Superconducting oscillators have been successfully used for quantum control and readout devices in conjunction with superconducting qubits. Also, squeezed states can improve the accuracy of measurements to subquantum, or at least subthermal, levels. Here, we show theoretically how to produce squeezed states of microwave radiation in a superconducting oscillator with tunable parameters. Its resonance frequency can be changed by controlling an rf SQUID inductively coupled to the oscillator. By repeatedly shifting the resonance frequency between any two values, it is possible to produce squeezed and subthermal states of the electromagnetic field in the (0.1-10) GHz range, even when the relative frequency change is small. We propose experimental protocols for the verification of squeezed state generation, and for their use to improve the readout fidelity when such oscillators serve as quantum transducers.
Superconducting oscillators have been successfully used for quantum control and readout devices in conjunction with superconducting qubits. Also, squeezed states can improve the accuracy of measurements to subquantum, or at least subthermal, levels. Here, we show theoretically how to produce squeezed states of microwave radiation in a superconducting oscillator with tunable parameters. Its resonance frequency can be changed by controlling an rf SQUID inductively coupled to the oscillator. By repeatedly shifting the resonance frequency between any two values, it is possible to produce squeezed and subthermal states of the electromagnetic field in the (0.1-10) GHz range, even when the relative frequency change is small. We propose experimental protocols for the verification of squeezed state generation, and for their use to improve the readout fidelity when such oscillators serve as quantum transducers.
In this licentiate thesis design, fabrication, and measurements of tunable superconducting microwave transmission line resonators are described. The resonators are of quarter wavelength type were the tuning is achieved by changing one of the boundary conditions of the resonator through a tunable impedance. As tunable impedance the Josephson inductance in form of SQUIDs is used. The Josephson inductance can then be tuned by applying a magnetic field to the SQUID loop. A tuning range of 750 MHz for a 5 GHz resonator is achieved, and as a figure of merit it can be tuned over 200 line widths. The purpose of the tunable resonators is to use them for dynamic coupling of superconducting quantum bits, this requires that the resonators can be tuned fast on the timescale of the resonator-qubit coupling. To measure tuning speeds faster then the ring up time of the resonators a method that measures the leakage of energy out of a detuned resonator was developed. With this method a frequency shift of the energy stored in the resonator can be measured. A detuning of 330 MHz in less than 10 ns is demonstrated for a 4.5 GHz resonator with a quality factor of 104. Working in the few photon limit indicates that the devices can be used to change the frequency of individual photons, this is however still to be demonstrated. As a part of this work the dressed states of a superconducting charge qubit was also studied.
In the circuit quantum electrodynamics architecture, both the resonance frequency and the coupling of superconducting qubits to microwave field modes can be controlled via external electric and magnetic fields to explore qubit-photon dynamics in a wide parameter range. Here, we experimentally demonstrate and analyze a scheme for tuning the coupling between a transmon qubit and a microwave resonator using a single coherent drive tone. We treat the transmon as a three-level system, with the qubit subspace defined by the ground and the second excited states. If the drive frequency matches the difference between the resonator and the qubit frequencies, a Jaynes-Cummings-type interaction is induced, which is tunable in both amplitude and phase. We show that coupling strengths of about 10 MHz can be achieved in our setup, limited only by the anharmonicity of the transmon qubit. This scheme has been successfully used to generate microwave photons with a controlled temporal shape [M. Pechal et al., Phys. Rev. X 4, 041010 (2014)] and can be directly implemented with superconducting quantum devices featuring larger anharmonicity for higher coupling strengths.
The laws of quantum mechanics imply the existence of an intrinsic uncertainty, or noise, in the electromagnetic field. These noise fluctuations are central to many processes in atomic physics and quantum optics, including spontaneous emission of radiation by an atomic system, backaction on an atomic system during non-demolition measurement by probe light, and intrinsic bounds on the noise performance of an ideal amplifier. While quantum noise cannot be eliminated, the noise of one observable quantity may be reduced provided that of the conjugate observable is increased in accord with the relevant Heisenberg uncertainty relation; this process is known as squeezing.Recently, superconducting circuits have emerged as a powerful platform for studying the interaction of squeezed light and matter, leveraging the low-dimensionality of the circuit environment to efficiently couple atomic systems to squeezed radiation. Beyond enabling the verification of canonical predictions of quantum optics, these experiments explore the potential utility of squeezing for the state readout of quantum bits, or qubits, used for quantum information processing.In this thesis, we present three experiments probing the interaction of a superconducting qubit with squeezed radiation. First, we observe how the fluorescence spectra emitted by a two-level atomic system are modified by squeezing of a resonant drive. The subnatural linewidths of the resulting spectra provide the first successful verification in any system of predictions from nearly three decades prior, and provide a tool for characterization of microwave squeezed states. Second, we combine injected squeezed noise with a stroboscopic measurement scheme to demonstrate the first improvement of the signal-to-noise ratio of qubit state readout due to input squeezing. This study includes a characterization of the effect of squeezing on measurement backaction, exhibiting the first use of squeezing to slow measurement-induced dephasing. Finally, we develop a circuit incorporating the qubit inside of a squeezed-microwave source and extensively study the measurement physics of this hybrid system. This device enables the transfer of quantum information from the qubit at $\\sim$30 milliKelvin to a room temperature detector with a marked increase in steady-state efficiency.
