Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Log inSign up
Challenges
Datasets
Workspaces
Papers
Discussions
Leaderboard
Blog
Job Board
Q3AS

© 2026 Aqora Quantum S.A.S.

TermsPrivacyLegal Notice

Springer proceedings in physics

Low Noise UHF Thin Film SQUID with Cryogenic HEMT Preamplifier

Antonella Cavalleri, MASSIMO CERDONIO, Giorgio Fontana, Grzegorz Jung, R. Macchietto, R. Mezzena, Stefano Vitale, J.-P. Zendri

Published Jan 1, 1992• 3 citations
Publisher
DOI
10.1007/978-3-642-77457-7_45

Related papers

Planar Microwave Biased rf-SQUIDs with a Cryogenic HEMT amplifier

R. Mezzena, Stefano Vitale

•Jan 1, 1992•0 citations

Ultrahigh frequency thin film rf-SQUID magnetometer with a cryogenic preamplifier employing a high-electron-mobility transistor

Antonella Cavalleri, MASSIMO CERDONIO, Giorgio Fontana +5 more

Ultrahigh frequency rf-SQUID magnetometer employing a cryogenic preamplifier and a commercially available thin film rf-SQUID sensor have been designed, manufactured, and tested. The system has been operated at 316 MHz, which is the maximum pump frequency accepted by the thin film sensor. The cryogenic preamplifier has been built around a microwave high-electron-mobility transistor which was made unconditionally stable at ultrahigh frequency band by means of an appropriate circuit design, namely, a cascode configuration. The total flux noise of the magnetometer has been found to be 8.4 × 10−6Φ0/√Hz at 4.2 K and 5.8× 10−6Φ0/√Hz at 1.4 K. The temperature dependence of the fractional step rise α of the current-voltage rf characteristic has been measured to be proportional to the 2/3 power of the SQUID sensor temperature. The noise performance of the system at 4.2 K has been limited by the intrinsic SQUID noise only, in good agreement with theoretical predictions.

Review of Scientific Instruments•Nov 1, 1992•4 citations

Low-noise rf Amplifiers based on dc SQUIDs

Michael Mück, Marc-Olivier André, John L. Clarke +2 more

APS•Mar 1, 1998•0 citations

Improved sensitivity of planar microwave based RF-SQUIDs using a cryogenic HEMT preamplifier

Giorgio Fontana, R. Mezzena, Stefano Vitale +4 more

The design and performance of a planar microwave RF-SQUID (superconducting quantum interference device) read out by a cryogenic high-electron-mobility-transistor (HEMT) preamplifier are described. The SQUID sensor consists of a planar half-wavelength microstrip resonator, into which the SQUID loop is integrated. The SQUID is operated at a pump frequency of 1.7 GHz. The cryogenic preamplifier uses a microwave HEMT, located close to the SQUID sensor. Measurements of the flux noise and the fractional step rise parameter were carried out in the temperature range between 4.2 K and 1.5 K. In an open loop, a flux noise of 2*10/sup -6/ Phi /sub 0// square root Hz was measured at 4.2 K, resulting in an energy resolution of about 100 h. The design of a 3-GHz magnetometer is also described, and the preliminary results of the measurements are reported.>

IEEE Transactions on Applied Superconductivity•Mar 1, 1993•5 citations

DC SQUID preamplifier for low temperature NMR

Jaakko Henrik KOIVUNIEMI, Yasushi Kondo, M. Krusius

Czechoslovak Journal of Physics•May 1, 1996•3 citations

Planar microwave biased radio frequency SQUIDs with a cryogenic preamplifier

Michael Mück, G. Hallmanns, Christoph Heiden +4 more

We report on the design and performance of a planar microwave rf-SQUID readout by a cryogenic preamplifier. The SQUID-sensor consists of a planar half-wavelength microstrip resonator, into which the SQUID-loop is integrated. The pump frequency is 1.7 GHz. The cryogenic preamplifier employs a microwave high electron mobility transistor (HEMT), located close to the SQUID sensor. Measurements of the flux noise and the fractional step rise parameter were carried out in the temperature range between 4.2 and 1.5 K. In an open loop white flux noise values of 2×10−6 Φ0/√Hz were obtained at 4.2 K.

Applied Physics Letters•Sep 7, 1992•6 citations
Ultrahigh frequency rf-SQUID magnetometer employing a cryogenic preamplifier and a commercially available thin film rf-SQUID sensor have been designed, manufactured, and tested. The system has been operated at 316 MHz, which is the maximum pump frequency accepted by the thin film sensor. The cryogenic preamplifier has been built around a microwave high-electron-mobility transistor which was made unconditionally stable at ultrahigh frequency band by means of an appropriate circuit design, namely, a cascode configuration. The total flux noise of the magnetometer has been found to be 8.4 × 10−6Φ0/√Hz at 4.2 K and 5.8× 10−6Φ0/√Hz at 1.4 K. The temperature dependence of the fractional step rise α of the current-voltage rf characteristic has been measured to be proportional to the 2/3 power of the SQUID sensor temperature. The noise performance of the system at 4.2 K has been limited by the intrinsic SQUID noise only, in good agreement with theoretical predictions.
The design and performance of a planar microwave RF-SQUID (superconducting quantum interference device) read out by a cryogenic high-electron-mobility-transistor (HEMT) preamplifier are described. The SQUID sensor consists of a planar half-wavelength microstrip resonator, into which the SQUID loop is integrated. The SQUID is operated at a pump frequency of 1.7 GHz. The cryogenic preamplifier uses a microwave HEMT, located close to the SQUID sensor. Measurements of the flux noise and the fractional step rise parameter were carried out in the temperature range between 4.2 K and 1.5 K. In an open loop, a flux noise of 2*10/sup -6/ Phi /sub 0// square root Hz was measured at 4.2 K, resulting in an energy resolution of about 100 h. The design of a 3-GHz magnetometer is also described, and the preliminary results of the measurements are reported.>
We report on the design and performance of a planar microwave rf-SQUID readout by a cryogenic preamplifier. The SQUID-sensor consists of a planar half-wavelength microstrip resonator, into which the SQUID-loop is integrated. The pump frequency is 1.7 GHz. The cryogenic preamplifier employs a microwave high electron mobility transistor (HEMT), located close to the SQUID sensor. Measurements of the flux noise and the fractional step rise parameter were carried out in the temperature range between 4.2 and 1.5 K. In an open loop white flux noise values of 2×10−6 Φ0/√Hz were obtained at 4.2 K.