Investigating electromagnetically induced transparency spectral lineshape distortion due to non-uniform fields in Rydberg-atom electrometry
Andrew P. Rotunno, Christopher L. Holloway, Nikunjkumar Prajapati, Samuel Berweger, Alexandra B. Artusio‐Glimpse, Roger C. Brown, Matthew T. Simons, Amy K. Robinson, Baran Kayim, Michael A. Viray, Jasmine Jones, Brian C. Sawyer, Robert Wyllie, Thad G Walker, Richard W. Ziolkowski, Steven R. Jefferts, Steve Geibel, Jonathan M. Wheeler, Eric Imhof
We investigate the effects of spatially non-uniform radio-frequency electric (E) field amplitudes on the spectral line shapes of electromagnetically induced transparency (EIT) signals in Rydberg atomic systems used in electrometry (i.e., the metrology of E-field strengths). Spatially non-uniform fields distort the EIT spectra from that of an ideal case, and understanding this distortion is important in the development of Rydberg atom-based sensors, as these distortions can limit accuracy and sensitivity. To characterize this distortion, we present a model that approximates the atom vapor as multi-layered media and then uses Beer’s law to combine the absorption through its many discrete thin segments. We present a set of expected line distortions caused by various RF electric-field distributions found in practice. This provides an intuitive diagnostic tool for experiments. We compare this model to measured experimental atomic spectra in both two-photon and three-photon excitation schemes in the presence of non-uniform radio-frequency fields. We show that we can accurately model and reproduce the EIT lineshape distortion observed in these experimental data.
We investigate the effects of spatially non-uniform radio-frequency electric (E) field amplitudes on the spectral line shapes of electromagnetically induced transparency (EIT) signals in Rydberg atomic systems used in electrometry (i.e., the metrology of E-field strengths). Spatially non-uniform fields distort the EIT spectra from that of an ideal case, and understanding this distortion is important in the development of Rydberg atom-based sensors, as these distortions can limit accuracy and sensitivity. To characterize this distortion, we present a model that approximates the atom vapor as multi-layered media and then uses Beer’s law to combine the absorption through its many discrete thin segments. We present a set of expected line distortions caused by various RF electric-field distributions found in practice. This provides an intuitive diagnostic tool for experiments. We compare this model to measured experimental atomic spectra in both two-photon and three-photon excitation schemes in the presence of non-uniform radio-frequency fields. We show that we can accurately model and reproduce the EIT lineshape distortion observed in these experimental data.
We present a model for calculating broadened Autler-Townes spectra when probing ac electric field magnitudes by use of Rydberg atom electromagnetically-induced transparency. This model approximates the atom vapor as a multi-layered media and uses Beer's law to combine probe beam absorption through many discrete thin segments, replicating the broadening seen in experimental measurements. The methodology can be easily applied to other non-uniform optical parameters when monitoring total spectral transmission or phase delay. Field non-uniformity is present in standing waves of unmatched waveguides and glass vapor cells, which are generally due to source characteristics and environmental reflections. We present broadening and distortion effects caused by various types of electric-field distributions, and compare this model to results obtained from measured atomic spectra.
Highly excited Rydberg atoms in a room-temperature vapor cell are promising for developing a radio-frequency (RF) electric field (E-field) sensor and relevant measurement standards with high accuracy and sensitivity. The all-optical sensing approach is based on electromagnetically-induced transparency and Autler-Townes splitting induced by the RF E-field. Systematic investigation of measurement uncertainty is of great importance for developing a national measurement standard. The presence of a dielectric vapor cell containing alkali atoms changes the magnitude, polarization, and spatial distribution of the incident RF field. In this paper, the field distortion of rubidium vapor cells is investigated, in terms of both field strength distortion and depolarization. Full-wave numerical simulation and analysis are employed to determine general optimization solutions for minimizing such distortion and validated by measuring the E-field vector distribution inside different vapor cells. This work can improve the accuracy of atom-based RF E-field measurements and contributes to the development of related RF quantum sensors.
