Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:0805.2708 · Measurement Science and Technology

Modulation transfer spectroscopy in atomic rubidium

Daniel McCarron, S. A. King, Simon L. Cornish

Published Aug 19, 2008• 209 citations
arXivHTMLPDF

Abstract

We report modulation transfer spectroscopy on the D2 transitions in 85 Rb and 87 Rb using a simple home-built electro-optic modulator (EOM). We show that both the gradient and amplitude of modulation transfer spectroscopy signals, for the 87 Rb F = 2 → F ' = 3 and the 85 Rb F = 3 → F ' = 4 transitions, can be significantly enhanced by expanding the beams, improving the signals for laser frequency stabilization. The signal gradient for these transitions is increased by a factor of 3 and the peak to peak amplitude was increased by a factor of 2. The modulation transfer signal for the 85 Rb F = 2 → F ' transitions is also presented to highlight how this technique can generate a single, clear line for laser frequency stabilization even in cases where there are a number of closely spaced hyperfine transitions.

DOI
10.1088/0957-0233/19/10/105601

Related papers

Laser frequency stabilization and shifting by using modulation transfer spectroscopy

Bing Cheng, Zhaoying Wang, Bin Wu +4 more

The stabilizing and shifting of laser frequency are very important for the interaction between the laser and atoms. The modulation transfer spectroscopy for the 87 Rb atom with D2 line transition F = 2 → F′ = 3 is used for stabilizing and shifting the frequency of the external cavity grating feedback diode laser. The resonant phase modulator with electro—optical effect is used to generate frequency sideband to lock the laser frequency. In the locking scheme, circularly polarized pump- and probe-beams are used. By optimizing the temperature of the vapor, the pump- and probe-beam intensity, the laser linewidth of 280 kHz is obtained. Furthermore, the magnetic field generated by a solenoid is added into the system. Therefore the system can achieve the frequency locking at any point in a range of hundreds of megahertz frequency shifting with very low power loss.

Chinese Physics B•Oct 1, 2014•25 citations

Observation of Modulation Transfer Spectroscopy in the Deep Modulation Regime

Zichao Zhou, Rong Wei, Chunyan Shi +1 more

We observe the modulation transfer spectroscopy on the D2 line of 87Rb in a rubidium cell with acoustic-optic modulator in the deep modulation regime. In this regime, the sidebands of the pump beam are involved in the four-wave mixing processes, which increase the signal gradients and the peak-to-peak amplitudes of both the absorption and dispersion components.

Chinese Physics Letters•Dec 1, 2010•5 citations

Note: Simultaneous modulation transfer spectroscopy on transitions of multiple atomic species for compact laser frequency reference modules

Moritz Mihm, Kai Lampmann, André Wenzlawski +1 more

We present a technique for simultaneous laser frequency stabilization on transitions of multiple atomic species with a single optical setup. The method is based on modulation transfer spectroscopy, and the signals are separated by modulating at different frequencies and electronically filtered. As a proof of concept, we demonstrate simultaneous spectroscopy of the potassium D1, D2 and rubidium D2 transitions. The technique can be extended in principle to other atomic species given the availability of optics and cells and allows the development of versatile and compact frequency reference modules.

Review of Scientific Instruments•Sep 1, 2018•6 citations

Modulation transfer spectroscopy for D1 transition line of rubidium

Bin Wu, Yin Zhou, Kanxing Weng +5 more

Modulation transfer spectroscopy (MTS) is widely used in an optical laboratory for laser frequency stabilization. There have been many theoretical and experimental papers on this spectroscopic method. However, most of the works focus on the cycling transitions like the D2 line of rubidium. In this paper, the MTS for noncycling transitions is investigated. We consider the D1 line of rubidium whose modulation transfer spectrum has been determined and compared to the polarization spectrum. It is found that the slope of the modulation transfer signal is sharper than the polarization spectrum. The performance of laser frequency locking based on the MTS method is better than that of the polarization spectroscopy method. The dependence of the signal amplitude on the temperature of the vapor cell was analyzed, and the high signal-to-noise-ratio spectra are achieved for D1 open transitions. The obtained results provide an effective spectroscopic method for the robust frequency locking of a laser at a wavelength of 795 nm.

Journal of the Optical Society of America B•Oct 8, 2018•30 citations

Frequency-modulation spectroscopy of rubidium atoms with an AlGaAs diode laser

Shunsuke Nakanishi, H. Ariki, Hiroshi Itoh +1 more

Frequency-modulation (FM) spectroscopy has been performed on the D(2) transitions of rubidium atoms with an AlGaAs diode laser at 780 nm. Doppler-broadened hyperfine-structure transitions of (85)Rb and (87)Rb were resolved with no residual amplitude-modulation-induced background signal by modulating the injection current of the laser diode at a low frequency (20-50 MHz) compared with the Doppler width. To obtain Doppler-free spectra, we combined FM spectroscopy with saturation spectroscopy. The results show that the FM spectroscopy technique is sensitive and should be useful for high-resolution spectroscopy, although the resolution was instrument limited and unusual double peaks were observed.

