We present an asymmetric focused-beam trap (FBT) of cold Rubidium-85 atoms.Unlike the cold atom preparation using the magneto-optical trap, the FBT has its path of cooling beam occupying only one axis.Since the experiments on these cold atoms usually require additional laser beams or other atom interacting sources, the FBT allows more optical and physical accessibility for these experiments.In our experiment, the cooling beams only occupied one axis, and the crossed repumping beams were in the transverse plane to the cooling beams.By varying the intensity of the repump laser, we have shown that the atomic cloud density can be monotonically manipulated from zero to the maximum value limited by the cooling power.With this monotonic control, we then computationally introduced a scheme for the precision loading of 1-6 atoms into the far-off-resonance optical dipole trap (FORT).Using the FBT for precision FORT loading could enable extensions toward the research areas, such as Rydberg atom, quantum simulation, and quantum computing.
We present an asymmetric focused-beam trap (FBT) of cold Rubidium-85 atoms.Unlike the cold atom preparation using the magneto-optical trap, the FBT has its path of cooling beam occupying only one axis.Since the experiments on these cold atoms usually require additional laser beams or other atom interacting sources, the FBT allows more optical and physical accessibility for these experiments.In our experiment, the cooling beams only occupied one axis, and the crossed repumping beams were in the transverse plane to the cooling beams.By varying the intensity of the repump laser, we have shown that the atomic cloud density can be monotonically manipulated from zero to the maximum value limited by the cooling power.With this monotonic control, we then computationally introduced a scheme for the precision loading of 1-6 atoms into the far-off-resonance optical dipole trap (FORT).Using the FBT for precision FORT loading could enable extensions toward the research areas, such as Rydberg atom, quantum simulation, and quantum computing.
We present an asymmetric focused-beam trap of rubidium-85 atoms where the cloud volume only varied with the trap laser intensity. By repumping on F=2 to F'=2 D2 transition, the Stokes Raman scattering has strongly affected the population ratio in the two hyperfine ground states. With the volume and trap number simultaneously and separately controlled, we have shown that the cloud density can be monotonously manipulated from zero to the maximum value limited by the cooling power. By solely varying the intensity of repump laser, the scheme for precision loading of exact 1-6 atoms in the FORT, which is beyond the practical loading limit of the blue-detuned light-assisted collision, is described.
We investigate the properties of the focused-beam magneto-optical trap (FBT) of Rb 85 atoms, which provides more optical accessibility in contrast to typical magneto-optical trap (MOT). We have characterised the relations between temperature, number and density of trapped atoms versus trap parameters. In this paper, we discuss some distinctive features of the FBT comparing to those of standard MOTs, and determine a suitable condition in which loading atoms into a far-off-resonance optical dipole trap (FORT) is possible. Although the trap can capture fewer atoms comparing to the standard MOTs, due to its asymmetric geometry, it may offer an alternative trap configuration for preparing single atom.
We discuss our experimental results on forced evaporative cooling of cold rubidium 87 Rb atoms to quantum degeneracy in an Optical Dipole Trap. The atoms are first trapped and cooled in a magneto-optical trap (MOT) loaded from a continuous beam of cold atoms [1]. More than 10 10 atoms are trapped in the MOT and then about 10 8 atoms are transferred to a Quasi-Electrostatic Trap (QUEST) formed by tightly focused CO2 laser (λ = 10.6μ m ) beams intersecting at their foci in an orthogonal configuration in the horizontal plane. Before loading the atoms into the dipole trap, the phase-space density of the atomic ensemble was increased making use of sub-doppler cooling at large detuning and the temporal dark MOT technique. In a MOT the phase-space density of the atomic ensemble is six orders of magnitude less than what is required to achieve quantum degeneracy. After transferring atoms into the dipole trap efficiently, phase-space density increases by a factor of 10 3 . Further increase in phase-space density to quantum degeneracy is achieved by forced evaporative cooling of atoms in the dipole trap. The evaporative cooling process involves a gradual reduction of the trap depth by ramping down the trapping laser intensity over a second. The temperature of the cold atomic cloud was measured by time-of-flight (TOF) technique. The spatial distribution of the atoms is measured using absorption imaging. We report results of evaporative cooling in a single beam and in a crossed double-beam dipole traps. Due to the large initial phase space density, and large initial number of atoms trapped, the quantum phase transition occurs after about 600 ms of evaporative cooling in our optimized crossed dipole trap.
