Alice and Bob make independent measurements for non-identical properties. If every Alice (or Bob) event is fixed for any choice of measurement by Bob (or Alice), can they violate a Bell-type inequality? In theory, the answer is negative if all the properties are measured at the same time. However, the answer is positive if only one pair of events is recorded in each iteration. This fact is not widely acknowledged, though often discussed at specialized conferences, because it does not seem to make sense. The overlooked nuance is that staggered events allow for pairwise combinations that are not possible for simultaneous coincidences. This can be illustrated with two synchronized “wheel-of-fortune” tables, while focusing on the patterns of coincidence between consecutive (rather than simultaneous) events.
Alice and Bob make independent measurements for non-identical properties. If every Alice (or Bob) event is fixed for any choice of measurement by Bob (or Alice), can they violate a Bell-type inequality? In theory, the answer is negative if all the properties are measured at the same time. However, the answer is positive if only one pair of events is recorded in each iteration. This fact is not widely acknowledged, though often discussed at specialized conferences, because it does not seem to make sense. The overlooked nuance is that staggered events allow for pairwise combinations that are not possible for simultaneous coincidences. This can be illustrated with two synchronized “wheel-of-fortune” tables, while focusing on the patterns of coincidence between consecutive (rather than simultaneous) events.
Quantum theory predicts violations of Bell’s inequality. Yet, this propensity can be foiled in some measurement schemes. A known example is quantum monogamy, where global detection forces joint distributions in the output data. A similar effect is discovered in the case of loophole-free Bell experiments with random settings. Expected violations cannot be confirmed with raw data. Instead, they can be recovered in post-processing, when missing events are replaced with random values. The reality of Bell violations is not in question, but the underlying mechanism is local. To clarify this point, we designed a simulated Bell experiment with two independent computers (“Alice” and “Bob”). A system with mutually exclusive properties was used to create maximal violations at the input. Yet, there were no violations at the output, because the settings were selected at random. This is purely a combinatorial effect, without perturbing detection outcomes. The measurement scheme connected events from different input frames in 1/4 of the trials. For a full analogy with real experiments, mismatched events were treated as “missing”, if they did not fit in a fixed coincidence window. This enabled a partial recovery of the input pattern by injecting random values for missing events.
Let us imagine an experimentalist, who has maximally entangled photons and wants to violate Bell’s inequality in his laboratory. Among many obstacles he has to overcome, two of them are the most significant. Firstly, he has to avoid exchanging information about the measurement settings between the particles. Secondly, he has to detect particles with a high enough probability, because if the detection efficiency is too low, one can reproduce quantum correlations using a LHV (Local Hidden Variables) model. These two problems are known in the literature, respectively, as the locality loophole [1] and the detection loophole [2, 3]. Fortunately, it is possible to close the locality loophole using photons in the experiment [4, 5, 6, 7, 8]. However, closing the detection loophole is still an object of study. The authors of [9] showed that for the CHSH inequality, the lower bound for detector efficiency needed to close the loophole is 82.8% for maximally entangled states. This bound was lowered to 66.7% by Eberhard [10]. Furthermore, the detector efficiency has been studied for other Bell inequalities [11, 12, 13, 14, 15, 16]. In our research, we are trying to answer the following question: If we prepare a Bell experiment and we have two detectors, having different efficiencies both smaller than 100%, which detector should each party receive? And also: Which representation of the chosen Bell inequality should we consider? These are very crucial questions, which arise in laboratories. Hence, we hope that our results will be useful for experimentalists. We focus on the I3322 inequality [17], which is a natural candidate for testing, because of its asymmetry [14, 18]. We consider the case of a post-selection strategy, which consists in rejecting all the rounds in the Bell experiment when one of the detectors does not click. We used numerical optimisation methods to find both the best classical strategy for Alice and Bob and the best detector clicking strategy. Thus, we have found minimal efficiencies of the detectors of Alice and Bob needed to violate I3322. We made the same studies also for symmetric representations of I3322 [19]. Our results show that the minimal efficiencies of Alice and Bob’s detectors of the asymmetric representation of I3322 is lower than in case of the symmetric one [20]. It is work in progress, and we are examining other post-selection methods as well as other Bell inequalities. We want to consider also the case when non-maximally entangled states are used in Bell experiments.
In the case of a pair of two-outcome measurements, incompatibility is equivalent to Bell nonlocality. Indeed, any pair of incompatible two-outcome measurements can violate the Clauser–Horne–Shimony–Holt Bell inequality, which has been proven by Wolf et al (2009 Phys. Rev. Lett. 103 230402). In the case of more than two measurements the equivalence between incompatibility and Bell nonlocality is still an open problem, though partial results have recently been obtained. Here we show that the equivalence breaks for a special choice of three measurements. In particular, we present a set of three incompatible two-outcome measurements, such that if Alice measures this set, independent of the set of measurements chosen by Bob and the state shared by them, the resulting statistics cannot violate any Bell inequality. On the other hand, complementing the above result, we exhibit a set of N measurements for any that is -wise compatible, nevertheless it gives rise to Bell violation.
Summary form only given. In a Bell experiment, one prepares pairs of entangled particles and sends them to two observers, Alice and Bob, for measurement and detection [1]. For some choices of their measurement settings, Alice and Bob may observe strong correlations between their results in accordance with the predictions of quantum mechanical theory. Conversely, any physical theory that assumes no physical influence can be faster than the speed of light and that properties of physical systems are elements of reality [2] - a local realistic theory - can predict only a limited amount of correlation between Alice's and Bob's measurement outcomes. Upon observing correlations sufficient to violate Bell's inequality, Alice and Bob must abandon local realism.It is common that in an experiment, some particles emitted by the source will not be detected. Then the subset of detected particles might display correlations that violate the Bell inequality although the entire ensemble can be described by a local realistic theory [3]. To achieve a conclusive Bell violation without assuming that the detected particles are a “fair” sample, a highly efficient setup is necessary. Due to experimental limitations, fair sampling has been assumed in most Bell experiments performed to date, and it has never been possible to avoid this assumption with photons due to the absence of efficient sources and detectors. Here we report the first Bell experiment with photons that does not rely on any fair-sampling assumption. In our experiment we employ the Eberhard inequality, a Bell inequality that by construction does not rely on the fair-sampling assumption [4]. Our source of entangled photon pairs utilizes bulk-crystal spontaneous parametric downconversion in a Sagnac configuration, which has shown to be very efficient [5, 6]. For photon detection, we employ superconducting transition-edge sensors, which not only offer high efficiency but also are intrinsically free of dark counts [7]. This combination of features is imperative for an experiment in which no correction of count rates can be tolerated. We achieve uncorrected coupling efficiencies over 73% in each arm of our source, facilitating a violation of the inequality by nearly 70 standard deviations after five minutes of measurement. Since the first experimental Bell test, a satisfactory laboratory realization of the motivating gedankenexperiment has remained an outstanding challenge. The two other main assumptions include “locality” [8, 9] and “freedom of choice” [10]. Invoking any of these renders an experiment vulnerable to explanation by a local realistic theory. The realization of an experiment that is free of all three assumptions-a so-called loopholefree Bell test-remains an important outstanding goal for the physics community with strong implications for quantum technologies. We note that with our experiment, photons are the first physical system for which each of these three assumptions has been successfully addressed, albeit in different experiments. This represents promise for practical applications like one-sided device-independent quantum key distribution [11], and in an additional test, we also demonstrate that our experimental apparatus is capable of implementing this protocol on both sides.