A complete analysis of the decoherence properties of a Josephson junction qubit is presented. The qubit is of the flux type and consists of two large loops forming a gradiometer, one small loop, and three Josephson junctions. We develop a complete, quantitative description of the inductances and capacitances of the circuit. Including two stray capacitances makes the quantum mechanical modeling of the system five dimensional. To make the required calculation tractable, we devise a general Born-Oppenheimer approximation which reduces the effective dimensionality in the calculation to one. Contributions to relaxation
(T1) and dephasing $({T}_{\ensuremath{\phi}})$ arising from two different control circuits, one coupled to the small loop and one coupled to a large loop, is computed. We explore
T1 and ${T}_{\ensuremath{\phi}}$ along an optimal line in the space of applied fluxes; along this ``S line'' we see significant and rapidly varying contributions to the decoherence parameters, primarily from the circuit coupling to the large loop.
We investigated decoherence of a Josephson vortex quantum bit (qubit) in dissipative and noisy environment. As the Josephson vortex qubit (JVQ) is fabricated by using a long Josephson junction (LJJ), we use the perturbed sine-Gordon equation to describe the phase dynamics representing a two-state system and estimate the effects of quasiparticle dissipation and weakly fluctuating critical and bias currents on the relaxation time
T1 and on the dephasing time ${T}_{\ensuremath{\phi}}$. We show that the critical current fluctuation does not contribute to dephasing of the qubit in the lowest order approximation. Modeling the weak current variation from magnetic field fluctuations in the LJJ by using the Gaussian colored noise with long correlation time, we show that the coherence time
T2 is limited by the low frequency current noise at very low temperatures. Also, we show that a ultra-long coherence time may be obtained from the JVQ by using experimentally accessible value of physical parameters.
Among the potential physical implementations of quantum bits (qubits) solid state devices appear most promising for large scale applications and integration in electronic circuits. Devices based on low-capacitance Josephson junctions exploit the coherence of the superconducting state, combined with the possibility to control individual charges by Coulomb blockade effects. The logical states in these systems differ by one Cooper-pair charge. Single- and two-bit operations can be performed by applying a sequence of gate voltages. The phase coherence time is sufficiently long to allow a series of these steps. If, in addition, the strength of the Josephson coupling is controlled (e.g. by currents in SQUID loops) the system is ideal for quantum computation. Recent experiments by Nakamura et al. show the feasibility of this approach. In addition to the manipulations of qubits the resulting quantum state has to be read out. This quantum measurement process can be accomplished by coupling a single-electron transistor (SET) capacitively to the qubit. We investigate the process by analyzing the time-evolution of the density matrix of the coupled system. The measurement process is characterized by three time scales: the dephasing time, which is fast when a dissipative current flows in the SET, a longer ‘measurement time’ needed to read out the signal, and a third, even longer ‘mixing time’, characterizing measurement induced transitions which destroy the information about the initial quantum state. The noise spectrum of the current in the SET displays these time scales and allows their direct observation.
This work concerns the study of Josephson junction circuits in the context of their usability for quantum computing. The zero-voltage state of a current-biased Josephson junction has a set of metastable quantum energy levels. If a junction is well isolated from its environment, it will be possible to use the two lowest states as a qubit in a quantum computer. I first examine the meaning of isolation theoretically. Using a master equation, I analyzed the effect of dissipation on escape rates and suggested a simple method, population depletion technique, to measure the relaxation time. Using a stochastic Bloch equation to analyze microwave resonance shapes, I found a relation between current noise induced decoherence and the noise spectrum. I then analyze and test a few qubit isolation schemes, including resistive isolation, inductor-capacitor (LC) isolation, and inductor-junction (LJ) isolation. I found the resistive isolation scheme has a severe heating problem. Macroscopic quantum tunneling and energy level quantization were observed in the LC isolated junction qubits at 25 mK. Relaxation times of 4-12 ns and spectroscopic coherence times of 1-3 ns were obtained for these LC isolated qubits. I measured a relaxation time of 50 ns and a spectroscopic coherence time of 5-8 ns for the LJ isolated junction qubit. Both times are much longer than those of the LC isolated qubits. Rabi oscillations were also observed on this sample with a decay time of around 10 ns. Using microwave spectroscopy techniques, I probed quantum phenomena in a coupled macroscopic three-qubit system that is comprised of two Nb/AlOx/Nb Josephson junctions and an LC resonator. The measured spectrum at 25 mK in the frequency range 4-15 GHz agrees well with quantum mechanical calculations, consistent with the existence of entangled states between the three degrees of freedom. These entangled states and a first-order strong coupling between two junction qubits open the possibility of using a resonator as a data bus for information storage and manipulation in a multi-qubit system. The measurements also demonstrate spectroscopy is a powerful tool and can be used to study a composite system with many qubits.
In this thesis transport phenomena in the arrays consisting of two (SSET) or three (CPP) or more Josephson junctions are discussed. A quantitative theory of adiabatic Cooper pair transport in phase biased arrays is developed. The theory predicts that the quantum inaccuracy of the Cooper pair pumping in arrays with a small number of junctions is very large. The effects due to inhomogeneous arrays or nonideal gating sequences are also quantitatively treated. It is also shown explicitly how the pumped charge in the Cooper pair pump can be understood as a partial derivative of Berry’s phase with respect to the phase difference
φ across the array. This makes possible to obtain information about Berry’s phase by measuring the pumped current in the CPP. Also the decoherence time
τφ, which is one of the central quantities in quantum computing, is quantitatively estimated in a dissipative electromagnetic environment of the circuit. This method allows comparison of the suitability of a system as a quantum bit. Also a direct measurement of
τφ as a crossover between coherent and incoherent pumping in the single Cooper pair pump is suggested. In experiments with Cooper pair pump it is demonstrated in practise how the CPP can be used as a turnstile with help of dissipation. Also a regular pumping experiment is performed. To explain the twofold behavior of the CPP, sometimes yielding
e-periodicity while sometimes
2e-periodicity, the energy-minimisation model is developed. It is shown also experimentally that
Nb based junctions with high critical temperature (
Tc≈8.5 K) and Josephson coupling can be fabricated using the regular self-alignment technique. The measured
Al/Nb/Al SSETs show a clear signature of resonant tunnelling of Cooper pairs combined with elastic cotunnelling of quasiparticles,
q-MQT, through the barrier of
ΔNb.
We study the dynamics of a quantum superconducting circuit which consists of a Josephson charge qubit, coupled capacitively to a current biased Josephson junction. Under certain conditions, the eigenstates of the qubit and the junction become entangled. We obtain the time evolution of these states in the limit of weak coupling. Rabi oscillations occur, as a result of the spontaneous emission and re-absorption of a single oscillation quantum in the junction. We discuss a possible way to experimentally determine the quantum state of the junction and hence observe the Rabi oscillations.