Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:quant-ph/0111092 · Physical Review A

Quantum phase gate for photonic qubits using only beam splitters and postselection

Holger Friedrich Hofmann, Shigeki Takeuchi

Published Aug 8, 2002• 193 citations
arXivHTMLPDF

Abstract

We show that a beam splitter of reflectivity one-third can be used to realize a quantum phase gate operation if only the outputs conserving the number of photons on each side are postselected.
DOI
10.1103/physreva.66.024308

Related papers

Realization of quantum operations on photonic qubits by linear optics and post-selection

Holger Friedrich Hofmann, Shigeki Takeuchi

One of the greatest difficulties in the applications of single photon polarization states as qubits is the realization of controlled interactions between two photons. Recently, it has been shown that such interactions can be realized using only beam splitters and high efficiency photon detection by post-selecting a well defined part of the results in the output. We analyze these interactions and discuss schemes for qubit operations based on this mechanism.

arXiv:quant-ph/0204045•Apr 9, 2002•5 citations

Simulation of quantum gates by postselection of interference experiments in multi-port beam-splitter (BS) configurations

Y. Ben-Aryeh

Using multiport beam-splitter (BS) configurations eight input operators a(0),a(1),a(2) a(3),a(4) a(5),a(6), a(7) are mixed by 12 BS's to produce the output operators b(0), b(1), b(2), b(3), b(4), b(5), b(6), b(7). A single photon entering into, or exiting from, one port of a BS is considered as the |0> state while that in the second port of the BS is considered as the |1> state. Two single photons are inserted into two of the BS's simulating two input qubit-states by operators a(0), a(1),a(2), a(3) . In order to simulate the two-qubit gates we exclude by postselection all the cases in which one or two photons exit through output ports b(4), b(5), b(6), b(7) so that only 25% of the experiments are taken into account. The method simulates explicitly the CNOT and SWAP gates but similar methods can be used for other gates.

arXiv:0909.3970•Sep 22, 2009•0 citations

Linear optical scheme for direct implementation of a nondestructive N -qubit controlled phase gate

Xu‐Bo Zou, Ke Li, Guang‐Can Guo

We propose a linear optical scheme for direct realization of a nondestructive $N$-qubit controlled phase gate without resorting to a sequence of single- and two-qubit gates. The proposed setup involves linear optical elements, nonmaximally entangled pairs of photons, and multiphoton coincidence detection. To implement the scheme, physical qubits represented by the polarization states of single photons are probabilistically encoded into the two-photon states. Based on such encoding operation, a nondestructive $N$-qubit phase gate can be directly achieved by $N$-photon interference on an array of polarization beam splitters and $N$-photon coincidence detection.

Physical Review A•Oct 26, 2006•54 citations

On construction of evolutionary operator for rectangular linear optical multiport

M.M. Lipovich, I. S. Lobanov

The work of Knill et. al. (2001) established the possibility of nondeterministic realization of certain quantum logic operations using linear optical elements, ancilla photons and postselection techniques.It was also shown that any discrete unitary operator acting on N optical modes can be implemented by a triangular multiport device constructed from a series of beam splitters and phase shifters (see work of Reck, Zeilinger et. al., 1994).Here, we consider the rectangular linear optical multiport that is used for the probabilistic realization of unitary transformations on n qubits.This kind of linear optical scheme is suitable for probabilistic realization of unitary operators using ancilla photons and projective measurements.Qubits are encoded into the bosonic states of optical modes in two possible polarizations, and a number of ancilla photons and photodetectors are used for postselection of the qubits' state, based on the output of the detectors.We derive a procedure of evolutionary operator calculation for schemes of the considered type and present algorithms for their efficient computation on symmetric state space.We also provide complexities for different algorithms for the computation of evolutionary operator and estimate demands of resources in each case.A destructive Toffoli gate, acting on three qubits, using one ancilla photon and a photodetector, is implemented using schemes of the presented type.

Nanosystems Physics Chemistry Mathematics•Aug 28, 2015•0 citations

Proposal for a two-qubit quantum phase gate for quantum photonic integrated circuits

R. Johne, Andrea Fiore

We propose a protocol for a two-qubit quantum phase gate based upon the reflection of photon pulses from a quantum dot in a cavity. Depending on the state of the quantum dot the reflected photons acquire a conditional phase shift. The key ingredient is the ultrafast control of the quantum dot energies by electric fields, which allows for tuning the exciton and biexciton successively into resonance with the cavity mode. The complete dynamics of the gate are simulated, revealing a fidelity of about 0.9. The proposed scheme uses position coding and is therefore well suited to the implementation in an integrated photonic quantum processor.

arXiv:1207.4912•Physical Review A•Dec 14, 2012•14 citations

Filtering of the absolute value of photon-number difference for two-mode macroscopic quantum superpositions

