Parametric effects in superconducting circuits based on Josephson elements

Göran Johansson

In this talk, I will start by briefly introducing the Josephson-junction, which is the non-linear circuit element used to engineer the artificial atoms. Then I will discuss two qualitatively different methods using this non-linear element for generating entangled photon pairs in superconducting circuits. One approach builds on parametric down-conversion of a coherent ac drive (see fig. 1)[2] while the other relies on the ac Josephson effect, requiring only a dc voltage bias (see fig. 2) [3]. Finally, I will discuss a few recent experimental implementations [4-8].

Xueying Jin, Florent Lecocq, Katarina Cicak +5 more

Ryoji Miyazaki, Tsuyoshi Yamamoto

We theoretically propose a circuit of the four-body coupler for superconducting qubits based on Josephson parametric oscillators (JPOs). Our coupler for the four-body interaction has a superconducting loop, similar to a capacitively shunted flux qubit, where an external magnetic flux set to half a flux quantum is threaded. This coupler circuit is a specific setup of the circuit called superconducting nonlinear asymmetric inductive elements (SNAIL) and also is a generalization of the previously proposed one for the four-body interaction of JPOs. We clarify roles of circuit parameters in the four-body interaction and, in particular, show that the four-body coupling constant in our circuit can be significantly increased by tuning capacitance of the coupler or the area ratio of the Josephson junctions of the coupler.

Marric Stephens

Likai Yang, Jennifer Wang, Daryoush Shiri +6 more

The development of large-scale superconducting quantum computers critically depends on the accurate readout of qubit states. To enable this, cryogenic parametric amplifiers have been proposed and developed, and have since found widespread use in small-signal detection applications. Among various amplifier architectures, Josephson traveling-wave parametric amplifiers (JTWPAs) are widely adopted due to their broad bandwidth, high saturation power, and compatibility with superconducting qubits. In this work, we present a design workflow of JTWPAs based on a co-simulation approach combining electromagnetic (EM) and circuit-level simulation. We apply this method to a uniform JTWPA, comparing our simulation results with experimental data. To mitigate the challenge of constructing lumped element circuit models usually used in conventional simulation method, we directly perform full EM analysis of the device to accurately determine its linear response. The extracted S parameters are then fed into a nonlinear harmonic balance simulator with Josephson junctions modeled as circuit elements. By doing so, the linear and gain properties of the JTWPA are extracted. Different factors that impact device performance including gain compression, phase matching, and fabrication imperfections are further investigated and modeled. A good agreement between simulation and measurements is identified, establishing the effectiveness of our approach in designing quantum parametric amplifiers.

James Edward Zimmerman