Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:1008.5292

Hyperfine spectroscopy using co-propagating pump-probe beams

Alok K. Singh, Sapam Ranjita Chanu, Dipankar Kaundilya, Vasant Natarajan A

Published Aug 31, 2010• 0 citations
arXivHTMLPDF

Abstract

We have shown earlier that hyperfine spectroscopy in a vapor cell using co-propagating pump-probe beams has many advantages over the usual technique of saturated-absorption spectroscopy using counter-propagating beams. The main advantages are the absence of crossover resonances, the appearance of the signal on a flat (Doppler-free) background, and the higher signal-to-noise ratio of the primary peaks. Interaction with non-zero-velocity atoms causes additional peaks, but only one of them appears within the primary spectrum. We first illustrate the advantages of this technique for high-resolution spectroscopy by studying the $D_2$ line of Rb. We then use an acousto-optic modulator (AOM) for frequency calibration to make precise hyperfine-interval measurements in the first excited $P_{3/2}$ state of $^{85,87}$Rb and $^{133}$Cs.

DOI
10.48550/arxiv.1008.5292

Related papers

Saturated-absorption spectroscopy: eliminating crossover resonances by use of copropagating beams

Ayan Banerjee, Vasant Natarajan A

We demonstrate a new technique for saturated-absorption spectroscopy by use of copropagating beams that does not have the problem of crossover resonances. The pump beam is locked to a transition, and its absorption signal is monitored while the probe beam is scanned. As the probe comes into resonance with another transition, the pump absorption is reduced and the signal shows a Doppler-free dip. We use this technique to measure hyperfine intervals in the D2 line of 85Rb with a precision of 70 kHz and to resolve hyperfine levels in the D2 line of 39K that are less than 10 MHz apart.

arXiv:physics/0307095•Optics Letters•Oct 15, 2003•58 citations

Measuring the Hyperfine Splittings of Lowest Energy Atomic Transitions in Rubidium

Benjamin Graber

The goal of this experiment was to measure the hyperfine energy splittings of the ground to first excited state transitions in rubidium using saturated absorption spectroscopy. Using this technique, we measured these transition energy spectra by taking the difference of two photodiode outputs due to multiple beams of a single laser scanned over a range of frequencies and shone through a cell of Rb vapor. When the laser frequency was resonant with an atomic transition, photons of those frequencies were absorbed, leaving a dip in intensity of the beam measured at the photodiode. One of the two laser beams had its excitations saturated by a more intense, counter-propagating pump beam from the same laser. The pump beam saturated the absorption of the velocity equal zero atoms that the counter-propagating probe beam could have also interacted with due to no Doppler shift. At these frequencies the probe beam experienced less absorption that was measured by a photodiode. The photodiode output was calibrated to the change in frequency of the scanned laser using a Fabry-Pérot interferometer. The output of this interferometer served as a reference for how the laser frequency changed. Final results for the 87Rb F=1 spectrum accounted for the largest error with a maximum of 12.2% deviation from accepted energy spacing values due in part to systematic error. Other spectra measurements were in better agreement, possessing error ranging from 2.1% to 10.1% and some agreeing with accepted values to within our uncertainty.

•Jan 1, 2015•0 citations

Optical pumping spectroscopy of Rb vapour with co-propagating laser beams: line identification by a simple theoretical model

Aleksandar J. Krmpot, Mihailo D. Rabasović, Branislav M. Jelenkovic

In this paper the saturation spectra of rubidium vapour at room temperature, obtained with overlapped co-propagating laser beams, were examined. Unlike the standard saturation spectroscopy, here the transmission of the pump laser beam was detected. The pump laser was locked to an atomic transition of the D2 line, while the probe laser frequency was scanned in a wide frequency range. The pump and probe beams had approximately the same intensities; thus the probe laser can saturate transitions and contribute to optical pumping. This, together with Doppler broadening, leads to rich pump transmission spectra, with many lines appearing due to the interaction of lasers with atoms in different velocity groups. The advantages of this method are well-resolved structures and appearance of spectral lines on a flat, Doppler-free background. Agreement between experimental and theoretical results shows the usefulness of this simple model, based on the rate equations, for identification of lines and determination of relative contribution to the observed line intensity from atoms with different velocities. Theoretical spectra are a useful tool for the calibration of experimental spectra obtained by a nonlinear dependence of the laser frequency on the voltage applied to the piezo used for the laser diode frequency scanning.

