Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:0901.4922 · The European Physical Journal Applied Physics

Impedance model for the polarization-dependent optical absorption of superconducting single-photon detectors

E. F. C. Driessen, Floris Braakman, Elisabeth Reiger, Sander N. Dorenbos, Val Zwiller, M. J. A. de Dood

Published May 13, 2009• 51 citations
arXivHTMLPDF

Abstract

We measured the single-photon detection efficiency of NbN superconducting single-photon detectors as a function of the polarization state of the incident light for different wavelengths in the range from 488 nm to 1550 nm. The polarization contrast varies from ~5% at 488 nm to ~30% at 1550 nm, in good agreement with numerical calculations. We use an optical-impedance model to describe the absorption for polarization parallel to the wires of the detector. For the extremely lossy NbN material, the absorption can be kept constant by keeping the product of layer thickness and filling factor constant. As a consequence, the maximum possible absorption is independent of filling factor. By illuminating the detector through the substrate, an absorption efficiency of ~70% can be reached for a detector on Si or GaAs, without the need for an optical cavity.

DOI
10.1051/epjap/2009087

Related papers

Optical properties of superconducting nanowire single-photon detectors

Vikas Anant, Andrew J. Kerman, Eric A. Dauler +3 more

We measured the optical absorptance of superconducting nanowire single photon detectors. We found that 200-nm-pitch, 50%-fill-factor devices had an average absorptance of 21% for normally-incident front-illumination of 1.55-microm-wavelength light polarized parallel to the nanowires, and only 10% for perpendicularly-polarized light. We also measured devices with lower fill-factors and narrower wires that were five times more sensitive to parallel-polarized photons than perpendicular-polarized photons. We developed a numerical model that predicts the absorptance of our structures. We also used our measurements, coupled with measurements of device detection efficiencies, to determine the probability of photon detection after an absorption event. We found that, remarkably, absorbed parallel-polarized photons were more likely to result in detection events than perpendicular-polarized photons, and we present a hypothesis that qualitatively explains this result. Finally, we also determined the enhancement of device detection efficiency and absorptance due to the inclusion of an integrated optical cavity over a range of wavelengths (700-1700 nm) on a number of devices, and found good agreement with our numerical model.

arXiv:0806.3194•Optics Express•Jul 3, 2008•167 citations

Design of a polarization-insensitive superconducting nanowire single photon detector with high detection efficiency

Fan Zheng, Ruiying Xu, Guanghao Zhu +5 more

Superconducting nanowire single photon detectors (SNSPDs) deliver superior performance over their competitors in the near-infrared regime. However, these detectors have an intrinsic polarization dependence on the incident wave because of their one-dimensional meander structure. In this paper, we propose an approach to eliminate the polarization sensitivity of SNSPDs by using near-field optics to increase the absorption of SNSPDs under transverse magnetic (TM) illumination. In addition, an optical cavity is added to our SNSPD to obtain nearly perfect absorption of the incident wave. Numerical simulations show that the maximum absorption of a designed SNSPD can reach 96% at 1550 nm, and indicate that the absorption difference between transverse electric (TE) and TM polarization is less than 0.5% across a wavelength window of 300 nm. Our work provides the first demonstration of the possibility of designing a polarization-insensitive and highly efficient SNSPD without performing device symmetry improvements.

Scientific Reports•Mar 7, 2016•37 citations

Superconducting nanowire single-photon detectors at a wavelength of 940 nm

W. J. Zhang, Hao Li, Lixing You +9 more

We develop single-photon detectors comprising single-mode fiber-coupled superconducting nanowires, with high system detection efficiencies at a wavelength of 940 nm. The detector comprises a 6.5-nm-thick, 110-nm-wide NbN nanowire meander fabricated onto a Si substrate with a distributed Bragg reflector for enhancing the optical absorptance. We demonstrate that, via the design of a low filling factor (1/3) and active area (Φ = 10 μm), the system reaches a detection efficiency of ∼60% with a dark count rate of 10 Hz, a recovery time <12 ns, and a timing jitter of ∼50 ps.

arXiv:1506.07921•AIP Advances•Jun 1, 2015•7 citations

Design of a low-filling-factor and polarization-sensitive superconducting nanowire single photon detector with high detection efficiency

