We present spectroscopic measurements of the Autler-Townes doublet and the sidebands of the Mollow triplet in a driven superconducting qubit. The ground to first excited state transition of the qubit is strongly pumped while the resulting dressed qubit spectrum is probed with a weak tone. The corresponding transitions are detected using dispersive readout of the qubit coupled off resonantly to a microwave transmission line resonator. The observed frequencies of the Autler-Townes and Mollow spectral lines are in good agreement with a dispersive Jaynes-Cummings model taking into account higher excited qubit states and dispersive level shifts due to off-resonant drives.
We experimentally study a vacuum-induced Autler-Townes doublet in a superconducting three-level artificial atom strongly coupled to a coplanar waveguide resonator and simultaneously to a transmission line. The Autler-Townes splitting is observed in the reflection spectrum from the three-level atom in a transition between the ground state and the second excited state when the transition between the two excited states is resonant with a resonator. By applying a driving field to the resonator, we observe a change in the regime of the Autler-Townes splitting from quantum (vacuum-induced) to classical (with many resonator photons). Furthermore, we show that the reflection of propagating microwaves in a transmission line could be controlled by different frequency microwave fields at the single-photon level in a resonator.
I discuss the design, fabrication and measurement at millikelvin-temperatures of Al/AlO
x/Al Josephson junction-based transmon qubits coupled to superconducting thin-film lumped element microwave resonators made of aluminum on sapphire. The resonators had a center frequency of around
6GHz, and a total quality factor ranging from 15,000 to 70,000 for the various devices. The area of the transmon junctions was about
150nm×150nm and with Josephson energy
EJ such that
10GHz≤EJ/h≤30GHz. The charging energy of the transmons arising mostly from the large interdigital shunt capacitance, was
Ec/h≈300MHz. I present microwave spectroscopy of the devices in the strongly dispersive regime of circuit quantum electrodynamics. In this limit the ac Stark shift due to a single photon in the resonator is greater than the linewidth of the qubit transition. When the resonator is driven coherently using a coupler tone, the transmon spectrum reveals individual ``photon number'' peaks, each corresponding to a single additional photon in the resonator. Using a weighted average of the peak heights in the qubit spectrum, I calculated the average number of photons
nˉ in the resonator. I also observed a nonlinear variation of
nˉ with the applied power of the coupler tone
Prf. I studied this nonlinearity using numerical simulations and found good qualitative agreement with data. In the absence of a coherent drive on the resonator, a thermal population of
5.474GHz photons in the resonator, at an effective temperature of
120mK resulted in a weak
n=1 thermal photon peak in the qubit spectrum. In the presence of independent coupler and probe tones, the
n=1 thermal photon peak revealed an Autler-Townes splitting. The observed effect was explained accurately using the four lowest levels of the dispersively dressed Jaynes-Cummings transmon-resonator system, and numerical simulations of the steady-state master equation for the coupled system. I also present time-domain measurements on transmons coupled to lumped-element resonators. From
T1 and Rabi oscillation measurements, I found that my early transmon devices (called design LEv5) had lifetimes (
T1∼1μs) limited by strong coupling to the
50Ω transmission line. This coupling was characterized by the the rate of change of the Rabi oscillation frequency with the change in the drive voltage (
dfRabi/dV) -- also termed the Rabi coupling to the drive. I studied the design of the transmon-resonator system using circuit analysis and microwave simulations with the aim being to reduce the Rabi coupling to the drive. By increasing the resonance frequency of the resonator
ωr/2π from 5.4
GHz to 7.2
GHz, lowering the coupling of the resonator to the transmission line and thereby increasing the external quality factor
Qe from 20,000 to 70,000, and reducing the transmon-resonator coupling
g/2π from 70
MHz to 40
MHz, I reduced the Rabi coupling to the drive by an order of magnitude (
∼ factor of 20). The
T1∼4μs of devices in the new design (LEv6) was longer than that of the early devices, but still much shorter than the lifetimes predicted from Rabi coupling, suggesting the presence of alternative sources of noise causing qubit relaxation. Microwave simulations and circuit analysis in the presence of a dielectric loss tangent
tanδ≃5×10−6 agree reasonably well with the measured
T1 values, suggesting that surface dielectric loss may be causing relaxation of transmons in the new designs.
