Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1205.2160 · Journal of Physics Condensed Matter

Readout of superconducting flux qubit state with a Cooper pair box

Mun Dae Kim, Kyungsun Moon

Published May 15, 2012• 0 citations
arXivHTMLPDF

Abstract

We study a readout scheme of a superconducting flux qubit state with a Cooper pair box as a transmon. The qubit states consist of the superpositions of two degenerate states where the charge and phase degrees of freedom are entangled. Owing to the robustness of the transmon against external fluctuations, our readout scheme enables the quantum non-demolition and single-shot measurement of flux qubit states. The qubit state readout can be performed by using the nonlinear Josephson amplifiers after a π/2 rotation driven by an ac electric field.

DOI
10.1088/0953-8984/24/22/225305

Related papers

Read-out of superconducting qubits - a quantum measurement process

Lars Tornberg

In this work we consider measurements on quantum systems emphasizing\non read-out of superconducting qubits. The qubit is always coupled to an\nenvironment, containing a macroscopic number of degrees of freedom. This\nperturbs the qubit and destroys the phase coherence of the quantum state.\nOne tries to minimize this destructive effect by encoding the quantum information in quantum states which do not couple strongly to the dominant\nnoise sources. It is therefore necessary to design read-out methods that can\ndistinguish these states.\n\nWe focus primarily on the single Cooper-pair box (SCB) charge qubit, whose\nproperties are based on the Josephson effect and Coulumb blockade in superconducting electrical circuits. By encoding the information in the qubit\nenergy eigenstates, it is possible to protect it from the most dangerous decoherence source - charge fluctuations in the environment. We investigate\nthe measurement setup, where the SCB is coupled to a lumped element LCoscillator whose resonance frequency is orders of magnitude smaller than the qubit energy splitting. In this regime the SCB will act as an effective positive or negative capacitance, depending on the quantum state. This quantum capacitance then shifts the oscillator resonance frequency, which can be detected in a homodyne phase measurement.\n\nWe have found that reading out a charge qubit by measuring its quantum\ncapacitance in this manner is quantum limited, independently of the oscillator\nquality factor Q. Moreover, we have found that the low-Q oscillator\nis advantageous for the measurement in two ways: first, such an oscillator\nbetter protects the qubit from thermal dephasing, and, second, it allows to\nincrease the speed of the read-out, making it possible to distinguish the qubit states in a single shot measurement.

•Jan 1, 2007•0 citations

Single-shot readout of a superconducting flux qubit with a flux-driven Josephson parametric amplifier

Z. R. Lin, K. Inomata, William D. Oliver +4 more

We report single-shot readout of a superconducting flux qubit by using a flux-driven Josephson parametric amplifier (JPA). After optimizing the readout power, gain of the JPA, and timing of the data acquisition, we observe the Rabi oscillations with a contrast of 74%, which is mainly limited by the bandwidth of the JPA and the energy relaxation of the qubit. The observation of quantum jumps between the qubit eigenstates under continuous monitoring indicates the nondestructiveness of the readout scheme.

arXiv:1309.6706•Applied Physics Letters•Sep 23, 2013•83 citations

Superconducting Qubits: Charge read-out and backaction

Andreas Käck

For quantum computers to become reality, not only do the qubits have to be carefully engineered to be well isolated during operation time, but this also puts great strain on the measurement setup. We have looked at the backaction from a single-electron transistor (SET), operated both in the normal and in the superconducting state, on a single Cooper-pair box qubit. We have also designed a new read-out setup for a flux qubit using a Cooper-pair transistor that would allow read-out at the flux degeneracy point. In the first case we calculate the mixing time and the influence on the qubit steady-state distribution. We find that the mixing time is larger than typical experimental measurement times, indicating the possibility of single shot read-out. For the steady-state distribution of the qubit, we calculate the Coulomb staircase, finding additional structure due to the noise in the SET. For the flux qubit we design a read-out scheme involving a quantum flip-flop process, where the measurement outcome results in the presence or absence of an incoherent tunneling process. We estimate read-out and mixing times and find that single shot read-out should be achievable.