Optics Letters•Nov 1, 1987•10 citations

Laser frequency stabilization in the 10 −14 range via optimized modulation transfer spectroscopy on the 87 Rb D 2 line

Sanglok Lee, Geol Moon, Sang Eon Park +5 more

We present a high-performance laser frequency stabilization method using modulation transfer spectroscopy (MTS) on the rubidium 87 D 2 transition line. A substantial improvement of the laser frequency stability was achieved by searching for the optimal diameter and intensity settings of the probe and pump beam. The frequency instability measured from the beat frequency of two locked external cavity diode lasers (ECDLs) reached a short-term stability of 4.5 × 10 − 14 / τ and did not exceed 2 × 10 −12 until 10 5 s, which is the best performance reported thus far with a D 2 transition. The long-term stability is limited by the offset fluctuations of the baseline induced by the residual amplitude modulation (RAM), which can be further improved by reducing the current temperature variation of about 0.2 K by means of temperature stabilization or through a further reduction of the RAM.

Optics Letters•Jan 17, 2023•47 citations
We report modulation transfer spectroscopy on the D2 transitions in 85 Rb and 87 Rb using a simple home-built electro-optic modulator (EOM). We show that both the gradient and amplitude of modulation transfer spectroscopy signals, for the 87 Rb F = 2 → F ' = 3 and the 85 Rb F = 3 → F ' = 4 transitions, can be significantly enhanced by expanding the beams, improving the signals for laser frequency stabilization. The signal gradient for these transitions is increased by a factor of 3 and the peak to peak amplitude was increased by a factor of 2. The modulation transfer signal for the 85 Rb F = 2 → F ' transitions is also presented to highlight how this technique can generate a single, clear line for laser frequency stabilization even in cases where there are a number of closely spaced hyperfine transitions.
The stabilizing and shifting of laser frequency are very important for the interaction between the laser and atoms. The modulation transfer spectroscopy for the 87 Rb atom with D2 line transition F = 2 → F′ = 3 is used for stabilizing and shifting the frequency of the external cavity grating feedback diode laser. The resonant phase modulator with electro—optical effect is used to generate frequency sideband to lock the laser frequency. In the locking scheme, circularly polarized pump- and probe-beams are used. By optimizing the temperature of the vapor, the pump- and probe-beam intensity, the laser linewidth of 280 kHz is obtained. Furthermore, the magnetic field generated by a solenoid is added into the system. Therefore the system can achieve the frequency locking at any point in a range of hundreds of megahertz frequency shifting with very low power loss.
We present a technique for simultaneous laser frequency stabilization on transitions of multiple atomic species with a single optical setup. The method is based on modulation transfer spectroscopy, and the signals are separated by modulating at different frequencies and electronically filtered. As a proof of concept, we demonstrate simultaneous spectroscopy of the potassium D1, D2 and rubidium D2 transitions. The technique can be extended in principle to other atomic species given the availability of optics and cells and allows the development of versatile and compact frequency reference modules.
Modulation transfer spectroscopy (MTS) is widely used in an optical laboratory for laser frequency stabilization. There have been many theoretical and experimental papers on this spectroscopic method. However, most of the works focus on the cycling transitions like the D2 line of rubidium. In this paper, the MTS for noncycling transitions is investigated. We consider the D1 line of rubidium whose modulation transfer spectrum has been determined and compared to the polarization spectrum. It is found that the slope of the modulation transfer signal is sharper than the polarization spectrum. The performance of laser frequency locking based on the MTS method is better than that of the polarization spectroscopy method. The dependence of the signal amplitude on the temperature of the vapor cell was analyzed, and the high signal-to-noise-ratio spectra are achieved for D1 open transitions. The obtained results provide an effective spectroscopic method for the robust frequency locking of a laser at a wavelength of 795 nm.
Frequency-modulation (FM) spectroscopy has been performed on the D(2) transitions of rubidium atoms with an AlGaAs diode laser at 780 nm. Doppler-broadened hyperfine-structure transitions of (85)Rb and (87)Rb were resolved with no residual amplitude-modulation-induced background signal by modulating the injection current of the laser diode at a low frequency (20-50 MHz) compared with the Doppler width. To obtain Doppler-free spectra, we combined FM spectroscopy with saturation spectroscopy. The results show that the FM spectroscopy technique is sensitive and should be useful for high-resolution spectroscopy, although the resolution was instrument limited and unusual double peaks were observed.
We present a high-performance laser frequency stabilization method using modulation transfer spectroscopy (MTS) on the rubidium 87 D 2 transition line. A substantial improvement of the laser frequency stability was achieved by searching for the optimal diameter and intensity settings of the probe and pump beam. The frequency instability measured from the beat frequency of two locked external cavity diode lasers (ECDLs) reached a short-term stability of 4.5 × 10 − 14 / τ and did not exceed 2 × 10 −12 until 10 5 s, which is the best performance reported thus far with a D 2 transition. The long-term stability is limited by the offset fluctuations of the baseline induced by the residual amplitude modulation (RAM), which can be further improved by reducing the current temperature variation of about 0.2 K by means of temperature stabilization or through a further reduction of the RAM.