We analyze the crosstalk error mechanism in measurement of two capacitively coupled superconducting flux-biased phase qubits. The damped oscillations of the superconducting phase after the measurement of the first qubit may significantly excite the second qubit, leading to its measurement error. The first qubit, which is highly excited after the measurement, is described classically. The second qubit is treated both classically and quantum mechanically. The results of the analysis are used to find the upper limit for the coupling capacitance (thus limiting the frequency of two-qubit operations) for a given tolerable value of the measurement error probability.
We analyze the crosstalk error mechanism in measurement of two capacitively coupled superconducting flux-biased phase qubits. The damped oscillations of the superconducting phase after the measurement of the first qubit may significantly excite the second qubit, leading to its measurement error. The first qubit, which is highly excited after the measurement, is described classically. The second qubit is treated both classically and quantum mechanically. The results of the analysis are used to find the upper limit for the coupling capacitance (thus limiting the frequency of two-qubit operations) for a given tolerable value of the measurement error probability.
We investigate measurement crosstalk in a system with two flux-biased phase qubits coupled by a resonant coplanar waveguide cavity. After qubit measurement, the superconducting phase undergoes damped oscillations in a deep anharmonic potential producing a frequency chirped voltage or crosstalk signal. We show experimentally that a coplanar waveguide cavity acts as a bandpass filter that can significantly reduce the propagation of this crosstalk signal when the qubits are far off resonance from the cavity. The transmission of the crosstalk signal $\ensuremath{\propto}{({\ensuremath{\omega}}_{q}{C}_{x})}^{2}$ can be further minimized by reducing the qubit frequencies and the coupling capacitance to the cavity. We model the large amplitude crosstalk signal and qubit response classically with results that agree well with the experimental data. We find that the maximum energy transferred by the crosstalk generating qubit roughly saturates for long energy relaxation times (T1>100ns) while the delay time necessary for the crosstalk signal to propagate to the cavity scales linearly with T1. Ultimately, the use of resonant cavities as coupling elements and crosstalk filters is extremely beneficial for future architectures incorporating many coupled qubits.
We present a new configuration concept in which two similar Josephson junctions are coupled through a capacitor placed in parallel to a dc-superconducting quantum interference device (SQUID) to improve the characteristics of phase qubits. In real coupled quantum systems, because of mutual effects such as crosstalk, entangled quantum states cannot be independently measured. The proposed two-qubit system is demonstrated to have a negligible crosstalk, obtained from the application of a single measurement pulse and an appropriate external flux to one of the junctions and the dc-SQUID, respectively. Surprisingly, the theoretically predicted fidelity for a single-qubit design increases to 99.99% for typical Josephson junction parameters. The high-fidelity measurement is reached even with pulse times less than 1 ns, while the highest fidelities reported so far are obtained by wide temporal pulses through single-shot current pulse measurements. This is accomplished by proper coupling capacitance, which determines the coupling time, the measurement time, and their proportion. Furthermore, the ratio of decoherence time for this structure with respect to the one belonging to a typical qubit is found to be more than 1.42.
Maintaining or even improving gate performance with growing numbers of parallel controlled qubits is a vital requirement for fault-tolerant quantum computing.For superconducting quantum processors, though isolated one-or two-qubit gates have been demonstrated with high fidelity, implementing these gates in parallel commonly shows worse performance.Generally, this degradation is attributed to various crosstalks between qubits, such as quantum crosstalk due to residual inter-qubit coupling.An understanding of the exact nature of these crosstalks is critical to figuring out respective mitigation schemes and improved qubit architecture designs with low crosstalk.Here we give a theoretical analysis of quantum crosstalk impact on simultaneous gate operations in a qubit architecture, where fixed-frequency transmon qubits are coupled via a tunable bus, and sub-100-ns controlled-Z (CZ) gates can be realized by applying a baseband flux pulse on the bus.Our analysis shows that for microwave-driven single-qubit gates, the dressing from the qubit-qubit coupling can cause non-negligible cross-driving errors when qubits operate near frequency collision regions.During CZ gate operations, although unwanted nearest-neighbor interactions are nominally turned off, sub-MHz parasitic next-nearest-neighbor interactions involving spectator qubits can still exist, causing considerable leakage or control error when one operates qubit systems around these parasitic resonance points.To ensure high-fidelity simultaneous operations, a request could be raised to figure out a better way to balance the gate error from target qubit systems themselves and the error from nonparticipating spectator qubits.Overall, our analysis suggests that towards useful quantum processors, the qubit architecture should be examined carefully in the context of high-fidelity simultaneous gate operations in a scalable qubit lattice.
