Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1209.1515 · Journal of the Optical Society of America A

Optical phase noise engineering via acousto-optic interaction and its interferometric applications

Nandan Satapathy, Deepak Pandey, Sourish Banerjee, Hema Ramachandran

Published Apr 15, 2013• 3 citations
arXivHTMLPDF

Abstract

Rapid and fine control over the phase of light is demonstrated by transferring digitally generated phase jumps from radio-frequency electrical signals onto light by means of acousto-optic interaction, and the underlying mechanism elucidated. This technique was used to engineer optical phase noise by tailoring the statistics of phase jumps in the electrical signal, which was then quantified using visibility measurements of the interference fringes. Such controlled dephasing finds applications in modern experiments involving the spread or diffusion of light in optical networks. In addition, the zero-delay intensity-intensity correlation [G2(0)] values of light emerging from different ports of a well-stabilized Mach-Zehnder interferometer in the presence of engineered partial phase noise are calculated, and it is shown analytically how the dark port of the interferometer nontrivially becomes a weak source of highly correlated or bunched photons.

DOI
10.1364/josaa.30.000910

Related papers

Sub-Shot Noise Interferometry and Quantum Imaging

Richard E. Slusher, Arthur La Porta, Philippe Grangier +2 more

Optimizing the sensitivity for interferometric measurement of optical phase involves maximizing the intensity of the illuminating light source and minimizing any noise sources. Limits to the light source intensity may arise from the availability of a stable high-power laser or from damage to the system being measured. For example, we describe here a scanning confocal polarization microscope designed to image the dynamics of nerve networks. In this case the light intensity limit is set by several factors, including the scanning rate, the required response time and damage limits of the biological system. Assuming a stable experimental configuration for the interferometer and light source, the limiting noise source for visible light interferometry is shot-noise associated with the quantum state of the light inputs to the interferometer. Shot-noise can be thought of as arising from vacuum fluctuations entering the dark input port of the interferometer.(1) These vacuum field fluctuations combine with the light entering the other port to cause shot-noise in the detected photocurrent at the output ports of the interferometer. This shot-noise current normally limits the measured phase variance Δϕ to a value of 1/N where N is the average number of photons detected in a measurement interval. We describe an experiment which demonstrates that this shot-noise limit can be improved by injecting squeezed vacuum into the normally dark input port.(2) In this case the phase variance is reduced below the 1/N limit by the degree of squeezing. In contrast to early experiments,(2) we are now operating the interferometer in a dark fringe mode(3–5) in order to avoid setting a limit to the light level caused by detector saturation (near 1 mW).

Topical Meeting on Quantum-Limited Imaging and Image Processing•Jan 1, 1989•0 citations

Noise-suppressing and lock-free optical interferometer for cold atom experiments

Xiao-Xiao Ma, Xian Zhang, Kaikai Huang +1 more

A novel noise-suppressing and lock-free interferometer is proposed and experimentally demonstrated in the study of the quantum non-destructive (QND) interaction of cold atoms. A QND measurement based on far-off resonant dispersive probing is usually carried out by a Mach-Zehnder type interferometer. It is an experimental challenge in its own right to reduce the classical noise, such as acoustic noise, phase noise and amplitude noise of lasers, and to lock the interferometer at the white-light position that corresponds to a nearly zero path-length difference. Here, we report an interferometer with an inserted acousto-optic modulator (AOM). It is noise immune and lock-free in principle. The experiments show that the new interferometer is able to measure cold atoms for more than 30 minutes and reduce the phase noise by about 30 dB.

Optics Express•Aug 28, 2020•2 citations

Noise-resistant phase imaging with intensity correlation

Jerzy Szuniewicz, Stanisław Kurdziałek, Sanjukta Kundu +4 more

Interferometric methods form the basis of highly sensitive measurement techniques from astronomy to bioimaging. Interferometry typically requires high stability between the measured and reference beams. The presence of rapid phase fluctuations washes out interference fringes, making phase profile recovery impossible. This challenge can be addressed by shortening the measurement time. However, such an approach reduces photon-counting rates, precluding applications in low-intensity imaging. We introduce a phase imaging technique which is immune to time-dependent phase fluctuations. Our technique, relying on intensity correlation instead of direct intensity measurements, allows one to obtain high interference visibility for arbitrarily long acquisition times. We prove the optimality of our method using the Cramér-Rao bound in the extreme case when no more than two photons are detected within the time window of phase stability. Our technique will broaden prospects in phase measurements, including emerging applications such as in infrared and x-ray imaging and quantum and matter-wave interferometry.

