Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:0804.3499 · Applied Physics Letters

Contribution of dielectrics to frequency and noise of NbTiN superconducting resonators

R. Barends, H. L. Hortensius, T. Zijlstra, J. J. A. Baselmans, S. J. C. Yates, J. R. Gao, T. M. Klapwijk

Published Jun 2, 2008• 108 citations
arXivHTMLPDF

Abstract

We study NbTiN resonators by measurements of the temperature dependent resonance frequency and frequency noise. Additionally, resonators are studied covered with SiOx dielectric layers of various thicknesses. The resonance frequency develops a nonmonotonic temperature dependence with increasing SiOx layer thickness. The increase in the noise is independent of the SiOx thickness, demonstrating that the noise is not dominantly related to the low temperature resonance frequency deviations.

DOI
10.1063/1.2937837

Related papers

Noise in NbTiN, Al, and Ta Superconducting Resonators on Silicon and Sapphire Substrates

R. Barends, H. L. Hortensius, T. Zijlstra +4 more

We present measurements of the frequency noise and resonance frequency temperature dependence in planar superconducting resonators on both silicon and sapphire substrates. We show, by covering the resonators with sputtered SiOxlayers of different thicknesses, that the temperature dependence of the resonance frequency scales linearly with thickness, whereas the observed increase in noise is independent of thickness. The frequency noise decreases when increasing the width of the coplanar waveguide in NbTiN on hydrogen passivated silicon devices, most effectively by widening the gap. We find up to an order of magnitude more noise when using sapphire instead of silicon as substrate. The complete set of data points towards the noise being strongly affected by superconductor-dielectric interfaces.

IEEE Transactions on Applied Superconductivity•Jun 1, 2009•45 citations

Frequency and quality factor of NbTiN∕Au bilayer superconducting resonators

R. Barends, Werner Karl-Gustav Daalman, Akira Endo +6 more

We have measured the temperature dependence of the resonance frequency and quality factor of superconducting resonators made of a 300 nm thick NbTiN and 10 nm thick Au bilayer down to a temperature of 350 mK. At low temperatures we find a strong temperature dependence compared to bare NbTiN resonators: when increasing the temperature from 350 mK to 2 K the quality factor drops from a value of 105 down to 103 and the frequency decreases by about 1%. This while for bare NbTiN the quality factor remains on the order of 106 and the fractional frequency change remains below 10−4. These results indicate that the proximitised thin Au layer dominates the low temperature properties. Using the Usadel equations and Nam’s expression for the complex conductivity we can accurately describe the data assuming an interface transparency of 0.15.

AIP conference proceedings•Jan 1, 2009•11 citations

Reduced frequency noise in superconducting resonators

R. Barends, N. Vercruyssen, Akira Endo +4 more

We report a reduction in the frequency noise in coplanar waveguide superconducting resonators. The reduction of 7 dB is achieved by removing the exposed dielectric substrate surface from the region with high electric fields and by using NbTiN. In a model-analysis the surface of NbTiN is found to be a negligible source of noise, experimentally supported by a comparison with NbTiN on SiOx resonators. The reduction is additive to decreasing the noise by widening the resonators.

arXiv:1005.5394•Applied Physics Letters•Jul 19, 2010•57 citations

Slow noise processes in superconducting resonators

Jonathan Burnett, T. Lindström, M. Oxborrow +4 more

Slow noise processes, with characteristic timescales $\ensuremath{\sim}$1 s, have been studied in planar superconducting resonators. A frequency-locked loop is employed to track deviations of the resonator center frequency with high precision and bandwidth. Comparative measurements are made in varying microwave drive and temperature, and between bare resonators and those with an additional dielectric layer. All resonators are found to exhibit flicker frequency noise which increases with decreasing microwave drive. We also show that an increase in temperature results in a saturation of flicker noise in resonators with an additional dielectric layer, while bare resonators stop exhibiting flicker noise, instead showing a random frequency walk process.

arXiv:1210.2351•Physical Review B•Apr 5, 2013•29 citations

Temperature dependence of the frequency and noise of superconducting coplanar waveguide resonators

Shwetank Kumar, Jiansong Gao, Jonas Zmuidzinas +3 more

We present measurements of the temperature and power dependence of the resonance frequency and frequency noise of superconducting niobium thin-film coplanar waveguide resonators carried out at temperatures well below the superconducting transition (Tc=9.2K). The noise decreases by nearly two orders of magnitude as the temperature is increased from 120to1200mK, while the variation of the resonance frequency with temperature over this range agrees well with the standard two-level system (TLS) model for amorphous dielectrics. These results support the hypothesis that TLSs are responsible for the noise in superconducting microresonators and have important implications for resonator applications such as qubits and photon detectors.

arXiv:0802.4268•Applied Physics Letters•Mar 24, 2008•81 citations

Improvements in Silicon Oxide Dielectric Loss for Superconducting Microwave Detector Circuits

