Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Superconductor Science and Technology

Monolithic high-temperature superconducting (HTS) K-band sub-harmonic mixer based on reverse-biased Josephson junctions

He Zhu, Ting Zhang, Jia Du

Published Jan 13, 2026• 1 citation
Publisher

Abstract

Abstract This paper presents a monolithic high-temperature superconducting K-band sub-harmonic Josephson mixer using a pair of reverse-biased Josephson junctions (JJs), which are biased using reversed DC current. The sub-harmonic mixer can provide higher conversion gain and stronger rejection of the even-order harmonics of the local oscillator signal. A matching circuit with several bandpass filters (BPFs) is designed to match the junctions and achieve a maximum conversion gain. Based on the circuit configuration and using the established Verilog-A JJ mixer model, transient simulation has been done in the circuit simulator. An electromagnetic (EM) model is built and simulated in a full-wave simulation environment, and the results reveal that the design realizes very low loss at 25 GHz, excellent port isolation and high conversion efficiency. A prototype has been fabricated and tested in a cryocooler at operating temperatures of 40 K and 20 K. Measurements have experimentally verified the novel radio frequency design and simulation results. Maximum conversion gains of −10.5 dB and −6.5 dB were obtained at 40 K and 20 K, respectively, with a bandwidth greater than 400 MHz and outstanding gain linearity. It is also predicted that the mixer performance can be further improved with higher critical current I c values and identical or similar I c values between two parallel junctions.

DOI
10.1088/1361-6668/ae37e0

Related papers

600-GHz high-temperature superconducting sub-harmonic mixer coupled using a double-Y-type slot integrated lens antenna

Xiang Gao, Huanxin Li, Ting Zhang +4 more

In this paper, we present a quasi-optically coupled 600-GHz high-temperature superconducting (HTS) sub-harmonic mixer for communication and sensing applications. The mixer features an innovative double-Y-type slot integrated lens antenna, which can efficiently couple the radio frequency (RF) and local oscillator (LO) signals with a small frequency ratio by exciting the half-wave and full-wave resonant current modes on the slot, respectively. Considering the low impedance characteristics of HTS Josephson junctions, a coplanar-waveguide stepped impedance transformer is utilized for minimizing the mismatching loss. A cascaded filter network is designed to prevent the high-frequency signal leakage at both bands while coupling the intermediate-frequency (IF) signal output efficiently. Based on this antenna design and an established HTS step-edge junction technology, a 600-GHz mixer prototype was designed, fabricated and measured, which was compared with the simulation results. The achieved conversion gain and noise temperature are the best performance specs as reported to date for HTS harmonic mixers at comparable frequencies and operating temperatures.

Optics Express•Aug 30, 2022•5 citations

Simulations and Analysis of a High Harmonic Monolithic YBCO HTS Josephson Mixer

Ekaterina A. Matrozova, L. S. Revin, Alexander V. Chiginev

This paper presents an electromagnetic simulation of YBaCuO superconducting Josephson mixer for terahertz frequency band coupled with a log-periodic antenna. The proposed mixer design includes an on-chip diplexer and bias-tee. This approach reduces signal transmission losses, improves circuit isolation and makes the device very compact. The theoretical approach to the description of high-harmonic mixing proposed by the authors allows us to estimate the mixer conversion efficiency for experimentally obtained parameters of Josephson junctions. Comparison of experimental data with the theory showed the applicability of the suggested approach for a qualitative description of the mixer operation and allowed to estimate the efficiency of the simulated monolithic mixer.

IEEE All-Russian Microwave Conference (RMC)•Nov 25, 2024•0 citations

A high-temperature superconducting monolithic microwave integrated Josephson down-converter with high conversion efficiency

Jia Du, Ting Zhang, Y. Jay Guo +1 more

A compact high-Tc superconducting monolithic microwave integrated circuit Josephson down-converter is presented. The circuit consists of a single Josephson junction mixer, a bandpass filter, a lowpass filter, and a resonator for local oscillator fabricated on a single 10 mm × 20 mm chip of YBa2Cu3O7−x film on MgO substrate. The down-converter demonstrates superior performance in terms of conversion efficiency, dynamic range, linearity, and low local oscillator power with stable operation from 20 to 77 K. A maximum conversion gain of −4.7 dB was measured at 20 K and −12.8 dB at 70 K.

