Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:quant-ph/0511254 · Optics Letters

Mid-infrared single-photon counting

Guilherme P. Temporão, Sébastien Tanzilli, Hugo Zbinden, Nicolas Gisin, Thierry Aellen, Marcella Giovannini, Jérôme Faist

Published Mar 29, 2006• 62 citations
arXivHTMLPDF

Abstract

We report a procedure to detect mid-infrared single photons at 4.65 microm by means of a two-stage scheme based on sum-frequency generation, by using a periodically poled lithium niobate nonlinear crystal and a silicon avalanche photodiode. An experimental investigation shows that, in addition to a high timing resolution, this technique yields a detection sensitivity of 1.24 pW with 63 mW of net pump power.

DOI
10.1364/ol.31.001094

Related papers

High efficiency single photon detection via frequency up-conversion

Aaron P. VanDevender, Paul G. Kwiat

We propose a method of single photon detection of infrared (IR) photons at potentially higher efficiencies and lower noise than allowed by traditional IR band avalanche photodiodes (APDs). By up-converting the photon from the IR, e.g. 1550 nm, to a visible wavelength in a nonlinear crystal, we can utilize the much higher efficiency of silicon APDs at these wavelengths. We have used a periodically poled lithium niobate (PPLN) crystal and a pulsed 1064 nm Nd:YAG laser to perform the up-conversion to a 631 nm photon. We observed conversion efficiencies as high as ∼ 80%, and demonstrated scaling down to the single photon level while maintaining a background of 3 ×s; 10−4 dark counts per count. We also propose a 2-crystal extension of this scheme, whereby orthogonal polarizations may be up-converted coherently, thus enabling complete quantum state transduction of arbitrary states.

Journal of Modern Optics•Jun 1, 2004•214 citations

High efficiency single photon detection via frequency up-conversion

Aaron P. VanDevender, Paul G. Kwiat

We propose a method of single photon detection of infrared (IR) photons at potentially higher efficiencies and lower noise than allowed by traditional IR band avalanche photodiodes (APDs). By up-converting the photon from the IR, e.g. 1550 nm, to a visible wavelength in a nonlinear crystal, we can utilize the much higher efficiency of silicon APDs at these wavelengths. We have used a periodically poled lithium niobate (PPLN) crystal and a pulsed 1064 nm Nd:YAG laser to perform the up-conversion to a 631 nm photon. We observed conversion efficiencies as high as ∼ 80%, and demonstrated scaling down to the single photon level while maintaining a background of 3 ×s; 10−4 dark counts per count. We also propose a 2-crystal extension of this scheme, whereby orthogonal polarizations may be up-converted coherently, thus enabling complete quantum state transduction of arbitrary states.

Journal of Modern Optics•Jan 1, 2004•29 citations

Periodically poled lithium niobate waveguide sum-frequency generator for efficient single-photon detection at communication wavelengths

Rostislav V. Roussev, Carsten Langrock, Jonathan R. Kurz +1 more

We present a device to facilitate single-photon detection at communication wavelengths based on continuous-wave sum-frequency generation with an upconversion efficiency exceeding 90%. Sum-frequency generation in a periodically poled lithium niobate waveguide is used to upconvert signal photons to the near infrared, where detection can be performed efficiently by use of silicon avalanche photodiodes.

Optics Letters•Jul 1, 2004•188 citations

High-efficiency single photon detection via frequency up-conversion

Aaron P. VanDevender, Paul G. Kwiat

We propose a method of single photon detection of infrared (IR) photons at potentially higher efficiencies and lower noise than allowed by traditional IR band Avalanche Photodiodes (APD). By up-converting the photon from IR, e.g., 1550 nm, to a visible wavelength in a nonlinear crystal, we can utilize the much higher efficiency of visible wavelength APDs. We have used a nonlinear crystal -- Periodically Poled Lithium Niobate (PPLN) -- and a pulsed 1064-nm Nd:YAG laser to perform the up-conversion to a 631-nm photon. When properly quasi-phase-matched, PPLN provides a large enough second order nonlinear susceptibility that near unit conversion efficiency of the IR photon into the visible should be possible. We have been able to observe peak conversion efficiencies as high as 80%, and have demonstrated scaling down to the single photon level while maintaining a background of 3 x 10-4 dark counts/count. Since the PPLN only acts on one polarization of the single photon, we also propose a 2-crystal extension of this scheme whereby orthogonal polarizations may be up-converted coherently, thereby enabling complete quantum state transduction.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Aug 5, 2003•8 citations

New results on single-photon upconversion

Aaron P. VanDevender, Paul G. Kwiat

The process of up-conversion is shown to enable superior single-photon detectors in the infrared, compared to InGaAs and germanium Avalanche Photodiodes (APDs) (normally used for IR single photon detection). After up-converting an infrared photon to a visible one in a non-linear crystal-Periodically Poled Lithium Niobate (PPLN)-we use a silicon APD to efficiently detect the frequency up-shifted IR photon. We have demonstrated this process at the "high-intensity" level and at the single-photon level, where the up-converted state is effectively a superposition of the single photon Fock state and the vacuum state. We achieve an 80% conversion efficiency over the width of the pulse, and show that this process is coherent, a necessary ingredient for many applications.

