Quantum transport in mesoscopic conductors is essentially governed by the laws of quantum mechanics. One of the major open questions of quantum mechanics is what happens if noncommuting observables are measured simultaneously. Since current operators at different times do not commute, the high-frequency correlation functions of the current are realization of this fundamental quantum question. We formulate this problem in the context of measurements of finite-frequency current cumulants in a general quantum point contact, which are the subject to ongoing experimental effort. To this end, we present two models of detectors that correspond to a weak time-resolved measurement of the electronic current in a mesoscopic junction. In both cases, the backaction of the detector leads to observable corrections to the current correlations functions involving the so-called noise susceptibilities. As a result, we propose a reinterpretation of environmental corrections to the finite-frequency cumulants as inevitable effect resulting from basic quantum mechanical principles. Finally we make concrete predictions for the temperature, voltage, and frequency dependence of the third cumulant, which could be verified directly using current experimental techniques.
The impossibility of measuring non-commuting quantum mechanical observables is one of the most fascinating consequences of the quantum mechanical postulates. Hence, to date the investigation of quantum measurement and projection is a fundamentally interesting topic. We propose to test the concept of weak measurement of non-commuting observables in mesoscopic transport experiments, using a quasiprobabilistic description. We derive an inequality for current correlators, which is satisfied by every classical probability but violated by high-frequency fourth-order cumulants in the quantum regime for experimentally feasible parameters. We further address the creation and detection of entanglement in solid-state electronics, which is of fundamental importance for quantum information processing. We propose a general test of entanglement based on the violation of a classically satisfied inequality for continuous variables by 4th or higher order quantum correlation functions. Our scheme provides a way to prove the existence of entanglement in a mesoscopic transport setup by measuring higher order cumulants without requiring the additional assumption of single charge detection.
The impossibility of measuring noncommuting quantum mechanical observables is one of the most fascinating consequences of the quantum mechanical postulates. Hence, to date the investigation of quantum measurement and projection is a fundamentally interesting topic. We propose to test the concept of weak measurement of noncommuting observables in mesoscopic transport experiments, using a quasiprobabilistic description. We derive an inequality for current correlators, which is satisfied by every classical probability but violated by high-frequency fourth-order cumulants in the quantum regime for experimentally feasible parameters.
The development of solid-state quantum technologies requires the understanding of quantum measurements in interacting, nonisolated quantum systems.In general, a permanent coupling of detectors to a quantum system leads to memory effects that have to be taken into account in interpreting the measurement results.In this thesis we develop a microscopic framework for correlations in non-Markovian weak measurements.A special point of interest are the different orders of quantum mechanical operators that appear naturally in such a scheme.First, we analyze a generic setup of two detectors coupled to a quantum system and derive a compact formula in the weak-measurement limit that interpolates between an instantaneous (text-book type) and almost continuous -detector dynamics-dependent -measurement.A quantum memory effect that we term system-mediated detector-detector interaction is crucial to observe noncommuting observables simultaneously.A response function of the observed system variables introduces an antisymmetric operator order to the total result.We propose a mesoscopic double-dot detector setup in which the memory effect is tunable and that can be used to explore the transition to non-Markovian quantum measurements experimentally.The response and noise functions which we find to describe the system-mediated detector-detector interaction are analyzed in detail.They are compared to the phenomenological "equilibrium order" approach for non-Markovian measurements which was introduced in Ref. [1].We give an overview of the broad spectrum of results beyond "equilibrium order" in the microscopic model in a compendium of different detectors and discuss general mathematical properties of the detector functions.As the quantum measurement problem is not banned from our theory by operation in the weak measurement limit, but deferred from the system of interest to the detectors, we comment on the influence of the detector readout procedure on the results.Finally, we combine the phenomenological proposal for nonsymmetrized correlations in quantum noninvasive measurements [1] and our microscopic derivation of the systemmediated detector-detector interaction of second order to investigate higher-order correlations of non-Markovian weak quantum measurements.The general third-order correlator is introduced and the underlying physical processes are identified and discussed.We find a more complex behavior than in second-order correlations with four types of system operator orders which we denote third cumulant, noise susceptibility I and II and second-order susceptibility.We introduce a convenient diagrammatic description which we illustrate by an example of measuring the third-order correlations of the tunnel current through a barrier.v I would like to express my deep gratitude to all the people who contributed to this thesis.Special thanks to my supervisor Wolfgang Belzig for offering me the opportunity to work in his research group, for the numerous helpful discussions in which I learned a lot and which gave impetus to this work again and again, for being always patient and an excellent guidance during my studies.I also wish to express great thanks to my other collaborators, Adam Bednorz, whose ideas are an important part of the foundation of this work and who was always ready to comment new results and bring things forward, and Christoph Bruder, who was a great help in thinking through results and formulating them in an understandable manner while preparing parts of this work for publication.Many thanks to Maxim Trushin, who was willing to discuss our weak measurement formalism with the example of a graphene coherence measurement, and who contributed the initial idea of a optical detection of pseudospin superposition states as well as the description of the carrier statistics using the Liouville-von Neumann equation and very important parts of the discussion of the results.In this context I also want to acknowledge valuable discussions with Daniele Brida about the optical detection scheme and with Bertrand Reulet about third-order current correlations.Finally, I wish to thank the current and former members of the Quantum Transport Group
The existence of the third cumulant
S3 of voltage fluctuations has demonstrated the non-Gaussian aspect of shot noise in electronic transport. Until now, measurements have been performed at low frequency, \textit{i.e.} in the classical regime
ℏω<eV,kBT where voltage fluctuations arise from charge transfer process. We report here the first measurement of
S3 at high frequency, in the quantum regime
ℏω>eV,kBT. In this regime, experiment cannot be seen as a charge counting statistics problem anymore. It raises central questions of the statistics of quantum noise: 1) the electromagnetic environment of the sample has been proven to strongly influence the measurement, through the possible modulation of the noise of the sample. What happens to this mechanism in the quantum regime? 2) For
ℏω>eV, the noise is due to zero point fluctuations and keeps its equilibrium value:
S2=Gℏω with
G the conductance of the sample. Therefore,
S2 is independent of the bias voltage and no photon is emitted by the conductor. Is it possible, as suggested by some theories, that
S3=0 in this regime? With regard to these questions, we give theoretical and experimental answers to the environmental effects showing that they involve dynamics of the quantum noise. Using these results, we investigate the question of the third cumulant of quantum noise in the a tunnel junction.
When measuring quantum mechanical properties of charge transport in mesoscopic conductors, backaction effects occur. We consider a measurement setup with an elementary quantum circuit, composed of an inductance and a capacitor, as detector of the current flowing in a nearby quantum point contact. A quantum Langevin equation for the detector variable including backaction effects is derived. Differences with the quantum Langevin equation obtained in linear response are pointed out. In this last case, a relation between fluctuations and dissipation is obtained, provided that an effective temperature of the quantum point contact is defined.
Quantum mechanics can strongly influence the noise properties of mesoscopic devices. To probe this effect we have measured the current fluctuations at high-frequency (5-90G Hz) using a superconductor-insulator-superconductor tunnel junction as an on-chip spectrum analyzer. By coupling this frequency-resolved noise detector to a quantum device we can measure the high-frequency, non-symmetrized noise as demonstrated for a Josephson junction. The same scheme has been used to detect the current fluctuations arising from coherent charge oscillations in a two-level system, a superconducting charge qubit. A narrow band peak was observed in the spectral noise density at the frequency of the coherent charge oscillations.