Artificially engineered atoms, built using superconducting electrical circuits, have had a broad impact on the field of quantum information and quantum computing. Based on the Josephson effect, superconducting qubits have provided a robust platform for engineering light-matter interactions at the single-photon level. The ability to precisely control and manipulate single photons using superconducting qubits and cavities, a field now popularly known as circuit quantum electrodynamics (circuit QED), has enabled new and novel regimes in quantum physics, which previously remained inaccessible. For instance, the coupling between individual photons and artificial atoms have been shown to reach the ultrastrong and deep-strong regimes, a feat which is difficult to achieve with natural atoms. The superconducting circuit platform is now a promising contender for building large-scale quantum processors, attracting large investments from academic, industry and government players. \n \nThis thesis uses superconducting circuits to engineer photon interactions in two separate studies. The first is aimed at studying the physics of ``giant" artificial-atoms. The second study explores the route towards building a quantum heat engine using two parametrically-coupled, superconducting microwave cavities. We review the theoretical ideas and concepts which motivate our work, along with discussions of the design methodology, simulations, fabrication, measurement setup and the experimental findings. \n \nIn the first study, we explore a giant artificial atom, formed from a transmon qubit, which is coupled to propagating microwaves at multiple points along an open transmission line. The multipoint coupling nature of the transmon allows its radiated field to interfere with itself leading to some striking ``giant" atom effects. For instance, we observe strong frequency dependent couplings of the transmon's transition levels to its electromagnetic environment, a feature which is not observed with ordinary artificial atoms. We measure large on/off ratios, as high as
380, for the coupling rate of the
ket0−ket1 transition. Furthermore, we show that we can enhance or suppress the coupling rate of the
ket1−ket2 transition relative to the
ket0−ket1 transition, by more than a factor of
200. The relative modulation of the coupling rates was exploited to engineer a metastable state in the giant transmon and demonstrate electromagnetically-induced transparency (EIT), a typical signature of a lambda system. Our results show that we can transform the ladder structure of an ordinary transmon into a more interesting lambda system using a giant transmon, thereby paving the way for exploring new possibilities to study three-level physics in a waveguide-QED setting. \n \nExtending giant atom physics to multiple giant atoms, we then explore a device with two giant artificial atoms connected in a braided configuration to a transmission line. The braided topology of the qubits, offers an interesting regime where the qubits can interact with each other in a decoherence-free environment, where the interaction is mediated by virtual photons in the transmission line. We probe the resonant behavior of the qubits at two different frequency bias points, where we observe qualitatively different scattering behavior. Furthermore, when probing for the Autler-Townes Splitting (ATS), multiple resonances are observed for both resonant and off-resonant cases instead of the familiar doublet in the ATS spectroscopy. This comes as a surprise as the frequency-level spacings in both qubits are nominally identical. We believe these features could be an indication of a novel resonant interaction between the qubits facilitated by the braided topology. An effort to understand this theoretically is underway. \n \nFor our second study, we explore a system with two parametrically-coupled superconducting resonators, which implements an optomechanical-like interaction in an all-electrical network. The nonlinear nature of this interaction is mediated by a superconducting quantum interference device (SQUID), where the current in one resonator couples to the photon number in the other resonator. We propose to use this system to build a ``photonic piston" engine in the quantum regime. We motivate the feasibility of the proposal by reviewing key theoretical results which demonstrate an Otto-cycle by appropriately driving the system with noise. Our experimental findings demonstrate the crucial nonlinear coupling that is required for the engine to work. We also show that we can increase the coupling strength between the resonators depending on the chosen flux operating point.
In this thesis, measurements on superconducting electrical circuits that exhibit quantum mechanical effects are presented. Nonlinear superconducting circuits can be regarded as artificial atoms with energy spectra that can be engineered. The artificial atoms can be used as quantum bits for quantum computation. By coupling the artificial atoms to the electromagnetic field inside a transmission line resonator, quantum optical effects can be studied in these electrical circuits.The possibility of using a frequency tunable transmission line resonators for coupling of superconducting quantum bits is investigated. Tunable superconducting resonators consisting of coplanar waveguide structures, terminated to ground in one end via a superconducting quantum interference device (SQUID), are characterized. By applying a magnetic field to the SQUID loop, the boundary condition of the resonator changes leading to a change in resonance frequency.A change of the resonance frequency by more than 250 linewidths is demonstrated. It is also demonstrated that the resonator can be tune by several hundred MHz on a time scale that is much shorter than the photon lifetime of the resonator.Circuits containing both one and two transmon qubits coupled to the resonator are characterized. Quantum mechanical interactions between the resonator and the qubits, in form of vacuum Rabi splitting, are observed. Coherent control of a single qubit coupled to the resonator is demonstrated by performing Rabi oscillations of the qubit. In the two qubit case, coherent interaction between the qubits is observed in terms of a nonlinear scaling of the coupling strength between the resonator and the collective two qubit system.Measurements on a strongly driven single Cooper-pair box, using a quantum capacitance readout, are also presented. A rich structure in the response is well explained in terms of longitudinal dressed states of the single-Cooper pair box.When measuring the response of a single-electron box, a gate dependent excess dissipation is observed. The dissipation is understood by considering the internal dynamics of the single electron box. The excess dissipation is modeled as an effective resistance named the Sisyphus resistance.