Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:0908.1662 · Physical Review A

Measuring arbitrary-order coherences: Tomography of single-mode multiphoton polarization-entangled states

U. Schilling, Joachim von Zanthier, G. S. Agarwal

Published Jan 26, 2010• 29 citations
arXivHTMLPDF

Abstract

A scheme is discussed for measuring $N$th-order coherences of two orthogonally polarized light fields in a single spatial mode at very limited experimental cost. To implement the scheme, the only measurements needed are the $N$th-order intensity moments after the light beam has passed through two quarter-wave plates, one half-wave plate, and a polarizing beam splitter for specific settings of the wave plates. It is shown that this method can be applied for arbitrarily large $N$. A set of explicit values is given for the settings of the wave plates, constituting an optimal measurement of the $N$th-order coherences for any $N$. For Fock states the method introduced here corresponds to a full state tomography. Applications of the scheme to systems other than polarization optics are discussed.

DOI
10.1103/physreva.81.013826

Related papers

Measurements in Quantum Optics

U. Schilling

This thesis fathoms the possibilities and limitations of measurements in quantum optics. After a short introduction to the general aspects of measurements in quantum mechanics, it presents three examples of a measurement process in concrete applications to quantum optics. For one, while operators describing quantities of interest might have a simple theoretical form, it is often hard to actually implement a measurement of their expectation values experimentally. This situation is encountered in the first part which is devoted to the measurement of quantum statistical properties of a light beam. In contrast to classical optics, these statistics are not fully determined by first- and second-order correlations. Instead, higher-order correlations, usually described by non-Hermitian operators, are necessary to characterize the quantum state completely. A particular example is the N-photon Fock state, for which only a measurement of the Nth-order correlations allows for a full characterization. Here, we present a new method how to measure an important class of Nth-order correlations for arbitrary N in a single spatial mode with two polarizations with limited experimental resources. The second part is again centered around the realization of specific measurement operators for photon correlation measurements. However, in contrast to the previous chapter, these measurements are not an end in their own, but are designed to create specific quantum states as a consequence of the measurement process: A suitable measurement of photons emitted by a number of atoms allows to transfer the atoms into long-lived entangled states. We find that with this method it is possible to entangle two remote atomic qubits to an arbitrary and well-defined degree. Furthermore, we show how to generate two families of quantum states in an arbitrary number of remote atomic qubits: one family consists of all -- symmetric and non-symmetric -- total angular momentum eigenstates in N remote qubits, the other is a family of cluster states. It is also systematically investigated whether the technique of quantum state engineering by projective measurements allows for the creation of any arbitrary state. We find explicit solutions for the case of two and three qubits, while it is shown that no solution exist for N > 6. We conclude the section by proving that with some changes in the setup, this measurement-based quantum state engineering technique allows to create the same states among the scattered photons themselves rather than among the emitting atoms. The last part is devoted to the amount of information one is able to gain about a given system when performing a measurement. The corresponding limits of information are investigated at the example of the duality that arises in a two-way interferometer between the visibility of the interference pattern and the knowledge about the path of the interfering object. We show that there exist correlations between the phase difference the interfering object acquires on its way through the interferometer and the amount of which-way information retrievable from certain observables of the which-way detector. In this way, the which-way information becomes a phase-dependent quantity. In particular, we find that for certain values of the phase shift, the amount of extractable which-way information can be larger than allowed by phase-independent measurement. This property is put to use to find the optimal observable for the which-way detector readout in dependence on the phase of the interfering object. Following this strategy, we are able to gain more which-way information than previously thought possible.

•Oct 24, 2011•0 citations

From polarization multipoles to higher-order coherences

Aaron Z. Goldberg, A. B. Klimov, Hubert de Guise +3 more

We demonstrate that the multipoles associated with the density matrix are truly observable quantities that can be unambiguously determined from intensity moments. Given their correct transformation properties, these multipoles are the natural variables to deal with a number of problems in the quantum domain. In the case of polarization, the moments are measured after the light has passed through two quarter-wave plates, one half-wave plate, and a polarizing beam splitter for specific values of the angles of the wave plates. For more general two-mode problems, equivalent measurements can be performed.

