We demonstrate the time-reversed process of nondegenerate three-wave parametric amplification from three distinct sources in the fully nonlinear regime using a Josephson amplifier. In the reverse process, coherent attenuation, signal and idler beams destructively interfere in the presence of a pump to generate additional pump photons. This effect is observed through the symmetric phase-dependent amplification and attenuation of the signal and idler beams and, in the depleted pump regime, through the phase-dependent modulation of the amplifier gain, directly probing the enhancement of the pump. Results are found to be in good agreement with theory.
We demonstrate the time-reversed process of nondegenerate three-wave parametric amplification from three distinct sources in the fully nonlinear regime using a Josephson amplifier. In the reverse process, coherent attenuation, signal and idler beams destructively interfere in the presence of a pump to generate additional pump photons. This effect is observed through the symmetric phase-dependent amplification and attenuation of the signal and idler beams and, in the depleted pump regime, through the phase-dependent modulation of the amplifier gain, directly probing the enhancement of the pump. Results are found to be in good agreement with theory.
Linear parametric amplification is a key operation in information processing. Our interest here is quantum-limited parametric amplification, i.e., amplification of quantum signals while adding the minimum amount of noise allowed by quantum mechanics, which is essential for any viable implementation of quantum information processing. We describe parametric amplifiers based on the dispersive nonlinearity of Josephson junctions driven with appropriate tones playing the role of pumps. We discuss two defining characteristics in the architecture of these amplifiers: the number of modes occupied by the signal, idler, and pump waves and the number of independent ports through which these waves enter into the circuit. The scattering properties of these amplifiers are also reviewed. The main focus of this work are the computations of the dynamic range and phase-space distributions of the fluctuations of the modes of the amplifiers.
Microwave parametric amplifiers based on Josephson junctions have become indispensable components of many quantum information experiments. One key limitation which has not been well predicted by theory is the gain saturation behavior which limits the amplifier's ability to process large amplitude signals. The typical explanation for this behavior in phase-preserving amplifiers based on three-wave mixing, such as the Josephson Parametric Converter, is pump depletion, in which the consumption of pump photons to produce amplification results in a reduction in gain. However, in this work, we present experimental data and theoretical calculations showing that the fourth-order Kerr nonlinearities inherent in Josephson junctions are the dominant factor. The Kerr-based theory has the unusual property of causing saturation to both lower and higher gains, depending on bias conditions. This work presents an efficient methodology for optimizing device performance in the presence of Kerr nonlinearities while retaining device tunability and points to the necessity of controlling higher-order Hamiltonian terms to make further improvements in parametric devices.
We present the theory of a Josephson parametric amplifier employing two-pump sources. Our calculations are based on input-output theory, and can easily be generalized to any coupled system involving parametric interactions. We analyze the operation of the device, taking into account the feedback introduced by the reaction of the signal and noise on the pump power, and in this framework, compute the response functions of interest---signal and idler gains, internal gain of the amplifier, and self-oscillation signal amplitude. To account for this back action between signal and pump, we adopt a mean-field approach and self-consistently explore the boundary between amplification and self-oscillation. The coincidence of bifurcation and self-oscillation thresholds reveals that the origin of coherent emission of the amplifier lies in the multiwave mixing of the noise components. Incorporation of the back action leads the system to exhibit hysteresis, dependent on parameters such as temperature and detuning from resonance. Our analysis also shows that the resonance condition itself changes in the presence of back action and this can be understood in terms of the change in plasma frequency of the junction. The potential of the double-pump amplifier for quantum-limited measurements and as a squeezer is also discussed.
Superconducting traveling-wave parametric amplifiers (TWPAs) are increasingly used in various applications, including quantum computing, quantum sensing, and dark matter detection. However, one important characteristic of these amplifiers, gain compression, has not received much attention. As a result, there is a lack of comprehensive experimental exploration of this phenomenon in the existing literature. In this study, we present an experimental investigation of gain compression in a Josephson traveling-wave parametric amplifier based on a four-wave mixing process. We have implemented a novel setup to monitor the complex transmission of both the pump and signal tones, which allows us to simultaneously track pump depletion and signal amplification as functions of signal power and frequency across the entire bandwidth of the device. Our findings indicate that, while pump depletion occurs during gain compression, it is not the only mechanism involved in the saturation of a TWPA. Power-induced phase-matching processes also take place within the device. This study provides valuable insights for optimizing TWPAs for applications that require high total input power, such as multiplexed qubit readout or broadband photon emission.
Superconducting traveling-wave parametric amplifiers (TWPAs) are increasingly used in various applications, including quantum computing, quantum sensing, and dark matter detection. However, one important characteristic of these amplifiers, gain compression, has not received much attention. As a result, there is a lack of comprehensive experimental exploration of this phenomenon in the existing literature. In this study, we present an experimental investigation of gain compression in a Josephson traveling-wave parametric amplifier based on a four-wave mixing process. We have implemented a novel setup to monitor the complex transmission of both the pump and signal tones, which allows us to simultaneously track pump depletion and signal amplification as functions of signal power and frequency across the entire bandwidth of the device. Our findings indicate that, while pump depletion occurs during gain compression, it is not the only mechanism involved in the saturation of a TWPA. Power-induced phase-matching processes also take place within the device. This study provides valuable insights for optimizing TWPAs for applications that require high total input power, such as multiplexed qubit readout or broadband photon emission.
Superconducting traveling-wave parametric amplifiers (TWPAs) are essential elements for enhancing the signal-to-noise ratio (SNR) and thus the read-out fidelity of superconducting qubits because of their high gain and near quantum-limited noise. However, the impact of the pump source, e.g., phase noise on these amplifiers, has not yet been studied. In this work, we show that among the two amplification processes in JTWPAs, the three-wave mixing (3WM) process is more sensitive to the pump phase noise than the four-wave mixing (4WM) process. We show that the even-order nonlinearity of 4th order and above in three-wave mixing is responsible for more than 10 dB increase of phase noise at high frequency offsets within the phase noise mask as the power of the pump increases. A polynomial model of the amplifier and cyclo-stationary property of phase noise also corroborate with the simulations. The Harmonic Balance (HB) periodic noise analysis tool and Leeson phase noise model in Keysight Advanced Design System (ADS) simulator were used in this study.