Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:quant-ph/0306008 · IEEE International Workshop on Workload Characterization (WWC)

Quantum system identification

Maxim Raginsky

Published Apr 23, 2004• 3 citations
arXivHTMLPDF

Abstract

We formulate and study, in general terms, the problem of quantum system identification, i.e., the determination (or estimation) of unknown quantum channels through their action on suitably chosen input density operators. We also present a quantitative analysis of the worst-case performance of these schemes.
DOI
10.1109/phycon.2003.1237004

Related papers

Identification and Estimation of Quantum Linear Input-Output Systems

Levitt, Matthew, Guţă, Mădălin, Kypraios, Theodore

The system identification problem is to estimate dynamical parameters from the output data, obtained by performing measurements on the output fields. We investigate system identification for quantum linear systems. Our main objectives are to address the following general problems: (1) Which parameters can be identified by measuring the output? (2) How can we construct a system realisation from sufficient input-output data? (3) How well can we estimate the parameters governing the dynamics? We investigate these problems in two contrasting approaches; using time-dependent inputs or time-stationary (quantum noise) inputs.

arXiv:1712.08531•Dec 22, 2017•0 citations

Generalized Moment Problems for Estimation of Spectral Densities and Quantum Channels

Mattia Zorzi, Augusto Ferrante

This thesis is concerned with two generalized moment problems arising in the estimation of stochastic models. Firstly, we consider the THREE approach, introduced by Byrnes Georgiou and Lindquist, for estimating spectral densities. Here, the output covariance matrix of a known bank of filters is used to extract information on the input spectral density which needs to be estimated. The parametrization of the family of spectral densities matching the output covariance is a generalized moment problem. An estimate of the input spectral density is then chosen from this family. The choice criterium is based on the minimization of a suitable divergence index among spectral densities. After the introduction of the THREE-like paradigm, we present a multivariate extension of the Beta divergence for solving the problem. Afterward, we deal with the estimation of the output covariance of the filters bank given a finite-length data generated by the unknown input spectral density. Secondly, we deal with the quantum process tomography. This problem consists in the estimation of a quantum channel which can be thought as the quantum equivalent of the Markov transition matrix in the classical setting. Here, a quantum system prepared in a known pure state is fed to the unknown channel. A measurement of an observable is performed on the output state. The set of the employed pure states and observables represents the experimental setting. Again, the parametrization of the family of quantum channels matching the measurements is a generalized moment problem. The choice criterium for the best estimate in this family is based on the maximization of maximum likelihood functionals. The corresponding estimate, however, may not be unique since the experimental setting is not "rich" enough in many cases of interest. We characterize the minimal experimental setting which guarantees the uniqueness of the estimate. Numerical simulation evidences that experimental settings richer than the minimal one do not lead to better performances

•Jan 21, 2013•0 citations

Locality and nonlocality in quantum pure-state identification problems

Yuki Ishida, T. Hashimoto, M. Horibe +1 more

Suppose we want to identify an input state with one of two unknown reference states, where the input state is guaranteed to be equal to one of the reference states. We assume that no classical knowledge of the reference states is given, but a certain number of copies of them are available instead. Two reference states are independently and randomly chosen from the state space in a unitary invariant way. This is called the quantum state identification problem, and the task is to optimize the mean identification success probability. In this paper, we consider the case where each reference state is pure and bipartite, and generally entangled. The question is whether the maximum mean identification success probability can be attained by means of a local operations and classical communication (LOCC) measurement scheme. Two types of identification problem are considered when a single copy of each reference state is available. We show that a LOCC scheme attains the globally achievable identification probability in the minimum-error identification problem. In the unambiguous identification problem, however, the maximal success probability by means of LOCC is shown to be less than the globally achievable identification probability.

arXiv:0807.1364•Physical Review A•Jul 8, 2008•13 citations

Measuring and Characterizing Quantum States and Processes

Daniel F. V. James

I will give an introductory overview of current experimental techniques used to characterize the density matrix of a system and the quantum process describing a device, with emphasis on applications in quantum optics.

Conference on Lasers and Electro-Optics•Jan 1, 2010•0 citations

Exact identification of unknown unitary processes

Santiago Llorens, Arnau Diebra, Michal Sedlák +1 more

The accurate identification of faulty hardware is a fundamental requirement for reliable quantum information processing. We address this problem in a quantum setting, where a series of $n$ devices is intended to apply the same unitary operation, but $k$ malfunctioning devices among them apply a different, unknown unitary action. Under the assumption of complete ignorance regarding the specific unitary transformation applied, we model our hypotheses using representation-theoretic tools and study the zero-error protocol for identifying these faulty devices. We derive the optimal success probability for the single- and two-anomaly scenarios, demonstrating that it is independent of the total number of devices in the series. Furthermore, we present a simple protocol that makes use of ancillary systems that achieves this optimal limit. Notably, this protocol offers significant operational advantages, such as allowing us to test each device independently. Finally, we extend our analysis to the general scenario in which both the number of anomalies and the local dimension of the systems are arbitrary, evaluating our protocol's performance and conjecturing its global optimality in the general case.

quant-pharXiv:2605.04981•May 7, 2026•0 citations

Convex Optimization-Based Parameter Estimation and Experiment Design for Pauli Channels

Gábor Balló, Katalin Mária Hangos, D�nes Petz

In this technical note, we study the problem of parameter estimation for quantum channels, which are (completely positive) maps acting on quantum states. We focus on an important subclass of channels called Pauli channels which are characterized by a certain set of vectors (directions) and a number of scalar parameters. For the case where the directions are known, a special parametrization turns the parameter estimation problem into a convex optimization problem. For the case of unknown directions we give a simple algorithm to estimate the directions for qubit Pauli channels. These results assume that the identification experiment configuration is given, namely, a set of quantum states are given on which the channel acts, and a set of positive measurement (operator)s are fixed from which information is gathered. In the second part of the technical note we consider the problem of determining the experiment design, namely, determining states and measurements for optimal parameter identification of the channels. We formalize this problem as a maximization problem for Fisher information and, assuming known channel directions, prove that this problem is convex. We also prove that the optimal states to be used in experiments are pure and the optimal measurements are extremal. For qubit Pauli channels we prove that both the optimal pure input states and projective measurements should be directed towards the channel directions. We illustrate the results of the technical note with numerical examples and simulations.