Journal of Physics B Atomic Molecular and Optical Physics•Jun 14, 2010•5 citations

Doppler-free spectroscopy of rubidium atoms driven by a control laser

Zheng Tan, Xiuchao Zhao, Yong Cheng +5 more

A scheme of Doppler-free spectroscopy is experimentally demonstrated with a co-propagating control laser locking to an atomic hyperfine transition, and the differential transmission of the probe and the reference laser is detected. Crossover resonances are eliminated by selecting the class of atoms with zero velocity in the direction of beam propagation. In addition, the sub-Doppler spectrum experiences optical gain compared to the conventional saturated-absorption spectrum as a result of optical pumping.

Frontiers of Physics•Jul 7, 2011•0 citations

Comparison of absorption, fluorescence, and polarization spectroscopy of atomic rubidium

Seth Ashman, C. Stifler, Joaquín Romero

An ongoing spectroscopic investigation of atomic rubidium utilizes a two-photon, single-laser excitation process. Transitions accessible with our tunable laser include 5P1/2 (F ′ ) ← 5S1/2 (F) and 5P3/2 (F ′ ) ← 5S1/2 (F). The laser is split into a pump and probe beam to allow for Doppler-free measurements of transitions between hyperfine levels. The pump and probe beams are overlapped in a counter-propagating geometry and the laser frequency scans over a transition. Absorption, fluorescence and polarization spectroscopy techniques are applied to this basic experimental setup. The temperature of the vapor cell and the power of the pump and probe beams have been varied to explore line broadening effects and signal-to-noise of each technique. This humble setup will hopefully grow into a more robust experimental arrangement in which double resonance, two-laser excitations are used to explore hyperfine state changing collisions between rubidium atoms and noble gas atoms. Rb-noble gas collisions can transfer population between hyperfine levels, such as 5P3/2 (F ′ = 3) Collision ←− 5P3/2 (F ′ = 2), and the probe beam couples 7S1/2 (F ′′ = 2) ← 5P3/2 (F ′ = 3). Polarization spectroscopy signal depends on the rate of population transfer due to the collision as well as maintaining the orientation created by the pump laser. Fluorescence spectroscopy relies only on transfer of population due to the collision. Comparison of these techniques yields information regarding the change of the magnetic sublevels, mF , during hyperfine state changing collisions.

Bulletin of the American Physical Society•Jun 11, 2015•0 citations

Hyperfine spectroscopy on the 6 P 3/2 state of 133 Cs using coherent control

Dipankar Das, Vasant Natarajan A

We show that coherent-control techniques are uniquely suited for high-resolution hyperfine spectroscopy. We apply this method to a V-type system in the D 2 line of 133 Cs The spectrum of a weak probe beam shows Doppler-free transparency peaks when the strong control beam is resonant with a neighboring hyperfine transition. The lineshape and linewidth are consistent with theoretical calculations. Using an acousto-optic modulator to calibrate the frequency of the control beam, we measure hyperfine intervals in the 6 P 3/2 state with an accuracy of 6 kHz. The measurement is important because there is a large discrepancy between two earlier measurements on this state.

