In this thesis I discuss work that has been carried out on the dynamics of a Bose Einstein condensate of Rb 87 produced near an atom chip. A Bose Einstein Condensate (BEC) is a quantum state of matter where a single quantum state becomes occupied by a macroscopic number of identical Bosons. In our case this is achieved by cooling a system of trapped identical rubidium 87 atoms to its ground state. To reach temperatures of condensation we initially laser cool atoms from room temperature, before loading them into a magnetic trap. The magnetic trap is produced through a combination of uniform magnetic fields from coils outside our vacuum chamber and currents running through wires on an atom chip. The atom chip is a microfabricated device, produced by a coating a silicon chip with a thin layer of gold and etching wires into it. Together, these fields create a magnetic field minimum 120μm from the surface of the chip which can be used to confine low field seeking hyperfine states of the atom in an elongated harmonic trap. Once the atoms are confined in the magnetic trap we used force evaporative cooling out to reach the phase space densities required for Bose Einstein condensation. The BEC is used to investigate the relative dynamics between the fraction of the atoms in the condensate to those not in the condensate. Our atom chip provided a suitable environment to investigate this due to fragmentation of the magnetic potential close to the chip. Small imperfections in the wires on our atom chip mean that the trapping potential isn’t smooth. Small regions of higher trapping frequency - or fragments - are formed. Due to the small size of these fragments it is possible to find a position where a condensate can form in the fragment, and see a potential of high frequency, whereas a non-condensed atom will see a lower frequency potential. We exploit this to set the condensed fraction moving relative to the non condensed part and investigate the subsequent damping of their motion relative to each other.
Atom chips are devices used to magnetically trap and manipulate ultracold atoms and Bose-Einstein condensates near a surface. In particular, permanent magnetic film atom chips can allow very tight confinement and intricate magnetic field designs while circumventing technical current noise. Research described in this thesis is focused on the development of a magnetic film atom chip, the production of Bose-Einstein condensates near the film surface, the characterisation of the associated magnetic potentials using rf spectroscopy of ultracold atoms and the realisation of a precision sensor based on splitting Bose-Einstein condensates in a double-well potential. The atom chip itself combines the edge of a perpendicularly magnetised GdTbFeCo film with a machined silver wire structure. A mirror magneto-optical trap collects up to 5 x 108 87Rb atoms beneath the chip surface. The current-carrying wires are then used to transfer the cloud of atoms to the magnetic film microtrap and radio frequency evaporative cooling is applied to produce Bose-Einstein condensates consisting of 1 x 105 atoms. We have identified small spatial magnetic field variations near the film surface that fragment the ultracold atom cloud. These variations originate from inhomogeneity in the film magnetisation and are characterised using a novel technique based on spatially resolved radio frequency spectroscopy of the atoms to map the magnetic field landscape over a large area. The observations agree with an analytic model for the spatial decay of random magnetic fields from the film surface. Bose-Einstein condensates in our unique potential landscape have been used as a precision sensor for potential gradients. We transfer the atoms to the central region of the chip which produces a double-well potential. A single BEC is formed far from the surface and is then dynamically split in two by moving the trap closer to the surface. After splitting, the population of atoms in each well is extremely sensitive to the asymmetry of the potential and can be used to sense tiny magnetic field gradients or changes in gravity on a small spatial scale.
Atom chips are an excellent tool for studying ultracold degenerate quantum gases, due to the high degree of controllability afforded by the precise potentials generated from the current-carrying microfabricated wires on the chip surface. The geometries of the trapping potentials are inherently capable of realising extreme aspect ratios, and therefore creating model systems with effectively reduced dimensionality, particularly the theoretically-tractable one-dimensional Bose gas. In addition, the temporal tunability makes it possible to impart non-adiabatic changes on the trapping potentials, allowing experimental investigation of samples which have been brought out of equilibrium - a situation which is not fully theoretically understood. This thesis describes the implementation, development and characterisation of an experimental system for producing the first Bose-Einstein condensates of atomic rubidium 87 gas trapped on the surface of an atom chip in Nottingham. Such an apparatus is very complex and requires careful characterisation in order to run in a stable and reliable way. Details of the experimental setup are thoroughly outlined, including the vacuum system, lasers, electronics, computer control and timing, and the optical imaging system. A newly installed compact two-dimensional magneto-optical trap provides an loading rate of 5e7 atoms per second for loading a three-dimensional mirror-magneto-optical trap with 1.5e8 atoms, at a temperature of 300uK within 10s. The cloud is then sub-Doppler cooled to 50uK, and spin-polarised with 96% purity into the |F=2,mF=+2> ground state within 5ms, in preparation for loading a purely magnetic trap. A millimeter sized copper Z-shaped conductor located beneath the atom chip surface creates a Ioffe-Pritchard magnetic trap, into which the laser cooled cloud is loaded with 70% efficiency, and can be held with a vacuum-limited lifetime of 40s. Evaporative cooling then pre-cools the sample to below 20uK within 10s, to allow the subsequent loading into potentials created by the atom chip with 100% efficiency. A final evaporation stage then cools the cloud below the phase transition temperature of 800nK, resulting finally in pure BECs with
105 atoms confined using the atom chip. Key measurements of various properties of the trapped condensates are presented, which are important in order to characterise the system fully, and to compare with theoretical expectations. In particular, included are the variation of condensate fraction with temperature, the BEC expansion dynamics, and the condensate lifetime in the trap, for example. Finally, it is demonstrated how BECs can be produced on the atom chip without the use of external macroscopic coils, achieved by using novel, integrated sheet structures located beneath the chip surface - unique to this experimental system - to create the necessary bias fields.
Abstract We propose a new miniature Bose–Einstein condensate (BEC) system based on a transparent atom chip with a compact external coil structure. A standard six-beam macroscopic magneto-optical trap (MOT) is able to be created near the chip surface due to the chip’s transparency. A novel wire pattern consisting of a double-z wire and a z-shaped wire is designed on the transparent atom chip. With a vertical bias magnetic field, the double-z wire can create the quadrupole magnetic field of an intermediate chip MOT, which is suitable for transporting atoms from the macroscopic MOT to the chip z-wire trap efficiently. The compact external coil structure is designed with a rectangular frameless geometry consisting of only four coil pairs and its volume is less than 0.3 liters. The maximum system power consumption during the BEC generation procedure is about 45 W. The miniature system is evaluated, and about 3 × 10 6 atoms can be loaded into the chip z-wire trap. The miniature chip BEC system has the advantages of small volume and low power consumption, and it has great potential for practical applications of BEC.
We demonstrate a new magneto-optical trap (MOT) configuration using a simple pair of crossed wires rotated at 45 deg and an appropriate bias field to generate a MOT of >10^8 atoms. The same pair of wires, with slightly adjusted control parameters, is then used to magnetically trap the atoms and cool them via forced evaporative cooling into a Bose-Einstein condensate (BEC) with >10^4 atoms.
We present the theoretical framework for generating a quadrupole field using a pair of crossed wires with arbitrary rotation angle, along with the atom chip design and fabrication. Finally, we describe the experimental protocols required for BEC production using only a single crossed-wire atom chip.