Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

arXiv:cond-mat/9811232

Quantum squeezing micron-sized cantilevers

M. P. Blencowe, Martin N. Wybourne

Published Nov 16, 1998• 1 citation
arXivHTMLPDF

Abstract

We show that substantial quantum squeezing of mechanical motion can be achieved for micron-sized cantilever devices fabricated using available techniques. A method is also described for measuring the cantilever fluctuation magnitudes in the squeezing regime.
DOI
10.48550/arxiv.cond-mat/9811232

Related papers

Quantum squeezing of mechanical motion for micron-sized cantilevers

M. P. Blencowe, Martin N. Wybourne

Physica B Condensed Matter•May 1, 2000•60 citations

Quantum amplification of mechanical oscillator motion

S. C. Burd, R. Srinivas, J. J. Bollinger +5 more

Detection of the weakest forces in nature is aided by increasingly sensitive measurements of the motion of mechanical oscillators. However, the attainable knowledge of an oscillator's motion is limited by quantum fluctuations that exist even if the oscillator is in its lowest possible energy state. We demonstrate a technique for amplifying coherent displacements of a mechanical oscillator with initial magnitudes well below these zero-point fluctuations. When applying two orthogonal squeezing interactions, one before and one after a small displacement, the displacement is amplified, ideally with no added quantum noise. We implemented this protocol with a trapped-ion mechanical oscillator and determined an increase by a factor of up to 7.3 (±0.3) in sensitivity to small displacements.

arXiv:1812.01812•Science•Jun 20, 2019•206 citations

Generation of mechanical squeezing via magnetic dipoles on cantilevers

Hyojun Seok, Lukas F. Buchmann, Swati Singh +2 more

A scheme to squeeze the center-of-mass motional quadratures of a quantum mechanical oscillator below its standard quantum limit is proposed and analyzed theoretically. It relies on the dipole-dipole coupling between a magnetic dipole mounted on the tip of a cantilever to equally oriented dipoles located on a mesoscopic tuning fork. We also investigate the influence of several sources of noise on the achievable squeezing, including classical noise in the driving fork and the clamping noise in the oscillator. A detection of the state of the cantilever based on state transfer to a light field is considered. We investigate possible limitations of that scheme.

arXiv:1110.4935•Physical Review A•Mar 20, 2012•13 citations

Quantum squeezing of motion in a mechanical resonator

Emma E. Wollman, Chan U Lei, Alan J Weinstein +5 more

According to quantum mechanics, a harmonic oscillator can never be completely at rest. Even in the ground state, its position will always have fluctuations, called the zero-point motion. Although the zero-point fluctuations are unavoidable, they can be manipulated. Using microwave frequency radiation pressure, we have manipulated the thermal fluctuations of a micrometer-scale mechanical resonator to produce a stationary quadrature-squeezed state with a minimum variance of 0.80 times that of the ground state. We also performed phase-sensitive, back-action evading measurements of a thermal state squeezed to 1.09 times the zero-point level. Our results are relevant to the quantum engineering of states of matter at large length scales, the study of decoherence of large quantum systems, and for the realization of ultrasensitive sensing of force and motion.

arXiv:1507.01662•Science•Aug 27, 2015•683 citations

Single-electron measurements with a micromechanical resonator

Rodney Polkinghorne, Gerard J Milburn

A mechanical electroscope based on a change in the resonant frequency of a cantilever one micron in size in the presence of charge has recently been fabricated. We derive the decoherence rate of a charge superposition during measurement with such a device using a master equation theory adapted from quantum optics. We also investigate the information produced by such a measurement, using a quantum trajectory approach. Such instruments could be used in mesoscopic electronic systems, and future solid-state quantum computers, so it is useful to know how they behave when used to measure quantum superpositions of charge.

arXiv:cond-mat/0110302•Physical Review A•Sep 19, 2001•6 citations

Viewpoint: Quantum Squeezing of Micromechanical Motion

Warwick P. Bowen

The act of a quantum measurement reduces the uncertainty in the motion of a vibrating membrane below the fundamental quantum limit.

•Dec 7, 2015•0 citations
Detection of the weakest forces in nature is aided by increasingly sensitive measurements of the motion of mechanical oscillators. However, the attainable knowledge of an oscillator's motion is limited by quantum fluctuations that exist even if the oscillator is in its lowest possible energy state. We demonstrate a technique for amplifying coherent displacements of a mechanical oscillator with initial magnitudes well below these zero-point fluctuations. When applying two orthogonal squeezing interactions, one before and one after a small displacement, the displacement is amplified, ideally with no added quantum noise. We implemented this protocol with a trapped-ion mechanical oscillator and determined an increase by a factor of up to 7.3 (±0.3) in sensitivity to small displacements.
A scheme to squeeze the center-of-mass motional quadratures of a quantum mechanical oscillator below its standard quantum limit is proposed and analyzed theoretically. It relies on the dipole-dipole coupling between a magnetic dipole mounted on the tip of a cantilever to equally oriented dipoles located on a mesoscopic tuning fork. We also investigate the influence of several sources of noise on the achievable squeezing, including classical noise in the driving fork and the clamping noise in the oscillator. A detection of the state of the cantilever based on state transfer to a light field is considered. We investigate possible limitations of that scheme.
According to quantum mechanics, a harmonic oscillator can never be completely at rest. Even in the ground state, its position will always have fluctuations, called the zero-point motion. Although the zero-point fluctuations are unavoidable, they can be manipulated. Using microwave frequency radiation pressure, we have manipulated the thermal fluctuations of a micrometer-scale mechanical resonator to produce a stationary quadrature-squeezed state with a minimum variance of 0.80 times that of the ground state. We also performed phase-sensitive, back-action evading measurements of a thermal state squeezed to 1.09 times the zero-point level. Our results are relevant to the quantum engineering of states of matter at large length scales, the study of decoherence of large quantum systems, and for the realization of ultrasensitive sensing of force and motion.
A mechanical electroscope based on a change in the resonant frequency of a cantilever one micron in size in the presence of charge has recently been fabricated. We derive the decoherence rate of a charge superposition during measurement with such a device using a master equation theory adapted from quantum optics. We also investigate the information produced by such a measurement, using a quantum trajectory approach. Such instruments could be used in mesoscopic electronic systems, and future solid-state quantum computers, so it is useful to know how they behave when used to measure quantum superpositions of charge.