Dezhi Li, Rongzhen Jiao

We designed a low-filling-factor and polarization-sensitive superconducting nanowire single photon detector (SNSPD), which can achieve a high absorption efficiency and counting rate simultaneously. Numerical simulations show that high absorption efficiency can be achieved by low-filling-factor SNSPDs with a silicon slot and silver reflector. The absorptance of the NbN nanowire for a transverse magnetic (TM) wave at the wavelength of 1550 nm can be 84.4% when the filling factor is only 16.5%, and the corresponding polarization extinction ratio (PER) is 562.9; the absorptance of the NbN nanowire for a transverse electric (TE) wave can be 67.0% when the filling factor is only 11.7%, and the PER is 7.4.

Photonics Research•Jul 15, 2019•18 citations

Intrinsic detection efficiency of superconducting nanowire single-photon detectors with different thicknesses

M. Hofherr, Dagmar Rall, K. Ilin +4 more

We evaluate experimentally the intrinsic detection efficiency (IDE) of superconducting NbN nanowire single-photon detectors in the range of wire thicknesses from 4 to 12 nm. The study is performed in the broad spectral interval between near-ultraviolet (wavelength 400 nm) and near-infrared (wavelength 2000 nm) light with plane waves at normal incidence. For visible light the IDE of the thinnest detectors reaches 70%. We use numerically computed absorptance of the nanowire-structures for the analysis of the experimental data. Variations in the detection efficiency with both the wire thickness and the wavelength evidence the red boundary of the hot-spot photon-detection mechanism. We explain the detection at larger wavelengths invoking thermal excitation of magnetic Pearl vortices over the potential barrier at the edges of the wire.

Journal of Applied Physics•Jul 1, 2010•93 citations

An Efficient and Polarization-Sensitive Superconducting-Nanowire Single-Photon Detector With Coupled Asymmetric Split-Ring Resonator-Loaded Cavity

Mengmeng Yang, Fan Zheng, Biaobing Jin +5 more

A highly efficient single-photon detector with strong polarization sensitivity is an important device in the field of quantum communication. Here, we present the design of a kind of superconducting-nanowire single-photon detector (SNSPD), in which the superconducting nanowire is embedded in a resonant cavity covered by a metasurface made of a coupled asymmetric split-ring resonator (CASRR). When illuminated by an incident light with different polarizations, CASRR will show totally different optical responses, which is used to obtain high polarization contrast in SNSPDs. Our simulation results show that an NbN nanowire meander with a filling factor of 0.2 can achieve an absorption efficiency of 84.3% at a wavelength of 1550 nm, when the electric field of the incident light is parallel to the NbN nanowire. Moreover, the polarization extinction ratio, i.e., the ratio of absorption rates between cases, where the electric fields are parallel and perpendicular to the NbN nanowire, is 522. Comparing with the results reported before, our SNSPD design demonstrates a much better performance.