IEEE Transactions on Automatic Control•Jul 19, 2012•10 citations
The system identification problem is to estimate dynamical parameters from the output data, obtained by performing measurements on the output fields. We investigate system identification for quantum linear systems. Our main objectives are to address the following general problems: (1) Which parameters can be identified by measuring the output? (2) How can we construct a system realisation from sufficient input-output data? (3) How well can we estimate the parameters governing the dynamics? We investigate these problems in two contrasting approaches; using time-dependent inputs or time-stationary (quantum noise) inputs.
This thesis is concerned with two generalized moment problems arising in the estimation of stochastic models. Firstly, we consider the THREE approach, introduced by Byrnes Georgiou and Lindquist, for estimating spectral densities. Here, the output covariance matrix of a known bank of filters is used to extract information on the input spectral density which needs to be estimated. The parametrization of the family of spectral densities matching the output covariance is a generalized moment problem. An estimate of the input spectral density is then chosen from this family. The choice criterium is based on the minimization of a suitable divergence index among spectral densities. After the introduction of the THREE-like paradigm, we present a multivariate extension of the Beta divergence for solving the problem. Afterward, we deal with the estimation of the output covariance of the filters bank given a finite-length data generated by the unknown input spectral density. Secondly, we deal with the quantum process tomography. This problem consists in the estimation of a quantum channel which can be thought as the quantum equivalent of the Markov transition matrix in the classical setting. Here, a quantum system prepared in a known pure state is fed to the unknown channel. A measurement of an observable is performed on the output state. The set of the employed pure states and observables represents the experimental setting. Again, the parametrization of the family of quantum channels matching the measurements is a generalized moment problem. The choice criterium for the best estimate in this family is based on the maximization of maximum likelihood functionals. The corresponding estimate, however, may not be unique since the experimental setting is not "rich" enough in many cases of interest. We characterize the minimal experimental setting which guarantees the uniqueness of the estimate. Numerical simulation evidences that experimental settings richer than the minimal one do not lead to better performances
Suppose we want to identify an input state with one of two unknown reference states, where the input state is guaranteed to be equal to one of the reference states. We assume that no classical knowledge of the reference states is given, but a certain number of copies of them are available instead. Two reference states are independently and randomly chosen from the state space in a unitary invariant way. This is called the quantum state identification problem, and the task is to optimize the mean identification success probability. In this paper, we consider the case where each reference state is pure and bipartite, and generally entangled. The question is whether the maximum mean identification success probability can be attained by means of a local operations and classical communication (LOCC) measurement scheme. Two types of identification problem are considered when a single copy of each reference state is available. We show that a LOCC scheme attains the globally achievable identification probability in the minimum-error identification problem. In the unambiguous identification problem, however, the maximal success probability by means of LOCC is shown to be less than the globally achievable identification probability.
The accurate identification of faulty hardware is a fundamental requirement for reliable quantum information processing. We address this problem in a quantum setting, where a series of nnn devices is intended to apply the same unitary operation, but kkk malfunctioning devices among them apply a different, unknown unitary action. Under the assumption of complete ignorance regarding the specific unitary transformation applied, we model our hypotheses using representation-theoretic tools and study the zero-error protocol for identifying these faulty devices. We derive the optimal success probability for the single- and two-anomaly scenarios, demonstrating that it is independent of the total number of devices in the series. Furthermore, we present a simple protocol that makes use of ancillary systems that achieves this optimal limit. Notably, this protocol offers significant operational advantages, such as allowing us to test each device independently. Finally, we extend our analysis to the general scenario in which both the number of anomalies and the local dimension of the systems are arbitrary, evaluating our protocol's performance and conjecturing its global optimality in the general case.
In this technical note, we study the problem of parameter estimation for quantum channels, which are (completely positive) maps acting on quantum states. We focus on an important subclass of channels called Pauli channels which are characterized by a certain set of vectors (directions) and a number of scalar parameters. For the case where the directions are known, a special parametrization turns the parameter estimation problem into a convex optimization problem. For the case of unknown directions we give a simple algorithm to estimate the directions for qubit Pauli channels. These results assume that the identification experiment configuration is given, namely, a set of quantum states are given on which the channel acts, and a set of positive measurement (operator)s are fixed from which information is gathered. In the second part of the technical note we consider the problem of determining the experiment design, namely, determining states and measurements for optimal parameter identification of the channels. We formalize this problem as a maximization problem for Fisher information and, assuming known channel directions, prove that this problem is convex. We also prove that the optimal states to be used in experiments are pure and the optimal measurements are extremal. For qubit Pauli channels we prove that both the optimal pure input states and projective measurements should be directed towards the channel directions. We illustrate the results of the technical note with numerical examples and simulations.