We report on the high-frequency mixing properties of ion irradiated YBa2Cu3O7 Josephson junctions. The frequency range, spanning above and below the characteristic frequencies fc of the junctions, permits a clear observation of the transition between two mixing regimes. The experimental conversion gain was found to be in good agreement with the prediction of the three-port model. Finally, we discuss the potential of the junctions to build a Josephson mixer operating in the terahertz frequency range.
We report on the high-frequency mixing properties of ion irradiated YBa2Cu3O7 Josephson junctions. The frequency range, spanning above and below the characteristic frequencies fc of the junctions, permits a clear observation of the transition between two mixing regimes. The experimental conversion gain was found to be in good agreement with the prediction of the three-port model. Finally, we discuss the potential of the junctions to build a Josephson mixer operating in the terahertz frequency range.
We report on an experimental and theoretical study of the high-frequency mixing properties of ion-irradiated YBa2Cu3O7 Josephson junctions embedded in THz antennas. We investigated the influence of the local oscillator power and frequency on the device performances. The experimental data are compared with theoretical predictions of the general three-port model for mixers in which the junction is described by the resistively shunted junction model. A good agreement is obtained for the conversion efficiency in different frequency ranges, spanning above and below the characteristic frequencies fc of the junctions.
We report on an experimental and theoretical study of the high-frequency mixing properties of ion-irradiated YBa2Cu3O7 Josephson junctions embedded in THz antennas. We investigated the influence of the local oscillator power and frequency on the device performances. The experimental data are compared with theoretical predictions of the general three-port model for mixers, in which the junction is described by the resistively shunted junction model. A good agreement is obtained for the conversion efficiency in different frequency ranges, spanning above and below the characteristic frequencies fc of the junctions.
The terahertz region of the electromagnetic spectrum [0.3-10THz] has, so far, not been exploited fully due to the lack of suitable sources and detectors. Indeed, THz frequency lies between the frequency range of traditional electronics and photonics where the existing technology cannot be simply extended. SIS Niobium tunnel junctions that are currently used as mixing element in heterodyne receivers are intrinsically limited in frequency by the energy gap of Nb and operate only at low temperature (4.2K). An alternative to these devices consists of using High-Tc superconducting receivers. Over the past years, we have developed a new approach based on ion irradiation to make Josephson nano-junctions and SQUIDs with YBCO thin films [1,2]. In this talk, we will present a study of the high-frequency mixing properties of such junctions up to 400 GHz [3]. Conversion gain has been measured at frequencies spanning the range below and above the characteristic frequency fc = (2e/h)IcRn of the junctions. The transition between two distinct mixing regimes has been clearly evidenced, in good agreement with the prediction of the three ports model.[1] N. Bergeal et al., Appl. Phys. Lett. 87, 102502 (2005)[2] N. Bergeal et al., Appl. Phys. Lett. 89, 1112515 (2006)[3] Luo et al, arXiv:1203.1734 (2012)
We report on the mixing properties of high-T, superconductor (HTS) Josephson junctions. Direct radiation and heterodyne mixing experiments in the frequency range 78 GHz-119 GHz have been performed using YBa 2Cu30 7_ x (YBCO) step-edge junctions (SEJ) and bicrystal junctions (BO) on LaA10 3 and MgO substrates. Under external radiation our junctions showed harmonic phase synchronization (Shapiro steps) up to 1.88 THz. Junctions with current voltage characteristics (PVC) dose to predictions of the resistively shunted junction model (RSJ) were mounted into a heterodyne mixing setup. Under the radiation of two monochromatic signals we obtained conversion efficiencies around -14 dB in the 11 GHz intermediate frequency (IF) band. In the fundamental mixing regime we observed response at IF at working temperatures up to 72K. We demonstrated the operation of HTS Josephson junctions in the self-mixing mode. The experimental results are in good agreement with simulations using the RSJ model.
This chapter discusses the high sensitivity superconducting mixers, i.e. detectors used in heterodyne receivers. Today, there are essentially two very successful concepts of superconducting mixers, or frequency down-converters, the superconductor-insulator-superconductor tunnel junction SIS mixer and the superconducting hot-electron bolometer mixer. Moving up to higher frequencies in the microwave and millimeter wave electromagnetic spectra makes it more and more difficult to retrieve a good signal-to-noise ratio with ordinary solid-state amplifiers. The driving force for using superconducting mixers is their excellent down-conversion efficiency and capability to down-convert RF signals from microwave frequencies up to the terahertz region. The main purpose of a receiver is to pick up and amplify a weak signal, which can then be accurately determined in amplitude and phase. The mixer noise temperature and conversion gain are the most important parameters for the mixing device. The Josephson junction mixer was one of the first suggested devices based on superconducting point contacts and later tunnel junctions.
NOTE: Text or symbols not renderable in plain ASCII are indicated by [...]. Abstract is included in .pdf document. This thesis describes both theoretical and experimental investigations into the dynamics and noise processes of Josephson junctions, with the intent of evaluating their potential as mixers in heterodyne instruments for submillimeter-wave (i.e., the frequency range from 300 GHz to 3THz) detection. Superconducting tunnel junctions utilizing the nonlinearity due to photon-assisted tunneling of quasiparticles (SIS mixers) have become the state-of-the-art technology for sensitive heterodyne detection up to frequencies of about 700 [...]. Recent progress in the fabrication of high [...], superconductors has led to Josephson-effect devices with [...] products of up to ten millivolts, which might be suitable for mixing at frequencies of many terahertz. The key question for weighing the prospects for high-frequency Josephson mixers is that of the sensitivity which can be attained. Previous experimental work on Josephson mixing suggests the existence of an "excess" noise, which degrades the sensitivity. Theoretical modeling of mixer performance, based on the resistivelyshunted junction (RSJ) model for the dynamics of the device, also indicates the presence of larger noise than expected. The origin of this noise was not clearly understood, however, nor was its exact magnitude or expected scaling with frequency or junction characteristics known. In addition, previous experiments utilized crude devices of the point-contact type, which were unstable and thus undesirable for real applications. In the first part of this thesis research, extensive numerical simulations were performed with the RSJ model, including calculations of mixer noise and conversion efficiency. These calculations have revealed that the source of excess noise is the AC Josephson oscillations of the device, which can be completely incoherent, with a linewidth comparable to their frequency. Thus they appear as a broadband noise source. While this noise is intrinsic and unavoidable, an optimized mixer is still shown to be capable of interesting sensitivity levels, and the excess noise is expected to become relatively less important as the operating frequency is increased. Secondly, a process has been developed for the fabrication of stable, well-characterized, and reproducible Josephson devices based on resistively-shunted Nb and NbN tunnel junctions. The devices utilize submicron-area, high current-density tunnel junctions and a AuGe shunt resistor to yield completely non-hysteretic I-V curves, normal-state resistances of about [...] products of about half a millivolt. These devices should be nearly optimal for mixing at [...]. Heterodyne measurements using these junctions have been performed in a waveguide mixer mount. Receiver temperatures as low as 190 K (DSB), with -6 dB conversion efficiency, have been obtained at 100 [...], but these results are still a factor of about four higher than those predicted by the RSJ simulations. Accurate measurements of the available noise power of the junctions at the intermediate frequency of 1.5 [...] were made, and confirmed that the receivers were limited by elevated junction output noise. The deviations of the noise from theoretical predictions are shown to be caused by the nonlinear interaction of the junction with the embedding circuit. While this work points out some of the complexity introduced by the strong nonlinearity of Josephson devices, it is still expected that Josephson-effect mixers may be useful for heterodyne detection at very high frequencies.