We have performed an experiment demonstrating that loop state-preparation-and-measurement tomography [Jackson and van Enk, Phys. Rev. A 92, 042312 (2015)] is capable of detecting correlated errors between the preparation and the measurement of a quantum system. Specifically, we have prepared pure and mixed states of single qubits encoded in the polarization of heralded individual photons. By performing measurements using multiple state preparations and multiple measurement device settings we are able to detect if there are any correlated errors between them, and we are also able to determine which state preparations are correlated with which measurements. This is accomplished by going around a ``loop'' in parameter space, which allows us to check for self-consistency. No assumptions are made concerning either the state preparations or the measurements, other than that the dimensions of the states and the positive-operator-valued measures (POVMs) describing the detector are known. In cases where no correlations are found we are able to perform quantum state tomography of the polarization qubits by using knowledge of the detector POVMs, or quantum detector tomography by using knowledge of the state preparations. Note, however, that the detection of correlated errors does not require estimating any state or measurement parameters.
In this paper, the influence of imprecise quantum measurement on remote state preparation scheme is investigated. By analyzing the measurement parameters and corresponding errors, we obtain the evolution of output state in the process of remote state preparation. In terms of the fidelity of initial state and output state, the influence of imprecise quantum measurement is discussed. The results of this paper have the reference value for the selection of measurement basis when the quantum measurement on remote state preparation is imprecise.
Remote state preparation (RSP) provides an indirect way of transferring quantum information based on the nonlocal effect of quantum measurement. Although RSP has been demonstrated in recent years to remotely prepare multiphoton states, quantum measurement on the same number of additional photons was required, i.e., to prepare
N-photon states via RSP, quantum measurement on the other
N-photons was required, hence significantly limiting practicality and applicability of RSP. Here we report an experimental demonstration of remote preparation of three-photon entangled states by measuring only a single-photon entangled with the three photons. We further generalize our protocol to prepare multiphoton entangled states with arbitrary photon number and purity and to prepare a genuinely three-partite entangled state, both via single-photon measurement. As our RSP scheme relies on the nonlinearity induced by single-photon measurement, it enables quantum state engineering of multiphoton entangled states beyond the linear optical limit. Our results are expected to have significant impacts on quantum metrology and quantum information processing.