arXiv:2109.04474•Optics Letters•Dec 13, 2021•7 citations

Fourier-transform quantum state tomography

Mohammadreza Mohammadi, Agata M. Brańczyk, Daniel F. V. James

We propose a technique for performing quantum state tomography of photonic polarization-encoded multiqubit states. Our method uses a single rotating wave plate, a polarizing beam splitter, and two photon-counting detectors per photon mode. As the wave plate rotates, the photon counters measure a pseudocontinuous signal which is then Fourier transformed. The density matrix of the state is reconstructed using the relationship between the Fourier coefficients of the signal and the Stokes' parameters that represent the state. The experimental complexity, i.e., different wave plate rotation frequencies, scales linearly with the number of qubits.

arXiv:1211.1399•Physical Review A•Jan 17, 2013•12 citations

Central-moment description of polarization for quantum states of light

Gunnar G. Bjork, Jonas Söderholm, Yong Soo Kim +6 more

We present a moment expansion for the systematic characterization of the polarization properties of quantum states of light. Specifically, we link the method to the measurements of the Stokes operator in different directions on the Poincar\'e sphere and provide a scheme for polarization tomography without resorting to full-state tomography. We apply these ideas to the experimental first- and second-order polarization characterization of some two-photon quantum states. In addition, we show that there are classes of states whose polarization characteristics are dominated not by their first-order moments (i.e., the Stokes vector) but by higher-order polarization moments.

arXiv:1111.5512•Physical Review A•May 25, 2012•18 citations

Single Photon Entangled State Tomography in a Single Measurement Setup

Ron Ziv, Roey Shafran, Mordechai Segev

We propose a method for reconstructing density matrices of single-photon OAM-polarization entangled states using a single intensity measurement, facilitated by coupling the state to higher-order OAM modes.

•Jan 1, 2024•0 citations

Any DOF All at Once: Single Photon State Tomography in a Single Measurement Setup

Roey Shafran, Ron Ziv, Mordechai Segev

Photonic quantum technologies utilize various degrees of freedom (DOFs) of light, such as polarization, frequency, and spatial modes, to encode quantum information. In the effort of further improving channel capacity of quantum communication, and for increasing the complexity of available quantum operations, high-dimensional and hyperentangled states are now gaining interest. However, efficiently measuring these high dimensional states is challenging due to the large number of measurements required for reconstructing the full density matrix via quantum state tomography (QST), and the fact that each measurement requires some modification in the experimental setup. Here, we propose a framework for reconstructing the density matrix of a single-photon hyperentangled across multiple DOFs using a single intensity-measurement obtainable from traditional cameras, and discuss extensions for multiphoton hyperentangled states. Our method hinges on the spatial DOF of the photon and uses it to encode the quantum information from the other DOFs. We numerically demonstrate this method for single-photon OAM-spin and OAM-frequency entangled states using an ideal coupler and a multimode fiber, to perform the information mixing and transfer the encoding to spatial information, where it is detected using a simple camera. This technique simplifies the experimental setup and reduces acquisition time compared to traditional QST-based methods. Moreover, it allows the recovery of DOFs that conventional cameras cannot detect, such as polarization, thus eliminating the need for projection measurements.