Europhysics Letters (EPL)•Nov 3, 2005•33 citations
We have shown earlier that hyperfine spectroscopy in a vapor cell using co-propagating pump-probe beams has many advantages over the usual technique of saturated-absorption spectroscopy using counter-propagating beams. The main advantages are the absence of crossover resonances, the appearance of the signal on a flat (Doppler-free) background, and the higher signal-to-noise ratio of the primary peaks. Interaction with non-zero-velocity atoms causes additional peaks, but only one of them appears within the primary spectrum. We first illustrate the advantages of this technique for high-resolution spectroscopy by studying the D2D_2D2​ line of Rb. We then use an acousto-optic modulator (AOM) for frequency calibration to make precise hyperfine-interval measurements in the first excited P3/2P_{3/2}P3/2​ state of 85,87^{85,87}85,87Rb and 133^{133}133Cs.
We demonstrate a new technique for saturated-absorption spectroscopy by use of copropagating beams that does not have the problem of crossover resonances. The pump beam is locked to a transition, and its absorption signal is monitored while the probe beam is scanned. As the probe comes into resonance with another transition, the pump absorption is reduced and the signal shows a Doppler-free dip. We use this technique to measure hyperfine intervals in the D2 line of 85Rb with a precision of 70 kHz and to resolve hyperfine levels in the D2 line of 39K that are less than 10 MHz apart.
The goal of this experiment was to measure the hyperfine energy splittings of the ground to first excited state transitions in rubidium using saturated absorption spectroscopy. Using this technique, we measured these transition energy spectra by taking the difference of two photodiode outputs due to multiple beams of a single laser scanned over a range of frequencies and shone through a cell of Rb vapor. When the laser frequency was resonant with an atomic transition, photons of those frequencies were absorbed, leaving a dip in intensity of the beam measured at the photodiode. One of the two laser beams had its excitations saturated by a more intense, counter-propagating pump beam from the same laser. The pump beam saturated the absorption of the velocity equal zero atoms that the counter-propagating probe beam could have also interacted with due to no Doppler shift. At these frequencies the probe beam experienced less absorption that was measured by a photodiode. The photodiode output was calibrated to the change in frequency of the scanned laser using a Fabry-Pérot interferometer. The output of this interferometer served as a reference for how the laser frequency changed. Final results for the 87Rb F=1 spectrum accounted for the largest error with a maximum of 12.2% deviation from accepted energy spacing values due in part to systematic error. Other spectra measurements were in better agreement, possessing error ranging from 2.1% to 10.1% and some agreeing with accepted values to within our uncertainty.
In this paper the saturation spectra of rubidium vapour at room temperature, obtained with overlapped co-propagating laser beams, were examined. Unlike the standard saturation spectroscopy, here the transmission of the pump laser beam was detected. The pump laser was locked to an atomic transition of the D2 line, while the probe laser frequency was scanned in a wide frequency range. The pump and probe beams had approximately the same intensities; thus the probe laser can saturate transitions and contribute to optical pumping. This, together with Doppler broadening, leads to rich pump transmission spectra, with many lines appearing due to the interaction of lasers with atoms in different velocity groups. The advantages of this method are well-resolved structures and appearance of spectral lines on a flat, Doppler-free background. Agreement between experimental and theoretical results shows the usefulness of this simple model, based on the rate equations, for identification of lines and determination of relative contribution to the observed line intensity from atoms with different velocities. Theoretical spectra are a useful tool for the calibration of experimental spectra obtained by a nonlinear dependence of the laser frequency on the voltage applied to the piezo used for the laser diode frequency scanning.
A scheme of Doppler-free spectroscopy is experimentally demonstrated with a co-propagating control laser locking to an atomic hyperfine transition, and the differential transmission of the probe and the reference laser is detected. Crossover resonances are eliminated by selecting the class of atoms with zero velocity in the direction of beam propagation. In addition, the sub-Doppler spectrum experiences optical gain compared to the conventional saturated-absorption spectrum as a result of optical pumping.
An ongoing spectroscopic investigation of atomic rubidium utilizes a two-photon, single-laser excitation process. Transitions accessible with our tunable laser include 5P1/2 (F ′ ) ← 5S1/2 (F) and 5P3/2 (F ′ ) ← 5S1/2 (F). The laser is split into a pump and probe beam to allow for Doppler-free measurements of transitions between hyperfine levels. The pump and probe beams are overlapped in a counter-propagating geometry and the laser frequency scans over a transition. Absorption, fluorescence and polarization spectroscopy techniques are applied to this basic experimental setup. The temperature of the vapor cell and the power of the pump and probe beams have been varied to explore line broadening effects and signal-to-noise of each technique. This humble setup will hopefully grow into a more robust experimental arrangement in which double resonance, two-laser excitations are used to explore hyperfine state changing collisions between rubidium atoms and noble gas atoms. Rb-noble gas collisions can transfer population between hyperfine levels, such as 5P3/2 (F ′ = 3) Collision ←− 5P3/2 (F ′ = 2), and the probe beam couples 7S1/2 (F ′′ = 2) ← 5P3/2 (F ′ = 3). Polarization spectroscopy signal depends on the rate of population transfer due to the collision as well as maintaining the orientation created by the pump laser. Fluorescence spectroscopy relies only on transfer of population due to the collision. Comparison of these techniques yields information regarding the change of the magnetic sublevels, mF , during hyperfine state changing collisions.
We show that coherent-control techniques are uniquely suited for high-resolution hyperfine spectroscopy. We apply this method to a V-type system in the D 2 line of 133 Cs The spectrum of a weak probe beam shows Doppler-free transparency peaks when the strong control beam is resonant with a neighboring hyperfine transition. The lineshape and linewidth are consistent with theoretical calculations. Using an acousto-optic modulator to calibrate the frequency of the control beam, we measure hyperfine intervals in the 6 P 3/2 state with an accuracy of 6 kHz. The measurement is important because there is a large discrepancy between two earlier measurements on this state.