The large electric dipole moment of the Rydberg atom allows for strong coupling with weak electric fields, and is widely used in electric field measurements because of its reproducibility, precision and stability. The combination of Rydberg atoms and electromagnetically induced transparency (EIT) technology has been used for detecting and characterizing radio-frequency (RF) electric fields. In this work, by selecting probe light (852 nm), dressed light (1470 nm), and coupled light (780 nm), the Rydberg state (49P3/2) of Cs atom is prepared by using a three-photon excitation scheme through using all-infrared light excitation of Rydberg atoms. We experimentally observe the EIT spectra of the Rydberg states decorated by radio-frequency electric fields, which optically detects Rydberg atoms. The effect of the amplitude and frequency of the RF electric field on the spectrum is explored in light of changes in the EIT spectrum. The results show that in the region of weak electric field, only the ac Stark energy shift and spectral broadening occur. As the electric field is further enhanced, the sideband phenomenon occurs in both the primary peak and secondary peak of the EIT. In the region of strong field, the Rydberg energy level produces a series of Floquet states with higher-order terms, as well as state shifting and mixing, resulting in asymmetry in the spectra of the EIT sideband peaks. The effect of frequency on the shielding effect of the Cs vapor cell is further discussed based on the shift of the main peak of the EIT. The demodulation of the electric field in a range of 50 Hz–1 kHz with a fidelity of 95% is achieved by modulating the low-frequency electric field to the RF electric field. The results can provide valuable references for spectral detection and traceable measurements of low-frequency electric fields.
We investigate the effect of band-limited white Gaussian noise (BLWGN) on electromagnetically induced transparency (EIT) and Autler-Townes (AT) splitting, when performing atom-based continuous-wave (CW) radio-frequency (RF) electric (E) field strength measurements with Rydberg atoms in an atomic vapor. This EIT/AT-based E-field measurement approach is currently being investigated by several groups around the world as a means to develop a new International System of Units traceable RF E-field measurement technique. For this to be a useful technique, it is important to understand the influence of BLWGN. We perform EIT/AT based E-field experiments with BLWGN centered on the RF transition frequency and for the BLWGN blue-shifted and red-shifted relative to the RF transition frequency. The EIT signal can be severely distorted for certain noise conditions (bandwidth, center frequency, and noise power), hence altering the ability to accurately measure a CW RF E-field strength. We present a model to predict the line shifts and broadenings in the EIT signal in the presence of noise. This model includes AC Stark shifts and on resonance transitions associated with the noise source. The results of this model are compared to the experimental data, and we find very good agreement between the two.
A Rydberg atom is a special type of atom characterized by a high principal quantum number. Electric field sensors based on Rydberg atoms have received widespread attention due to their high polarizability. However, there is currently little research on the use of Rydberg atoms for direct current (DC) or low-frequency electric fields, mainly due to the shielding effect of atomic vapor cells in low-frequency electric fields, which makes accurate measurement of the electric fields extremely challenging. In this paper, we construct a Rydberg ladder configuration by using probe laser at 852 nm and coupling laser at 510 nm in a room-temperature cesium vapor cell with integrated electrode plates, thereby enabling the realizing of a Floquet-EIT (electromagnetically induced transparency) spectrum dressed by a radio frequency (RF) field in the presence of a DC electric field. We further study the influence of DC electric field on spectral characteristic. Experimentally, it is observed that when only the RF electric field is applied, the EIT spectrum displays solely even-order sidebands. Furthermore, when both the RF field and the DC electric field are simultaneously present, the first-order sideband signal of the Floquet-EIT is observed. As the intensity of the DC electric field increases, the amplitude of the first-order sideband gradually increases. However, increasing the DC electric field to a sufficient magnitude induces sideband interference, which leads the sideband amplitudes to decrease. Furthermore, increasing the RF frequency can alleviate the interference effects induced by the DC electric field on the first-order sideband. Finally, comparing the relative standard deviation of the sideband amplitudes of the Floquet-EIT spectra with the frequency shifts of the DC-Stark spectra under weak DC electric fields, we find that the measurement accuracy of the former is significantly superior to that of the latter. This work makes use of a Cs atomic vapor cell with an integrated electrode to avoid shielding effects. By observing Floquet-EIT spectra, the response of the spectra to DC electric fields is investigated. This experiment provides novel insights into the quantum sensing measurements of DC and low-frequency electric fields.
We investigate the sensitivity of co-linear three-photon electromagnetically induced transparency (EIT) in 133Cs Rydberg atoms to radio frequency electric fields and compare against the conventional two-photon system. Specifically, we model the 4-level and 5-level atomic systems and compare how the transmission of the probe changes with different laser powers and RF field strengths. In this model, we define a sensitivity metric that relates to the current best experimental implementation and assumes photon shot noise limited detection. We find that the three-photon system boasts much narrower linewidths compared to the conventional two-photon EIT. These narrow line features, however, do not align with the regions of the best sensitivity. In addition to this, we calculate the expected sensitivity for the two-photon Rydberg sensor and find that the best achievable sensitivity is over an order of magnitude better than the current measured values of 5 μVm−1Hz−1/2. However, by accounting for additional noise sources in the experiment and the quantum efficiency of the photo-detectors, the values are in good agreement.