Feedback control in quantum transport has been predicted to give rise to several interesting effects, among them quantum state stabilization and the realization of a mesoscopic Maxwell's daemon. These results were derived under the assumption that control operations on the system are affected instantaneously after the measurement of electronic jumps through it. In this contribution, I describe how to include a delay between detection and control operation in the master equation theory of feedback-controlled quantum transport. I investigate the consequences of delay for the state stabilization and Maxwell's daemon schemes. Furthermore, I describe how delay can be used as a tool to probe coherent oscillations of electrons within a transport system and how this formalism can be used to model finite detector bandwidth.
Feedback control in quantum transport has been predicted to give rise to several interesting effects, among them quantum state stabilization and the realization of a mesoscopic Maxwell's daemon. These results were derived under the assumption that control operations on the system are affected instantaneously after the measurement of electronic jumps through it. In this contribution, I describe how to include a delay between detection and control operation in the master equation theory of feedback-controlled quantum transport. I investigate the consequences of delay for the state stabilization and Maxwell's daemon schemes. Furthermore, I describe how delay can be used as a tool to probe coherent oscillations of electrons within a transport system and how this formalism can be used to model finite detector bandwidth.
Feedback control in open quantum dynamics is crucial for the advancement of various coherent platforms. However, currently only a handful of feedback master equations exist in the literature, which are restricted to specific types of feedback. In this letter we first introduce a unifying framework, based on a single general equation, that describes all possible feedback schemes in sequentially (and continuously) measured systems, and from which all previous results follow. Next, we specialize it to the case of quantum jumps and introduce a new type of feedback based on the channel of the last detected jump, as well as the time elapsed since it occurred. Our description is experimentally grounded, and naturally allows for the introduction of realistic effects, such as time-delays in the feedback loop. We illustrate our results with two time-dependent feedback protocols conditioned on quantum-jump detections: one achieving population inversion of a two-level system against a thermal bath, and another enabling real-time reversal of quantum transitions, both admitting steady-state solutions.
Measurement and feedback control are essential features of quantum science, with applications ranging from quantum technology protocols to information-to-work conversion in quantum thermodynamics. Theoretical descriptions of feedback control are typically given in terms of stochastic equations requiring numerical solutions, or are limited to linear feedback protocols. Here we present a formalism for continuous quantum measurement and feedback, both linear and nonlinear. Our main result is a quantum Fokker-Planck master equation describing the joint dynamics of a quantum system and a detector with finite bandwidth. For fast measurements, we derive a Markovian master equation for the system alone, amenable to analytical treatment. We illustrate our formalism by investigating two basic information engines, one quantum and one classical.
A general theory of quantum-limited feedback for continuously monitored systems is presented. Two approaches are used, one based on quantum measurement theory and one on Hamiltonian system-bath interactions. The former gives rise to a stochastic non-Markovian evolution equation for the density operator, and the latter a non-Markovian quantum Langevin equation. In the limit that the time delay in the feedback loop is negligible, a simple deterministic Markovian master equation can be derived from either approach. Two special cases of interest are treated: feedback mediated by optical homodyne detection and self-excited quantum point processes.
Abstract The no-knowledge quantum feedback, introduced in Phys. Rev. Lett., 113, 020407 (2014), is a measurement-based feedback protocol for decoherence suppression in a quantum system coupled to noisy environment. By continuously measuring the environmental noise, without directly gathering any information about the system, the decoherence effect can be suppressed by feeding back quantum controls proportional to the measured signal. In the original work, the feedback control was assumed instantaneous, leading to perfect cancellation of noise backaction on the quantum system. However, the instantaneous feedback is difficult to achieve in practice, and close-loop feedback protocols are always associated with finite delayed time. Therefore, in this work, we consider the effects of the delay between the time at which the measurement signal is acquired and the time that such signal is fed back to the system. We investigate the problem with an example of a two-level system (qubit) coupled to a Markovian reservoir, via a Hermitian coupling operator, where a homodyne detection is used to measure the environmental noise. We numerically simulate quantum stochastic trajectories of the qubit and analyse their averaged dynamics. We find that the feedback control with time delay can either enhance or reduce the decoherence effects, depending on whether the delayed time is in-phase or out-of-phase with the unitary dynamics of the qubit system.
Quantum nonlinear feedback control is developed for traveling optical fields. We first describe the discretization of the traveling optical fields. The discrete-time formulation is used to describe the stochastic master equation subject to homodyne measurement. Nonlinear feedback is formulated by directly feeding the measurement outcomes back to the traveling field through a multiplicative action. Since the measurement outcomes have a correlation with the system, the multiplicative feedback control can create nonlinear effects in the traveling field. In this formulation, a time delay is naturally introduced in the feedback loop. This is essentially different from instantaneous feedback in a continuous-time setting. As an example of the feedback scheme, a quantum nondemolition sum gate is considered. Numerical results show that quantum superposition state can be created by applying the feedback to a squeezed state.
Measurement and control of quantum systems play an important role in science and technology, from the foundations of quantum mechanics to practical applications. This thesis presents theoretical and experimental work that exploits quantum measurement and measurement-based feedback control to study some new problems in the contexts of solid state physics and optical quantum systems. In the first part, we consider the dynamics of open quantum systems conditioned on continuous measurements. We revisit the fact that dynamical quantum events are detector dependent by framing the problem as a quantum correlation test of the Einstein-Podolsky-Rosen (EPR) steering type. In this regards, a no-go theorem for quantum diusion is derived. In order to study a realistic experimental situation we scrutinise dierent physical systems, Einstein-Podolsky-Rosen steering inequalities and measurement protocol. We show that the no-go result for quantum diusion is not universal and does not apply to quantum jumps by devising a novel adaptive measurement scheme. Since the objectiveness of pure-state dynamical models is ruled out by quantum entanglement, then it is reasonable to say that quantum jumps are more quantum than quantum diusion. In the rst part we also study a stochastic feedback control of quantum transport. We show that using a feedback control strategy it is possible to restrict the dynamics of a double quantum dot system to a non-orthogonal two-state ensemble. The feedback control approach can be less experimentally challenging than an adaptive measurement scheme, as the latter requires implementing local oscillators, which might be dicult to realise in mesoscopic physics.