Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:0706.1903 · Applied Physics B

Ultra-cold atoms in an optical cavity: two-mode laser locking to the cavity avoiding radiation pressure

Simone Bux, Gordon Krenz, Sebastian Slama, Claus Zimmermann, Ph. W. Courteille

Published Oct 20, 2007• 6 citations
arXivHTMLPDF
DOI
10.1007/s00340-007-2793-5

Related papers

Avoiding radiation pressure in an optical cavity interacting with ultra-cold atoms

Simone Bux, Gordon Krenz, Sebastian Slama +2 more

•Jun 13, 2007•0 citations

Cold atoms inside an optical cavity

Jean-Michel Courty, Astrid Lambrecht, E. Giacobino

European Quantum Electronics Conference (EQEC)•Aug 24, 2005•0 citations

A Laser-cooled Cesium Fountain Frequency Standard and a Measurement of the Frequency Shift due to Ultra-cold Collisions

Kurt Gibble, Steven Kasapi, Steven Chu

In our Cs atomic fountain, we laser cooled and trapped 10(exp 10) Cs atoms in 0.4 s. By shifting the frequencies of the laser beams, the atoms were launched upwards at 2.5 m/s and a fraction of the atoms were optically pumped into the F=3 ground state. The unwanted atoms in the F=4 ground state were removed from the fountain with radiation pressure from a laser beam tuned to excite only those atoms. The Cs atoms in the F=3 state traveled ballistically upwards, were excited by the microwave cavity, and then returned back through the same cavity in the atomic fountain configuration.

•Jun 1, 1993•0 citations

Cold Atoms Inside Optical Cavity: Beyond the Semi-classical Treatment

Chuanzhou Zhu, Dong Lin, Han Pu

Bulletin of the American Physical Society•Jun 6, 2017•0 citations

A novel experiment for coupling a Bose-Einstein condensate with two crossed cavity modes

Tobias Donner, Julian Léonard, Moojnoo Lee +3 more

Gate valve ◦ advancing the research area of cold atoms and cavity quantum electrodynamics requires setups with different cavity geometries ◦ typically only modifiable with large effort by breaking the ultra-high vacuum ◦ our approach: use a bipartite vacuum chamber with an integrated load lock chamber ◦ only a small science platform is exchanged ◦ we successfully transfer the platform while maintaining a pressure of ~1∙10-11 mBar in the science chamber The transfer system Properties

Bulletin of the American Physical Society•Jun 4, 2014•0 citations

Quantum and dynamical back-action effects using a gram-scale mechanical resonator in a high-finesse optical cavity

Alexandros Tavernarakis

Cavity Optomechanics, that is the study of the interaction between an optical cavity mode and a mechanical degree of freedom, has known impressive evolution over the past decade, to become a new field at the union of condensed matter physics and optics. One of the major goals of this discipline is to test and study quantum mechanics using macroscopic systems. Among the most fundamental problems the community aims to address is the question of the quantum limits in position measurement. Quantum mechanics predicts that any measurement comes along with a backaction, which perturbs the state of the measured system. Moreover, it is expected to be conjugated with the quantum noise of the measurement apparatus (called measurement noise) used to probe the system. The optimal sensitivity is reached whenever both the measurement and the backaction noise are identical, a situation which can be assimilated to the acceptance of Heisenberg's inequality for the measurement apparatus. In cavity optomechanics, the mode of an optical cavity is used as a measurement apparatus of the position of a mechanical resonator which is expected to be responsible for the backaction imprecision. However, this so-called radiation pressure quantum backaction has never been observed to date, while it remains a decisive step towards understanding quantum measurement processes. We describe in this manuscript the study of radiation pressure effects in cavity optomechanics. We introduce the optomechanical system we have developed, which consists in a cm-scale ultra high Q (~ 1 000 000) plano-convex mechanical resonator incorporated into a ultra-high finesse (~ 300 000) Fabry-Prot cavity. We present two important results we obtained with this system. First, we were able to report the first direct observation of radiation pressure in real-time, based on establishing pump-probe correlations. We were also able to demonstrate for the first time nonlinear backaction effects related to substantial improvement of position measurement sensitivity. We explain why demonstrating quantum backaction requires ultra-high stability of the optical mode. We present important changes made to the previous experimental setup, notably on the laser source, on the detection and the stabilization of the experiment. We then describe a new optomechanical detection technique providing an independent measurement of the cavity detuning. Finally, we present a proof-of-principle experiment allowing to extract quantum optomechanical correlations at room temperature.

•Dec 20, 2012•0 citations
In our Cs atomic fountain, we laser cooled and trapped 10(exp 10) Cs atoms in 0.4 s. By shifting the frequencies of the laser beams, the atoms were launched upwards at 2.5 m/s and a fraction of the atoms were optically pumped into the F=3 ground state. The unwanted atoms in the F=4 ground state were removed from the fountain with radiation pressure from a laser beam tuned to excite only those atoms. The Cs atoms in the F=3 state traveled ballistically upwards, were excited by the microwave cavity, and then returned back through the same cavity in the atomic fountain configuration.
Cavity Optomechanics, that is the study of the interaction between an optical cavity mode and a mechanical degree of freedom, has known impressive evolution over the past decade, to become a new field at the union of condensed matter physics and optics. One of the major goals of this discipline is to test and study quantum mechanics using macroscopic systems. Among the most fundamental problems the community aims to address is the question of the quantum limits in position measurement. Quantum mechanics predicts that any measurement comes along with a backaction, which perturbs the state of the measured system. Moreover, it is expected to be conjugated with the quantum noise of the measurement apparatus (called measurement noise) used to probe the system. The optimal sensitivity is reached whenever both the measurement and the backaction noise are identical, a situation which can be assimilated to the acceptance of Heisenberg's inequality for the measurement apparatus. In cavity optomechanics, the mode of an optical cavity is used as a measurement apparatus of the position of a mechanical resonator which is expected to be responsible for the backaction imprecision. However, this so-called radiation pressure quantum backaction has never been observed to date, while it remains a decisive step towards understanding quantum measurement processes. We describe in this manuscript the study of radiation pressure effects in cavity optomechanics. We introduce the optomechanical system we have developed, which consists in a cm-scale ultra high Q (~ 1 000 000) plano-convex mechanical resonator incorporated into a ultra-high finesse (~ 300 000) Fabry-Prot cavity. We present two important results we obtained with this system. First, we were able to report the first direct observation of radiation pressure in real-time, based on establishing pump-probe correlations. We were also able to demonstrate for the first time nonlinear backaction effects related to substantial improvement of position measurement sensitivity. We explain why demonstrating quantum backaction requires ultra-high stability of the optical mode. We present important changes made to the previous experimental setup, notably on the laser source, on the detection and the stabilization of the experiment. We then describe a new optomechanical detection technique providing an independent measurement of the cavity detuning. Finally, we present a proof-of-principle experiment allowing to extract quantum optomechanical correlations at room temperature.