Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:quant-ph/9805048

Generating and monitoring Schrödinger cats in conditional measurement on a beam splitter

Mohammed Dakna, Clausen, J., Knoll, L., Welsch, D. -G.

Published May 16, 1998• 0 citations
arXivHTMLPDF

Abstract

Preparation of Schrödinger-cat-like states via conditional output measurement on a beam splitter is studied. In the scheme, a mode prepared in a squeezed vacuum is mixed with a mode prepared in a Fock state and photocounting is performed in one of the output channels of the beam splitter. In this way the mode in the other output channel is prepared in a Schrödinger-cat-like state that is either a photon-subtracted or a photon-added Jacobi polynomial squeezed vacuum state, depending upon the difference between the number of photons in the input Fock state and the number of photons in the output Fock state onto which it is projected. Two possible photocounting schemes are considered, and the problem of monitoring cats that are ``hidden'' in a statistical mixture of states is studied.

DOI
10.48550/arxiv.quant-ph/9805048

Related papers

Quantum state engineering using conditional measurement on a beam splitter

Mohammed Dakna, L. Knöll, Welsch, D. -G.

State preparation via conditional output measurement on a beam splitter is studied, assuming the signal mode is mixed with a mode prepared in a Fock state and photon numbers are measured in one of the output channels. It is shown that the mode in the other output channel is prepared in either a photon-subtracted or a photon-added Jacobi polynomial state, depending upon the difference between the number of photons in the input Fock state and the number of photons in the output Fock state onto which it is projected. The properties of the conditional output states are studied for coherent and squeezed input states, and the probabilities of generating the states are calculated. Relations to other states, such as near-photon-number states and squeezed-state-excitations, are given and proposals are made for generating them by combining the scheme with others. Finally, effects of realistic photocounting and Fock-state preparation are discussed.

arXiv:quant-ph/9803077•The European Physical Journal C•Mar 26, 1998•3 citations

Generating Schrödinger-cat-like states by means of conditional measurements on a beam splitter

Mohammed Dakna, Tiemo Anhut, Tomáš Opatrný +2 more

A scheme for generating Schr\"odinger-cat-like states of a single-mode optical field by means of conditional measurement is proposed. Feeding a squeezed vacuum into a beam splitter and counting the photons in one of the output channels, the conditional states in the other output channel exhibit a number of properties that are very similar to those of superpositions of two coherent states with opposite phases. We present analytical and numerical results for the photon-number and quadrature-component distributions of the conditional states and their Wigner and Husimi functions. Further, we discuss the effect of realistic photocounting on the states.

arXiv:quant-ph/9612011•Physical Review A•Apr 1, 1997•447 citations

Photon adding and subtracting and Schroedinger-cat generation in conditional output measurement on a beam splitter

D.‐G. Welsch, Mohammed Dakna, L. Knöll +1 more

The problem of photon adding and subtracting is studied, using conditional output measurement on a beam splitter. It is shown that for various classes of states the corresponding photon-added and -subtracted states can be prepared. Analytical results are presented, with special emphasis on photon-added and -subtracted squeezed vacuum states, which are found to represent two different types of Schroedinger-cat-like states. Effects of realistic photocounting and Fock-state preparation are discussed.

arXiv:quant-ph/9708018•Aug 9, 1997•1 citation

Photon-added state preparation via conditional measurement on a beam splitter

Mohammed Dakna, Knöll, L, Welsch, D G

We show that conditional output measurement on a beam splitter may be used to produce photon-added states for a large class of signal-mode quantum states, such as thermal states, coherent states, squeezed states, displaced photon-number states, and coherent phase states. Combining a mode prepared in such a state and a mode prepared in a photon-number state, the state of the mode in one of the output channels of the beam splitter ``collapses'' to a photon-added state, provided that no photons are detected in the other output channel. We present analytical and numerical results, with special emphasis on photon-added coherent and squeezed vacuum states. In particular, we show that adding photons to a squeezed vacuum yields superpositions of quantum states which show all the typical features of Schrödinger-cat-like states.

•Mar 24, 1997•61 citations

Generating Hermite polynomial excited squeezed states by means of conditional measurements on a beam splitter

Xue-xiang Xu, Hong‐Chun Yuan, Hong-Yi Fan

A scheme for conditional generating Hermite polynomial excited squeezed vacuum states (HPESVS) is proposed. Injecting a two-mode squeezed vacuum state (TMSVS) into a beam splitter (BS) and counting the photons in one of the output channels, the conditional state in the other output channel is just a HPESVS. To exhibit a number of nonclassical effects and non-Gaussianity, we mainly investigate the photon number distribution, sub-Poissonian distribution, quadrature component distribution, and Wigner function of the conditional HPESVS. We find that its nonclassicality closely relates to the control parameter of the BS, the squeezed parameter of TMSVS, and the photon number of conditional measurement. These further demonstrate that performing the conditional measurement on a BS is an effective approach to generate non-Gaussian state.

arXiv:1503.04919•Journal of the Optical Society of America B•May 15, 2015•19 citations

Measurement-induced amplification of optical cat-like states

Amine Laghaout, Jonas Schou Neergaard-Nielsen, Johannes Rigas +3 more

Coherent state superpositions, also known as Schrödinger cat states, are widely recognized as promising resources in quantum information, quantum metrology, as well as fundamental tests. These states are hard to produce deterministically and most schemes for their probabilistic generation can only attain amplitudes too small for practical use. This is for example the case for photon-subtracted squeezed vacuum (PSSV), which can be used to approximate cat states of amplitude no larger than y = 1.5 if the fidelity is to be maintained above 95%. One way to reach larger amplitudes is to start with pairs of small cats and then to interfere them on a balanced beam splitter. The projective measurement of one of the outputs is used to herald a larger cat resulting from the constructive interference of the initial states. The scheme proposed here uses the projection |x = 0〉〈x = 0| as the heralding condition. Homodyning is proposed, as opposed to photon counting, because homodyne detection has high a quantum efficiency, and - as demonstrated in the paper - can be tuned to increase the success probability of the amplification without heavily compromising the output's fidelity.