arXiv:2301.11969•Science Advances•Sep 22, 2023•18 citations

Phase noise due to vibrations in Mach-Zehnder atom interferometers

Alain Miffre, Marion Jacquey, M Büchner +2 more

Atom interferometers are very sensitive to accelerations and rotations. This property, which has some very interesting applications, induces a deleterious phase noise due to the seismic noise of the laboratory and this phase noise is sufficiently large to reduce the fringe visibility in many experiments. We develop a model calculation of this phase noise in the case of Mach-Zehnder atom interferometers and we apply this model to our thermal lithium interferometer. We are able to explain the observed phase noise which has been detected through the rapid dependence of the fringe visibility with the diffraction order. We think that the dynamical model developed in the present paper should be very useful to reduce the vibration induced phase noise in atom interferometers, making many new experiments feasible.

arXiv:quant-ph/0604028•Apr 5, 2006•6 citations

Theory of interferometric photon-correlation measurements: Differentiating coherent from chaotic light

A. Lebreton, Izo I. Abram, Rémy Braive +3 more

Interferometric photon-correlation measurements, which correspond to the second-order intensity cross correlations between the two output ports of an unbalanced Michelson (or Mach-Zehnder) interferometer, are sensitive to both amplitude and phase fluctuations of an incoming beam of light. Here, we present the theoretical framework behind these measurements and show that they can be used to unambiguously differentiate a coherent wave undergoing dynamical amplitude and phase fluctuations from a chaotic state of light. This technique may thus be used to characterize the output of nanolasers and monitor the onset of coherent emission.

arXiv:1302.7187•Physical Review A•Jul 2, 2013•21 citations

Audio-frequency interferometry at the shot noise limit using an EOIM-based frequency-synthesized light

Peng Yang, Chaoran Tu, Zhichao Shi +1 more

The shot-noise-limited sensitivity for detecting audio-frequency phase signals has garnered significant interest in both research and practical applications. This work presents a novel experimental setup that generates frequency-synthesized light with suppressed carrier and enhanced sidebands using an electro-optic intensity modulator (EOIM). When injected into a Mach-Zehnder interferometer (MZI), the EOIM-generated light not only enables phase-sensitive heterodyne locking to stabilize the relative phase of the MZI but also functions as a balanced heterodyne detector for audio-frequency phase measurements. By integrating these three key techniques into the MZI, phase detection sensitivity reaches the shot-noise limit across the audio-frequency band. This advancement holds promise for applications in gravitational wave detection, vacuum magnetic birefringence studies, spin-orbital interactions, material characterization, polarization microscopy, atomic magnetometry, and biomedical optics.