Applied Physics Letters•May 27, 2013•20 citations

Characterizations of High-Temperature Superconducting Step-Edge Josephson Junction Mixer

Dan Dan Bai, Jia Du, Yu Sheng He

We report the experimental evaluation of a high-temperature superconducting (HTS) Josephson mixer. The mixer is fabricated from a HTS step-edge junction on MgO substrate. The mixer device operates as a lower side-band down-converter from a radio frequency between 6 and 10 GHz to a 1-2 GHz intermediate frequency under the action of a local oscillator. The experimental results of the current-voltage characteristics, optimal bias conditions, dynamic range, linearity, conversion gain, and the temperature dependence of the mixer are presented.

IEEE Transactions on Applied Superconductivity•Aug 15, 2014•6 citations

Simulation of HTS Josephson Mixers

Colin M. Pegrum, Ting Zhang, Jia Du +1 more

The Commonwealth Scientific and Industrial Research Organization has developed superconducting microwave monolithic integrated circuit (MMIC) mixers using step-edge Josephson junctions and on-chip filters, made from YBaCuO on MgO substrates. Integration into an MMIC results in a compact and efficiently coupled structure. These have been shown to have outstanding conversion efficiency, dynamic range, and linearity. We report here a range of simulations of this type of mixer. We have mainly used Josephson simulators and analyze the data in both the time and frequency domains. More recently, we have also used microwave simulators incorporating a novel Verilog-A Josephson junction model that we have developed. We have looked at the interactions of junction bias current, local oscillator power, and radio-frequency input power with conversion efficiency, dynamic range, and linearity. Good agreement is found overall with measurements.

IEEE Transactions on Applied Superconductivity•Feb 19, 2016•14 citations

Terahertz harmonic mixer based on HTS Josephson junction

Mei Yu, Weiwei Xu, Jin Shi +3 more

High temperature superconducting (HTS) Josephson junction (JJ) mixers are attractive candidates in receivers for terahertz (THz) communication due to their high sensitivity, wide bandwidth, low local oscillator (LO) power requirement and high harmonic numbers. The required LO frequencies and the cost can be greatly reduced when harmonic signals can be detected at high orders (more than 100). In this paper, up to 114thharmonic mixings is presented in a HTS bicrystal YBa2Cu3O7-δ(YBCO) JJ harmonic mixer coupled with a bowtie loaded meander antenna at 0.21 THz. HTS JJs will be promising high-order harmonic mixers for THz practical applications on reception or detection at THz bands.