In this thesis I present different types of manipulations of microwave fields using tunable superconducting resonators. A resonator is made tunable by adding one or more superconducting quantum interference devices, SQUIDs. The SQUID consists of a superconducting loop with two Josephson junctions and acts as a tunable nonlinear inductor. Modulation of the SQUID nonlinearity can be performed to induce different types of non-trivial oscillator dynamics. The first project I present is on subharmonic oscillations. Here, the SQUID in a tunable resonator is driven with an external signal at an integer multiple of the frequency w. When w is placed slightly below the first resonator mode, I show generation of radiation at w, which is known as frequency down-conversion. In my measurements, subharmonic oscillations have been detected from period doubling up to period quintupling. For the specific case of period tripling, theory is developed and I show good agreement between theory and experiments. The second project of the thesis is on a doubly tunable resonator. Here, I show creation of a superconducting resonator with two independently tunable boundary conditions. The idea with this system is to operate the resonator in a breathing or a translational mode and compare the two. For static dc magnetic flux the performance is very good. As a second step, I perform fast modulation of both SQUIDs to generate radiation. Even though some of the measurement results are promising, I also show some contradicting observations. These indicate that the actual modulation mechanism of the SQUID is not pumping of the magnetic flux in the SQUID loop as intended, but rather direct current driving of the SQUID. However, the system remains a promising idea for microwave manipulation and creation of interesting non-classical states. As a possible application of the doubly tunable resonator, I present a theory proposal on how to use it for measurements on relativistic effects. By using the tunability of the resonator boundary conditions, the resonator can simulate a space rocket and time dilation could be measured. However, due to the crosstalk problems in the doubly tunable resonator this experiment was never realized. Finally, I finish the thesis by presenting a design for a tunable microwave coupling. Papers E and F show a high on-off ratio for the coupler and demonstrate how it can be used for storage of microwave signals. Furthermore, the tunable coupler can be used to shape a microwave signal by tuning the strength of the coupling.
We have created a doubly tunable resonator, with the intention to simulate relativistic motion of the resonator boundaries in real space. Our device is a superconducting coplanar-waveguide microwave resonator, with fundamental resonant frequency ω 1 / (2 π ) ~ 5 GHz. Both of its ends are terminated to ground via dc-SQUIDs, which serve as magnetic-flux-controlled inductances. Applying a flux to either SQUID allows the tuning of ω 1 / (2 π ) by approximately 700 MHz. Using two separate on-chip magnetic-flux lines, we modulate the SQUIDs with two tones of equal frequency, close to 2 ω 1 . We observe photon generation, at ω 1 , above a certain pump amplitude threshold. By varying the relative phase of the two pumps we are able to control this threshold, in good agreement with a theoretical model. At the same time, some of our observations deviate from the theoretical predictions, which we attribute to parasitic couplings resulting in current driving of the SQUIDs.
The perhaps most promising platform for quantum information processing is the circuit-QED architecture based on superconducting circuits representing quantum bits. These circuits must be made with low losses so that the quantum information is retained for as long as possible. We developed fabrication processes achieving state-of-the-art coherence times of over 100 µs. We identified the primary source of loss to be parasitic two-level systems by studying fluctuations of qubit relaxation times.Using our high-coherence circuits, we implemented a quantum processor built on fixed-frequency qubits and frequency-tunable couplers. The tunable couplers were lumped-element LC resonators, where the inductance came from a superconducting quantum interference device (SQUID). We achieved a controlled-phase gate with a fidelity of 99% by parametric modulation of the coupler frequency. Using this device, and another similar to it, we demonstrated two different quantum algorithms, the quantum approximate optimization algorithm, and density matrix exponentiation. We achieved high algorithmic fidelities, aided by our carefully calibrated gates.Additionally, we researched parametric oscillations using frequency-tunable resonators. Previously, degenerate parametric oscillations have been demonstrated by modulation of the resonant frequency at twice that frequency. We use this phenomenon to implement a readout method for a superconducting qubit with a fidelity of 98.7%. We demonstrated correlated radiation in nondegenerate parametric oscillations by modulating at the sum of two resonant frequencies of a multimode resonator. We showed an excellent quantitative agreement between the classical properties of the oscillations with a theoretical model. Moreover, we studied higher-order modulation at up to five times their resonant frequencies. These types of parametric oscillation states might be used as a quantum resource for continuous-variable quantum computing.