•Jan 1, 2004•0 citations

Single-shot measurement of the Josephson charge qubit

O. V. Astafiev, Yu. A. Pashkin, Tsuyoshi Yamamoto +2 more

We demonstrate single-shot readout of quantum states of the Josephson charge qubit. The quantum bits are transformed into and stored as classical bits (charge quanta) in a dynamic memory cell---a superconducting island. The transformation of state $|1〉$ (differing form state $|0〉$ by an extra Cooper pair) is a result of a controllable quasiparticle tunneling to the island. The charge is then detected by a conventional single-electron transistor, electrostatically decoupled from the qubit. We study relaxation dynamics in the system and obtain the readout efficiency of 87% and 93% for $|1〉$ and $|0〉$ states, respectively.

arXiv:cond-mat/0402619•Physical Review B•May 12, 2004•81 citations

Superconducting qubits : survey and theoretical investigations for solid state quantum computing

Santosh Kumar Gupta

Superconducting qubits have in recent years become a promising candidate for the implementation of a quantum computer due to their design flexibility, good protection from decohering elementary excitations, and availability of well developed fabrication and measurement techniques. Superconducting flux qubits, for which the effect of offset charge noise is reduced due to the fact that the Josephson energy dominates over the charging energy, correspond to one of the proposed means of designing a superconducting qubit. A nonlinear dispersive readout scheme of flux qubits involving a DC SQUID magnetometer that avoids the effects of on-chip dissipation can be readily implemented, yielding high contrast output for single qubit readout. Coupling schemes via nonlinear Josephson elements have also been realized. On the other hand, while the means of isolating superconducting qubits from external noise sources has been found, the mechanisms by which they undergo relaxation and decoherence due to intrinsic noise sources in the junctions themselves are not very well understood, and the question of how to deal with these noise sources remains unanswered in the general case. Other questions deal with the problem of experimentally observing entanglement in an array of coupled superconducting qubits, and finding the means by which the existence of entanglement in a typical laboratory setup may to some extent be verified by measurements on a global scale. Following a brief introductory review, we will first investigate the influence of a Two-Level Fluctuator on a DC SQUID driven by a finite current bias. Then we introduce a directly measurable signature of multiqubit entanglement for a large system of qubits and show that it is compatible to a recently introduced measure of global entanglement.

•Jan 1, 2010•0 citations

Single-Shot Readout of Macroscopic Quantum Superposition State in a Superconducting Flux Qubit

Hirotaka Tanaka, Shiro Saito, Hayato Nakano +3 more

Single-shot readout experiments were performed on the two lowest-energy states of a superconducting qubit with three Josephson junctions embedded in a superconducting loop. We measured the qubit state via switching current Isw of a current-biased dc-SQUID, a quantum detector surrounding the qubit loop. The qubit signals were measured in a small Isw regime of the SQUID, typically less than 100 nA, where the Isw distribution is particularly narrow. The obtained single-shot data indicate that the qubit state is readout, through the flux generated by the qubit persistent-current, as energy eigenstates rather than current eigenstates.