Dale Li, J. Gao, Jason E. Austermann +12 more

Dielectric loss in low-temperature superconducting integrated circuits can cause lower overall efficiency, particularly in the 90 to 220 GHz regime. We present a method to tune the dielectric loss for silicon oxide deposited by plasma-enhanced chemical-vapor deposition at ambient temperatures. Deposition in an environment with a higher silane-to-oxygen ratio produces silicon oxide films with a lower loss-tangent and a slightly higher optical index of refraction, while contributing no appreciable change in film stress. We measured the dielectric loss by fabricating a series of Nb-SiOx-Nb microstrip resonators in the frequency range of 6 to 9 GHz and comparing their temperature dependence to a model of parasitic two-level-system fluctuators. The dielectric loss-tangent of silicon oxide was improved from 6 ×10-3for stoichiometric silicon dioxide to 2 ×10-3for a more silicon-rich silicon oxide. We present details of the fabrication process and measurements of microstrip resonators.

IEEE Transactions on Applied Superconductivity•Jan 24, 2013•24 citations
We study NbTiN resonators by measurements of the temperature dependent resonance frequency and frequency noise. Additionally, resonators are studied covered with SiOx dielectric layers of various thicknesses. The resonance frequency develops a nonmonotonic temperature dependence with increasing SiOx layer thickness. The increase in the noise is independent of the SiOx thickness, demonstrating that the noise is not dominantly related to the low temperature resonance frequency deviations.
We present measurements of the frequency noise and resonance frequency temperature dependence in planar superconducting resonators on both silicon and sapphire substrates. We show, by covering the resonators with sputtered SiOxlayers of different thicknesses, that the temperature dependence of the resonance frequency scales linearly with thickness, whereas the observed increase in noise is independent of thickness. The frequency noise decreases when increasing the width of the coplanar waveguide in NbTiN on hydrogen passivated silicon devices, most effectively by widening the gap. We find up to an order of magnitude more noise when using sapphire instead of silicon as substrate. The complete set of data points towards the noise being strongly affected by superconductor-dielectric interfaces.
We have measured the temperature dependence of the resonance frequency and quality factor of superconducting resonators made of a 300 nm thick NbTiN and 10 nm thick Au bilayer down to a temperature of 350 mK. At low temperatures we find a strong temperature dependence compared to bare NbTiN resonators: when increasing the temperature from 350 mK to 2 K the quality factor drops from a value of 105 down to 103 and the frequency decreases by about 1%. This while for bare NbTiN the quality factor remains on the order of 106 and the fractional frequency change remains below 10−4. These results indicate that the proximitised thin Au layer dominates the low temperature properties. Using the Usadel equations and Nam’s expression for the complex conductivity we can accurately describe the data assuming an interface transparency of 0.15.
Slow noise processes, with characteristic timescales $\ensuremath{\sim}$1 s, have been studied in planar superconducting resonators. A frequency-locked loop is employed to track deviations of the resonator center frequency with high precision and bandwidth. Comparative measurements are made in varying microwave drive and temperature, and between bare resonators and those with an additional dielectric layer. All resonators are found to exhibit flicker frequency noise which increases with decreasing microwave drive. We also show that an increase in temperature results in a saturation of flicker noise in resonators with an additional dielectric layer, while bare resonators stop exhibiting flicker noise, instead showing a random frequency walk process.
We present measurements of the temperature and power dependence of the resonance frequency and frequency noise of superconducting niobium thin-film coplanar waveguide resonators carried out at temperatures well below the superconducting transition (Tc=9.2K). The noise decreases by nearly two orders of magnitude as the temperature is increased from 120to1200mK, while the variation of the resonance frequency with temperature over this range agrees well with the standard two-level system (TLS) model for amorphous dielectrics. These results support the hypothesis that TLSs are responsible for the noise in superconducting microresonators and have important implications for resonator applications such as qubits and photon detectors.
Dielectric loss in low-temperature superconducting integrated circuits can cause lower overall efficiency, particularly in the 90 to 220 GHz regime. We present a method to tune the dielectric loss for silicon oxide deposited by plasma-enhanced chemical-vapor deposition at ambient temperatures. Deposition in an environment with a higher silane-to-oxygen ratio produces silicon oxide films with a lower loss-tangent and a slightly higher optical index of refraction, while contributing no appreciable change in film stress. We measured the dielectric loss by fabricating a series of Nb-SiOx-Nb microstrip resonators in the frequency range of 6 to 9 GHz and comparing their temperature dependence to a model of parasitic two-level-system fluctuators. The dielectric loss-tangent of silicon oxide was improved from 6 ×10-3for stoichiometric silicon dioxide to 2 ×10-3for a more silicon-rich silicon oxide. We present details of the fabrication process and measurements of microstrip resonators.