Optics Express•Feb 19, 2026•2 citations
Rapid and fine control over the phase of light is demonstrated by transferring digitally generated phase jumps from radio-frequency electrical signals onto light by means of acousto-optic interaction, and the underlying mechanism elucidated. This technique was used to engineer optical phase noise by tailoring the statistics of phase jumps in the electrical signal, which was then quantified using visibility measurements of the interference fringes. Such controlled dephasing finds applications in modern experiments involving the spread or diffusion of light in optical networks. In addition, the zero-delay intensity-intensity correlation [G2(0)] values of light emerging from different ports of a well-stabilized Mach-Zehnder interferometer in the presence of engineered partial phase noise are calculated, and it is shown analytically how the dark port of the interferometer nontrivially becomes a weak source of highly correlated or bunched photons.
Optimizing the sensitivity for interferometric measurement of optical phase involves maximizing the intensity of the illuminating light source and minimizing any noise sources. Limits to the light source intensity may arise from the availability of a stable high-power laser or from damage to the system being measured. For example, we describe here a scanning confocal polarization microscope designed to image the dynamics of nerve networks. In this case the light intensity limit is set by several factors, including the scanning rate, the required response time and damage limits of the biological system. Assuming a stable experimental configuration for the interferometer and light source, the limiting noise source for visible light interferometry is shot-noise associated with the quantum state of the light inputs to the interferometer. Shot-noise can be thought of as arising from vacuum fluctuations entering the dark input port of the interferometer.(1) These vacuum field fluctuations combine with the light entering the other port to cause shot-noise in the detected photocurrent at the output ports of the interferometer. This shot-noise current normally limits the measured phase variance Δϕ to a value of 1/N where N is the average number of photons detected in a measurement interval. We describe an experiment which demonstrates that this shot-noise limit can be improved by injecting squeezed vacuum into the normally dark input port.(2) In this case the phase variance is reduced below the 1/N limit by the degree of squeezing. In contrast to early experiments,(2) we are now operating the interferometer in a dark fringe mode(3–5) in order to avoid setting a limit to the light level caused by detector saturation (near 1 mW).
A novel noise-suppressing and lock-free interferometer is proposed and experimentally demonstrated in the study of the quantum non-destructive (QND) interaction of cold atoms. A QND measurement based on far-off resonant dispersive probing is usually carried out by a Mach-Zehnder type interferometer. It is an experimental challenge in its own right to reduce the classical noise, such as acoustic noise, phase noise and amplitude noise of lasers, and to lock the interferometer at the white-light position that corresponds to a nearly zero path-length difference. Here, we report an interferometer with an inserted acousto-optic modulator (AOM). It is noise immune and lock-free in principle. The experiments show that the new interferometer is able to measure cold atoms for more than 30 minutes and reduce the phase noise by about 30 dB.
Interferometric methods form the basis of highly sensitive measurement techniques from astronomy to bioimaging. Interferometry typically requires high stability between the measured and reference beams. The presence of rapid phase fluctuations washes out interference fringes, making phase profile recovery impossible. This challenge can be addressed by shortening the measurement time. However, such an approach reduces photon-counting rates, precluding applications in low-intensity imaging. We introduce a phase imaging technique which is immune to time-dependent phase fluctuations. Our technique, relying on intensity correlation instead of direct intensity measurements, allows one to obtain high interference visibility for arbitrarily long acquisition times. We prove the optimality of our method using the Cramér-Rao bound in the extreme case when no more than two photons are detected within the time window of phase stability. Our technique will broaden prospects in phase measurements, including emerging applications such as in infrared and x-ray imaging and quantum and matter-wave interferometry.
Atom interferometers are very sensitive to accelerations and rotations. This property, which has some very interesting applications, induces a deleterious phase noise due to the seismic noise of the laboratory and this phase noise is sufficiently large to reduce the fringe visibility in many experiments. We develop a model calculation of this phase noise in the case of Mach-Zehnder atom interferometers and we apply this model to our thermal lithium interferometer. We are able to explain the observed phase noise which has been detected through the rapid dependence of the fringe visibility with the diffraction order. We think that the dynamical model developed in the present paper should be very useful to reduce the vibration induced phase noise in atom interferometers, making many new experiments feasible.
Interferometric photon-correlation measurements, which correspond to the second-order intensity cross correlations between the two output ports of an unbalanced Michelson (or Mach-Zehnder) interferometer, are sensitive to both amplitude and phase fluctuations of an incoming beam of light. Here, we present the theoretical framework behind these measurements and show that they can be used to unambiguously differentiate a coherent wave undergoing dynamical amplitude and phase fluctuations from a chaotic state of light. This technique may thus be used to characterize the output of nanolasers and monitor the onset of coherent emission.
The shot-noise-limited sensitivity for detecting audio-frequency phase signals has garnered significant interest in both research and practical applications. This work presents a novel experimental setup that generates frequency-synthesized light with suppressed carrier and enhanced sidebands using an electro-optic intensity modulator (EOIM). When injected into a Mach-Zehnder interferometer (MZI), the EOIM-generated light not only enables phase-sensitive heterodyne locking to stabilize the relative phase of the MZI but also functions as a balanced heterodyne detector for audio-frequency phase measurements. By integrating these three key techniques into the MZI, phase detection sensitivity reaches the shot-noise limit across the audio-frequency band. This advancement holds promise for applications in gravitational wave detection, vacuum magnetic birefringence studies, spin-orbital interactions, material characterization, polarization microscopy, atomic magnetometry, and biomedical optics.