Proceedings of SPIE, the International Society for Optical Engineering/Proceedings of SPIE•Oct 19, 2004•1 citation

Upconversion detection of 1.25 Gb/s mid-infrared telecommunications using a silicon avalanche photodiode

Alan C. Gray, Sam A. Berry, Lewis G. Carpenter +3 more

With an ever-increasing interest in secure and reliable free-space optical communication, upconversion detectors enabled through nonlinear optical processes are an attractive route to transmitting data as a mid-infrared signal. This spectral region is known to have a higher transmissivity through the atmosphere. In this work, we present an upconversion scheme for detection in the silicon absorption band using magnesium-oxide doped periodically poled lithium niobate to generate 21 mW of a 3.4 µm signal from commercial laser sources using a difference frequency generation process. Following a further nonlinear frequency conversion, via sum-frequency generation, the resulting signal at 809 nm is detected. We achieve >50 µW of signal and bit error rates of 10−7 from a single-pass nonlinear conversion for both the transmitter and receiver systems without the need for additional optical amplifiers at the receiving end. The error rates due to potentially reduced laser powers at the receiver end are investigated and laser noise transfer through our system is discussed.

Optics Express•Oct 5, 2020•9 citations
We report a procedure to detect mid-infrared single photons at 4.65 microm by means of a two-stage scheme based on sum-frequency generation, by using a periodically poled lithium niobate nonlinear crystal and a silicon avalanche photodiode. An experimental investigation shows that, in addition to a high timing resolution, this technique yields a detection sensitivity of 1.24 pW with 63 mW of net pump power.
We propose a method of single photon detection of infrared (IR) photons at potentially higher efficiencies and lower noise than allowed by traditional IR band avalanche photodiodes (APDs). By up-converting the photon from the IR, e.g. 1550 nm, to a visible wavelength in a nonlinear crystal, we can utilize the much higher efficiency of silicon APDs at these wavelengths. We have used a periodically poled lithium niobate (PPLN) crystal and a pulsed 1064 nm Nd:YAG laser to perform the up-conversion to a 631 nm photon. We observed conversion efficiencies as high as ∼ 80%, and demonstrated scaling down to the single photon level while maintaining a background of 3 ×s; 10−4 dark counts per count. We also propose a 2-crystal extension of this scheme, whereby orthogonal polarizations may be up-converted coherently, thus enabling complete quantum state transduction of arbitrary states.
We propose a method of single photon detection of infrared (IR) photons at potentially higher efficiencies and lower noise than allowed by traditional IR band avalanche photodiodes (APDs). By up-converting the photon from the IR, e.g. 1550 nm, to a visible wavelength in a nonlinear crystal, we can utilize the much higher efficiency of silicon APDs at these wavelengths. We have used a periodically poled lithium niobate (PPLN) crystal and a pulsed 1064 nm Nd:YAG laser to perform the up-conversion to a 631 nm photon. We observed conversion efficiencies as high as ∼ 80%, and demonstrated scaling down to the single photon level while maintaining a background of 3 ×s; 10−4 dark counts per count. We also propose a 2-crystal extension of this scheme, whereby orthogonal polarizations may be up-converted coherently, thus enabling complete quantum state transduction of arbitrary states.
We propose a method of single photon detection of infrared (IR) photons at potentially higher efficiencies and lower noise than allowed by traditional IR band Avalanche Photodiodes (APD). By up-converting the photon from IR, e.g., 1550 nm, to a visible wavelength in a nonlinear crystal, we can utilize the much higher efficiency of visible wavelength APDs. We have used a nonlinear crystal -- Periodically Poled Lithium Niobate (PPLN) -- and a pulsed 1064-nm Nd:YAG laser to perform the up-conversion to a 631-nm photon. When properly quasi-phase-matched, PPLN provides a large enough second order nonlinear susceptibility that near unit conversion efficiency of the IR photon into the visible should be possible. We have been able to observe peak conversion efficiencies as high as 80%, and have demonstrated scaling down to the single photon level while maintaining a background of 3 x 10-4 dark counts/count. Since the PPLN only acts on one polarization of the single photon, we also propose a 2-crystal extension of this scheme whereby orthogonal polarizations may be up-converted coherently, thereby enabling complete quantum state transduction.
The process of up-conversion is shown to enable superior single-photon detectors in the infrared, compared to InGaAs and germanium Avalanche Photodiodes (APDs) (normally used for IR single photon detection). After up-converting an infrared photon to a visible one in a non-linear crystal-Periodically Poled Lithium Niobate (PPLN)-we use a silicon APD to efficiently detect the frequency up-shifted IR photon. We have demonstrated this process at the "high-intensity" level and at the single-photon level, where the up-converted state is effectively a superposition of the single photon Fock state and the vacuum state. We achieve an 80% conversion efficiency over the width of the pulse, and show that this process is coherent, a necessary ingredient for many applications.
With an ever-increasing interest in secure and reliable free-space optical communication, upconversion detectors enabled through nonlinear optical processes are an attractive route to transmitting data as a mid-infrared signal. This spectral region is known to have a higher transmissivity through the atmosphere. In this work, we present an upconversion scheme for detection in the silicon absorption band using magnesium-oxide doped periodically poled lithium niobate to generate 21 mW of a 3.4 µm signal from commercial laser sources using a difference frequency generation process. Following a further nonlinear frequency conversion, via sum-frequency generation, the resulting signal at 809 nm is detected. We achieve >50 µW of signal and bit error rates of 10−7 from a single-pass nonlinear conversion for both the transmitter and receiver systems without the need for additional optical amplifiers at the receiving end. The error rates due to potentially reduced laser powers at the receiver end are investigated and laser noise transfer through our system is discussed.