Conference on Lasers and Electro-Optics Europe & European Quantum Electronics Conference (CLEO/Europe-EQEC)•May 1, 2013•0 citations
Preparation of Schrödinger-cat-like states via conditional output measurement on a beam splitter is studied. In the scheme, a mode prepared in a squeezed vacuum is mixed with a mode prepared in a Fock state and photocounting is performed in one of the output channels of the beam splitter. In this way the mode in the other output channel is prepared in a Schrödinger-cat-like state that is either a photon-subtracted or a photon-added Jacobi polynomial squeezed vacuum state, depending upon the difference between the number of photons in the input Fock state and the number of photons in the output Fock state onto which it is projected. Two possible photocounting schemes are considered, and the problem of monitoring cats that are ``hidden'' in a statistical mixture of states is studied.
State preparation via conditional output measurement on a beam splitter is studied, assuming the signal mode is mixed with a mode prepared in a Fock state and photon numbers are measured in one of the output channels. It is shown that the mode in the other output channel is prepared in either a photon-subtracted or a photon-added Jacobi polynomial state, depending upon the difference between the number of photons in the input Fock state and the number of photons in the output Fock state onto which it is projected. The properties of the conditional output states are studied for coherent and squeezed input states, and the probabilities of generating the states are calculated. Relations to other states, such as near-photon-number states and squeezed-state-excitations, are given and proposals are made for generating them by combining the scheme with others. Finally, effects of realistic photocounting and Fock-state preparation are discussed.
A scheme for generating Schr\"odinger-cat-like states of a single-mode optical field by means of conditional measurement is proposed. Feeding a squeezed vacuum into a beam splitter and counting the photons in one of the output channels, the conditional states in the other output channel exhibit a number of properties that are very similar to those of superpositions of two coherent states with opposite phases. We present analytical and numerical results for the photon-number and quadrature-component distributions of the conditional states and their Wigner and Husimi functions. Further, we discuss the effect of realistic photocounting on the states.
The problem of photon adding and subtracting is studied, using conditional output measurement on a beam splitter. It is shown that for various classes of states the corresponding photon-added and -subtracted states can be prepared. Analytical results are presented, with special emphasis on photon-added and -subtracted squeezed vacuum states, which are found to represent two different types of Schroedinger-cat-like states. Effects of realistic photocounting and Fock-state preparation are discussed.
We show that conditional output measurement on a beam splitter may be used to produce photon-added states for a large class of signal-mode quantum states, such as thermal states, coherent states, squeezed states, displaced photon-number states, and coherent phase states. Combining a mode prepared in such a state and a mode prepared in a photon-number state, the state of the mode in one of the output channels of the beam splitter ``collapses'' to a photon-added state, provided that no photons are detected in the other output channel. We present analytical and numerical results, with special emphasis on photon-added coherent and squeezed vacuum states. In particular, we show that adding photons to a squeezed vacuum yields superpositions of quantum states which show all the typical features of Schrödinger-cat-like states.
A scheme for conditional generating Hermite polynomial excited squeezed vacuum states (HPESVS) is proposed. Injecting a two-mode squeezed vacuum state (TMSVS) into a beam splitter (BS) and counting the photons in one of the output channels, the conditional state in the other output channel is just a HPESVS. To exhibit a number of nonclassical effects and non-Gaussianity, we mainly investigate the photon number distribution, sub-Poissonian distribution, quadrature component distribution, and Wigner function of the conditional HPESVS. We find that its nonclassicality closely relates to the control parameter of the BS, the squeezed parameter of TMSVS, and the photon number of conditional measurement. These further demonstrate that performing the conditional measurement on a BS is an effective approach to generate non-Gaussian state.
Coherent state superpositions, also known as Schrödinger cat states, are widely recognized as promising resources in quantum information, quantum metrology, as well as fundamental tests. These states are hard to produce deterministically and most schemes for their probabilistic generation can only attain amplitudes too small for practical use. This is for example the case for photon-subtracted squeezed vacuum (PSSV), which can be used to approximate cat states of amplitude no larger than y = 1.5 if the fidelity is to be maintained above 95%. One way to reach larger amplitudes is to start with pairs of small cats and then to interfere them on a balanced beam splitter. The projective measurement of one of the outputs is used to herald a larger cat resulting from the constructive interference of the initial states. The scheme proposed here uses the projection |x = 0〉〈x = 0| as the heralding condition. Homodyning is proposed, as opposed to photon counting, because homodyne detection has high a quantum efficiency, and - as demonstrated in the paper - can be tuned to increase the success probability of the amplification without heavily compromising the output's fidelity.