arXiv:cond-mat/0407299•Jul 12, 2004•8 citations
We study a readout scheme of a superconducting flux qubit state with a Cooper pair box as a transmon. The qubit states consist of the superpositions of two degenerate states where the charge and phase degrees of freedom are entangled. Owing to the robustness of the transmon against external fluctuations, our readout scheme enables the quantum non-demolition and single-shot measurement of flux qubit states. The qubit state readout can be performed by using the nonlinear Josephson amplifiers after a π/2 rotation driven by an ac electric field.
In this work we consider measurements on quantum systems emphasizing\non read-out of superconducting qubits. The qubit is always coupled to an\nenvironment, containing a macroscopic number of degrees of freedom. This\nperturbs the qubit and destroys the phase coherence of the quantum state.\nOne tries to minimize this destructive effect by encoding the quantum information in quantum states which do not couple strongly to the dominant\nnoise sources. It is therefore necessary to design read-out methods that can\ndistinguish these states.\n\nWe focus primarily on the single Cooper-pair box (SCB) charge qubit, whose\nproperties are based on the Josephson effect and Coulumb blockade in superconducting electrical circuits. By encoding the information in the qubit\nenergy eigenstates, it is possible to protect it from the most dangerous decoherence source - charge fluctuations in the environment. We investigate\nthe measurement setup, where the SCB is coupled to a lumped element LCoscillator whose resonance frequency is orders of magnitude smaller than the qubit energy splitting. In this regime the SCB will act as an effective positive or negative capacitance, depending on the quantum state. This quantum capacitance then shifts the oscillator resonance frequency, which can be detected in a homodyne phase measurement.\n\nWe have found that reading out a charge qubit by measuring its quantum\ncapacitance in this manner is quantum limited, independently of the oscillator\nquality factor Q. Moreover, we have found that the low-Q oscillator\nis advantageous for the measurement in two ways: first, such an oscillator\nbetter protects the qubit from thermal dephasing, and, second, it allows to\nincrease the speed of the read-out, making it possible to distinguish the qubit states in a single shot measurement.
We report single-shot readout of a superconducting flux qubit by using a flux-driven Josephson parametric amplifier (JPA). After optimizing the readout power, gain of the JPA, and timing of the data acquisition, we observe the Rabi oscillations with a contrast of 74%, which is mainly limited by the bandwidth of the JPA and the energy relaxation of the qubit. The observation of quantum jumps between the qubit eigenstates under continuous monitoring indicates the nondestructiveness of the readout scheme.
For quantum computers to become reality, not only do the qubits have to be carefully engineered to be well isolated during operation time, but this also puts great strain on the measurement setup. We have looked at the backaction from a single-electron transistor (SET), operated both in the normal and in the superconducting state, on a single Cooper-pair box qubit. We have also designed a new read-out setup for a flux qubit using a Cooper-pair transistor that would allow read-out at the flux degeneracy point. In the first case we calculate the mixing time and the influence on the qubit steady-state distribution. We find that the mixing time is larger than typical experimental measurement times, indicating the possibility of single shot read-out. For the steady-state distribution of the qubit, we calculate the Coulomb staircase, finding additional structure due to the noise in the SET. For the flux qubit we design a read-out scheme involving a quantum flip-flop process, where the measurement outcome results in the presence or absence of an incoherent tunneling process. We estimate read-out and mixing times and find that single shot read-out should be achievable.
We demonstrate single-shot readout of quantum states of the Josephson charge qubit. The quantum bits are transformed into and stored as classical bits (charge quanta) in a dynamic memory cell---a superconducting island. The transformation of state ∣1〉|1〉∣1〉 (differing form state ∣0〉|0〉∣0〉 by an extra Cooper pair) is a result of a controllable quasiparticle tunneling to the island. The charge is then detected by a conventional single-electron transistor, electrostatically decoupled from the qubit. We study relaxation dynamics in the system and obtain the readout efficiency of 87% and 93% for ∣1〉|1〉∣1〉 and ∣0〉|0〉∣0〉 states, respectively.
Superconducting qubits have in recent years become a promising candidate for the implementation of a quantum computer due to their design flexibility, good protection from decohering elementary excitations, and availability of well developed fabrication and measurement techniques. Superconducting flux qubits, for which the effect of offset charge noise is reduced due to the fact that the Josephson energy dominates over the charging energy, correspond to one of the proposed means of designing a superconducting qubit. A nonlinear dispersive readout scheme of flux qubits involving a DC SQUID magnetometer that avoids the effects of on-chip dissipation can be readily implemented, yielding high contrast output for single qubit readout. Coupling schemes via nonlinear Josephson elements have also been realized. On the other hand, while the means of isolating superconducting qubits from external noise sources has been found, the mechanisms by which they undergo relaxation and decoherence due to intrinsic noise sources in the junctions themselves are not very well understood, and the question of how to deal with these noise sources remains unanswered in the general case. Other questions deal with the problem of experimentally observing entanglement in an array of coupled superconducting qubits, and finding the means by which the existence of entanglement in a typical laboratory setup may to some extent be verified by measurements on a global scale. Following a brief introductory review, we will first investigate the influence of a Two-Level Fluctuator on a DC SQUID driven by a finite current bias. Then we introduce a directly measurable signature of multiqubit entanglement for a large system of qubits and show that it is compatible to a recently introduced measure of global entanglement.
Single-shot readout experiments were performed on the two lowest-energy states of a superconducting qubit with three Josephson junctions embedded in a superconducting loop. We measured the qubit state via switching current Isw of a current-biased dc-SQUID, a quantum detector surrounding the qubit loop. The qubit signals were measured in a small Isw regime of the SQUID, typically less than 100 nA, where the Isw distribution is particularly narrow. The obtained single-shot data indicate that the qubit state is readout, through the flux generated by the qubit persistent-current, as energy eigenstates rather than current eigenstates.