Quantum entanglement distillation refers to the process of extracting higher quality entangled pairs from a larger set of lower-quality pairs. Here, we present a basic structure of entanglement distillation protocol based on quantum error correction code. We perform the distillation procedure of this protocol in bit flip channel and show the performance in terms of output fidelity. Combining the characteristics of QEC and EDP, QEC-based EDP holds great promise for future applications in quantum network.
Quantum entanglement distillation refers to the process of extracting higher quality entangled pairs from a larger set of lower-quality pairs. Here, we present a basic structure of entanglement distillation protocol based on quantum error correction code. We perform the distillation procedure of this protocol in bit flip channel and show the performance in terms of output fidelity. Combining the characteristics of QEC and EDP, QEC-based EDP holds great promise for future applications in quantum network.
This paper investigates entanglement distillation protocols assisted by quantum codes under bit-flip noise. Three protocols are compared: repetition code in correction and detection modes, and the [[4, 2, 2]] code in detection mode. We derive output fidelity and success probability for each, showing that the detection-based repetition code achieves the highest fidelity, while the [[4, 2, 2]] code provides better success rates. These results illustrate trade-offs between fidelity and yield, and highlight the potential of quantum codes in realistic noisy channels.
Quantum network applications impose a variety of requirements on entanglement resources in terms of rate, fidelity, latency, and more. The repeaters in the quantum network must combine good methods for entanglement generation, effective entanglement distillation, and smart routing protocols to satisfy these application requirements. In this work, we focus on entanglement distillation in a linear chain of quantum repeaters. While conventional approaches reuse the same distillation scheme over multiple hop lengths after entanglement swaps, we propose a novel adaptive quantum error correction (QEC) scheme that boosts end-to-end metrics. Specifically, depending on the network operating point, we adapt the code used in distillation over successive rounds to monotonically increase the rate while also improving fidelity. We demonstrate the effectiveness of this strategy using three codes, with parameters [[9,1,3]], [[9,2,3]], [[9,3,3]], and a new performance metric, efficiency, that incorporates both overall rate and fidelity. Since the minimum input fidelity for QEC-based distillation is high, we then extend our study to include non-QEC-based purification protocols, specifically DEJMPS since it outperforms others. We compare the performance of end-to-end DEJMPS against adapting from DEJMPS to QEC once DEJMPS improves the initial fidelity to the threshold for QEC. Through a refined efficiency metric, we illuminate the regime where QEC is beneficial. These results provide a detailed outlook for entanglement purification and distillation in first and second generation quantum repeaters.
We present a practical entanglement distillation protocol (EDP) with linear optics for a genuine mixed state. Each components of the genuine mixed state is a pure less-entangled state. After successfully performing this EDP, we can obtain a high quality entangled mixed state. Our EDP can work for both ideal entanglement sources and current available spontaneous parametric down-conversion (SPDC) sources, which makes it feasible in current experimental technology. Moreover, by using the SPDC source, we can obtain a higher fidelity. This protocol can also be used to distill the multi-partite entangled systems. All the features make it practical and useful in current quantum communications.
Bell-state measurement (BSM) on entangled states shared between quantum repeaters is the fundamental operation used to route entanglement in quantum networks. Performing BSMs on Werner states shared between repeaters leads to exponential decay in the fidelity of the end-to-end Werner state with the number of repeaters, necessitating entanglement distillation. In this work, we use quantum error correcting codes for deterministic entanglement distillation to route Werner states on a chain of repeaters. To maximize the end-to-end distillable entanglement, we utilize global link-state knowledge to determine the optimal policy for scheduling distillation and BSMs at the repeaters. We observe that low-rate codes produce high-fidelity end-to-end states owing to their excellent error-correcting capability, whereas high-rate codes yield a larger number of end-to-end states but of lower fidelity. The number of quantum memories used at repeaters increases with the code rate as well as the classical computation time of the decoder.
Entanglement distillation has many applications in quantum information processing and is an important tool for improving the quality and efficiency of quantum communication, cryptography, computing, and simulation. We propose an entanglement distillation scheme using only one pair of polarization-frequency hyperentangled photons, which can be equivalently viewed as containing two pairs of entangled logical qubits: a pair of polarization-entangled qubits and a pair of frequency-entangled qubits. To perform the required CNOT operation between the two qubits we consider the use of a polarization-dependent frequency converter. Compared to past methods of entanglement distillation that relied on polarization and spatial-mode/energy-time degree of freedom, the utilization of frequency-encoded qubits offers an advantage in that it is immune to bit-flip errors when the channel is linear. After distillation, the fidelity of polarization entanglement can be significantly improved by sacrificing the frequency degree of freedom. Through simulation, we show that high fidelity gains, large yield, and high distillation rate can be achieved. Our distillation scheme is simple to implement with current technologies, compatible with existing telecommunication fiber networks, and is a promising approach for achieving efficient quantum communication.
Entanglement is essential for quantum information processing, but is limited by noise. We address this by developing high-yield entanglement distillation protocols with several advancements. (1) We extend the 2-to-1 recurrence entanglement distillation protocol to higher-rate n -to- ( n − 1 ) protocols that can correct any single-qubit errors. These protocols are evaluated through numerical simulations focusing on fidelity and yield. We also outline a method to adapt any classical error-correcting code for entanglement distillation, where the code can correct both bit-flip and phase-flip errors by incorporating Hadamard gates. (2) We propose a constant-depth decoder for stabilizer codes that transforms logical states into physical ones using single-qubit measurements. This decoder is applied to entanglement distillation protocols, reducing circuit depth and enabling protocols derived from high-performance quantum error-correcting codes. We demonstrate this by evaluating the circuit complexity for entanglement distillation protocols based on surface codes and quantum convolutional codes. (3) Our stabilizer entanglement distillation techniques advance quantum computing. We propose a fault-tolerant protocol for constant-depth encoding and decoding of arbitrary states in surface codes, with potential extensions to more general quantum low-density parity-check codes. This protocol is feasible with state-of-the-art reconfigurable atom arrays and surpasses the limits of conventional logarithmic depth encoders. Overall, our study integrates stabilizer formalism, measurement-based quantum computing, and entanglement distillation, advancing both quantum communication and computing.