quant-pharXiv:2512.22869•Optics Express•Dec 30, 2025•1 citation
A scheme is discussed for measuring NNNth-order coherences of two orthogonally polarized light fields in a single spatial mode at very limited experimental cost. To implement the scheme, the only measurements needed are the NNNth-order intensity moments after the light beam has passed through two quarter-wave plates, one half-wave plate, and a polarizing beam splitter for specific settings of the wave plates. It is shown that this method can be applied for arbitrarily large NNN. A set of explicit values is given for the settings of the wave plates, constituting an optimal measurement of the NNNth-order coherences for any NNN. For Fock states the method introduced here corresponds to a full state tomography. Applications of the scheme to systems other than polarization optics are discussed.
This thesis fathoms the possibilities and limitations of measurements in quantum optics. After a short introduction to the general aspects of measurements in quantum mechanics, it presents three examples of a measurement process in concrete applications to quantum optics. For one, while operators describing quantities of interest might have a simple theoretical form, it is often hard to actually implement a measurement of their expectation values experimentally. This situation is encountered in the first part which is devoted to the measurement of quantum statistical properties of a light beam. In contrast to classical optics, these statistics are not fully determined by first- and second-order correlations. Instead, higher-order correlations, usually described by non-Hermitian operators, are necessary to characterize the quantum state completely. A particular example is the N-photon Fock state, for which only a measurement of the Nth-order correlations allows for a full characterization. Here, we present a new method how to measure an important class of Nth-order correlations for arbitrary N in a single spatial mode with two polarizations with limited experimental resources. The second part is again centered around the realization of specific measurement operators for photon correlation measurements. However, in contrast to the previous chapter, these measurements are not an end in their own, but are designed to create specific quantum states as a consequence of the measurement process: A suitable measurement of photons emitted by a number of atoms allows to transfer the atoms into long-lived entangled states. We find that with this method it is possible to entangle two remote atomic qubits to an arbitrary and well-defined degree. Furthermore, we show how to generate two families of quantum states in an arbitrary number of remote atomic qubits: one family consists of all -- symmetric and non-symmetric -- total angular momentum eigenstates in N remote qubits, the other is a family of cluster states. It is also systematically investigated whether the technique of quantum state engineering by projective measurements allows for the creation of any arbitrary state. We find explicit solutions for the case of two and three qubits, while it is shown that no solution exist for N > 6. We conclude the section by proving that with some changes in the setup, this measurement-based quantum state engineering technique allows to create the same states among the scattered photons themselves rather than among the emitting atoms. The last part is devoted to the amount of information one is able to gain about a given system when performing a measurement. The corresponding limits of information are investigated at the example of the duality that arises in a two-way interferometer between the visibility of the interference pattern and the knowledge about the path of the interfering object. We show that there exist correlations between the phase difference the interfering object acquires on its way through the interferometer and the amount of which-way information retrievable from certain observables of the which-way detector. In this way, the which-way information becomes a phase-dependent quantity. In particular, we find that for certain values of the phase shift, the amount of extractable which-way information can be larger than allowed by phase-independent measurement. This property is put to use to find the optimal observable for the which-way detector readout in dependence on the phase of the interfering object. Following this strategy, we are able to gain more which-way information than previously thought possible.
We demonstrate that the multipoles associated with the density matrix are truly observable quantities that can be unambiguously determined from intensity moments. Given their correct transformation properties, these multipoles are the natural variables to deal with a number of problems in the quantum domain. In the case of polarization, the moments are measured after the light has passed through two quarter-wave plates, one half-wave plate, and a polarizing beam splitter for specific values of the angles of the wave plates. For more general two-mode problems, equivalent measurements can be performed.
We propose a technique for performing quantum state tomography of photonic polarization-encoded multiqubit states. Our method uses a single rotating wave plate, a polarizing beam splitter, and two photon-counting detectors per photon mode. As the wave plate rotates, the photon counters measure a pseudocontinuous signal which is then Fourier transformed. The density matrix of the state is reconstructed using the relationship between the Fourier coefficients of the signal and the Stokes' parameters that represent the state. The experimental complexity, i.e., different wave plate rotation frequencies, scales linearly with the number of qubits.
We present a moment expansion for the systematic characterization of the polarization properties of quantum states of light. Specifically, we link the method to the measurements of the Stokes operator in different directions on the Poincar\'e sphere and provide a scheme for polarization tomography without resorting to full-state tomography. We apply these ideas to the experimental first- and second-order polarization characterization of some two-photon quantum states. In addition, we show that there are classes of states whose polarization characteristics are dominated not by their first-order moments (i.e., the Stokes vector) but by higher-order polarization moments.
Photonic quantum technologies utilize various degrees of freedom (DOFs) of light, such as polarization, frequency, and spatial modes, to encode quantum information. In the effort of further improving channel capacity of quantum communication, and for increasing the complexity of available quantum operations, high-dimensional and hyperentangled states are now gaining interest. However, efficiently measuring these high dimensional states is challenging due to the large number of measurements required for reconstructing the full density matrix via quantum state tomography (QST), and the fact that each measurement requires some modification in the experimental setup. Here, we propose a framework for reconstructing the density matrix of a single-photon hyperentangled across multiple DOFs using a single intensity-measurement obtainable from traditional cameras, and discuss extensions for multiphoton hyperentangled states. Our method hinges on the spatial DOF of the photon and uses it to encode the quantum information from the other DOFs. We numerically demonstrate this method for single-photon OAM-spin and OAM-frequency entangled states using an ideal coupler and a multimode fiber, to perform the information mixing and transfer the encoding to spatial information, where it is detected using a simple camera. This technique simplifies the experimental setup and reduces acquisition time compared to traditional QST-based methods. Moreover, it allows the recovery of DOFs that conventional cameras cannot detect, such as polarization, thus eliminating the need for projection measurements.