International Conference on Infrared, Millimeter, and Terahertz Waves (IRMMW-THz)•Aug 29, 2021•0 citations
Abstract This paper presents a monolithic high-temperature superconducting K-band sub-harmonic Josephson mixer using a pair of reverse-biased Josephson junctions (JJs), which are biased using reversed DC current. The sub-harmonic mixer can provide higher conversion gain and stronger rejection of the even-order harmonics of the local oscillator signal. A matching circuit with several bandpass filters (BPFs) is designed to match the junctions and achieve a maximum conversion gain. Based on the circuit configuration and using the established Verilog-A JJ mixer model, transient simulation has been done in the circuit simulator. An electromagnetic (EM) model is built and simulated in a full-wave simulation environment, and the results reveal that the design realizes very low loss at 25 GHz, excellent port isolation and high conversion efficiency. A prototype has been fabricated and tested in a cryocooler at operating temperatures of 40 K and 20 K. Measurements have experimentally verified the novel radio frequency design and simulation results. Maximum conversion gains of −10.5 dB and −6.5 dB were obtained at 40 K and 20 K, respectively, with a bandwidth greater than 400 MHz and outstanding gain linearity. It is also predicted that the mixer performance can be further improved with higher critical current I c values and identical or similar I c values between two parallel junctions.
In this paper, we present a quasi-optically coupled 600-GHz high-temperature superconducting (HTS) sub-harmonic mixer for communication and sensing applications. The mixer features an innovative double-Y-type slot integrated lens antenna, which can efficiently couple the radio frequency (RF) and local oscillator (LO) signals with a small frequency ratio by exciting the half-wave and full-wave resonant current modes on the slot, respectively. Considering the low impedance characteristics of HTS Josephson junctions, a coplanar-waveguide stepped impedance transformer is utilized for minimizing the mismatching loss. A cascaded filter network is designed to prevent the high-frequency signal leakage at both bands while coupling the intermediate-frequency (IF) signal output efficiently. Based on this antenna design and an established HTS step-edge junction technology, a 600-GHz mixer prototype was designed, fabricated and measured, which was compared with the simulation results. The achieved conversion gain and noise temperature are the best performance specs as reported to date for HTS harmonic mixers at comparable frequencies and operating temperatures.
This paper presents an electromagnetic simulation of YBaCuO superconducting Josephson mixer for terahertz frequency band coupled with a log-periodic antenna. The proposed mixer design includes an on-chip diplexer and bias-tee. This approach reduces signal transmission losses, improves circuit isolation and makes the device very compact. The theoretical approach to the description of high-harmonic mixing proposed by the authors allows us to estimate the mixer conversion efficiency for experimentally obtained parameters of Josephson junctions. Comparison of experimental data with the theory showed the applicability of the suggested approach for a qualitative description of the mixer operation and allowed to estimate the efficiency of the simulated monolithic mixer.
A compact high-Tc superconducting monolithic microwave integrated circuit Josephson down-converter is presented. The circuit consists of a single Josephson junction mixer, a bandpass filter, a lowpass filter, and a resonator for local oscillator fabricated on a single 10 mm × 20 mm chip of YBa2Cu3O7−x film on MgO substrate. The down-converter demonstrates superior performance in terms of conversion efficiency, dynamic range, linearity, and low local oscillator power with stable operation from 20 to 77 K. A maximum conversion gain of −4.7 dB was measured at 20 K and −12.8 dB at 70 K.
We report the experimental evaluation of a high-temperature superconducting (HTS) Josephson mixer. The mixer is fabricated from a HTS step-edge junction on MgO substrate. The mixer device operates as a lower side-band down-converter from a radio frequency between 6 and 10 GHz to a 1-2 GHz intermediate frequency under the action of a local oscillator. The experimental results of the current-voltage characteristics, optimal bias conditions, dynamic range, linearity, conversion gain, and the temperature dependence of the mixer are presented.
The Commonwealth Scientific and Industrial Research Organization has developed superconducting microwave monolithic integrated circuit (MMIC) mixers using step-edge Josephson junctions and on-chip filters, made from YBaCuO on MgO substrates. Integration into an MMIC results in a compact and efficiently coupled structure. These have been shown to have outstanding conversion efficiency, dynamic range, and linearity. We report here a range of simulations of this type of mixer. We have mainly used Josephson simulators and analyze the data in both the time and frequency domains. More recently, we have also used microwave simulators incorporating a novel Verilog-A Josephson junction model that we have developed. We have looked at the interactions of junction bias current, local oscillator power, and radio-frequency input power with conversion efficiency, dynamic range, and linearity. Good agreement is found overall with measurements.
High temperature superconducting (HTS) Josephson junction (JJ) mixers are attractive candidates in receivers for terahertz (THz) communication due to their high sensitivity, wide bandwidth, low local oscillator (LO) power requirement and high harmonic numbers. The required LO frequencies and the cost can be greatly reduced when harmonic signals can be detected at high orders (more than 100). In this paper, up to 114thharmonic mixings is presented in a HTS bicrystal YBa2Cu3O7-δ(YBCO) JJ harmonic mixer coupled with a bowtie loaded meander antenna at 0.21 THz. HTS JJs will be promising high-order harmonic mixers for THz practical applications on reception or detection at THz bands.