This dissertation reports on the design, construction, and investigation of a pulsed optical dipole force trap which uses laser light to confine ultracold rubidium (Rb) atoms. Because the laser frequency is detuned far from the atomic resonance frequency, the optical dipole force trap is also called a "far-off-resonance trap" (FORT). The use of pulsed laser light to create an optical trap may find application in expanding the number of atomic species which can be confined. The experiments reported here are principally aimed, however, at understanding the physics of pulsed FORT dynamics in anticipation of using the free electron laser (FEL) at Jefferson Lab (Jlab) to construct a FORT. The Jlab FEL will provide a tunable, high power laser light source enabling the realization of spatially large and/or energetically deep traps which are not presently accessible with table-top laser sources. Here, a mode-locked Nd:YAG laser is used as a pulsed laser source. Since the conservative optical dipole force trap does not cool Rb atoms, ultracold atoms must be loaded into the FORT. The optical dipole force trap is formed at the focus of a Gaussian, 1.06 μm Nd:YAG laser beam which is located at the center of a high vacuum chamber and superimposed onto the center of a pre-cooled Rb atom cloud that has been previously accumulated in a magneto-optic trap (MOT). The performance of the pulsed FORT is compared to a continuous wave mode (cw) FORT which is built using the same laser beam; the operation of the two kinds of FORTs can be switched easily without disturbing the experimental alignment. The dependencies of FORT loading efficiency to FORT and MOT parameters such as FORT laser power, loading time, storage/holding time, detuning of the primary MOT laser frequency, and repump laser intensity are investigated. There are about 1.5×107 ultracold rubidium atoms in the MOT. At 7 Watts FORT laser power, about 8% of the atoms are loaded successfully into the cw FORT and about 5% into the pulsed FORT under similar, but not identical, conditions. In most respects both the cw and pulsed FORTs show comparable behavior. The behavior of both FORTs depends strongly on FORT laser power. As expected, at higher power, more atoms can be loaded into the FORT. Both FORTs also depend on the loading time and holding time.
This work deals with the cooling and trapping of single cesium (Cs) atoms in a large-magnetic-gradient magneto-optical trap (MOT) and the confinement of single Cs atoms in a far-off-resonance optical dipole trap (FORT). The experiment setup is based on two large-numerical-aperture lens assemblies which allow us to strongly focus a 1064-nm TEM00-mode Gaussian laser beam to a 1/e2 radius of ~ 2.3 μm to form a microscopic FORT for isolating single atom with environment and to efficiently collect the laser-induced-fluorescence photons emitted by single atoms for detecting and recognizing single atom’s internal state. We have tried both of “bottom-up” and “top-down” loading schemes to confine single atoms in the microscopic FORT. In the “bottom-up” scheme, we have successfully prepared single Cs atoms in the MOT and transferred it into FORT with a probability of almost 100%. In the “top-down” scheme, we have achieved ~ 74% of single atom loading probability in the FORT using light-assisted collisions induced by blue detuning laser and with prepared many Cs atoms in the MOT. The relaxation time in hyperfine level of ground state of trapped single Cs atom is measured to be ~5.4 s. To coherently manipulate atomic quantum bits (qubit) encoded in the clock states (mF = 0 states in Fg = 3 and 4 hyperfine levels) of single Cs atom via the two-photon simulated Raman adiabatic passage (STIRAP), we have prepared two phase-locked laser beams with a frequency difference of ~ 9.192 GHz by optically injecting an 852-nm master laser to lock the +1-order sideband of a 9-GHz current-modulated slave diode laser. The two phase-locked laser beams are used to drive STIRAP process in the Λ-type three-level system consists of Cs |6S1/2 Fg = 4, mF = 0> and |6S1/2 Fg = 3, mF = 0< long-lived clock states and Cs |6S1/2 Fe = 4, mF = +1 > excited state with the single-photon detuning of ~ -20 GHz. Rabi flopping experiments are in progress.
The aim of this research is to pave the way for making a trap for cold neutral atoms based on the force generated by pulses of a mode-locked laser. As an onset towards such a trap we decided to use a far-off-resonance trap (FORT) loaded with cold rubidium atoms from a magneto-optical trap (MOT). Our FORT setup consists of a titanium-sapphire laser that can operate both in continuous wave mode and in mode-locked mode. Our MOT setup uses a magnetic field gradient, and two diode lasers whose frequency is locked very accurately to the atomic transition using polarisation spectroscopy. Since the measurements we do require very precise timing of the order of less than one millisecond between the various phases of the experiment, a time-sequencing program was developed. Using this sophisticated setup, several characteristics of FORTs made with continuous and pulsed lasers were analysed. For example, we have investigated the loading behaviour of the traps and found that under general circumstances there is no significant difference. However, under special conditions it is possible to load more atoms into a pulsed trap. The lifetime of the number of atoms in the trap shows no dependence on the power of the trap laser in the continuous case. For the pulsed trap, however, the increased scattering due to the high peak intensities of the pulses does limit the achievable lifetimes. Moreover, due to the presence of a large number of photoassociation lines, i.e. lines were loosely bound molecules are formed by the interaction of two atoms an a photon, the two-particle losses depend heavily on the wavelength of the trap laser. Furthermore we have done measurements of the temperature of the trapped atoms, which revealed that the temperature is a constant fraction of the trap depth. We also looked at the effects of parametric excitation of the atoms in the FORT. The anharmonicity of the trap formed by the titanium-sapphire laser results in interesting physics, including a change in the average temperature of the atoms, depending on the modulation frequency. We also investigated the trapping behaviour of the FORT at low pulse repetition rates by switching the laser intensity on and off on a kHz scale. We investigated the dependence of the number of atoms on the polarisation of the FORT laser light, both for continuous and pulsed traps. Atoms can be trapped at elliptical polarisations as well, although the number of trapped atoms is less. As the laser is detuned further to the red of the rubidium D line, this effect becomes less and less pronounced, as predicted by our model.