IEEE Transactions on Applied Superconductivity•Jul 20, 2016•4 citations
We measured the single-photon detection efficiency of NbN superconducting single-photon detectors as a function of the polarization state of the incident light for different wavelengths in the range from 488 nm to 1550 nm. The polarization contrast varies from ~5% at 488 nm to ~30% at 1550 nm, in good agreement with numerical calculations. We use an optical-impedance model to describe the absorption for polarization parallel to the wires of the detector. For the extremely lossy NbN material, the absorption can be kept constant by keeping the product of layer thickness and filling factor constant. As a consequence, the maximum possible absorption is independent of filling factor. By illuminating the detector through the substrate, an absorption efficiency of ~70% can be reached for a detector on Si or GaAs, without the need for an optical cavity.
We measured the optical absorptance of superconducting nanowire single photon detectors. We found that 200-nm-pitch, 50%-fill-factor devices had an average absorptance of 21% for normally-incident front-illumination of 1.55-microm-wavelength light polarized parallel to the nanowires, and only 10% for perpendicularly-polarized light. We also measured devices with lower fill-factors and narrower wires that were five times more sensitive to parallel-polarized photons than perpendicular-polarized photons. We developed a numerical model that predicts the absorptance of our structures. We also used our measurements, coupled with measurements of device detection efficiencies, to determine the probability of photon detection after an absorption event. We found that, remarkably, absorbed parallel-polarized photons were more likely to result in detection events than perpendicular-polarized photons, and we present a hypothesis that qualitatively explains this result. Finally, we also determined the enhancement of device detection efficiency and absorptance due to the inclusion of an integrated optical cavity over a range of wavelengths (700-1700 nm) on a number of devices, and found good agreement with our numerical model.
Superconducting nanowire single photon detectors (SNSPDs) deliver superior performance over their competitors in the near-infrared regime. However, these detectors have an intrinsic polarization dependence on the incident wave because of their one-dimensional meander structure. In this paper, we propose an approach to eliminate the polarization sensitivity of SNSPDs by using near-field optics to increase the absorption of SNSPDs under transverse magnetic (TM) illumination. In addition, an optical cavity is added to our SNSPD to obtain nearly perfect absorption of the incident wave. Numerical simulations show that the maximum absorption of a designed SNSPD can reach 96% at 1550 nm, and indicate that the absorption difference between transverse electric (TE) and TM polarization is less than 0.5% across a wavelength window of 300 nm. Our work provides the first demonstration of the possibility of designing a polarization-insensitive and highly efficient SNSPD without performing device symmetry improvements.
We develop single-photon detectors comprising single-mode fiber-coupled superconducting nanowires, with high system detection efficiencies at a wavelength of 940 nm. The detector comprises a 6.5-nm-thick, 110-nm-wide NbN nanowire meander fabricated onto a Si substrate with a distributed Bragg reflector for enhancing the optical absorptance. We demonstrate that, via the design of a low filling factor (1/3) and active area (Φ = 10 μm), the system reaches a detection efficiency of ∼60% with a dark count rate of 10 Hz, a recovery time <12 ns, and a timing jitter of ∼50 ps.
We designed a low-filling-factor and polarization-sensitive superconducting nanowire single photon detector (SNSPD), which can achieve a high absorption efficiency and counting rate simultaneously. Numerical simulations show that high absorption efficiency can be achieved by low-filling-factor SNSPDs with a silicon slot and silver reflector. The absorptance of the NbN nanowire for a transverse magnetic (TM) wave at the wavelength of 1550 nm can be 84.4% when the filling factor is only 16.5%, and the corresponding polarization extinction ratio (PER) is 562.9; the absorptance of the NbN nanowire for a transverse electric (TE) wave can be 67.0% when the filling factor is only 11.7%, and the PER is 7.4.
We evaluate experimentally the intrinsic detection efficiency (IDE) of superconducting NbN nanowire single-photon detectors in the range of wire thicknesses from 4 to 12 nm. The study is performed in the broad spectral interval between near-ultraviolet (wavelength 400 nm) and near-infrared (wavelength 2000 nm) light with plane waves at normal incidence. For visible light the IDE of the thinnest detectors reaches 70%. We use numerically computed absorptance of the nanowire-structures for the analysis of the experimental data. Variations in the detection efficiency with both the wire thickness and the wavelength evidence the red boundary of the hot-spot photon-detection mechanism. We explain the detection at larger wavelengths invoking thermal excitation of magnetic Pearl vortices over the potential barrier at the edges of the wire.
A highly efficient single-photon detector with strong polarization sensitivity is an important device in the field of quantum communication. Here, we present the design of a kind of superconducting-nanowire single-photon detector (SNSPD), in which the superconducting nanowire is embedded in a resonant cavity covered by a metasurface made of a coupled asymmetric split-ring resonator (CASRR). When illuminated by an incident light with different polarizations, CASRR will show totally different optical responses, which is used to obtain high polarization contrast in SNSPDs. Our simulation results show that an NbN nanowire meander with a filling factor of 0.2 can achieve an absorption efficiency of 84.3% at a wavelength of 1550 nm, when the electric field of the incident light is parallel to the NbN nanowire. Moreover, the polarization extinction ratio, i.e., the ratio of absorption rates between cases, where the electric fields are parallel and perpendicular to the NbN nanowire, is 522. Comparing with the results reported before, our SNSPD design demonstrates a much better performance.