patterned on stoichiometric silicon nitride waveguides for detecting visible and infrared photons. The use of silicon nitride on insulator on silicon substrates allows us to simultaneously realize photonic circuits for visible and infrared light and integrate them with nanowire detectors directly on-chip. By implementing a traveling wave detector geometry in this material platform, we achieve efficient single photon detection for both wavelength regimes. Our detectors are an ideal match for integrated quantum optics as they provide crucial functionality on a wideband transparent waveguide material.

arXiv:1302.0786•Applied Physics Letters•Feb 4, 2013•89 citations

Optical time domain reflectometry with low noise waveguide-coupled superconducting nanowire single-photon detectors

Carsten Schuck, Wolfram H. P. Pernice, Xiao‐Song Ma +1 more

We demonstrate optical time domain reflectometry over 200 km of optical fiber using low-noise NbTiN superconducting single-photon detectors integrated with Si3N4 waveguides. Our small detector footprint enables high timing resolution of 50 ps and a dark count rate of 3 Hz with unshielded fibers, allowing for identification of defects along the fiber over a dynamic range of 37.4 dB. Photons scattered and reflected back from the fiber under test can be detected in free-running mode without showing dead zones or other impairments often encountered in semiconductor photon-counting optical time domain reflectometers.

arXiv:1305.7000•Applied Physics Letters•May 13, 2013•41 citations
Superconducting nanowire single-photon detectors are an ideal match for integrated quantum photonic circuits due to their high detection efficiency for telecom wavelength photons. Quantum optical technology also requires single-photon detection with low dark count rate and high timing accuracy. Here we present very low noise superconducting nanowire single-photon detectors based on NbTiN thin films patterned directly on top of Si3N4 waveguides. We systematically investigate a large variety of detector designs and characterize their detection noise performance. Milli-Hz dark count rates are demonstrated over the entire operating range of the nanowire detectors which also feature low timing jitter. The ultra-low dark count rate, in combination with the high detection efficiency inherent to our travelling wave detector geometry, gives rise to a measured noise equivalent power at the 10(-20) W/Hz(1/2) level.
Superconducting nanowire single-photon detectors (SNSPDs) provide high efficiency for detecting individual photons while keeping dark counts and timing jitter minimal. Besides superior detection performance over a broad optical bandwidth, compatibility with an integrated optical platform is a crucial requirement for applications in emerging quantum photonic technologies. Here we present SNSPDs embedded in nanophotonic integrated circuits which achieve internal quantum efficiencies close to unity at 1550 nm wavelength. This allows for the SNSPDs to be operated at bias currents far below the critical current where unwanted dark count events reach milli-Hz levels while on-chip detection efficiencies above 70% are maintained. The measured dark count rates correspond to noise-equivalent powers in the 10(-19) W/Hz(-1/2) range and the timing jitter is as low as 35 ps. Our detectors are fully scalable and interface directly with waveguide-based optical platforms.
Future applications in integrated quantum photonics will require large numbers of efficient, fast, and low-noise single-photon counters. Superconducting nanowire single-photon detectors made from amorphous material systems are best suited to meet these demands, but the integration with nanophotonic circuits has remained a challenge. Here, we show how amorphous molybdenum silicide (MoSi) nanowires are integrated with nanophotonic silicon nitride waveguides in traveling wave geometry. We found a saturated on-chip detection efficiency of (73 ± 10) % for telecom wavelength photons and the sub-10 Hz dark count rate at a temperature of 2.1 K, which allows for operation in robust, compact, and economic cryogenic systems. Applications requiring fast counting will benefit from the sub-5 ns recovery times of our devices that we combine with 135 ps timing accuracy. Achieving this performance with waveguide-integrated amorphous superconductors is an important step toward enabling high yield fabrication of competitive single-photon detectors on a large variety of nanophotonic material systems.
Fast and efficient detection of single photons with high timing accuracy is a crucial requirement in most quantum optics experiments and enables novel sensing and imaging solutions. Superconducting nanowire single-photon detectors (SNSPD) achieve technology-leading performance in terms of detection efficiency, dark count rate, timing jitter, and detector dead times. However, conventional SNSPDs with high system detection efficiency typically rely on resonant enhancement of the absorption efficiency, thus only achieving attractive detector benchmarks over narrow spectral windows. Waveguide-integrated SNSPDs allow for leveraging the wideband material absorption in superconducting nanowires by absorbing light in a traveling-wave geometry but have been limited to low system detection efficiencies due to interface losses when coupling to optical fibers. Here, we show how high system detection efficiencies of 22%–73% are realized over a broad wavelength range from 532 nm to 1640 nm in a single waveguide-integrated SNSPD device. We accomplish efficient coupling between optical fibers and waveguide-integrated nanowire detectors by employing a 3D interface, produced in direct laser writing, that relies on total internal reflection for achieving a broad transmission bandwidth. We further find low timing jitter of 25.7 ps and detector decay times of 9.8 ns, allowing for single-photon counting with high repetition rates up to 100 MHz. Our work paves the way for an efficient single-photon detector solution that combines the spectral requirements of an extremely wide range of quantum optics experiments in a single device. The coupling approach and SNSPD-integration with nanophotonic circuits are further well-suited for realizing large-scale detector arrays.
Single-photon detection with high efficiency, high time resolution, low dark counts, and high photon detection rates is crucial for a wide range of optical measurements. Although efficient detectors have been reported before, combining all performance parameters in a single device remains a challenge. Here, we show a broadband NbTiN superconducting nanowire detector with an efficiency exceeding 92%, over 150 MHz photon detection rate, and a dark count rate below 130 Hz operated in a Gifford-McMahon cryostat. Furthermore, with careful optimization of the detector design and readout electronics, we reach an ultra-low system timing jitter of 14.80 ps (13.95 ps decoupled) while maintaining high detection efficiencies (>75%).
We demonstrate niobium titanium nitride superconducting nanowires patterned on stoichiometric silicon nitride waveguides for detecting visible and infrared photons. The use of silicon nitride on insulator on silicon substrates allows us to simultaneously realize photonic circuits for visible and infrared light and integrate them with nanowire detectors directly on-chip. By implementing a traveling wave detector geometry in this material platform, we achieve efficient single photon detection for both wavelength regimes. Our detectors are an ideal match for integrated quantum optics as they provide crucial functionality on a wideband transparent waveguide material.
We demonstrate optical time domain reflectometry over 200 km of optical fiber using low-noise NbTiN superconducting single-photon detectors integrated with Si3N4 waveguides. Our small detector footprint enables high timing resolution of 50 ps and a dark count rate of 3 Hz with unshielded fibers, allowing for identification of defects along the fiber over a dynamic range of 37.4 dB. Photons scattered and reflected back from the fiber under test can be detected in free-running mode without showing dead zones or other impairments often encountered in semiconductor photon-counting optical time domain reflectometers.