Magdalena Stobińska, Falk Töppel, Pavel Sekatski +5 more

We discuss a device capable of filtering out two-mode states of light with mode populations differing by more than a certain threshold, while not revealing which mode is more populated. It would allow engineering of macroscopic quantum states of light in a way which is preserving specific superpositions. As a result, it would enhance optical phase estimation with these states as well as distinguishability of ``macroscopic'' qubits. We propose an optical scheme, which is a relatively simple, albeit nonideal, operational implementation of such a filter. It uses tapping of the original polarization two-mode field, with a polarization-neutral beam splitter of low reflectivity. Next, the reflected beams are suitably interfered on a polarizing beam splitter. It is oriented such that it selects unbiased polarization modes with respect to the original ones. The more an incoming two-mode Fock state is unequally populated, the more the polarizing beam-splitter output modes are equally populated. This effect is especially pronounced for highly populated states. Additionally, for such states we expect strong population correlations between the original fields and the tapped one. Thus, after a photon-number measurement of the polarizing beam-splitter outputs, a feed-forward loop can be used to let through a shutter the field, which was transmitted by the tapping beam splitter. This happens only if the counts at the outputs are roughly equal. In such a case, the transmitted field differs strongly in occupation number of the two modes, while information on which mode is more populated is nonexistent (a necessary condition for preserving superpositions).

arXiv:1108.4906•Physical Review A•Dec 19, 2012•20 citations
Using multiport beam-splitter (BS) configurations eight input operators a(0),a(1),a(2) a(3),a(4) a(5),a(6), a(7) are mixed by 12 BS's to produce the output operators b(0), b(1), b(2), b(3), b(4), b(5), b(6), b(7). A single photon entering into, or exiting from, one port of a BS is considered as the |0> state while that in the second port of the BS is considered as the |1> state. Two single photons are inserted into two of the BS's simulating two input qubit-states by operators a(0), a(1),a(2), a(3) . In order to simulate the two-qubit gates we exclude by postselection all the cases in which one or two photons exit through output ports b(4), b(5), b(6), b(7) so that only 25% of the experiments are taken into account. The method simulates explicitly the CNOT and SWAP gates but similar methods can be used for other gates.
We propose a linear optical scheme for direct realization of a nondestructive NNN-qubit controlled phase gate without resorting to a sequence of single- and two-qubit gates. The proposed setup involves linear optical elements, nonmaximally entangled pairs of photons, and multiphoton coincidence detection. To implement the scheme, physical qubits represented by the polarization states of single photons are probabilistically encoded into the two-photon states. Based on such encoding operation, a nondestructive NNN-qubit phase gate can be directly achieved by NNN-photon interference on an array of polarization beam splitters and NNN-photon coincidence detection.
The work of Knill et. al. (2001) established the possibility of nondeterministic realization of certain quantum logic operations using linear optical elements, ancilla photons and postselection techniques.It was also shown that any discrete unitary operator acting on N optical modes can be implemented by a triangular multiport device constructed from a series of beam splitters and phase shifters (see work of Reck, Zeilinger et. al., 1994).Here, we consider the rectangular linear optical multiport that is used for the probabilistic realization of unitary transformations on n qubits.This kind of linear optical scheme is suitable for probabilistic realization of unitary operators using ancilla photons and projective measurements.Qubits are encoded into the bosonic states of optical modes in two possible polarizations, and a number of ancilla photons and photodetectors are used for postselection of the qubits' state, based on the output of the detectors.We derive a procedure of evolutionary operator calculation for schemes of the considered type and present algorithms for their efficient computation on symmetric state space.We also provide complexities for different algorithms for the computation of evolutionary operator and estimate demands of resources in each case.A destructive Toffoli gate, acting on three qubits, using one ancilla photon and a photodetector, is implemented using schemes of the presented type.
We propose a protocol for a two-qubit quantum phase gate based upon the reflection of photon pulses from a quantum dot in a cavity. Depending on the state of the quantum dot the reflected photons acquire a conditional phase shift. The key ingredient is the ultrafast control of the quantum dot energies by electric fields, which allows for tuning the exciton and biexciton successively into resonance with the cavity mode. The complete dynamics of the gate are simulated, revealing a fidelity of about 0.9. The proposed scheme uses position coding and is therefore well suited to the implementation in an integrated photonic quantum processor.
We discuss a device capable of filtering out two-mode states of light with mode populations differing by more than a certain threshold, while not revealing which mode is more populated. It would allow engineering of macroscopic quantum states of light in a way which is preserving specific superpositions. As a result, it would enhance optical phase estimation with these states as well as distinguishability of ``macroscopic'' qubits. We propose an optical scheme, which is a relatively simple, albeit nonideal, operational implementation of such a filter. It uses tapping of the original polarization two-mode field, with a polarization-neutral beam splitter of low reflectivity. Next, the reflected beams are suitably interfered on a polarizing beam splitter. It is oriented such that it selects unbiased polarization modes with respect to the original ones. The more an incoming two-mode Fock state is unequally populated, the more the polarizing beam-splitter output modes are equally populated. This effect is especially pronounced for highly populated states. Additionally, for such states we expect strong population correlations between the original fields and the tapped one. Thus, after a photon-number measurement of the polarizing beam-splitter outputs, a feed-forward loop can be used to let through a shutter the field, which was transmitted by the tapping beam splitter. This happens only if the counts at the outputs are roughly equal. In such a case, the transmitted field differs strongly in occupation number of the two modes, while information on which mode is more populated is nonexistent (a necessary condition for preserving superpositions).