We analyze conditions for violation of the Bell inequality in the Clauser-Horne-Shimony-Holt form, focusing on Josephson phase qubits. We start the analysis with maximum violation in the ideal case, and then take into account the effects of local measurement errors and decoherence. Special attention is paid to configurations of the qubit measurement directions in the pseudospin space lying within either horizontal or vertical planes; these configurations are optimal in certain cases. Besides local measurement errors and decoherence, we also discuss the effect of measurement crosstalk, which affects both the classical inequality and the quantum result. In particular, we propose a version of the BI which is insensitive to the crosstalk.
Superconducting qubits have achieved exceptional gate fidelities, exceeding the error-correction threshold in recent years. One key ingredient of such improvement is the introduction of tunable couplers to control the qubit-to-qubit coupling through frequency tuning. Moving toward fault-tolerant quantum computation, increasing the number of physical qubits is another step toward effective error correction codes. Under a multiqubit architecture, flux control (Z) lines are crucial in tuning the frequency of the qubits and couplers. However, dense flux lines result in magnetic flux crosstalk, wherein magnetic flux applied to one element inadvertently affects neighboring qubits or couplers. This crosstalk obscures the idle frequency of the qubit when flux bias is applied, which degrades gate performance and calibration accuracy. In this study, we characterize flux crosstalk and suppress it in a multiqubit-coupler chip with multi-Z lines without adding additional readout for couplers. By quantifying the mutual flux-induced frequency shifts of qubits and couplers, we construct a cancellation matrix that enables precise compensation of non-local flux, demonstrating a substantial reduction in Z-line crosstalk from 56.5‰ to 0.13‰, which is close to statistical error. Flux compensation corrects the CZ SWAP measurement, leading to a symmetric map with respect to flux bias. Compared with a crosstalk-free calculated CZ SWAP map, the measured map indicates that our approach provides a near-zero crosstalk for the coupler-transmon system. These results highlight the effectiveness of our approach in enhancing flux crosstalk-free control and supporting its potential for scaling superconducting quantum processors.
We present a systematic study of the phase coherent dynamics of a superconducting three-Josephson-junction flux qubit. The qubit state is detected with the integrated-pulse method, which is a variant of the pulsed switching-dc-superconducting quantum interference device (SQUID) method. In this scheme, the dc SQUID bias current pulse is applied via a capacitor instead of a resistor, giving rise to a narrow bandpass instead of a pure low-pass filter configuration of the electromagnetic environment. Measuring one and the same qubit with both setups allows a direct comparison. With the capacitive method about four times faster switching pulses and an increased visibility are achieved. Furthermore, the deliberate engineering of the electromagnetic environment, which minimizes the noise due to the bias circuit, is facilitated. Right at the degeneracy point, the qubit coherence is limited by energy relaxation. We find two main noise contributions. White noise limits the energy relaxation and contributes to the dephasing far from the degeneracy point. 1∕f noise is the dominant source of dephasing in the direct vicinity of the optimal point. The influence of 1∕f noise is also supported by nonrandom beatings in the Ramsey and spin echo decay traces. Numeric simulations of a coupled qubit-oscillator system indicate that these beatings are due to the resonant interaction of the qubit with at least one pointlike fluctuator, coupled especially strongly to the qubit.